Having problems with your 2000 Ford Taurus ?

Would like to remove starter butrncant get

\015 Would like to remove starter but cant get access to both starterbolts. how do you do this.\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Did you remove the bolts that hold the splash guard in place? Take the splash guard down and then remove the wires etc. You may need wobble extensions or sockets but that should be all.
Repair Help & Product Troubleshooting for 2000 Ford Taurus

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Would like to remove starter butrncant get


Did you remove the bolts that hold the splash guard in place? Take the splash guard down and then remove the wires etc. You may need wobble extensions or sockets but that should be all. ... 2000 Ford Taurus

I need to replace a starter in a 1999 chevy k2500. It was replaced but the starter is faulty and doesn't work only worked for a little while. Is there a manual out there to show me how to remove the starter so i can return it. Someone else did the job for me before. So I would like to at least get it off the truck and returned and exchanged for a new one.


First thing disconnect the battery terminal.There is a postive wire that is attached to the starter that should be a 13 mm, and pull of the negitive connectio to the starter. There will be no more than two to three bolt to remove on the starter. Prob ... 1995 Chevrolet K2500

No start condition new battery , good starter, turn key to start position light come on dash, go forward to start light go out and you hear click under dash area like relay, no power getting to starter. happens intermittently - remove battery cable let sit for a bit . starts right up . happened twice to my wife , then would not reoccur . got into car & finally happened to me. bad relay ?? is there a relay under drivers dash area that's bad ?


No starter relay is always at the fuse relay box at the engine compartment. The relay that you hear is the relay for the accessories to turn off the power during starting position. ... 1999 Ford Windstar

How do i get to 91 chevy s10 starter?new battery, alt. will only start with jump most of the time had problems in summer here in las vegas, nevada. getting a lot of different opinions. just would like to get the starter our to test it. thanx. (it looks like a whole lot of trouble)


Yhea they can be a tight fit, really tight if its 4x4!\015\012Your local parts store should be able to test the starter while it still on the truck. You can hook up the vat machine and run a starter drain test! Make sure the cables are tight ... 2000 Chevrolet S-10

Starter removal I have a 1994 Crown Vic that i have worked for 9 hours on trying to get at the top bolt to remove it. In my 45 years at wrenching on all types of vehicles from farm tractors and combines to riding lawn mowers I've never seen a starter so difficult to remove. First off you have to use a mirror to even see it I've tried socket and wrench know to man.as a last resort I thought about cutting the starter off with a torch and then removing the bolt,but I would have a fight replacing th


As a last resort I removed the exhaust manifold from the right passenger side of the engine to allow enough room to work, at that point it was easy to remove. 27 hours total time. My advice if you own one of the ... 1994 Ford Crown Victoria

Ok, im a newly owner of a 1981 Fiat spider 2000. I know nothing about them other than i really like them. I went to pick it up yesterday and it would not start unless i used starter fluid. I went back today to do some testing, i checked fuses and power to fuel pump all good. It started rite up getting ready to take it home finally (ha) it died and would not restart. Do i need to go ahead and replace fuel pump cuz im not getting fuel constantly like i should. The fuel pump works just when it want


There is also the fuel pressure regulator, that regulates the fuel pressure. So it might not be the fuel pump. And there is also the fuel pump relay switch that may be faulty. So if i was u, id check there also. Hope this helps u :) ... 2006 Fiat 124

Is it the same with the 3.0 2001 dodge stratus rt 5 speed manuel to remove the tranny how would i do that its ready to come down right now it just wont would i remove the starter still and see if there are four bolts to remove it and would i need to take my a arms off as well im trying to get this done today i apologise for the inconvience


If you really want the info rather than listen our suggestions then go to mitchelldiy online and for 10 bucks you get what you wanting plus everything else about your car. ... Dodge Stratus

Starter problem a mechanic took off the starter and now quit. noone knows the wiring for the starter and i cant get it figured out. i put new cables new batt new starter. i put the wire the lites up when you turn the key to r post i put the wire that lites up when you engage the key to the i post. it turns over slow makes clicking noises in the solenoid and acts like its not getting enough juice. new batt to any help would be great


Wiring to the starter; large cable coming from the battery to the \012large post on the starter is direct current, hot at all times. there are two small wires that connect to the solenoid, one comes from the ignition.\012Look for loose connec ... 1996 Oldsmobile 88

I have to replace starter on 91 bravada, is there some kind of trick to getting it out, cause i loosen the 2 bolts and it wont clear the tranny housing, looks like a bracket on the back part of starter but its not attached to the starter, does that have to be removed? and what is that bracket for, i mean can i use a hammer to bend it enough to move it out of the way to remove the starter


... 1991 Oldsmobile Bravada

I have established that my starter is bad, and I'm in the process of trying to remove it. I have removed the electrical wires, and the two retaining bolts (with extreme difficulty!) but there seems to be a third retaining bolt on the top of the unit , that is extremely difficult to get to. Its obstructed by the oil filter and two nearby pipes. There are also two small nuts which appear to be stablising the starter to a bracket. They look like they both need to be removed. Does this seem familia


It is a 3 bolt starter for sure, And yes the bracket has to be removed, Id advise removing the oil filter as well, But it can be done without it.. ... 1993 Ford Tempo

Looking for Removable roof racks for my 2000 RAV4 would like the factory ones. I called my local dealer and he can not get them anymore so he says. I have tried a few junk yards but no luck yet. I would like to know where I can find them new or used? if they are missing the key, but in good condition I still would be interested.


My neighbor found racks at a local Pick ... 2000 Toyota RAV4

Car died while turning around. I have found that there is no spark at the plugs. I also tried to squirt some starting fluid into the intake and still nothing. the distributor cap on this 96 dodge neon is in a tight spot to get to. it would require disconnecting a few parts to get to the dist. . by the way i have checked all the fuses i could find and none were blown. I would like to know if there is a way to check and see if the dist. is getting power before I remove all these parts for nothing.


\015\012You can test the coil wire running to the distributer and see if spark is making it to the distributer cap. \015\012\015\012\015\012Disconnect the ignition coil wire from the di ... Dodge Stratus

My name is nathan and i have a 96 grand chreokee v6 it is getting gas and fire it will crank over but will not start.before it started acting up it would go hay wire like the door woud start clicking gages started going off and on windows wouldnt go down but it would not affect the driving.then it just would not start so i crossed the starter wires and it started but the next time i tried to start it all it did was click at the main power fuse box so ichanged the starter fuse and took the starte


... 1997 Jeep Grand Cherokee

Starter problems For about a month, I've been having trouble starting my 1999 Plumouth Grand Voyager. It would take an avarage about 5 or 6 time to get it started. The other day, when I was driving it, the van died on me twice. It was also making a really loud noise. When I parked it and tried to shut it off, it would sound like it was trying to stay running. It took about half hour to get it to shut off completing and when I did get it to stop running, it started smoking really bad, even up thr


Starter is done replace it it is located on the front of motor down bt the oil pan ... 1999 Plymouth Grand Voyager

I went out and started my vehicle acted like battery was dead. Realized the vehicle was out of gear (it is a automatic) placed vehicle in park tried to start. It over turned however would not stop turning over. I removed the key still cranking over. I had to remove the battery terminal. When you place terminal back on it starts to crank again without key(I had starter and silinoid checked, no problems) with the starter removed for testing I checked ignition. It turns all power on (fan starts to


I think the only possible solution is that at the back end of the steering lock is the ignition switch itself ,it has two screws that hold it on and this switch is the problem ,the contacts inside have collapsed or broke loose so its shorting inside ... Ford Escort

I have a 1998 Ford Explorer V6 4.0L I am trying to find out were my Camshaft Position Sensor is located and can i get to it without having to remove any other parts such as air intake lines or anything like that if you could hook me up with a diagram or picture of were the Camshaft Position Sensor is located it would be much appreciated, even if you cant get a picture or diagram if you could explain were to find it that would be great. Thanks, Billy Blackwelder


It should be on the drivers side valve cover directly to the rear of the the oil fill cap, should have one bolt that holds it in place with two wire connector on it. ... 1998 Ford Explorer

Can you legally remove a rear wiper on a honda pilot just because it would look better without one? If it's put there by the factury to ensure clearer vision through the back window, can you get ticketed for removing it just like you can get a ticket in some states for having anything hanging from your rear view mirror? '


Yes you can remove it. It is for your convenience only. It is not required by law. ... Honda Pilot

My 2004 honda accord lx will not turn over. It has a new battery, and a new starter. I tried to jump it with battery cables and it had no effect. I have been having some signs that it might do this. I would have to turn the key quickly on and off to get it to start some times. I just talked to a mechanic who said I could actually put a screwdriver on the two posts of the starter if I can get to it. Isn't there something called an "actuator" that's like a rely between the battery and the st


... 2004 Honda Accord

1994 Chevy Sub died, would not start back up until I hit it with starter fluid. New plugs, wires, cap, rotor, fuel pump and filter. Just drove it from AZ to IN 2 weeks ago and ran great, pulling my Malibu on a trailer! Limited mechanical exp. and $ after the move and would like to get it fixed myself if possible. It's done it two days in a row now and both times ran after some starter fluid.


Check the fuel pressure regulator ... 1994 Chevrolet Suburban

I have a 1997 camaro rs with a v6. Without warning it suddenly would not start. Battery checks out good, no signal to the starter. The security light flashes instead of going out like it use to. I have tried to access the diagnostic mode by removing the #17 radio fuse and switching the ignition to the accessory position as prescribed by Mitchell On Demand. I am assuming that would be the same way the factory accesses the diagnostic mode. However, it system never chimes like it says it shoul


Hi, check your battery connection. I have seen too many cars not start with a good battery due to a loose or corroded battery connection. Just take the old battery connection off the positive post of the battery, bring to Wallmart or auto part store, ... 1996 Chevrolet Camaro

How do you remove the from brake rotors on a 2003 Toyota Landcruiser? I took the brake calipers off and unbolted the six nuts that appear to be holding an unknown plate. I took the cir clip that holds the axle, but still cannot figure out how to remove the rotor. I have banged on the rotor, sprayed lubicate on places I thought would need it and still nothing. I would like to replace the front and rear rotors as well as the pads if I could just get the rotors off. I have not taken the rear w


Hi ou can ask these experts how to remove the brake rotors just click on the live support icon, you dont have to buy it.\015\012\015\012Link: ... 2003 Toyota Land Cruiser

Starter replacement? For a while now I've had a periodic , occasional click when I try to start but eventually it kicks over. The problem has gotten progressively worse and would not start today until I pushed it about 20-30 feet. It seems to me it's down under neath and not in plain sight. I don't like doing even simple stuff but wonder how tough it is to get tension off, and back on the belt. Can anyone give me an idea of how to get that starter out, tools needed and rebuilt cost? Thanks!


If the car dosent sound like its turning over and only giving clicking sounds, than most likely the battery needs to be charged. ... 1997 Saturn SL

1987 toyota camry starter removal diagram i would like to know what tools i need and what i have to do to remove the starter motor for replacement.


Hi there,\015\012Best thing to do is buy a Haynes or Clinton's repair shop manual at your local AP store for your particular vehicle. Then read up on it in the trouble shooting section or the step by step RR section. You can purchase these at your lo ... 1987 Toyota Camry

I need to know if I need any special tools to remove and replace the ac pump on a 2000 gmc Z71 sierra with a 5.4 ltr motor. Also it would help to know the best way to get it out. It appears to look like the way to go would be to remove the passenger side front tire and inner fender well and approch it from the lower side rather than comming down from the top. ????????


I dont think so but u have the right idea about removing it from truck go boy go ... 2000 GMC Sierra

Suzuki sidekick 1997 Sport 1.8 liter manual transmission AC power steering. It happened about this time last year, when trying to start would get one loud solenoid click, so I had help (wife) turn ignition switch and I tapped the starter with a broom handle, and it would start. Kept doing that until it just wouldn't start any more. So I replaced the starter, lo' and behold it still wouldn't start. So I removed the steering column covering and at the opposite end of the key where the


... 1997 Suzuki Sidekick
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.6003 seconds