Having problems with your 2000 Mazda MX-5 Miata ?

2000 mazda Miata speedo problems

\015 Inaccurate speed reading\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2000 Mazda MX-5 Miata

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2000 mazda Miata speedo problems


... 2000 Mazda MX-5 Miata

I have a 98 plymouth voyager se 3.3l auto (4 speed) and the speedo bounces cause the vehicle to have a jerking motion. when the speedo stays a 0 the vehicle runs fine but this doesn't last long befoer the speedo bounces. it also bounces when you are not moving the bouncing goes from 0 to 200 and when moving its between 20 and 80 . any help would be appreciated We have the same problem and had the speed sensor replaced three times. That was not the issue. Now when sitting at a stand still the sp


I would suggest taking it into a Jiffy Lube or Another Auto-Repair company. They can fix it for sure, and if they don't, you get a refund, and an apology. ... 2000 Plymouth Voyager

I have a mazda astina ba 95 just had a clutch change after this has been done it has gotten 2 problems which were working fine before the change, problem 1 is when put into gear doesn't matter what gear it will idle high then I put the air con on at the same time the idle will go a lot higher and stay at a high rpm until I turn the air con off or take it out of gear, 2nd problem is the speedo is now not working, any help would be great as I don't have a lot of knowledge of mazdas


... Cars & Trucks

2000 Mazda MX-5 1.8i intermittent misfire problem. (It's not a Miata but the website didn't have an option for a normal MX5!) Sometimes the car starts with what sounds like only 2 cylinders firing - it idles at 500 revs, has pitifully little power (it couldn't get up a steep hill) and reaches 3000 revs around 20mph. Then, sometimes, the problem clears itself. It's recently had new HT leads and the plugs have been cleaned and checked. There are no warning lights on the dashboard when it has this


All MX-5's are MIATA'S. the coil pack may be bad. 3000 rpms at 20mph, sounds like the trans is slipping if it was an automatic trans. it helps when you tell EVERYTHING about the car, like what trans is has, ect. ... 2000 Mazda MX-5 Miata

Hi i got a problem i have renault espace and speed always show 0 i change speedo sensor but still not working maybe somebody know what problem is


... 2000 Renault 181

Mazda Miata 2001 car problem


Batteries can have a dead cell in them, meaning there is sufficient charge to run accessories and the "check glass" may look fine (dark green in color on maintenance free batteries), but one dead cell in the battery indicates replacement time. ... 2001 Mazda MX-5 Miata

I just bought a 2003 Mazda Miata last April when my other car died. Today on my way home I noticed the check engine light. My car has 55,000 miles but looks and runs like new. I was checkingon line and the manual and it said maybe gas cap not tight. I got gas about 40-50 miles before so I decided to check the cap. It was not as tight as it should have been, but it also was not very loose. I tightened all the way but the light is stil on. Could this be the problem???? What should I do?


Good Evening, there are several automotive stores like autozone or advanced auto parts that offer the service of scanning your check engine light for free. It would be very worthwhile to have them do that and retrieve the code or codes that caused yo ... 2003 Mazda MX-5 Miata

92 mazda miata new clutch new clutch master cylinder systems been bled several times clutch will work 4 awhile park car then try again and clutch quits working again, while driving clutch works fine 4 about a mile then quits after pumping pedal clutch works a little. intermitten problem sometimes it works but always quits. last time clutch started working again even without bleeding???


Sounds like the seal in the new clutch master cylinder. I've seen that same problem in the hand brake system in small 2 and 4 seat airplanes. ( I'm and aircraft mechanic) The problem is not air in the lines so bleeding won't help. The piston seal i ... 1997 Mazda MX-5 Miata

Took my 2009 #.0 Mazda BT 50 for a wash. Engine light now stays on and revs to max of 2200 rpm. Wash included engine wash, but the problem started day after wash. Don't know if it relates.


... Cars & Trucks

I have a 54 plate ford focus and when im driving along my speedo jumps from 60/70 to 0 mph and back again whats the problem/


In a Focus second half of 2004 is fitted electronic speedometer sensor,located on a gearbox diferential housing.Change.There is pin/steel/.Very difficult going out. ... 2004 Ford Focus

2003 mx-5 rear end shake problem - 2003 Mazda MX-5 Miata


... 2003 Mazda MX-5 Miata

The engine on my sons 91 Mazda Miata is running ruff. Like on 3 cylinders. If I pull the spark plug wire on the #1 cylinder the engine runs the same. If I pull the spark plug wires on the #2,3, or 4 cylinders the engine runs worse or dies. It seems to be getting a good spark but I changed the plugs and wires anyway and the problem remains. While running the engine with the #1 spark plug wire removed there is no accumulation of fuel on the spark plug. It's bone dry. Nor does any fuel come o


You have done a great test but If I assk you to do a swap of the Ist cylinder plug and injector with one from the 3rd , we can come to a conclusion before we can change the full set of plugs and injectors for a good performance.( only if the mileage ... 1991 Mazda MX-5

1999 mx-5 mazda miata- turns over but will not start. fuel pump, fuse not the problem


Check your diagnostics in case they can reveal something...If you're driving an American model WITH a check engine light on the\015\012dash, put a paper clip between terminal 10 and GND in your diagnostic\015\012box (right side of the eng ... 1991 Mazda MX-5

1999 Mazda Miata Problem


I have driven Mazdas for 25 years, and am sharing these experiences in case they can help anyone.  I had two RX-7s and then bought a 2004 Miata a year ago.  The Miata really was brand new, a showroom car with minimal miles on it--truly mint ... 1999 Mazda MX-5 Miata

Mazda Miata: Replaced the coil pack because of misfires, that fixed misfires. Now the check Engine light comes on and the code was related to Cat Convertor. The car get hot around the console and gear shift. There is exhaust coming from the tailpipe but I do not know if it is enough of a flow. Can the Cat convertor be partially stopped up and how can I check and be sure of what the problem is before I buy parts I do not need? Thanks, Danny


The cat converter was trying to burn all of the excess fuel that was being sent out of the exhaust due to the misfire, got way to hot and melted the inside of the cat. I experimented with this while in tech school. You can burn up a cat in about 15 ... 2000 Mazda MX-5 Miata

I am replacing the left front wheel bearing hub on 2006 mx-5 "miata" mazda. There is no center spline nut, but there are four bolts accessed from the inside that probably releases the rotors and the wheel bearing hub assembly. I am installing a used hub that comest with steering nuckles and rotor.the new hub is over $345.00 Should I anticipate any problems doing the job myself. My car currently makes a roaring sound that goes away when I turn left. Mark


When replacing any hub assembly you should never over-tighten the three or four bolts that bolt on the assembly. This will cause it to fail quickly. Use lock-tight to make sure they do not loosen up after installation. A way to tell if your hub assem ... 2006 Mazda Miata

Shifter works when car is off, start car and then shifter won't go in gear. if i start vehicle in first with clutch pedal to floor, car starts going forward. mazda miata mx-5 just put new slave cylinder in and bled. next step was to put clutch master cylinder in. i have adjusted clutch pedal up under dash. i have a very soft clutch pedal. i had a problem with car going in reverse or forward with clutch pedal to the floor


The one item I would suspect is the through-out-bearing not completely\015\012disengaging the pressure plate from the fly wheel. If the vehicle is in neutral\015\012and you slowly depress the clutch and release it do hear a singing or whining\015\012 ... 1997 Mazda MX-5 Miata

I have a well maintained 2004 Mazda 6 V6 with 131,000 miles. Water pump idler bearing froze and engine overheated briefly. I replaced the idler bearing assy and no more overheating problems. But now, after the engine warms it will fluctuate idle between 1400 RPM and 0. However it runs fine if not at idle or if the engine is cold. I can easily maintain a constant 1500RPM while setting still. What's wrong now?


Replace coolant temputer sensor ... 2004 Mazda 6

Hi I have a 1989 mazda capella station wagon, I had the carpartor and dizzy repaired, now they have done that my heater and speedo are not longer working what could the problem be?


Hi my names thomas \015\012its could be a fuse problem or possibly there was a short out some wherealong the wireing \015\012goodluck ... Mazda 929

2002 mazda miata. Low beam on right side will not work. I have checked the bulb and fuses, including under the hood. Could the connector the bulb fits into need to be replaced? How can I tell if this is the problem and what would the approx. repair cost?


... 2002 Mazda Miata

I have a 1990-Mazda miata and the air bag goes off. I replace with a new airbag but the airbag light still on. How to fix this problem?


Disconnect the neg battery terminal for about 15 or 30 seconds to reset the computor ... 1990 Mazda MX-5

I am having problems with my 2002 Mazda Miata It shows engine hesitation surges around 2500-3500 rpm. Dring that time the engine has lack of power


... 2002 Mazda Miata

1999 Mazda 2.5tdi double cab - Speedo not working although cable replaced. It appears that the problem is where the cable connect to gearbox. Any advice?


There is a gear there that might need to be replaced right where the cable connects to the transmission ... 1999 Mazda B-Series

1999 Mazda Miata check engine keeps coming on I have it tune up and replace the ignition coil and wire set.Do I need to replace EGR ,oxygen sensors etc., and where are they located if these are the problem the catalytic converter and fuel pumps are new.Pls. advise.Tks. Rey


... 1999 Mazda MX-5 Miata

How do i troubleshoot mazda miata low beam headlight problem?


... 2002 Mazda Miata
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.5082 seconds