Having problems with your 2000 Suzuki Esteem ?

How to fix IAT sensor on 2000 suzuki esteem 1.8l

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 2000 Suzuki Esteem

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to fix IAT sensor on 2000 suzuki esteem 1.8l

... 2000 Suzuki Esteem

Where is IAT sensor located on 2000 suzuki esteem 1.8l

... 2000 Suzuki Esteem

I have a 1995 nissan altima GXE and i replaced my IAC valve saying the trouble code i was getting from the self diagnostics was IACV?ACC valve, IAT Sensor, EGR Solenoid Valve, and Knock Sensor but it only showed on the obd2 scanner. Now I replaced the IAC vlave new and fixed the IAT saying it was only a resister. The knock sensor well the wirer harness was stuck between the starter and the motor tight but loosen that up. Now my egr valve works it opens then throtle is used and the closes but the

Hello,The EGR solenoid is activated by the ECM at mid range speeds so if you are testing it at a idle it will not show voltage. The ECM grounds the solenoid to turn it on which supplies vacuum the source to the EGR valve.. To test the EGR solen ... 1995 Nissan Altima

Is there any difference in a AFH55-13M 6612 & a AFH55-13M 01X mass air flow sensor on a 2002 Suzuki Esteem & a 2003 Suzuki Esteem

... 2002 Suzuki Esteem

My 2001 suzuki esteem wagon ABS light came on...it's been on for several months...I finally cleaned all 4 ABS sensors...yesterday...2 sensors were very dirty..the light remains on...if the dirty sensors were in fact the cause...will the light go off on its own or do i need to re-set it and how do i re-set it? i did not have it scanned yet...just assumed that dirty sensors may be the problem

Scan the abs system clear codes then test drive if it comes on again the reread codes and fix probably a bad wire or sensor ... 2001 Suzuki Esteem

Changed maf sensor because of p0113 code stillhave problem after i changed sensor battery light came on fixed bad belt could belt have caused the pcm to not read the 5v it needed to wor k the iat sensor?

P0113 is air temp circuit high. The maf sensor (mass air flow) sensor just measures the amount of air entering the engine. The iat (intake air temp) sensor is the one that detects the temperature of the air.\015\012Change that sensor, and the c ... 2000 Mazda MPV

I have a 2000 suzuki esteem wagon 1.8L. My mechanic told me it doesn't have a crankshaft sensor but a camshaft sensor. One mechanic told me need to replace the crankshaft sensor and the other mechanic says its the camshaft. Please tell me which is which.

... 2000 Suzuki Esteem


Take it back,they checked nothing, before they sold it to you. That's what they do. Next time, buy from a private party, and learn to do all your own repairs,you'll never have a vehicle issue again. ... 2007 Suzuki Forenza Sedan

Where is the suzuki sx4 heater sensor located? i have a "HO2S Heater Control Circuit Low (Bank 1 Sensor 2)" problem and do not no where to find that sensor or how to fix that problem

That is an error for a heater oxygen sensor (H02S). It's located on the exhaust pipe after the catalytic converter. If you have a 4 cylinder, there will only be one catalytic converter so it will be pretty easy to figure out which sensor to replace. ... 2008 Suzuki SX4

Would a problem be caused to use a 2003 Suzuki Esteem Mass Air Flow Sensor on a 2002 since it seems to be working great

They have to be exactly the same part electrically,etcNo way to know that unless the part number & application is the sameYour cars pcm won't have proper air flow readings if you don'thave the correct sensorAre they th ... Cars & Trucks

99 suzuki esteem 1.6 camshaft sensor Location

... Cars & Trucks

Crankshaft postion sensor 1.8 suzuki esteem 2001 loction

... Cars & Trucks

Crankshaft postion sensor 1.8 suzuki esteem 2001 loction

... Cars & Trucks

Code number PO100- air flow sensor, volume airflow (MAF/VAF) and code number PO110- air intake air temperature IAT sensor I just had the car diagnosed by an auto electrician, he advised me to find out from Ford where i could locate these problems. Could you please let me know where the problem is located and how to fix it. Thank you.

Those sensors are actually connected to your air intake pipe just after your air filter. They're just plug and play sensors. ... Ford Laser

P2110, p2135, p101, and p2135 codes on my 2006 suzuki forenza. runs very rough. won't idle. suzuki changed throttle body and transmission range sensor previously. what can i do to fix it?

... Cars & Trucks

Need to locate ect sensor on suzuki esteem - Suzuki Cars & Trucks

... Suzuki Cars & Trucks

The Transmission Speed Sensor, output, for an automatic 1998 Suzuki Esteem, Station Wagon, is broken. Where can i find de sensor to replace it?

Go to oemsuzukiparts.com--they have all the parts you need, including the speed sensor, for a good price--I have used them quite a bit recently for my 2006 Forenza wagon. ... 1998 Suzuki Esteem

1999 Chrysler 300M, Dies on deceleration and at idle when warm. I can some time see the tach go to 0 rpm, with out the car actually dying I have had may suggestions, from EGR, throttle Body, fuel injectors, fuel pump, cam & crank sensors and more, I really would not prefere to just start replacing parts untill I find a solution. Has any body found a fix for this issue, I have seen many posts with similar conditions, but so far not a single one that says the problem was fixed...

For the price of a can of throttle body, spray cleaner, I'd remove the IAC motor , clean it, and port it came out of and try it and see what happens. It sure sounds like the same old dirty IAC problems that are frequent . Normally that will cure it, ... 1999 Chrysler 300M

My 2003 chevy trailblazer ls rpm gage has completly stopped working. when it first started going bad it would work on occasion and now the needle doesnt even move from 0. my car feels and sounds like it is shifting when it should its just the gage that doesnt work. what could cause this? is it a bad sensor, wires or something all my other gages work fine its just the rpm gage. if anyone knows how i can fix this problem please let me know what i need to check i want to be able to fix it myself if

... 1996 Audi A4

My 2002 Suzuki Vitara made a noise while starting. Now it will turn over but will not start. I took it to a local mechanic and he read the service engine code and said I needed a cam position sensor. He replaced the sensor and it did not fix the problem. He say's it still has no spark and almost no fuel. Any idea's???

Timing belt or crank sensor ... 2002 Suzuki Vitara

What should be the ideal reading in ohms for the oxygen sensor, since my 1997 suzuki esteem stalls at street corners; it seems unable to keep the motor idling...Could be another sensor (idle?), and what should the reading be? It was 2,000 ohms on my old Volks, but I have no idea what it is for this one. Thanks!

... 1998 Suzuki Esteem

2002 Suzuki esteem 1.8L I/M Readyness not compleeting

It is not how far you drive it is how you drive. Google this to read more about it Google "OBD 2 Drive Cycle" ... 2002 Suzuki Esteem

1993 suzuki sidekick 16 valve JLX i need to find out where the iat sensor is

... Isuzu Trooper

How to replace an IAT Sensor in a 2005 Suzuki Forenza?

... 2005 Suzuki Forenza

How to reset the SYS lite on a 2002 Suzuki Esteem after replacing the Mass Air Flow Sensor

Answered ... 2002 Suzuki Esteem
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.2200 seconds