Having problems with your 2001 Chrysler Sebring ?

Po725 code on chrysler sebring can it cause the starter to go bad

Posted / edited by AnonymousUser on : 23-01-2017

Answers :

Hi there:

DTC P0725 - ENGINE SPEED SENSOR CIRCUIT


When Monitored: Continuously after a ignition key is turned from the OFF to RUN

position and/or key is turned from the CRANK to the RUN position.

Set Condition: The code is set when the engine speed sensed by the Transmission Control

Module (TCM) is different than the engine speed reported by the Powertrain Control

Module (PCM) over the Communication Buss.


POSSIBLE CAUSES:

CHECKING SYMPTOMS AND POSSIBLE CAUSES

LOW BATTERY VOLTAGE

BAD CONNECTIONS AT VARIOUS CONNECTORS

CRANK POSITION SENSOR SIGNAL OPEN

CRANKSHAFT POSITION SENSOR GROUND CIRCUIT OPEN

TCM CRANK POSITION SENSOR MONITORING DEFECTIVE



Hope this helps.

Repair Help & Product Troubleshooting for 2001 Chrysler Sebring

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0076 seconds