Having problems with your 2000 Chrysler Town & Country ?

I have a problem with the AC fan speed control, just works in the last position

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Sounds like the blower motor resistor is burnt out and it is defaulting to high.
Repair Help & Product Troubleshooting for 2000 Chrysler Town & Country

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a problem with the AC fan speed control, just works in the last position


Sounds like the blower motor resistor is burnt out and it is defaulting to high. ... 2000 Chrysler Town & Country

2000 Mitsubishi Spyder Interior Fan Only works on 3rd position. Fan Only works on 3rd position. Changed Fan speed control (Twice), resistor , fan ,and relays, But no change. Just one speed on 3rd position. Also looked for broken or grounded wires. Anybody out there got any ideas ? ? Also noted that the AC shuts off on 1,2 and 4 positions. It only runs on the 3rd position on the fan speed control. is it possible that the new resistor is bad out of the box? I hate throwing good money after bad.


Maybe you got a wrong blower resistor pack. You should recheck and replace it if necessary. Here is an example that may help you to understand the role of the resitor pack.\012\012 ... 2001 Mitsubishi Eclipse Spyder

I have an '03 Dodge Ram 1500. I can control the temp of the air coming from the vents and which vents the air is circulated through, but i cannot control the fan speed, you can only feel air circulating when traveling at higher speeds... Once in a blue moon, the fan motor with work properly for a few days and i will have fulll control of the fan speed and then it will stop working again. I have replaced the climate control panel and still have the same problem. Everything works except the fan s


These trucks have problems with the blower motors,these stock motors are known to fail intermittently when one or more motor windings fail. This is evidenced by the motor not running occasionally after the car/truck is turned on. At high ... Dodge Ram 1500

Actuator that opens and closes water flow valve is not getting a signal, there is a main processor that controls rear air damper floor to above ceiling air and variable speed fan and the said problem water valve. front console control and midway control does not cause water flow actuator to work cool or heat position.


... 2003 Chevrolet Tahoe

I have a 2000 pontiac grand prix gt and the fan speed control will only work on #5 setting and when I turn the speed to 4 or less it does not work and it turns off the automatic headlights and then I have to turn them on manually. I have replaced the fan blower and sensor and the control panel for all the switchs that have fan speed temp and where the heat or ac blows on feet front etc. No one seems to know what the problem is and also my rear speakers only work when its hot in the summer plus n


Check your wiring harness where it hugs the engine on the right front side, because of vibration this area is prone to broken and shorted wires ... 2000 Pontiac Grand Prix

My defrost fan does not work, how can I find the problem? I traced electric into the control panel. It started with only 1 speed (high) and I replaced a resistor bank and it made no difference. Now there is no fan at any speed. I tested the wiring harness for power and it is reaching the control panel. Where can I test beyond the panel to eliminate the fan as a problem. And, where is the fan. I have no clue.


Dodge systems put power to the blower motor first then ground out through the resistor and switch position.if the resistor block had metal windings in it you may have to replave it again with the blower motor,the resistor has a fusible link built in ... 2002 Chrysler Voyager

Hi expert, I have problem with a BMW 525i 2003 car. the problem is the heater fan all of the time blow the air even no key in the ignition lock. The heater control panel working correctly except the fan control button but the display for fan speed working well. do you have any idea? thanks


Sounds like a bad relay. They are troublesome. You can test it with an ohmmeter. You can test power to and from the relay with a voltmeter. ... 2001 BMW 5 Series

2001 Pathfinder LE - Fan made a chirping noise about three days ago on high, then worked fine low-high either setting it Manually or via the Auto mode, that is until today. Now neither the automatic setting or manual setting makes a difference in the fan speed. All the "visual" indications of fan speed seem to work on the panel but the the fan runs extremely slow if at all. This is the opposite of most problems like this where the fan speed is stuck on high. Could it still be the fan control a


Blower motor resistor to replace, on the blower motor where the wires connect ... Nissan Pathfinder

My heater fan keeps cutting out or not coming on. Sometimes both the ciculate and air from outside lights are on at the same time. When it's not working, the cruise control light comes on when I play with the fan speeds (1-5). When working properly all fan speeds work fine. The check engine light has also come on since this problem started.


Ac not cooling conpressor an gas ok fan goes off but just go to another speed an back it is on again ... 2002 Chevrolet Impala

Started last year. Fan switch for air and heat has 4 settings. Speed 2 quite working. a few months later speed one quite working. Now now of the speeds work on the fan switch thus I am not getting heat pushed out. What do you think the problem is. Thanks a lot


You have a blower motor resister that has gone out,this controls all your speeds,it is located right next to the blower motor,it will have about 7 wires going to it. ... 1991 Subaru Legacy

Intermittent wiper function does not work. When the wiper control is in intermittent position, wipers will work at uniterform speed. But, intermittentency will not work. One reputable bmw dealer's mechanic tried to fix this problem through trial and error by switching increasingly expensive control modules. After two attempts, none worked. I need knowledeable information on this problem before trying another dealer or mechanic.


Has the wiper switch been changed out? because in my 35 years of experience 90% of the time the wiper switch is defective and the cause of the problem, the symptoms u have reinforce my opinion this is the problem. ... 2006 BMW 750Li

99 beetle power windows quit working along with mirrors and fan control. I had replaced both regulators last month and were working ok (not perfect, but working) fan speed control just quit yesterday!!!!


I would start by checking ALL fuses , even ones that appear not to be related to the problem at hand. VW has a habit of running circuits in line with others and not indicating this on the fuse/relay legend plate. Also you want to look around for a po ... 2000 Volkswagen Beetle

The heater fan won't stop, even if i turn off the key the fan still turn, unable to control it, it only turn at one speed (not the fastest one), i check the resistor it look like there's a short in it, the voltage past true the batt to the motor without any signal. I change it, the second one work for at least 1h30, now the problem still the same the only difference it's the speed of the fan with the second one it's turn slower, but i can't control it. Thank's for your help Impala 2005


... Chevrolet Impala

No heat Suddenly the heater isn't. Used to warm up and defrost the windows in 5 minutes, now nothing. On the last highway drive it started out with heat, then it quit and while driving it came back on for the last 10 miles. Since then nothing. The auto fan comes on and turns the speed down if it's a warm enough day. There is no fan at all on the floor setting for the heater either, it only works on mix and defrost. And is there a way (when the heater is working again) to bypass the temp. control


... 1985 Ford Crown Victoria

Just replaced fan blower motor on ac, only passenger side vents blow cold air and stronger than the drivers side. it only works on high speed and it will also change fan speed while driving without changing the control. i changed the control panel last year. I need help this is the second new blower that i have put on this car. the reason for this second one is water was in it, i guess someone didn't do something right??? water was pouring in the floor board too...


The water problem is a drain hose is plugged up.should be a hose hanging down for moisture to drain out from under the evapoator. try running a small plastic tube up it and see if it will clear it. ... 1998 Oldsmobile Intrigue

Heater only works on one speed, #3. Changed out control panel and same problem. Would this be a module issue at the fan maybe. All other controls on panel work fine. Smelled hot electrical before the problem started.


Is #3 your highest setting? try replacing your resistor pack. it's mounted in the hvac box under the dash close to the fan. there should be wires going into the connector for it and then out to the fan itself. ... 2003 Chevrolet Express

Have a 2005 GMC Envoy Denali. My blower fan for the heater stopped working. Short while later it came on full force, could not regulate the speed. Kept running even after I turned off the engine. Took to the shop and they replaced it with a new relay sensor module?? If thats the correct term. It worked for them. Took off down the road and had the same problem again. The fan went on high speed and could not control it. Called shop back and will have to bring it back in. They mentioned i


Hanson4, did you get this resolved? My 2008 Envoy is doing exactly the same thing. ... 2005 GMC Envoy Denali

I have a 99 pontiac grand prix gt and the heater/ac fan speed only works on number 5. I replaced the resistor and the "in dash" unit that has the three control knobs for fan speed, air direction and temperature. Neither of them fixed the problem. Also, when I turn the fan speed from 5 to 1-4 the automatic headlights turn off. There is also something funky going on with the rear defrost button and the AC button on the "in dash" unit. Please HElp!!


It sounds like the wire harness where the fuse block is may have melted causing the short in your electrical system. This is common when the blower resistor goes bad and the blower draws so much amp, the wires will melt and short out to other electri ... 1999 Pontiac Grand Prix

I change a ac fan control for a new one but still with the same problem whit the speed number 4 the lower numbers donot work is the any other problem with it


I had this problem with a '01 Focus. Replaced the switch (also set up 1-4 speeds) and it fixed it. You may have a blower motor going bad. Hope this helped! ... 2000 Dodge Stratus

Montana van 2002 the fan speed switch are only working on speed 4&5 but speed 1,2&3 are not working. i even changed the used control switch and it is the same problem


Check the blower motor resister ... 2002 Pontiac Montana

My 2000 318i e46 aircon has an intermittent problem. The lights come on and the fan speed/temp adjustments work - however the fan has now stopped blowing. The last week or so it blew at speeds unrelated to the indicator. i.e on 1/4 speed indicated it was on full pelt. Now the fan has stopped all together, except once in a while when it will blast full taps and then stop. The unit itself functions as it should aside from the auto button which will switch on, but not off. any ideas?


This is your blower fan resistor fitted on the right side to the heater box and takes +- 1 hour to change and is a defect on this models ... 1999 BMW 318 ti

Went to turn on my fan last week, fan speed control knob doesn't make fan turn in all positions. I have checked all fuses, have changed blower motor resistor. If I toggle A/C, I hear that engage. If I choose to recirculated air, with glove box down, I see cover close. I have had dash board completely off. I have changed out the speed knob. I am stumped. the car did sit, from april til this past tuesday, I had shoulder surgery and was advised not to drive my manual trans til tuesday. Please any


Have u replaced the fan speed control switch in the ac control in the dash, u never really say anything about that, as far as Ford raping u on labor it takes allot of money to pay for the special equipment and tech training to fix your car in a minim ... Ford Focus

I have a 92 Seville and the problem is with the Dash section of the car. The speedometer and Tach work along with all the high beem turn signals restraint lights, but the Milage does not display, nor does the Climiate control readout or the info center. The controls for the Climiate control work, I can ajust the temp and the fan speed turn it on auto, off. but no displays, any help would be appreciated.


The backlight bulbs are burnt out. Common on this model. Unfortunately, it is NOT an easy fix. You'll need to pull the dash cluster and replace the bulbs. It involves de-soldering the old bulbs and replacing with new. I have done this but it is very ... 1992 Cadillac Seville

Climate control problems The climate control console doesn't really work. The fan speed always works. But the directional knob and the temperature knob do not work. I think I just may need a new console. Can you help?


... 2002 Dodge Stratus

1995 Jeep Cherokee AC blower doesn't work. Replaced blower resister, blower, and Aux fan fuse and still it doesn't work. I'm running out of things to check. Original problem was that blower was screeching and then quit working. At the time it was only working on high speed. It quit working and also the AC compressor doesn't engage when switched to that position. I replace the usual suspects like the resistor and blower motor, but still no joy on getting it work. Will not work when switched to ve


Do you have feed to blower motor ?? sorry CSI is coming on TV now and er indoors is screaming that i spent too long on here '¡'¡'¡'¡'¡ usual ----typical woman ,if you have her i will throw my jag in the deal for free ... 1995 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.4831 seconds