Having problems with your 2000 Dodge Grand Caravan ?

Gear selector is sticky/hard to move

\015 I am looking at a used van and this is one of the only issues of concern. When moving into drive or any gear the shifter moves very slowly. Better after the vehicle was warmed up and driven. Had sat for a few weeks.\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 2000 Dodge Grand Caravan

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Gear shift selector light is not in sinc with the gears on the 4 speed auto. Selector will stop on N and not move till it gets to 1st then it only moves over to 2. None of the gears are in sinc with the selector light except park.

... 1995 Chevrolet C2500

I moved my truck into the driveway to wash it, and now the gear selector lever is stuck in park. the engine runs fine, even when I depress the brake pedal to move the selector lever, it is stuck in park and I cannot move it to any other gear.

Look under the dash at the top of the brake pedal and their is a switch ,this has failed and you cannot get it into park also check the stop lights as when this switch goes the stop lights do not work either as a rule ,but some vehicles do have two s ... Ford F-150

I have a 1999 C230 Mercedes Kompressor, automatic transmission. The gear selector can be moved from park down through reverse, neutral and to drive, but refuses to move to the left to 4th. I removed the center console to raveal a "black box" which the gear selector enters. this "box", for lack of a better term, has linkage underneath which goes to the transmission, an eletrical connection, and two springs. I don't know how to open it, I'm certain something is broken or malfunctioning inside. The

Hello drtonyg... This is an electronic shifter controler on the C230...Almost every time they fail the shifter assy. needs replaced as a whole unit....There have been some techs that have tried to clean and repair the shifter assembly and reuse it bu ... Mercedes-Benz C-Class

I was wondering if you can help me out, I have a 1992 Nissan Terrano 3Lt V6 4x4, its just an old farm truck, Well today I was driving it down the paddock and all of a sudden it wont move in any gear, everything is fine I can move the gear lever but the problem is that it wont move forward or reverse, Ive worked the 4x4 selector as well and that seems fine, It was driving good as gold and then it just stopped going forward I can push the truck so its not stuck in gear or anything like that. I ho

Hi, if it is an automatic transmission, it could be several things:It could be really low on transmission fluid or the fluid may have leaked out. Do you see an reddish or reddish-brown fluid under the car? Check the fluid level by l ... 1993 Nissan Pathfinder

I was wondering if you can help me out, I have a 1992 Nissan Terrano 3Lt V6 4x4, its just an old farm truck, Well today I was driving it down the paddock and all of a sudden it wont move in any gear, everything is fine I can move the gear lever but the problem is that it wont move forward or reverse, Ive worked the 4x4 selector as well and that seems fine, It was driving good as gold and then it just stopped going forward I can push the truck so its not stuck in gear or anything like that. I hop

If it is an automatic, and absoloutely no movement it sounds like the torque convertor has failed. Either impellor or turbine. If it is a manual the clutch may have gone. If it is a manual, place it in gear and get a friend to rock the car back and ... 1994 Nissan Pathfinder

The gear selector on my 2002 Ford Windstar moves, but the transmission won't go into gear. Why is the transmission not going into gear?

Try to replace transmission strainer first torque convertor and see if that helps if not it probabaly the transmission ... Cars & Trucks

BMW 318 SE Auto (2000). Whilst driving a yellow light appeared of a cog with an exclamation mark in the middle. Now the car will not start or even crank, and the gear selection on dash displays that the gear lever is in position 'S', even when the gear lever is moved through all ranges. The gears seem to be moving and the diagnosis suggests a 'transmission selector switch' fault. Any ideas. Please help

... 2003 BMW 330

I started my 2004 armada backed out the garage, and notice that the light on the floor, meaning in the gear selector console was not on so i tapped it a couple of times and the light came on. i then put it in park to retrieve some equipment. when i came back no matter what i did its not going forward, or back. the gear selector is moving, but the actual gears are not engaging

Sounds like you knocke the linkage loos the car connection the transmission to the shifter. You will have to get under the car and take a look. ... Nissan Armada

2001 dodge ram gear selector moves freely, can shift gear from firewall. It seems to be disconnected somewhere in the steering column. Gear selector still rotates the electronic PRNDL locator

... 2001 Dodge Ram 1500 Truck 2WD

I have a c320, 2002, the gear does not move from D to P, unless I take off the foot from the brakes on N. Can you tell me if this is a faulty gear selector, or something had fallen into the shifter area, and if the gear selector needs to be replaced, what would be the average part cost and probable labor time-frame to do it?

There is an electronic shift lock unit that is not working as it should, it is designed so you must have your foot on the brake to get it out of park but can do all sorts of weird things when it fails, It is a specialist job to change as you require ... 2003 Mercedes-Benz C-Class

Replaced steering column, now transmission won't engage. Have 1984 F250 with tilt, cruise and auto trans. Had to replace steering column with 1983 one with no tilt and no cruise. Got everything together and starts fine. Shift selector will go through the gears, and the shift lever at the end of the column moves and moves the shift rods- but the transmission itself just doesn't change gears. Any ideas?

... 1984 Ford F 250

Transmission problem i have 2003 ford windstar v-6 automatic transmission. the car will start and the gear shift lever will ingage to all drives. howerever the car will not move in any gear. i have checked the fluid level and it seems ok. the link looks like it is working order. the metal rod moves the selector level under the hood. i do not know what the problem is. would it be something electrical or is it with the transmission? thanks for the help. jake eicher email: [email protected]

Sorry to say i had the same problem. the spline between the engine and the trans sheared. I complained to Ford customer service and they were able to help with the cost but it still cost about 1500 ... 2003 Ford Windstar

Hi i have a 1996 ford trader 0409 that i can not select gears gear leaver will not move left or right and selector on top of gearbox will not move can any one help

... Cars & Trucks

My 1995 xj6 3.2 auto is stuck in gear , can move selector but does nothing, even in park its moving forward in gear!is there a reset for transmision as it seems to be electical, also on the heater display i,m getting ER and beeps? help!

... 1995 Jaguar XJ6

Car was driving along fine and then it just stopped going. Can move gear selector in all ranges but vehicle doesn't move. Put code reader on it and it gave incorrect gear ratio in all ranges to include reverse


I changed the gear box of my jeep renegarde,now i have move the gear selector to 2 before moving it to DRIVE also the car is somehow jerky. What is the problem?

... 2006 Jeep Liberty Renegade

Purchased audi 80 2.3 1992 model automatic. when cold gear box works, but after driving about 1klm we seem to loose our gears. on the instrument panel where it shows p.r.n.d.3.2.1 all highlight except for the d position. once we loose gears you can still move selector but the d becomes highlighted and does not change. once turned of for awhile we get gears back and the whole process begins again. i am hoping that you may have had this occur before so i can work out which i need to focus on ie.

Hi! Few things to work on to have this solve. Replace the torque converter, it may be faulty causing the gear to malfunction specially on running. Please replace the automatic transmission fluid and fluid filter too. A smooth ride and quick shifting ... 1992 Audi 80

I have a year 2000 Mercedes E200 Automatic. On Friday when driving car it appeared to get stuck in gear and KICK DON did not work nor did tiptronic control. I stopped car and put gear selector to PARK and it stuck in park position. I switched off engine and it would not restart. Is there a switch which can trip causing car to stay in gear even when lever is moved to PARK position which would cause ignition module to think car is in gear although lear lever is in park position and can it be reset

... 2000 Mercedes-Benz E-Class

My 2000 s-10 2.2 cranked fine this morning. But when i went to take off, none of the gears worked. The selector moves, but you dont feel it going into any gears. The trans has just had filter and fluid change and gaskets less than 2000 miles ago. It was whining b/t 1st and 2nd gear, but overall the truck run great. This is an automatic 2 cylinder. Any suggestions?

If the transmission fluid is full and the linkage connected then you have but one choice here the transmission has failed. I have seen this exact scenario come through the door of the shop dozens of times, drove fine then nothing the next day or an h ... 2000 Chevrolet S-10

I cannot select any gear other than 5th of the 5 speed manual transmission in my 2001 Renault Scenic MPV / sportswagon. This occurred after the front suspension bottomed out going into a sandy 'boghole' on a dirt road and the left side radiator bottom mount bracket was ripped back about 170 degrees. Motor still runs well and clutch operates as it should. But gear selector will move around in neutral & forward into 5th, but no other gear can be selected. I'm told there's a cover I could unbolt &

... 2001 Renault Sportwagon

Multi-Gear Grind 1992 Chevrolet Lumina APV 3.8L. All shifts are smooth except under light acceleration. Under light acceleration, the third-to-fourth transition sometimes feels like the transmission is trying to use both gears at once. Also, when cruising between 40 and 60 mph, the same 'multi-gear grind' occurs. Trying to hold a speed in that range uphill makes it happen more often than on the flat, but neither flat or hills is certain to cause the issue. Moving the selector to D (as op

I would suspect low fluid pressure, possibly due to a accumulator sticking. This can easy be tested by measuring the line pressure at the transaxle's external test port and performing a road test under the conditions mentioned.\015\012 Most tra ... 1992 Chevrolet Lumina APV

1984 ford f150 automatic gear selector not moving

... 1984 Ford F 150

I have 2001 montero sport when i put in drive it dose not move shift to third gear it dose all other gears are fine just no overdrive changed range selector switch thats the code it had no other codes still have same problem

Change the overdrive relay ... 2002 Mitsubishi Montero

I have a 2003 vw golf gt tdi 130 6 speed and have lost 1st and 2nd gear. I have checked the cables and they are working fine, the selector is moving but the gears are not engageing.


Transmission problem I have a 2000 VW passat 1.8t and it is triptronic transmission. When selector lever is put on "D" it illuminates all gears selected and it moves but does not upshift. When put on "R" there is a cracking noise from the gear box

I have the same problems it seems like it's the TCM that is wrong check out these links : http://forums.fourtitude.com/zerothread?i ... 2000 Volkswagen Passat 4Motion
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.9597 seconds