Having problems with your 2000 Mazda MPV ?

Engine Light repair codes for a 2000 Mazda MPV

\015 I went to Checker and they ran the diagnostic on my check engine light and the following codes were on it. P0136 and P1512. One I know is the oxygen sensor and I know how to repair it, but the other means a stuck manifold and I honestly don't know where to look to correct the problem. I saw the information for the P1512 code on www.CanOBD2.com, but it doesn't tell where the problem is or how to correct it. Can you please help? Also the transmission has gone out too, if that helps anything.\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2000 Mazda MPV

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Engine Light repair codes for a 2000 Mazda MPV

... 2000 Mazda MPV

2001 Mazda MPV, 2.5L eng. During accelerating on to highway, van lost power. Van continued to operate but with little power available. I have no engine light and my code "checker" shows PASS (no codes). I was unable to continue to drive and had to have van towed home. I cleaned the MAF senser with contact cleaner (just forward of throttle body). I can start and idle van ok. When I accelerate engine in PARK (neutral) engine operates OK. Put van in drive and I have little power with low RPM (Trans

... 2001 Mazda MPV

My 2002 Mazda MPV recently developed an engine shake when stop at intersection or driving 45mph or slower. My mechanic scanned and found OS2 code, vacuum leak, replaced the intake hose, reset engine light. After driving it for less than a mile later, everything was back, engine light on, shaking even more frequent that before. Please advice, your help is deeply appreciated, thanks.

You might try another mechanic if this one can't get it fixed. Shaking is usually caused by one or more cylinders mis-firing for whatever reason--usually faulty ignition or fuel injection. Has the engine had recent tune-up? Bad spark plugs/plug wirin ... 2003 Mazda MPV

1998 mazda mpv code p0170 erase code car runs fine but when i stop for a few minutes it is hard to start and runs rough the engine light comes back on and the code will read p0170 again

This code indicates a fuel ratio problem. I would start by inspecting all the vacuum lines, including the pcv hose and power brake hose. Carefully inspect the air intake hose. This is the large hose between the throttle body and the airflow meter. ... 1998 Mazda MPV

Mazda mpv 2000 check engine light on code p1512 how to fix?

Idle Charge Actuator Mechanical malfunction. May have a bad O2 sensor or actuator. ... 2000 Mazda MPV

Mazda MPV 2000 engine light on code PO420 What is probiem?

... 2000 Mazda MPV

I have a 02 Mazda MPV. I unfortunely washed the engine off with a garden hose. Tried starting the engine didn't start, noticed a red glow under the car. Stopped trying to start it. Call repair shop. That was 2 yrs ago now and to much money, and didn't get the car fixed. Got a waver for the vehicle registration last year, had to spend $200 minimum. I have (2) OBD codes: P0421 and P0431- Warm up catalyst below threshold, bank 1 and bank 2. What do I need to do/replace?

Seems your car is dumping gas into the chambers. Do you smell gas at exhaust pipe? Codes are coming from O2 sensors. You seem to have 2-stage catayltic conversion, and the first ones are trying to burn the gas but cannot do a good job of it--too m ... 2002 Mazda MPV

My 2005 mazda mpv has a code of p0008 and p0009 engine performance bank 1 and bank 2 what do I need to do it runs great and idles great but bucks a little when excelerating unless I put my foot into it then the engine light flashes

... Cars & Trucks

I got a 2002 mazda mpv and the check engine light and abs light stay on and the car jolts. my mechainic changed the alternator. this did not work and the dealer said that there were no error codes and that i would need another alternator. my mechanic said he would change it, but did not think this would help. i read some where about a grounded ecm, but i do not know what that is...any ideas?

Those indicators light up only in 2 occasions - when there is a fault in them or when the power delivery to them is iffy. \012\012\012Since the there is no error code memorized it means that the first possibility is out. That leaves just the se ... Mazda MPV

Hey, I have a 1998 Mazda MPV, 4WD... my overdrive light is blinking and the check engine light is on... im getting code p1566 indicating speed control command switch out of range-low...does anyone have anymore helpful information on how to solve this problem? thanks, sincerely!

... 1998 Mazda MPV

Want to repair DTC code P1512 and P0031 P1512 is 2000 Mazda MPV van intake manifold runner control stuck closed and P0031-H02S heater control circuit low bank 1 sensor 1. If I can repair it myself, just need to know how and where the location in the engine compartment

... 2000 Mazda MPV

Check engine light code p0126 mazda mpv 2003 - MAZDA5 Mazda Cars & Trucks

... Mazda MAZDA5

I have a 2005 Mazda MPV with 83,000 miles and the engine light came on with codes P2187, P2189, P2195, and P2197. I was told all four O2 sensors need to be replaced. I put some Sea Foam in the gas tank and it runs great except for a rough idle. What would cause all four codes to show up like that?

The combination of the 4 codes leads to low fuel pressure, bad injectors or a leak in the air intake. ... Mazda MPV

My 2005 Nissan Pathfinder Service Engine Light came on at 80,495 miles.I took it to the dealer and after $403.78 worth of repairs code PO455 was replaced an cleared. One month later at 81,159 miles the Service Engine light returned and after $524.73 later, codes U1000 & P0403 were cleared and I was told that my vehicle will need BANK 2 CAT CONVERTER at a cost of $1200.00. The Service Engine Soon Light is on again at 81,700 miles. Is this a realistic cost for these repairs? How long do I have to

Are you the original buyer? If so I would have contacted nissan because most states have what is referred to as a lemon law. According to Statelawyers.com, Lemon Law refers to the statement from the government that was created to protect consu ... 2005 Nissan Titan

Check engine light on in 2001 mazda mpv codes p0102

The web is updated.\012 There is a code table here: Diagnostic Trouble Code Table, hope it can help u and good luck ... Cars & Trucks

My engine light on my 2005 Dodge Neon has been on for the past two days and it generated a P0420(Catalytic Convertor Efficiency)code on the engine code reader. I got the car checked out and the repair shop says that the catalytic convertor need to be replaced and that the 02 sensors may be bad as well. Now as of this morning prior to going to work the engine light never came back on and hasn't thru several driving intervals today. However everytime I plug an engine code reader to the OBD por

Let car warm up to normal temp. Disconnect the negative cable from the battery for 10 mins or... Pull the fuel pump fuse for 45 seconds. Resetting your Ecu each time you add a mod will help make the most out of them. ... 2005 Dodge Neon

Mazda 6 diesel yellow check engine light blinks -codes P0304-FF-PCM and P0342-FF-PCM

... 2003 Mazda 6

What could be the cause of a p0304 code on my 2005 mazda mpv. the check engine light is blinking

#4 cylinder could be faulty plug wire or plug or coil pack,I would start with plugs and plug wire and if it persist change coil pack I hope this helps you ... 2005 Mazda MPV

Mazda MPV 2003, Engine light on, code P0421 - warm up catalyst efficiency below threshold bank 1

Could anyone please help me with this problem that i have with my 2001 mazda protege es 2.0. i have a bad catalyst converter and im waiting for the converter to come in, but before the guys that are fixing on my car relize that i need a ... 2003 Mazda MPV

I have a Mazda MPV van and its engine light on and its being missing alot missfire, changing plug is not working, it had some p15 or 12 code

Sounds like an 02 sensor, it reads how much unbured fuel is running through the exhaust and then the computer adjusts the air/fuel mixture accordingly, when the sensor goes out it will lay the fuel to it because the computer isn't getting a read. ... 2000 Mazda MPV

Check engine light on code p0174 - 2001 Mazda MPV

... 2001 Mazda MPV

2001 Mazda MPV Error code p0431 makes engine light come on


My 2001 Mazda MPV has engine light on when started and blinking while the car is above 40mph. The code is P0303, I changed the spark plugs and new wires. What can go wrong?

Recommend you run a compression test. possibly a burned valve or blown head gasket. \015\012Please see my tip at http://www.fixya.com/ ... 2001 Mazda MPV

Have a 2005 Mazda MPV that is giving p2179 code from "check engine light". What does this mean?

... 2005 Mazda MPV

I have a Mazda MPV 2004 van that recently had the check engine light come on. Over time, the van started to **** and shake whenever idling in Drive. It shakes for few seconds, idles smoothly, then starts shaking again over a continuous cycle. Anytime we drop it down to third or throw it in park, the shaking instantly stops. We took it up to Autozone and it came back with a P0102 code. They recommended try cleaning out the MAF sensor with some canned cleaner and also changing the air filter. We d

I would try to replace the maf sensor first because ive seen that a few times on ford and mazda vehicles (same vehicles really with different names) and also clean the throttle plate at time u change the maf. ... 1999 Pontiac Firebird
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.7535 seconds