Having problems with your 2001 Dodge Dakota ?

2001 dakota code p0031

\015 Check engine light code p0031\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2001 Dodge Dakota

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2001 dakota code p0031

... 2001 Dodge Dakota

Can anyone tell me what these engine fault codes refer to on a 1998 mercedes c180 auto,1.8 petrol. I suspect it may be releated to tempeture sensor. Total of 6 codes 065 (2,2,0,41) resistance too high 104 (2,2,0,68) resistance too low 122 (2,2,0,7a) resistance too low 126 (2,2,0,7e) resistance too low 129 (2,2,0,81) resistance too low thanks jim 161 (2,2,0,a1) resistance too high

Most common is o2 sensor ... 2002 Mercedes-Benz C-Class

I have a 2000 Pontiac Bonneville 3.8 non supercharged. It is throwing the codes P0446, P0452, P0453. Yes it is throwing all of them and that is what is confusing me. Just reset the codes, did a start-stop-start-stop and got the 53 twice. Also, the fuel pressure isn't good, you hook up the gauge you get 0, when you turn the key on it jumps to 50 and as soon as the pump shuts off it goes back to 0, and when running it stays at about 47. I would greatly appreciate any help. and no my craftsman

... 2000 Pontiac Bonneville

I pulled the CEL code P0031 from my 05 Outback. Changed the front O2 sensor and reconnected everything. Cleared the code with the OBD2 reader. Upon startup CEL put out another P0031. Does the computer need to reset over a few days? Car is totally stock no exhaust mods and only 28500mi. Any advice?

This is a hard fault, this means u have a wiring problem, the sensor was good, that is why the PCM set a code for the same fault right away. ... 2005 Subaru Outback

Car came in no start-doa. replaced distributor pick up assembly. car ran but hesitated between 50-60 mph. replaced wires plugs,cap,rotor button, air filter. car runs, after about 4-5 min. driving car shuts down no throttle. let sit a few seconds, car starts and repeats problem. before tune-up pcm threw a mis-fire cyl#1,cleared code. no mis-fire code no hesitation just shut down problem with no engine lite. datastream shows cyl#1 0 misfire,cyl#2 0, cyl#4,5 &6 show high misfire rate. not famil

Have you replaced the fuel filter? what is the fuel pressure?, this sounds like a loss of fuel pressure issue, that would account for the miss fire codes, to check fuel pressure look at the top of the engine, in the fuel supply pipe that plugs to the ... Chrysler Cirrus

Engine code p0136 on a 2001 dakota

... 2001 Dodge Dakota

I have a 2006 DODGE DAKOTA 3.7 LITER. Had fault code 304 misfire #4 cylinder. swapped coil and plug with other cylinders cleared codes started agian,same code. Replaced #4 fuel injector. cleared codes agian. Now have code #204 open injector circuit #4 cylinder. checked injector wire plug has some discoloration on plug. Anything I can do to determine where the circuit to #4 injector is open?

... 2006 Dodge Dakota

I have 02 dakota with codes p1762 and p1763 when code is present truck will not accelerate and feels like theres no power. when u clear code for a sec or so truck is normal but sets code right away again

Check your fuel pump pressure at the rail. These codes are an indication that the fuel pressure sensor is faulty or the fuel pump is not bringing the Fuel pressure to the proper level. The first is a warning there is a problem, the second is tellin ... 2002 Dodge Dakota Club Cab

1988 honda civic stalled,code 16,replaced main relay,code now reads 0,car still dont start

... 1988 Honda Civic 2 Door

I have a 91 dakota 318 v8 single cab long box 4x4 with code 12 and code 41 showing just wondering what those codes are because it is starting to over heat when idiling or driving slow.

I will look in my 1992 service manual & post later today. ... 1991 Dodge Dakota

Hi i have two codes i need to know what they mean on an 07 dakota code 1 is p013a code 2 is po13c

You have two oxygen senors that were slow to respond information to computer,first was bank 1 sensor2,the other was bank 2 sensor two,they should clear themselves but if they don't you can clear those codes ... 2007 Dodge Dakota Cab SLT

I need the 4 digit code for my 2001 mitsubishi mirage factory radio! I don't know the code on the back of the stereo. I have called dealerships before and got the code and wrote it down but lost it again. Now when I called again they tell me I need to take the radio out. I don't have money to do that! I think I remember there being a 7,9, and a 0 in it but can't remember what the last digit was! If you can please help me I would really appreciate it!!!

Can't find your factory car stereo radio code? We can help!\015\012To all at radio-code.com. I recently experienced a dead battery in my 97 Mitsubishi Gallant ... 2001 Mitsubishi Mirage

I have a 1991 dodeg dakota sport (v-6) and in the past 3 months i have "gone through 3 batteries and 2 alternators. i pulled trouble codes and the same code comes up, code 12 ( stand by memory power lost). no one can tell me what this means! i am a college student and i was laid off work (paramedic). i can not afford a mechanic at this time. can you help me? god bless.


Codes Dodge dakota 2005 CHeck engine light solicited these codes, changed gas cap. WHats next? codes p0499 p0440 p0456

The first two were not listed in the file that I have, the third has to do with evaporative emission control has a small leak. The first two seem to be other codes having to do with the same area. Check the hoses and fittings at the fuel tank area fo ... 2004 Dodge Dakota

How to enter code? went online and paid nine bucks, didn't really help me because of the following problem. 5 digit code, car radio has preset # 1,2,3,4,5,6.. one of my code is 0 and 9 how the hell am i suppose to enter it?

Come on here for free ,anyway you press preset 1 and use either the volume or tuning buttons ,maybe even the tape buttons to place the number then when all numbers press 6 to enter the code on the venerable old classic vehicle ... 1984 BMW 3 Series

At elev. 8500 severe power loss under load. Live feed engine data as follows:0-5 engine timing retarded,pending code fuel system fault OL and sometimes will set mass air flow code. mass a sensor replaced recently. removed air filter resonator from behind bumper,left top portion w/filter element in place. once vehicle returns to lower elev. runs great.will not set code again until returns to 8k .vehicle 30k mi. org. owner.have own scanner w/live feed.

Does your scanner give you a reading for barometic pressure? ... 2001 Hyundai Sonata

97 gmc suburban, no start, has spark and fuel. no codes. scanner shows no problem, except cam ******=0 knock ******=0 and spark ******=0 doesnt show inj. pw. leaning towards pcm??any help would be great

... 1997 GMC Suburban

When ignition is turned off, I loose internal lights,radio and code,side mirrors and unable to lock the car via the key fob, I have checked the trip display for error codes and am getting code 905 CHECK 0

Fuses are a good thing check fuses under hood and under dash likely an under hood fuse is cooked ... Chrysler Voyager

Po871 code my dakota kicks out a po871 code when i haul my trailer. i dont have any issues when i'm not towing. what does the code mean?

... 2005 Dodge Dakota

Using my OBD II on 2000 honda prelude trouble codes PO401 & (PO401 pd) all reads MIL on, monitors, 1 INC, EVAP, 7 ready, MISFIRE, FUEL, COMP, CATLYST, 02 sensor, 02 HTR, EGR. Will be cleaning out EGR, BUT do I need to replace my Solenoid? My prelude stalls and ideals out of first gear. (Autotranny). Is this stall caused by these trouble codes? Also with 1 pending code, what do you recomend? I ran car and used OBD II a 2nd time and only change was (0 inc) and 8 (ready).

... Cars & Trucks

I have a 2005 Dodge Dakota with the code P0304 "cylinder 4 misfire". I took it to a Bridgestone dealership which I believe was an expensive mistake. They changed out the fuel injector then a week later I the engine light came on and I got the same code on the disgnostic took at O'Reilly Autoparts. Today I switched out a coil and the same code appeared about an hour later. Any ideas of what I should check next? Thanks

Hi:\015\012Often, a cylinder misfire can be caused by a sparkplug too, and it is sort of funny that they started with the most expensive parts, first? I fixed my cylinder misfire on my Honda by installing new sparkplug wires and plugs, and it ... 2002 Dodge Dakota Club Cab

Frieghtliner m2 fault codes eng 0, 4376, fail 5 and eng 0, 3361, fail 05

... Cars & Trucks

My 2000 dodge dakota 4x4 with the 3.9 v6 keeps throwing codes for the crankshaft postioning sensor i have replaces this part and reset the computer about three weeks ago now the code has poped back up

Check for loose or corroded wires. Get yourself a spray CRC type of wire connection cleaner. WD 40 is fine. I upon having strange problems, disconnect wiring connections and spray a shot on both connectors. I disconnect and reconnect a couple times e ... 2000 Dodge Dakota Quad Cab

1999 Dodge Dakota ''no bus'' code

... 1999 Dodge Dakota

2000 Dakota 44.7l has these Fault codes

... 1996 Dodge Dakota
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1363 seconds