Having problems with your 2001 Dodge Intrepid ?

Replace crankshaft sprocket 2001 dodge intrepid

\015 Timing sprocket worn\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2001 Dodge Intrepid

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replace crankshaft sprocket 2001 dodge intrepid


... 2001 Dodge Intrepid

I have a 98 dodge intrepid 2.7L and i had a guy come over to help me replace the water pump and timing chain. after we took the timing chain off and replaced the water pump i noticed that he rotated the camshaft sprockets individually. it was rotating hard with a pop and clank type noise. i told him to stop and to leave. i got the new chain back on with all the marks on the chain and sprockets lined up according to the manual but now my question is "is there valve damage done since the sprockets


If he just turned the cams over by hand then i doubt that he damaged anything as if a valve was open when the piston came to top dead center then it would have stopped moving.the noise isn`t uncommon because the valves springs will make some noise as ... Dodge Intrepid

I have a 1997 Dodge Intrepid ES with the 3.5 motor. For the past 3 years, the check engine light has been on but has been running fine. I now want to sell it so I went down to the auto parts store and the codes said that the plugs, plug wires, crankshaft sensor and a oxygen sensor needed replacing. I replaced the plugs and crank sensor then drove it to town and it ran great. The Check engine light was still on so I stopped by the parts house and they cleared the codes for me. I went out the nex


You need to reset the ECM once you make any changes to the car.If you only change the sensor then it won't be picked up unless you reset the car using a proper diagnostic tool.Be careful to read all codes before you reset it. ... 1997 Dodge Intrepid

I have a 1997 Dodge Intrepid ES with the 3.5 motor. For the past 3 years, the check engine light has been on but has been running fine. I now want to sell it so I went down to the auto parts store and the codes said that the plugs, plug wires, crankshaft sensor and a oxygen sensor needed replacing. I replaced the plugs and crank sensor then drove it to town and it ran great. The Check engine light was still on so I stopped by the parts house and they cleared the codes for me. I went out th


Then I am guessing that the oxygen sensor really needs to be changed, as most of the time the oxygen sensors will have intermittent problems and will sometimes work fine for a while and then bug up again. In some cases they will only go into fault at ... 1997 Dodge Intrepid

Replace crankshaft sensor on 2003 dodge intrepid 3.5 liter engine


... 2003 Dodge Intrepid

Replace front crankshaft seal on 3.5 L Dodge Intrepid


... 1995 Dodge Intrepid

How do i replace crankshaft seal on 1993 dodge daytona 3.0 liter v6? my crankshaft seal (the front crankshaft seal) is leaking oil on my 1993 dodge daytona 3.0 liter v6, internet says this was a regular thing for this engine, but i cant for the life on me find a diagram or instruction on how to do it without spending money on a book. please help with instructions and diagrams if you can [email protected] for reply answers


The oil pump assembly is mounted on the timing belt end of the engine block with the inner pump rotor indexed and installed on the crankshaft nose. The oil pump case also retains the crankshaft front oil seal and provides oil pan front end closure. ... 1993 Dodge Daytona

Replace thermostat on 1998 Dodge Intrepid - 1998 Dodge Intrepid


... 1998 Dodge Intrepid

2003 dodge intrepid starter replacement 2.7 - 2003 Dodge Intrepid


... 2003 Dodge Intrepid

3.2l dodge intrepid water pump replace - 1999 Dodge Intrepid


... 1999 Dodge Intrepid

Dodge intrepid 95 crankshaft sensor - 1995 Dodge Intrepid


... 1995 Dodge Intrepid

Replace starter in 2003 dodge intrepid - 2003 Dodge Intrepid


... 2003 Dodge Intrepid

Replacing coolant in 04 dodge intrepid - 2004 Dodge Intrepid


... 2004 Dodge Intrepid

Replace o2 sensor in dodge intrepid - 2003 Dodge Intrepid


... 2003 Dodge Intrepid

I have a 1996 dodge caravan (3.3L) that won,t start.I had diagnostic test done and it showed a bad crankshaft sensor.I replaced it and it still did'nt start so i went ahead and replaced the cam sensor and it still won't start what else could it be since the diagnostic test only showed the crankshaft sensor bad.


Typically, the on board computer monitors the crankshaft for rotation and the cam shaft for rotation, and fires the spark plug accordingly. There may also be a sensor for top dead center for cylinder number one. If you have a broken, or slipped timi ... Dodge Caravan

Mystery car my 2000 dodge stratus jumps going down the road and it goes dead. my rpm gauge goes crazy when this happens i have to let it sit for about 10 minutes before it will crank back up. i have replaced the altenater the brain box the heads the crank shaft censor plugs and plug wires. my signal and flashers also go out. i have replaced everything on this car the altenator the brain box the crankshaft and crankshaft censor the plugs and plug wires the heads. what could possibly be left to re


It sounds to me like a bad censor...you would probably have to take it to a shop for them to run a diagnosic test, that should tell you what censor. ... 2000 Dodge Stratus

Starter replacement on 1997 dodge intrepid - 1997 Dodge Intrepid


Disconnect battery negative cable Remove and Install Battery Cable Raise vehicle. For easier servicing, do not remove the wiring from starter at this time. Remove three starter atta ... 1997 Dodge Intrepid

How do i remove the engine of a 1999 dodge intrepid. I am replacing the engine in a dodge intrepid and am in need of some guidence. A manual would be nice if anyone can download that to me it would be great.


Not sure if such a thing exists...however, you'd go about it like you would any engine exchange. Methodically disconnect all electric, vacuum and water hoses, all the while, carefully marking each so you can reconnect everything the same. You will ... 1999 Dodge Intrepid

I have 94 Mercury Tracer 1.9L I did most of the work to replace the broken timing belt except i couldn't remove the crankshaft sprocket to replace the timing belt which I bought,how much time would it take for a shop to only remove the sprocket & put on the new belt & back together? thanks Don


Maybe 2 hrs labor, some shops may not do it because you took it apart but some will, good luck. ... 1994 Mercury Tracer

Replace rear struts on a 96 dodge intrepid - 1996 Dodge Intrepid


I suggest QuickStruts (r). Unless you have a spring compressor, they're the most user friendly. They come in the box as a ready to go, one piece, assembly. You can access the upper 3 bolts either behind the rear seat, under the rear deck, or through ... 1996 Dodge Intrepid

HOW TO REPLACE ENGINE IN 1999 DODGE INTREPID - 1999 Dodge Intrepid


... 1999 Dodge Intrepid

Replace water pump Dodge Intrepid - 1998 Dodge Intrepid


My best suggestion if uve never done it would be to take it to a mechanic its a lot for me to explain its an easy job if uve done it before ... 1998 Dodge Intrepid

Alternator replacement dodge intrepid 2.7 - 2001 Dodge Intrepid


... 2001 Dodge Intrepid

Replace oil pan gasket 03 dodge intrepid - 1999 Dodge Intrepid


... 1999 Dodge Intrepid

Replace rear speakers in dodge intrepid - 2004 Dodge Intrepid


... 2004 Dodge Intrepid
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.7442 seconds