Having problems with your 2000 GMC New Sierra 1500 ?

How dou disable the passlock on a 2000 sireea 1500 truck

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2000 GMC New Sierra 1500

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How dou disable the passlock on a 2000 sireea 1500 truck


... 2000 GMC New Sierra 1500

Check this out... I own 1999 K3500 Chevrolet truck. I was positive that my passlock would not let vehicle start. I looked at all of the symptoms one by one. Fuel injection disabled, security light on dash lit, and everything else on the vehicle worked. I worked on the vehicle for about an hour to try and outsmart the passlock. What I found was that the Terminals on the battery required a complete cleaning, both negative and positive, and the ground wire from the battery terminal negative to th


Great job! however i would check the rest of my main grounds also, escpecially where the neg cables contact the engine. ... Chevrolet 3500

Gm passlock security system how to disable - C3500 Chevrolet Cars & Trucks


There is no simple way to disable.. one would have to go buy resisters and after many attemps figure out which one would be needed for the correct wire. Mosy likely your key tumbler failed and replacing it would be the easiest thing to do. A code wo ... Chevrolet C3500

I have a 1998 Ford WIndstar. It died on us the other day. we put a refurbished alternator in it, changed the clamps that attach to the top of the battery, when the battery is in OUR van and is charged, it will hold the charge running for 1-2 minutes, then the radio goes off, the RPM goes to 0 and then it dings a couple times, then it dies. However, when the battery was in my friends truck it ran it just fine. so its not the battery. we are pretty much stumped. anyone have any ideas? I would grea


I suspect you hav a defective alternator. Remans are famous for this. Take it back where youbought it and have them put it on their testor to make sure it works.\012\012A battery should read about 12 1/2 volts when charged, engine off. ... 1998 Ford Windstar

After about 2 hrs of driving my oil guage on my 2003 sierra goes down to almost 0. I stop and shut the truck off for about 5 min. and the guaga goes back to normal for about 1 hour then the same problem reoccurs. Any ideas? Thanks [email protected]


A failing oil pressure sensor may be to blame, need to verify the pressure is actually falling to zero with a mechanical gauge. If the pressure on the mechanical gauge does not drop to zero under the same conditions then suspect the pressure sensor. ... 2003 GMC Sierra

2006 chevy colorado passlock comes on and stays on, truck won't start for 10+ min. Can I disable this feature?


No, it can not be disabled.\015\012The theft system is indicating a short term theft issue.\015\012Have you added any "after market" remote start systems or alarms?\015\012If NO.\015\012Insert the key in the ignition, turn the ... 2006 Chevrolet Colorado

Chevy s10 passlock disable - Cars & Trucks


... Cars & Trucks

How to disable the passlock on 2006 colorado truck


... Chevrolet Colorado

How to disable passlock system on 2000 Chevrolet 2500 series truck,the security lights stays on continuosly


There isnt any way to disable it that I know of, if you could, anybody could steal the car. It just needs to be fixed by a qualified repair shop or the dealer. ... 2001 Chevrolet Silverado 2500HD

Permanent remove passlock 1 or 2 systems 1999 yukon denali. fuel disabled


... 1999 GMC Yukon Denali

DISABLE PASSLOCK SYSTEM ON 2003 iMPALA - Cars & Trucks


... Cars & Trucks

This morning when I turned on my Durango, the radio volume would not increase when the volume knob is turned manually or with the steering wheel controls. The radio is on, I can change stations and to the CD player, but the volume dos not work. IT goes from 1 to 0 and back and that's it. I've tried turning the truck off, thinking the computer might need to reset and starting it back up, but nothing seems to work. What could it be?


Try disconnecting the vehicles battery for about 5 minutes. ... 2004 Dodge Durango

Passlock disable code - Cars & Trucks


... Cars & Trucks

MY CHEVROLET 1500 PICKUP SECURITY SYSTEM (PASSLOCK) HAS ENGAGED ITSELF AND NOW I CANNOT CRANK MY TRUCK. LAST TIME THIS HAPPENED I WAS TOLD TO USE THE KEY AND LOCK AND UNLOCK THE DOOR AND THAT WORKED. THAT WILL NOT WORK THIS TIME. WHAT SHOULD I DO? I CALLED THE DEALERSHIP AND THEY SAID IT CANNOT BE DISABLED. PLEASE HELP


Well we always found the cheapest way to fix that was to get a used column from a salvage yard and change the whole column. sorry but thats the cheapest and easiest. ... Chevrolet C1500

1995 Dodge ram 1500 V-8 5.9 litre 4x4 short bed is feels like it is bumping when the truck shifts into cruising gear and RPMs drop truck smmoths out when you speed up bumping goes away if you shift overdrive off transmission guy says transmission si fine the truck is not firing on cylenders 1 and 3 after a full tune up and intake gasket replaced (and 1,000 dollars later) truck continues to do same thing guy who replaced intake gasket says it may be valves not properly seating and suggest install


Perform compression check between cylenders #1 and #3. These are right next to each other. \015\012You might get away with a head gasket replacement, if the compression between these cylenders is the same, indicating a blown head gasket between ... 1996 Dodge Ram 1500 Club Cab

I just bought this truck off of ebay and it is great except i had to change the o2 sensor circuit high volt bank 1 sendor 1 & 2 and the crankshaft, now i'm getting the p1762 code and i need to get fixed so i can get truck registered, i live in tn where you have to pass emissions before you can register a vehicle, the truck runs fine, a little slow on the pickup and go but other than that it runs fine, i have a 1998 dodge ram 1500 quad cab 5.2 motor 318 automatic, any help would be great


Where in there is your question ?\015\012just go and register it if it fails emisions thy will tell you to fix it plain and simple\015\012do it on a busy day or close to clsoing time where thy might over look a small problem :) cheers ... Dodge Ram 1500

Hi, I own a 1997 Ford E 350 Econoline, I have the following transmission engagement problem: Truck will not start: Transmission will not engage any gear, neutral or park. The shift lever feels like is not engagin any thing (moves freely) except at the very bottom (like 2-or 1 position, I feel like engage 1 or 2 gears). I did the following troubleshooting? myself: Raised vehicle and manually moved transmission lever to the park position with the following results. 1.- The truck started 2.- Transm


The weld on the manual lever is known to break loose. First, with the wheels off the ground, with the lever in the park position, does the drive shaft lock in park? If yes or no sometimes, drop the trans pan. I bet the nut on the lever camd loose. ... 1994 Ford Econoline

I HAVE A P0300 OBD CODE I DID A COMPRESSION TEST TO ENGINE AND IT PASS THE TEST,I DID CHECK EGR VALVE,CHANGE SPARK PLUGS,IGNITION WIRES, CAP AND ROTOR, I DID CHECK TPS SENSOR MAF SENSOR,FUEL PRESSURE,AND OXIGEN SENSORSI I FOUND THAT ON BANK 1 BOTH SENSORS (UP STREAM & DOWN STREAM )WORKS NORMALY BUT ON BANK 2 THE SENSOR 1 CHANGE FROM 0 TO 600 MILIVOLTS BUT NO CHANGES FROM RICH TO LEAN &SENSOR 2 HAS 0 MILIVOLTS & NO CHANGES FROM RICH TO LEAN SO I SWICHT SENSOR TO TEST THEM FROM BANK 2 TO BANK 1 AN


... 1997 Nissan Pathfinder

2006 silverado wt 1500, had a remote start system installed and power locks. Shortly after the truck wouldn't start at all anymore. So had the remote start disabled but the power locks still work. Since the remote starts been disabled the truck starts fine everytime. The dealership tells us its the remote start, the business that installed the remote start is blaming the ignition for being faulty. Tryin to get a straight answer as to we have 2 of these trucks, and the other one is fine with the


If you are still using the compustar remotes and they are working then the remote start is still hooked up. What did the dealership say exactly? What is the shop telling you. The dealerships likes to blame everything on he remote start but if they ca ... 2006 Chevrolet Silverado 1500 2WD

I have a white volvo truck 1984 model and would like to orient me to find where in the frame is marked serial number on my property title has this vin number but do not see it marked on any side 1 w G


... Volvo C

I have a 1986 nissan pickup truck,with the z motor. 4 clyd. 8 plugs 4 intake 4 exhaust. when the truck starts it runs like its out of time but if you dont keep your foot on the gas it dies. You can smell fule bad and if you keep it running it smokes and you can smell the fule thier also. when i pulled the plugs the #1 intake plug and the #1 exhaust plug have fule on them as well as the #2 intake and#2 exh. but the 3 and 4 both intake and exh are foulded bad where you have to take them out and cl


I would suggest that you have a blown head-gasket. The Z24s have a tendency to blow the head-gasket between #3 & #4 cylinders. I would do a compression check. You will probably find low or no compression on those 2 cylinders. ... 1986 Nissan Pickup 4WD 1986

Have a 1987 nissan d21 pickup with 2.4l engine. truck will start and run for 1 to 2 seconds then quits. If i shut the key off and wait till the fuel pump relay kicks out maybe 30 seconds then turn the key on and let the fuel pump build thill it cuts out,truck will start and run for 1 to 2 seconds. If I just try to start it right away again it will not even fire although I can hear the fuel pump run. It comes up with codes 21 and 43


The signal from the distributor to the coil and injectors are off and on,not constant.Replace the distributor to fix the problem. ... Nissan Pickup

Have a 2006 Ford F350 6.0L Truck would not stay running, bought a meter, replaced batteries, replaced alternator, found alternator plug was shorting, got new plug at dealer, brought old alternator into dealer to ensure new plug fit, however my truck harness has two wires, #'s 1 and 3, while new plug has 3, #'s 1,2,3, can I use this plug?, if so, what do I do with the third9left over) or middle wire left over.? Any assistance is greatly appreciated. Thanks.


1 & 3 should be all you need. The middle one may be an extra ground or signal for PCM in another model. Colors on the harness are light green/red for pin 1 and orange/light blue for pin 3. OK?\015\012 ... Ford F-350

2005 gmc canyon w/5 cyl passlock stoped truck from starting.So i relearned the key to the bcm truck started but now the passlock light is saying on solid ,tryed to cycle the ignition 100 times (it worked befor) but did not work the light is still on. will it not go off until the problem of what set it of in the first place is fixed. and what could have set it off in the first place. i think the tumblers or the warnout key


... 2005 GMC Canyon

I have 2 problems #1 vehicle has a miss that in older vehicles could be attributed to a foiled spark plug but on this truck i cant seem to locate an access point the plugs. can you assist. #2 the truck goes in to reduced power mode at times while driving . what could possibly be causing these problems. i have been told that #1 could also be caused by a bad fuel filter. please assist if possible. my e-mail is [email protected] thank u


As far as your #1 problem, I had the same problem. I fixed it by throughly cleaning the throttled body. I used qtips and throttle body lceaner. I then had a buddy start hte vehicle and I throughly sprayed the insined of the throttle body. This se ... 2005 Chevrolet Colorado
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.0911 seconds