Having problems with your 2000 Isuzu Rodeo ?

How many o2 sensors on on an australian rodeo built in 2000

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

There should be 2 one towards rear exhuast and one up by the head firewall
Repair Help & Product Troubleshooting for 2000 Isuzu Rodeo

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How many o2 sensors on on an australian rodeo built in 2000


There should be 2 one towards rear exhuast and one up by the head firewall ... 2000 Isuzu Rodeo

How many oxygen sensors does a 2000 rodeo have on it? I have replaced two and the scan says oxygen sensors again


... 2000 Isuzu Rodeo

2001 rodeo cruise control, ck trans light come on car stalls and shuts off.... rpms jum around some times, car trying to take off on its own. Speed sensor already replaced and many small things done.... cruize control disconnected, but only seems to be disconnected in the stering colum and push button. Still keeps coming on.... want to know where else you disconnect the cruise control?... Nancy


... 2000 Isuzu Rodeo

1999 Chrysler 300M, Dies on deceleration and at idle when warm. I can some time see the tach go to 0 rpm, with out the car actually dying I have had may suggestions, from EGR, throttle Body, fuel injectors, fuel pump, cam & crank sensors and more, I really would not prefere to just start replacing parts untill I find a solution. Has any body found a fix for this issue, I have seen many posts with similar conditions, but so far not a single one that says the problem was fixed...


For the price of a can of throttle body, spray cleaner, I'd remove the IAC motor , clean it, and port it came out of and try it and see what happens. It sure sounds like the same old dirty IAC problems that are frequent . Normally that will cure it, ... 1999 Chrysler 300M

How many 02 sensors on a 02 dodge stratus rt coupe 3,0 engine


... Dodge Stratus

The speedometer on my 1998 rodeo works intermittently. when it doesn't work it just goes up to 20mph and bounces around a little every once in a while. Then all of a sudden it will bounce to 0 and then start working. I've changed the speed sensor and it still has the same problem. Any suggestions???


You need to replace the speedometer gear behind the sensor. And no it is not a magnetic pickup sensor as that on is for the computer. Google myisuzuparts.com and see fig.# 2-25 image 4 a/t thm; 6vd1 Item 1 GEAR; DRIVEN,SPD you may be able to buy ... 1998 Isuzu Rodeo

I HAVE A P0300 OBD CODE I DID A COMPRESSION TEST TO ENGINE AND IT PASS THE TEST,I DID CHECK EGR VALVE,CHANGE SPARK PLUGS,IGNITION WIRES, CAP AND ROTOR, I DID CHECK TPS SENSOR MAF SENSOR,FUEL PRESSURE,AND OXIGEN SENSORSI I FOUND THAT ON BANK 1 BOTH SENSORS (UP STREAM & DOWN STREAM )WORKS NORMALY BUT ON BANK 2 THE SENSOR 1 CHANGE FROM 0 TO 600 MILIVOLTS BUT NO CHANGES FROM RICH TO LEAN &SENSOR 2 HAS 0 MILIVOLTS & NO CHANGES FROM RICH TO LEAN SO I SWICHT SENSOR TO TEST THEM FROM BANK 2 TO BANK 1 AN


... 1997 Nissan Pathfinder

Hesitates after driving for awhile. Acts like it isnt getting enough fuel. I cleaned the 0-2 sensor, replaced thermostate, map sensor and spark plugs. When I am at a stop sign it acts like it is going to die. When put on puter it reads high input 0-2 sensor. 2000 cherokee jeep


You cant clean oxygen sensors, they need to be replaced, Also, remove your IAC and clean it out. ... 2000 Jeep Cherokee

I would like to remove keyless entry sensor from one rodeo and place it in another. I have two 2000 isuzu rodeos. keyless remote for parts car no keyless remote for working car I would like to swap sensors so keyless remote functions for working car


... 2000 Isuzu Rodeo

I have a 1999 mitsubishi galant someone was messing with the battery and all of sudden as i was driving home the check engine light came on the gasoline sensor turn on and the brake sensor turn on and when i was driving up a hill it turn off. After that i noticed that the needle on the meter would not stay on 0. What should i do about this because i don;t know if this is supposed to be on 0?


Try disconnecting the battery cable for 30 seconds and the reconnecting it. This show clear the codes. ... 1999 Mitsubishi Galant

Rodeo 95 Ihave rodeo 95 witsh is reach all the time black cmoke all the time and the plugs come full off gaz burn residue *No service engine soon* I changed Full injection reail and Coolant sensor and map sensor And i still have this probleme plearse help


I have an ecm for a 91 isuzu rodeo 3.1 hopefully you found it cheaper than $100 those things can go up to $800 ... 1994 Isuzu Rodeo

Oil pressure gage is at 0. should be at 30. how do you check to see if it is the pump or sensor. it used to be at 30 or so when it is running, now at 0. how do I check the sensor, or do I have to change pump..


Run a test light from the positive battery terminal to the connector on the sensor. with the engine running, the light should light up. ... 1988 Chevrolet Blazer

Help with troubleshooting speedometer problem. I had a "friend" do some work on my car a while back and ever since then my speedometer will just start jumping from 0 to 10 to 80 to 60 back to 0 at random. It jumps all over the place. Even in park it does this. When it does it going down the interstate it comes out of the torque convrter lockout. So I figure the speed sensor is going out in it. Replaced that and it's still doing it. Well I unplugged the sensor and it is still doing it. I dont thi


I had the same thing go wrong my buddy did not tell me that he droped the thans to the ground befor he saw that the speedo cable was not unbolted, I found out that he had STRETCHED the cable.\015\012not much but that was the problem, ... 1989 Chevrolet Corsica

P171 code p171 lean to bank 1. 2003 Infiniti G35. Maf sensor seems to be within range. Only thing I noticed on my scanner is my long term fuel trim was 37.5% and 0 to 3%. Short term fuel trim was 99% and 0. I checked for vacuum leaks with no luck. I'm leaning towards bad O2 sensor or clogged/bad injector.


Yes i would say the same if you are sure there are no vacuum leaks ... Infiniti G35

Oxygen sensors i have a 2000 maxima v6, and need to know how many oxygen sensors is there on my car , i was told there 2 then i was told 3 , and the third parts store told me there was 4. i cannot afford a mechanic if u could tell me how many there is and where r the located, i have someone that will help me fix it. thanks


Ashleyy_ryan that year maxima can have 3 or 4 oxygen sensors 2 pre cat and 1 post cat or 2 pre cat and 2 post cat depending on the production date. the best way to find them -i found- is to start at the front of the engines exhaust manifold and follo ... 2000 Nissan Maxima

I have been getting the P0421 code since June 2006. I replaced the O2 sensor that sits at the front this January, and the code is still there. I am scared to death that I am about to be autoless. I have been talking to too many people with too many, maybes, and I have apparently thrown money at the wrong things. I hope you can help, I have several questions: First -- did I replace the wrong sensor? 2nd -- Could my Cat be bad, since I do get a bad smell when the car first starts up after sitti


How many oxygen sensor are they on 2000 silverado\015\012 ... 2001 Mitsubishi Galant

2000 toyota 4 runner the code p1135 bank 1 sensor 1 (bad sensor). where is this sensor located and how many 02 sensor a 4 runner have. can i swap the bank 2 sensor 2 with bank 1 sensor 1 to see if the code will change. like the codes on p0302 and p0301.


P1135 Air/Fuel Sensor Heater Circuit Response (Bank 1 Sensor 1)\015\012almost certainly the heater inside the sensor has failed, the heater speeds up the time it take for the system to go into closed loop fuel control.\015\012The b ... Toyota 4Runner

Can anyone tell me what these engine fault codes refer to on a 1998 mercedes c180 auto,1.8 petrol. I suspect it may be releated to tempeture sensor. Total of 6 codes 065 (2,2,0,41) resistance too high 104 (2,2,0,68) resistance too low 122 (2,2,0,7a) resistance too low 126 (2,2,0,7e) resistance too low 129 (2,2,0,81) resistance too low thanks jim 161 (2,2,0,a1) resistance too high


Most common is o2 sensor ... 2002 Mercedes-Benz C-Class

I need a diagram of the exhaust system on a 1992 toyota previa, showing the oxygen sensors, I have replaced the sensor with 4 wires, I was told that there was another sensor with two wires, however the two wire sensor only occurs on 1995 models and up, there is supposed to be a 3 wire sensor for the 1992, where is that sensor located and how many wires does it have.... I am going to go to a junk yard to find it and want to make sure that I get the right one....is there any way to test an O2 sens


... 1992 Toyota Previa

What does the oxygen sensors look like in a 2003 Chevy Venture (warner Brothers Edition) ? How many are there? Where are they located? Can you show a picture of them in place? How do i replace them? Chevy dealer scanned it for codes: "VEHICLE HAS A CODE #PO141 - OXYGEN SENSOR BANK #1 SENSOR #2 WORKING SLOW.. VEHICLE NEEDS OXYGEN SENSOR BANK #1 SENSOR #2 REPLACEMENT.. (A SES LIGHT IS ON - NO RUNNING PROBLEMS)


There should be an O2 sensor before and after the catalytic converter on your vehicle, so it will have 2 sensors. You'll need a 7/8" open end wrench or an O2 sensor socket to replace them.It'll look something like this: http://www.carstee ... 2003 Chevrolet Venture Passanger

How many oxgen sensors does a 2004 Hyundai Santa Fe 2.7 2wheel drive vehicle have and where are they located? What idoes Bank 2 Sensor 1, Bank 1 Sensor 2, Bank 1 Sensor 1, and Bank 2 Sensor 2 mean?


You have 4 O2 sensors, bank one is the front cylinders ( close to the readiator ) there is 2 bank 1 O2 sensors one infront of the catalitic convertor ( bank 1 sensor 1 ) and one after the convertor ( bank 1 sensor 2 ) the same on the back cylinders t ... 2004 Hyundai Santa Fe

2003 mercedes c class how many sensor does it have. i install my scanner to check the two sensor front and back and only one register bank 1 sensor 2. what happen to bank 1 sensor 1. the car has 0420 code.


Thanks for choosing FixYa and welcome to the site. You have two sensors. The front one does most of the work. The back one is for exhaust. Your code is referring to the back sensor. Also, try checking the seal on your gas ca ... Mercedes-Benz C-Class

Coolant sensor I have a 1996 orvis edition straight 6 jeep. The air or heat does not work, blows out hot in summer and cold in winter. Now the display screen in the middle had an orange bar running acroos the front and "coolant sensor bad" keeps coming up. Does one have anything to do with the other and could it be a coolant level sensor or a coolant temperature sensor, and it is expensive and or easy to replace either? Reading through some of these, my truck also has many of the same issues as


Yes inexpensive and easy to change located on the engine block is a two wire sensor threaded into the water jacket, you should also check to see if your heater hoses (both) are hot after 20 min of idling if they ... 1996 Jeep Grand Cherokee

Rebuilt my 454 engine, installed distributor with rotor at 0 TDC on #1 cylinder. Engine ran fine but ses light was on. Code was P1345-- disagreement between cam sensor and crank sensor. Scanner showed anywhere from 19 to 25 degrees advanced. Rotated dist. shaft. to ****** timing. Wouldn't run. Tried two teeth positions in either direction from original setting. Ever have a sensor go bad. The crank sensor is new, cam (on distributor) is not.


The ignition timing is not adjusted with a timing light or with the engine running, and to set the ignition timing follow these procedures.There is a mark or notch on the distributor housing that the rotor should be pointing to when the e ... 1998 Chevrolet K2500

My 2003 range rover hse came back with a code p1107 - front heated os sensor was basically stuck. I wanted to purchase the o2 sensor from an aftermarket site but did not know the exact part I should get. They had many different length o2 sensors and I didnt want to get one too long or too short. please help. I was also told that the car has 4 sensors and upper low back and front. I need to front but is theretwo in the front or would i just need to change that one?


Look at the left and right exhaust manifolds for your front o2 sensors they will be before your converter and to get the right one measure the wire from the sensor to the connector thats your length, also if yours has two front o2's go ahead and repl ... 2003 Land Rover Range Rover
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.3900 seconds