Having problems with your 1999 Mitsubishi Diamante ?

How to remove ignition on a 1999 Mitsubishi diamante

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1999 Mitsubishi Diamante

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1999 Mitsubishi Diamante, will not start. Got a brand new battery like three weeks ago. Last thursday it wouldn't start all of the sudden. I took a wire brush to the connections to the battery and sprayed them with corrossion remover aswell. The dash lights still light up, headlights work, but when I turn the ignition it doesn't click or make any sounds, but it just hums a little. I am wondering if it is a bad connection. I tried to follow the + cable from the battery but I couldn't find the sta


Hi firstly when you try to start the car do the lights dim then, when you release the key they go bright again,\015\012If they do your starter is either stuck or the solenoid on the top of it has packed up.\015\012Firstly look around the ... 1999 Mitsubishi Diamante

How to remove ignition on a 1999 Mitsubishi diamante


... 1999 Mitsubishi Diamante

A key, without a chip, was cut to open the door of my 2002 Honda Odyssey. Unfortunately, someone tried to start the van with the same key. It is now stuck in the ignition and I can not pull it out. The ignition will not turn to 0 it will only turn to I. The van will start if the old key is held to the key in the ignition but the light for the gear shifter will not go off, the P stays lit. Do you know if the key can be removed and if so, how?


... 2002 Honda Odyssey

Mitsubishi l200 ignition barrel removal


... Cars & Trucks

Misfiering mitsubishi Has anyone figure out what's the problem with the number 3-6 coilmisfiring, on Diamante 1995 (DOHC). It seems like a common issue withthe 3000GT having the same problem. Any common denominators so far ?. Ihawe a Mitsubishi Sigma 3000cc 24v v6 engine 3-6 coil misfiring ''ecutested 100%,coil,ignition modul all good any more idieas...thank you?crank/cam sensors ok it is a comon fault it has too be soamthingsoamwheer ....car of the road 4 months now many thanks for ani litelhe


No fuel to the cylinders would also cause a misfire code make sure you are getting the accurate amount of fuel. Do you hear a tapping in the engine could be a loose rocker arm not opening the valves all the way or closing them all the way let it buil ... 1990 Mitsubishi Sigma

Ignition switch removal mitsubishi 3000gt - Mitsubishi Cars & Trucks


... Mitsubishi Cars & Trucks

I have a 98 Mitsubishi Mirage. THe key is stuck in the ignition. I can crank the car, just can remove the key and the steering wheel will not "lock" when it is turned. Is there an easy way to remove the key without expense???


... 1998 Mitsubishi Mirage

I have a 98 Mitsubishi Mirage. THe key is stuck in the ignition. I can crank the car, just can remove the key and the steering wheel will not "lock" when it is turned. Is there an easy way to remove the key without expense???


Has this car even been in an accident where the airbags deployed? I had this occur on my Chrysler after an accident, so it may be a feature to insure that you get it repaired properly. In my case the car was totaled, so no repair was made. ... 1998 Mitsubishi Mirage

I can't seem to remove the front engine mount from the engine on a 1994 Mitsubishi Diamante V6 3.0L DOHC. My Chiltons does Not have a picture of it or tell how to remove it. I pulled the three main bolts from the front and loosened the A/C mounting bolts but it won't budge?


... 1994 Mitsubishi Diamante

I lost the key to my 2001 mitsubishi mirage. I called a locksmith he said to bring my ignition switch and he can make the key.im having problems on removing my igniton switch/.. Any idea on how to remove it without the key.? Thanks


Here's a guide on ho ... Cars & Trucks

I have a 94 mitsubishi verada v6 ei & im having troubles as the key wont turn, the key barrel seams inexcesable. will i need to replace the ignition ? & how do i remove it as it seams that the bolts thats holding it on to the steering column have been made so they can not be removed. I appreciate your help. regards Antonio


... Mitsubishi Passenger

How do I replace the front structs on my 1994 Mitsubishi Diamante? There appear to be two mounts on either side of the engine when I open the hood. Do these have to be removed before the old struts can be removed?


Top mounts and bolts need to be removed, then the bottom part of strut needs to be removed. A spring compressor will likely also be needed to compress the springs to pull them out.You can go to autozone website, then register for free, then log ... Mitsubishi Diamante

2004 DIAMANTE SHIFTER REMOVE - 2004 Mitsubishi Diamante


... 2004 Mitsubishi Diamante

Mitsubishi horn sounds when key is removed from ignition


... 1997 Mitsubishi Diamante

Mitsubishi l200 2001 ignition barrel removal


... Cars & Trucks

How do I remove the ignition tumble from mitsubishi triton and replace with another one of the same


... Mitsubishi Cars & Trucks

Removing starter on 1998 Mitsubishi Diamante


Tap it a few timnes with a hammer.....it should loosen up then u decide .................. gl ... 1998 Mitsubishi Diamante

2001 mitsubishi diamante alternator removing it? What's the secret?


Fi you bend the dipstick and the aircond pipe carfully away from the altenator and remove the washer bottle, that is enough room to get them out of the engine bay ... 2002 Mitsubishi Diamante

S10 1999 bearings bad 0 oil pressure,removed and rebuilt engine, replaced most all. back in and...Won't start, not a crank or a ticking from the starter. Starter and starter selanoid, battery all tested OK.conecting to starter and starter getting power. Replaced neutral safety switch twice , check all 3 relays all OK. Still no response. Lights and accessory lights all go on when ignition turned. Have tried all gears but still nothing. Could I have forgotten to replace something. Is there a way t


Yes, you can hotwire the starter, use a button starter to energize the solenoid. there is a chance thet the new or rebuilt starter isn't working. it has happened to me I went an bought a newly rebuilt starter but it was no good, it happens sometimes. ... 1999 Chevrolet S-10 Pickup

Ignition chime stays on after key is removed - Pickup Mitsubishi Cars & Trucks


... Mitsubishi Pickup

How do you remove the radio 2001 mitsubishi diamante


Someone explain to me what are the secrew that i have to tae out and what is the face plate to get the radio out from a mitsubishi diamante ... 2001 Mitsubishi Diamante

1995 mitsubishi diamante ignition immobiliser


... 1995 Mitsubishi Diamante

Tensioner adjustment bolt has been removed and belt still tight. Tried to tighten bolt to see if the belt loosens as it gets turned clockwise and the belt still tight. Dont know which way. Is it seized, I know most are spring loaded. Vehicle is a 2004 Mitsubishi Diamante


Hi!!\015\012\015\012Here is a diagrm of the belt routing for your vehicle (according to your info). For what I can see, both, the V-Belt and the Serpentine Belt are tensioned by the Compressor and the Alternator respectively.\015\0 ... Mitsubishi Diamante

How do you remove the CD player - 2003 Mitsubishi Diamante


What do you mean, remove acd player? ... 2003 Mitsubishi Diamante

Need to replace the starter on the 97 mitsubishi Diamante, how hard is it to remove and replace ?


To replace the starter you need to;\015\012) Note if you have an anti-thief system and now to reset it if the battery is disconnected.\015\012) Note the radio station selections if they are not saved if the battery is disc ... 1997 Mitsubishi Diamante
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.6719 seconds