Having problems with your 2000 Saturn Ls 4dr Sedan ?

Video to replace 2000 saturn ls blower resistor

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2000 Saturn Ls 4dr Sedan

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Video to replace 2000 saturn ls blower resistor


... 2000 Saturn Ls 4dr Sedan

I have a 2000 Saturn LW2 V6 3.0. My heater quit working 2 years ago so I did my hw and found it to be the blower motor resistor. Well, the heater quit again with the same symptoms as before...intermittance...sometimes it would work on all settings, sometimes not at all and would come on or tirn off as I was driving down the road. I replaces the resistor yesturday...today..NO HEAT! Could someone please give me a clue as to what could be causing this to happen? I say a short or the blower motor is


With the vehicle running and the blower switch set to high and the blower motor not working tap the bottom of the blower motor with the handle end of a screwdriver. If the blower starts to work it is bad. Usually the brushes are worn out and tapping ... 2000 Saturn L-Series

Replaced the 3 blower resistor pack on 2004 saturn ion. The blower still does not come on.


... Saturn Cars & Trucks

2004 Buick Rendezvous - Heater/AC fan switch shorting out. I had issues with the switch working on only 2 speeds. I then replaced the resistor block. I then got all speeds except 2. The AC Light came on with #2 but blower not working. Also, the AC and other 'directional' switch didn't work either only worked for a 10-30 seconds. I then pulled the dash and found the switch burnt on a couple of pins. I replaced the switch and control head BUT now the fuse keeps blowing the moment of going from 0 t


... Buick Rendezvous

Rear AC/Heat Blower on my 2002 Dodge Grand Caravan only blows on high. I assumed the blower resistor is out and purchased the replacement for the rear blower from the dealer. Where is the rear blower motor resistor? How do I get to it to replace it? Someone told me it might be a part of the motor itself requiring a whole rear blower motor replacement. If this is true, why would the dealer sell me a resistor module for the rear blower?


... 2002 Dodge Grand Caravan

The blower on my 2002 Chevy Trailblazer was not working, I replaced the resistor and it worked on settings 1,2,4 &5. when I replaced the resistor I noticed that one of the leads was burned and the wire block into the resistor was partialy melted. The blower has stopped workin again. I looked at the new resistor and the situation is the same as the original. I did notice when I replaced the resistor and tested the system that the resistor was hot to the touch. Is this normal? Could the situation


Yes the resistor is going to be hot to the touch, unless you run the blower on high which bypass the resistors to give the blowers a full 12 volts. You could try replacing the wire block and harness just to make sure there i ... 2002 Chevrolet TrailBlazer

Blower motor resistor overheats and fried connector to blower motor on 2001 Grand Caravan. Replaced resistor once new one fried connection. Saw review online that the resistor diode may be the culprit. Have same rely fuse and blower motor in van. Also, can this fry the blower motor and should I replace relay with resistor. Would appriciate any advice/help. Thanks


You should be replacing the blower motor with the resistors. If your buying the parts from the dealer an experienced parts person will insist you replace both at the same time. The blower motor is usually what burns out the resistors. ... 2001 Dodge Grand Caravan

Blower motor no high speed. Replaced resistor (3 Times, keeps burning out) replaced wire going to resistor. it burned out . replaced blower motor with new resistor . resistor and wire burned out . i have low and medium , no high


... 2005 Chevrolet Astro

How to replace a 2000 Saturn LS heater blower resistor


... 2000 Saturn Ls 4dr Sedan

Saturn 2001 SL idles in neutral between 2000 and 3000 after engine gets warmed up. also blower for heater has bad resistor were is it located so i can replace it?


High idle concern is probably caused by either a sticking throttle plate, defective IAC or the computer is commanding the high idle for another reason.the blower motor is found behind the glove box in the HVAC case ... 2001 Saturn SL

1998 GMC Sierra. Blower motor works sometimes. No particular circumstances, just when it wants to. Checked all fuses, relays, even replaced the resistor, nothing. Followed the wire harness and found the two pigtails that others have mentioned. Took the wires off, black and purple, and turned ignition on. Getting around 11 volts on all sittings except for the highest setting, it reads 0 volts. The compressor turns on at the console, all the switches on the console work, just not the fan.


Could it be the blower motor it self? sometimes they have a "bad spot" when it is not working, can you hit it and make it run? pretty common on these trucks. the switch is also common. they often melt at the connector on the back making a bad connect ... 1998 GMC Sierra

Heater is out, apparently motor blower is out. Took to local shop where they replaced resistor. They advised not to run heater as it may damage new resistor. And, to order new motor blower. AS a test, i turned on heater for a few seconds and it seems fine. question: If motor blower works after new resistor, why replace?


I don't know why this says 96 Honda Passport....I entered that I have a 2001 Honda Accord. I don't know if that makes a difference. ... 1996 Honda Passport

Air Conditioner blower motor resistor was replaced 2 years ago when ac blower stopped working. Blower is not workinga again, i replaced the blower motor resistor (behind glove box) and still not working. Any suggestions?


Motor is also energized by a relay. check that and also check that the motor itself is good by running a hot lead right to it. I'm sure you already checked the fuse and know the switch is good? ... 2002 Jeep Liberty

How do i replace the blower resistor on my 1996 BMW 318ti?


If you have a right hander it's on the passenger side.....or when you're sitting in the car, the left hand side.....Remove the side panel from under the dash.....That will uncover the center located heat exchange unit.....Look very close ... 1996 BMW 318

I have replaced the blower resistor on my daughter's 2K dodge stratus twice in 6 months and now it is out again. Does excessive voltage draw by blower motor cause this and will replacing the motor and resistor likely be a longer term repair?


Hi i;m mike my wife has a 2000 stratus es and the blower motor rersistor used to blow all the so i got smart and instead of blowing 25.00 each time to replace it i took one of the resistors apart and went to radio shack and bought a higher temp resis ... 2000 Dodge Stratus

How to Replace the Blower Motor Resistor in a 1994 Jeep Grand Cherokee Read more: How to Replace the Blower Motor Resistor in a 2003 Jeep Grand Cherokee | eHow.com http://www.ehow.com/how_replace-2003-jeep-grand-cherokee


... 1994 Jeep Grand Cherokee

2001 Chry. T&C LXI 3.8V6 w/ Auto system. 05/2010 front fan stopped blowing, replaced Front Blower Motor Resistor (behind glove bx) and back to normal on all settings. Yesterday, front blower stopped again, replaced resistor and unit still doesn't work.


Very common for switch to fail and take resistor with it. Recommend testing switch with ohmmeter to make sure it makes only one connection per setting. Let me know if you have questions. ... Chrysler Town and Country

In 2002 Toyota Echo, I need to replace blower motor. There is also a resistor and a ''blower switch'' in a manual, but no explanation of the blower switch. Is this just the 'fan switch' on the dash. Also, my 'resistor' has a switch in it. Is the resistor supposed to be an assembly with a switch? It fails resistance check per procedure, so seems like it.


Blower switch is your fan knob on dash. resistors are located under pass side dash next to blower motor. on alot of cars the blower will work on high speed and not the lower ones- this is a tell tale way to tell the resistor is no good. if this happe ... 2002 Toyota ECHO

I got a 1995 s420 blower blows good then slows down almost to a stop , ive replaced the resistor it worked for like 2 min. blew hard then i think the blowermotor resistor burned out and completely stop working i put back the original one and it blow for like 30 seconds and then slows down almost to a stop i checked the resistor and it gets suppppper hot i cant even touch it i think the blower motor is bad what u think i jumped the blower motor direct and the wires get real hot i think the blowe


I would agree. If you wire it direct the wires should not get hot.The resistor will get hot under normal conditions because the resistance is how the motor speed is controlled.So you are probably right the motor is failing.You could get ... Mercedes-Benz S500

I have a 2000 Pontiac Grand Prix GT. The blower motor only works in the High position. I replaced the blower motor resistor, but it didn't help. Shot the wires with a meter and get 11.8vdc through the resistor pack on High, and 10.2vdc on switch positions 1-4. I would have expected to have varying voltages on each fan setting from the resistor pack and into the blower motor. No shorts to ground or each other in the voltage wires. Very odd problem as the fan will run with 11.8vdc but not wi


I would check all fuses associated with the HVAC, if all fuses are good and you are sure the new part you bought is good then the problem would be in the control unit. ... 2000 Pontiac Grand Prix

The 2 lower speeds for my blower quit working. I read on here that this means the resistor block is burnt out. I replaced the resistor block, but after about 1/2 hour of driving the blower quit again. I looked at the resistors and saw a burn mark. So I got a 2nd set and plugged them in but just left the resistors hanging under the dash. After a couple of minutes the resistors were so hot I could not touch them. Should they be this hot? Does this indicate another problem? If so, what else could b


This shouldnt be normal. you are getting to much power (amperage) to the resister unit. ide check the see which terminal going into ur reisister pack is sending all that power and trace it back ... 2003 Buick Century

1995 Jeep Cherokee AC blower doesn't work. Replaced blower resister, blower, and Aux fan fuse and still it doesn't work. I'm running out of things to check. Original problem was that blower was screeching and then quit working. At the time it was only working on high speed. It quit working and also the AC compressor doesn't engage when switched to that position. I replace the usual suspects like the resistor and blower motor, but still no joy on getting it work. Will not work when switched to ve


Do you have feed to blower motor ?? sorry CSI is coming on TV now and er indoors is screaming that i spent too long on here '¡'¡'¡'¡'¡ usual ----typical woman ,if you have her i will throw my jag in the deal for free ... 1995 Jeep Grand Cherokee

My heater blower stopped working on my 2002 Malibu. For awhile it worked only on a couple of speeds, then stopped working entirely. I replaced the blower resistor and this fixed the problem for about a week, then the blower stopped working again. I replaced the relay and the fuse, with no result. Recently, I noticed that the blower sometimes starts working for awhile when I slam the driver's side door hard, but it eventually stops working again. It works on all speeds when this happens. What do


Hello,\015\012\015\012The blower motor, as you have probably seen, is under the dash on the passengers side. While in Park with the parking brake applied:\015\012\015\012Turn the Key On with fan blower set to High. Locate the ... 2002 Chevrolet Malibu

2004 dakota - blower motor quites. I replaced the resistor twice. then the motor and resistor. The "blower motor common driver" ( No. 2 wire) connect keeps heating up and melting. The last time I bought both motor and resistor from a dodge dealer. The first two times the wires justed heated up and melted at the No 2 connection. The last time I heard like a "arching" and when I took the resistor out I could see it was starting to melt.


It seems like you have a short somewhere in the circuit. Here are some diagrams to help you find the problem.\015\012\015\012Good Luck! Don't forget to rate this post!!\015\012\015\012 ... 2004 Dodge Dakota

2000 impala. ac/heat not blowing out at all. Replaced the blower motor resistor(brand new) and blower motor(used) and the only difference was an audible click when turning the blower switch from four to five. Hooked the resistor back to my original blower motor and it cam on(only on setting 5 and then barely moving) for just a sec then went off again. Results were repeated a few time but only for a few seconds and then that stopped too.


Good Evening, on the passenger side of the dash when you open the passenger door there is an access panel to another fuse box. In there are/is fuses for high and low fan operation. Try checking those and the map on the cover should direct you to whic ... 2000 Chevrolet Impala
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.6638 seconds