Having problems with your 2001 Chevrolet Blazer ?

2001 chevy blazer fuel pump

\015 Troubleshooting fuel pump\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

You will need a fuel pressure tester to screw onto the fuel rail of engine.. if pressure reads 60psi pump is good...
Repair Help & Product Troubleshooting for 2001 Chevrolet Blazer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 2001 Chevy blazer extreme, I have replaced everything. Fuel pump, filter, and fuel injection spider. None of these were the problem, when I turn the key to the on position, the fuel pressure gauge climbs upto 2 psi. After the pump cycles the pressure drops to 0. If I prime the system the pressure will climb to 10 psi, then promptly die off as the engine stalls out again. I have changed the pump twice just to find out the problem still exists. What am I missing? I have no engine codes th


Maybe the gasket theres clearly no pressure holding ... Cars & Trucks

I bought a 1997 Chevy Blazer that was not running. I put a new battery in it and checked for spark. It had spark going to the main wire on the distributor, but the fuel pump was not pumping. I sprayed starting fluid in the intake and the truck started perfectly. So, I bought a new fuel pump, cleaned out the gas tank, and replaced the old one. Now the fuel pump comes on and pumps up, but the Blazer will not start. I checked to make sure that fuel was flowing through the fuel pump and it


Seeing the engine started before with a spray and wont now I would recheck the ignition system. before checking the fuel pressure. ... 1997 Chevrolet Blazer

I need a free wiring diagram for a 1998 chevy blazer. I was changeing the fuel pump in my daughters 1998 chevy blazer. i knocked the gass tank off the jack before I could get all the wires unhooked. The wires were pulled from the plug. The fuel pump has 2 connectors, a 4 wire and a 3 wire. I have found the diagram for the 4 wire but haven't been able to find anything on the 3 wire connector.It has a black/with a white stripe, a green, and a gray wire. I need to know what order they should be wir


Black/white is A,........ Green is B ......and Gray is C ... 1998 Chevrolet Blazer

I have a 1989 chevy Blazer 4.3 auto 4x4 Turned off the blazer tried to restart it would not turn over the fuel system is ok it has a new fuel pump relay fuel pump and fuel filter cleaned out the battery cables also tried starter fluid in the carborator. I believe I am getting no Spark.


Check your coils if you pull a plug and put it back into the wire, turn over to see if spark, if not coils or dis. module. hope this helps you, thanks robert b. ... 1989 Chevrolet S-10 Blazer

I replaced fuel pump in 98 Chevy blazer 8 months ago. Now my car will not start. Fuel is squirting out fuel rail like a water gun then it stops.it starts it I poured gas right into rail underhood an it start right up then shuts off. My check engine light keep telling me the evpor canister was bad since I got fuel pump done but I still drove it until now! When I turn key the hear the pump turn on. It is very loud! Do u think it can still be fuel pump? Or what else can I do to figure out what is g


Fuel pressure regulator. Dont drive it or start it, fire hazard ... Cars & Trucks

I need to know how to check the fuel pump relay. If it is good, my fuel pump is bad. Can I by-pass the internal gas tank fuel pump and put an external one on. This is for a 2001 chevy blazer. Is it true there is not a fuel pump inertia switch? The symptoms are: the truck would run fine, then the next time it would not start. Then later it would. Never knew when it would not start. Already changed the fuel filter.


No bypass. There is no switch (Fords only) there are several relays that are th esame, you can swap it with the horn relay. You should be able to hear the relay turn the pump on for 2 seconds when you turn the key on. Sometimes you can give the bott ... 1997 Chevrolet Blazer

Does anyone know of a problem with 01 chevy blazer fuel pumps? i am on my 5th one in 3 years. the first 3 times i put in airtec fuel pumps. they never lasted more than a few months. then i bought a delphi. it lasted 8 months and stopped working. i exchanged that one in jan 09 and it quit working yesterday. (only 4 months). once i put in a new pump my blazer runs fine for several months.


This is beginning to look like a pervasive problem not unique to your vehicle. It would be interesting to learn exactly what failed inside the pumps you changed. I don't have any good answers yet but I would make a direct ground connection from the b ... 2001 Chevrolet Blazer

Replacedfuel tank,sendingunit and fuel pump on a 94 chevy s-10 blazer. acts like it's not firing, replaced coil. still nothing. today didn't hear fuel pump come on. do i need to take fuel tank off again to troubleshoot the fuel pump?


No you should by able to read power,by at muti meter. ... 1994 Chevrolet S-10

I have 1991 Chevy S-10 Blazer, 4.3L with about 174,000 miles. It had been starting with no problem then one day when I went to start it, it won't start. Cranks over good, then found out that no fuel was coming up to the throttle body. Thought the fuel filter might be clogged, but nope. I had removed the tank and removed the pump and all. Hooked up the pump with fuel in a bucket to see if it would pump, I might get a drop or 2 or fuel. Now I am being told that either the oil pressure switch or fu


If you had the pump working, it should pump about a cup [ 8 oz. ] or more in 15 seconds. sounds like the pump is bad or the inlet screen is clogged. the pressure for this system should be at least 13 PSI. I wouldn't test it in a bucket of fuel as ... 1991 Chevrolet S-10

I have a 2002 chevy blazer 4.3L that wont start i have replaced the fuel pump, PCM, checked the fuel pump relay and fuel filter. If i run a jumper wire from the fuel pump wire to the battery it wil start and run does anyone have any suggestions?


Are you using the original key ?? sounds wear but in the key switch there is a sensor that detects if the right key is in use otherwise it will kill the power to the fuel pump or it can be a fuse look under the left rear passanger seat there is anot ... 2002 Chevrolet TrailBlazer

Where is my fuel pump relay on a 1996 chevy blazer? I changed out my fuel pump and the blazer still will not start


Its in the fuse panel under the hood the cover will tell you where it's located.You also may need to replace the crankshaft speed senser,if it's gone the relay won't work.If you listen and hear no fuel pump running when the key is first turn on then ... 1996 Chevrolet Blazer

I have changed the fuel pump on my 1997 chevy blazer 3 times in three months. I have changed to relay (found in the glove box), and the fuel filter. The car wont crank unless I pour gas directly into the butterfly on the top. The last two times I changed the fuel pump, the pump gradually stopped working, making a loud Whine before it quit. This time, we got it started, and running just fine for a few days, then it got where it would not crank without pouring gas in. Now, you can't here the fue


You may have a problem with the wireing harnest to the fuel pump There is a service boletin #25215705 released in march 07 The wiring is not resistance wire and tends to over heat When i did mind i bought a deiphi fuel pump and this kit came with the ... 1997 Chevrolet Blazer

My 1996 chevy blazer 4.3L will not start unless I put fuel in the carb body. I changed the fuel filter and checked fuel pump and lines. The fuel pump is working. No signs of fuel of leaks. A loss of power when I accelerated.


Could it be your fuel injector? uhm try using a cleaner hopefully it's just dirty ... 1996 Chevrolet Blazer

2000 chevy blazer 4.3L(2 door)3 New fuel pumps and none will pump


Bad ground? ... 2000 Chevrolet Blazer

(2000 Chevy s10 blazer, bogs under acceleration) the fuel pressure regulator was replaced when the injection module was replaced, like i said, the complete unit was replaced. the truck had the problem before all the work was done to it. When i replaced the fuel pump i drained all the old fuel out of the tank, then soaked up what fuel was left in the tank before i installed the new pump with shop rags, filled it up with fresh gas after installing everything, test drove and still have problem. pl


Check your throttle position sensor and if possible connect to snap-on scanner to check for codes ... 2000 Chevrolet Blazer

I have a 1989 chevy s-10 blazer. i have replaced the fuel pump, the fuel pump relays and i hooked up the pump for a dry run before putting it back into the tank, the float neddle works but the pump is not running...if possible, could you help me find the fp fuse location, i have had a couple people tell me there happens to be a fuse for it. i do appreciate if you could help me with this, i have been racking my brain about it for the past 2 weeks. thankyou, richard


If you didn't damage the fuel pump with the dry run, and the relays are new, and the wiring is connected properly, it should work. If you have checked all the fuses in the fuse panel and none are blown, I don't ... 1989 Chevrolet S-10 Blazer

Where is the fuel pump relay fuse at on a 2003 chevy blazer in the fuse box, glove box? my truck was running fine and then while idleing last winter it just died no fuel reaching the fuel filter. i am hoping that i dont have to drop the tank also would be nice if there was an access panel to remove the fuel pump. is there any sites with videos on this procedure? thank you mr.walking


The fuse I think is under the hood in that fuse box. I know of no other way to remove the pump except to lower the tank on your model ... 2003 Chevrolet Blazer

I have a 92 chevy s10 blazer 4x4 4.3 vortec W i just replaced the fuel pump and fuel filter.. it will start sometimes mainly after it sits overnight but when you drive it you can only drive for about 10 mins and it will chug the whole time and then shutoff... i was told it could be the fuel pump relay or the fuel pressure regulator and was wondering what to try first?


I had this problem.I removed the fuel pressure regulator and it was full of carbon.Remove it very carefully as to not damage any seals.Remove as much carbon as you can and reinstall.This should solve your problem. ... 1992 Chevrolet S-10 Blazer

No start. Ran sluggish for a few miles. Fuel pressure is about 40 psi at the schrader valve. Fuel pump? Car is a 2000 Chevy Blazer 4.3 V6 with 140,000. Fuel pump has been replaced about 2 years ago. Will start if I pour some fuel in the air horn but dies after about 3 seconds.


I would lean towards the pick up pump not delivering the fuel .Hope this helps. ... 2000 Chevrolet Blazer

2001 chevy blazer, have replaced fuelpump,filter,fuel pump relay.Fuel pump does not run everytime key is turned to start.When pump does run the engine runs for a short time and quits.When I try and re-start engine the fuel pump may not work at all. Any ideas


When replacing fuel pumps on alot of chevys its recommended to replace the harness also or you can have repeated fuel pump failures. Do a search on,, why repeat fuel pump failures;; and you'l have some info to go on. ... 2000 Chevrolet Blazer

I have a 1996 chevy blazer that won't start. I changed the fuel pump and checked the spark plugs. The fuel pump is fine. The injectors are not releasing the fuel so it could ignite. What could be wrong?


Hello! The first choice is the Manifold Absolute Pressure Sensor (MAP)...It is called the fuel boss...However I need to be sure that fuse # 10 (20A) interior fuse block Is OK...The MAP is bolted to the throttle body and has a three wire connector... ... Chevrolet Blazer

1994 chevy s-10 blazer. will start. runs for 25 or 30 minutes and dies when you try to accelerate or after it warms up. will not re start until it sets for 30 minutes. replaced distributor cap, fuel pump, fuel pump relay, entire distributor, computer in behind the glove box, coolant control sensor, throttle position sensor. no change. has plenty of fuel pressure and has spark. the wires to the spider assembly check ok when unplugged and checked during no start episodes. I am pulling my hair out


This sound like an EGR valve that has gunk in the needle seat. Take the valve off and clean it thoroughly of if it is too bad replace it. \015\012\015\012You can prove it is an EGR problem with a vacuum gage connected via a tee to a dir ... 1994 Chevrolet S-10

Elelctric problem I have a 1998 Chevy blazer and the problem is that. I have no delivery of fuel to get star however the engine thas crank, but won't start. I have check the fuel pump and gets 11.80 volts to the plug, also change the battery and still the same. Ihave no clue if the computer module for some code or if is that at all. I have change the sensor on the fuel pump too but no luck. there is no alarm active.


Try replacing the fuel filter. This has bitten me two times now. I use WIX fuel filters - have more filament. I change fuel filters on all my vehicles every year as regular maintenance. ... Chevrolet Blazer

My 1995 chevy blazer will not start fuel pump works smell gas also but still will not start replaced relays, fuel pump, fuel injectors, crank censor, distb. cap n rotor plugs and wires spark plugs, cat converter could you please help


Hi have you checked fuel pressure or a fuel leak you should not be able to smell gas ... 1995 Chevrolet Blazer

I have a '96 Chevy Blazer that has been hesitating. I have replaced the fuel pump, fuel filter and MAP sensor. I took it to a mechanic and he told the code came back as a fuel pump problem, but I have already changed it out. What else can it be?


How many miles are on this vehicle. What was the code that came up?? What is the fuel pressure at the rail??? ... Chevrolet Blazer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.7555 seconds