Having problems with your 1999 Lincoln Town Car ?
Need to replace a seat motor on a 1999 lincon town car
\015 The motor stopped working\015
Repair Help & Product Troubleshooting for 1999 Lincoln Town Car
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Need to replace a seat motor on a 1999 lincon town car
... 1999 Lincoln Town Car
I need to cahnge the power seat track on a 99 town car. Mine will not go front or back. I need to remove a replacement from a pick and pull. I can get to three nuts but cant get to the one iin the rear right. No power to move seat. Can not take a battery. Can I remove the center console to get there? If so, how do I remove it with out bringing a crow bar?
... 1999 Lincoln Town Car
The driver's side power seat in our Lincoln Town Car is in the full back position and will not move. The problem started as a ratching sound in the motor and the seat moving in jerks rather than the normal smooth operation. The switch was working because the seat was trying to move. The fuse is also good. After reading several of the previoius posts for this same problem it sounds like I need to remove the seat and power seat transmisssion. How can I get instructions on how to do this?
Year?\012\012sounds like gear or seat track is damaged. ... Lincoln Town Car
Seat tell me my ''intake flap motor'' needs replacing on my Seat Altea 2.0l tdi. I have found one for sale off a Seat Leon with an engine code of BMN. My engine code as far as I can see is BKD. Will this part be suitable for my car?
It should work fine without any problems\015\012John ... 2006 Volkswagen Golf
I have a 99 chysler town and country.. As I got in my car one afternoon I put the car in drive and it made a loud noise when trying to go in drive. Then it sounded like a piece of hardware was hitting something. It also hesitated going into reverse at first but did after a few tries. I took it to Goodyear and they told me that I needed new motor mounts and new sway bar link and power steering pulley. They replaced all of these items. I paid the money and then got into the car and it is
Chrysler had problems with their front pumps for a few years. There is a Technical Service Bulletin for later models (2002-2004) that involves replacing the front pump assembly due to a "loss of prime" condition. Although the bulletin was not publi ... Chrysler Town and Country
AM LOOKING TO BUY NAMED CAR AND SELLER SAYS DRIVERS SEAT DOESN'T WORK (ELECTRIC). WOULD IT NECESSARILY BE THE SEAT MOTOR NEEDS TO BE REPLACED OR COULD IT BE MORE SIMPLE REPAIR? EITHER WAY WHAT SHOULD I EXPECT TO PAY? THANKS.
Hi there,\012\012It will either be the switch which operates the seat or the motor.\012\012If you are handy with a multimeter, undo the power connector under the seat and measure the resistance of the connector "switch" termin ... Cadillac DeVille
Need to know how to remove electric window motor unit and cables for "001 Seat Ibiza passaenger door from 2nd hand door (bought from scrap yard) and replace in my car. On 4 bolts but hidden and to big to slide out of spaces on inside door frame. also how do we fit it in? Ibiza is same set up as VW - will have to pick that as you do not have Seat in your list below
... Volkswagen Golf
ON MY 2000 LINCON TOWN CAR 120" STRETCH LIMO DRIVERS SEAT BACK WILL NOT COME UP MOTOR WILL STILL PUT IT BACK. SEAT WILL STILL GO FORWARD & AND BACK BUT NOT RAISE BUT CLICKS AS AT BOTTON OF TRAVEL. CHECKED FUSE 8 OK WHEN REMOVED KILLS ALL AS SHOULD
Something is blocking the track... make sure seat belts are not getting caught in the track... ... 2001 Lincoln Town Car
I have a 1996 pontiac grand am and I need to replace the blower motor my a/c blows cold but i am having to tap on the motor to get it to blow most of the time. and even then It does not blow really hard cant even feel it in front let alone back seat of car where my baby sits ... how hard is it to change and how do I do it??please help single mommy
... 1996 Pontiac Grand Am
Need to know the location of the AC blend door motor on my 1987 Lincoln Town Car, and how to replace it? Is it easy? Also, the same with replacing the Auto Temp Control Sensor. It could be either or? Getting some cool air then I hear this click coming from around the glove box and the air blows warm?
Your blend air door is vacuum controlled. There is a control servo assembly and there is a temperature sensor for the automatic climate control. The sensors fail a lot. you may have to replace the sensor and recalibrate your system. To repl ... 1987 Lincoln Town Car
Need a vaccuum diagram for 1989 lincoln town car, 5.0L SEFI V-8 i just replaced motor, chiltons or haynes manuals do not have a vacuum diagram
... 1989 Lincoln Town Car
I need to replace my pwr seat switch in my 2003 lincoln town car. I got a door panel tool but the door panel is not coming off. I also found a torx bolt behind the door handle but can not find anymore bolts to remove. I do not want to ruin my door. does someone know how to get in there.
You'll need to remove screws that are by the door handle,\015\012arm rest, under door and side of door and then gently pull back on the\015\012panel as there will also be retaining clips attached and you don't want\015\012to break them. If needed, yo ... 2003 Lincoln Town Car
I'm trying to get the drivers door trim off my 89 town car to replace the power seat switch. I have all the fasteners loose and the door panel comes off a little. It seems to be stuck on a linkage that goes from the door lock indicator to the actual lock cylinder. What do I need to do to get the door panel off?
You will have to pull the little chrome knob off the manual door lock slide, and then push the wire linkage back until it unsnaps from the plastic slide on the backside of the door panel. ... 1989 Lincoln Town Car
How to replace the power seat motor on an 03 town car
... 2003 Lincoln Town Car
Leaking coolant, noticed drip under motor area, close to lower hose, but could not see crack or split in hose this is a 1991 lincon town car v-8 at low speed 25-40 mph you have viberation, i was told there are boots that need lube/grease but can not find the location of the boots
The only way to find a coolant leak like this is to pressure check the cooling system and track the leak down. This may require taking your car into a service centre to have this done.Small leaks like this are hard to find without doing this and it m ... 1991 Lincoln Town Car
Wiper motor needs replaced - 2001 Lincoln Town Car
Should be right in front o the windshield uder the wipers. pop cowl off an replace the wiper motor ... 2001 Lincoln Town Car
I need replace the water pump on the car a pontiac grand am 2002. Someone told me that there is a special tool that needs to be installed on the fron of the motor. it is supposed to hold the pump gear so that the water pump can be removed without having to take off the timing chain. i have replaced the water pump before in different cars, but i'm afraid to change it on this one because i dont want to cause any damages to the timing chain. Do i really need this special tool to replace the water p
I have never heard of a car that changing the water pump requires access to the timing chain. Just the wreches. ... 2002 Pontiac Grand Am
Just had our 2003 Honda Pilot serviced and the dealer said the FGR Valvue needed replacing as it was apparently cloging and causing the car to loose power and hesitate at times. The dealership said we also needed the front and side motor mounts replaced ($607) and the inner CV boot replaced ($260). Our car has 81,000 miles on it and is used for infrequent city driving. I was surprised! Decided to pospone that work. Would these issues be common with so little miles on the car?
... 2003 Honda Pilot
1999 Ford Explorer Sport. Cracked Lower Seat Frame front of left side hinge attatchment/recliner handle. Lower seat frame needs to be replaced or welded. I am working out of town and can't get to a shop during business hours. Need temporary fix. Can I swap Complete Driver and Passenger Seats? Can I remove Both Seat Assemblies, Remove Slider Tracks, then replace Passenger Seat on Driver's Slider tracks?
... Ford Explorer Sport
I need to replace the motor mounts on my daughter's Kia Rio Cinco (2002), but can't find a repair manual for the car. I've done motor mounts in other cars and they were easy. Any idea if there are any potential problems with replacing Kia mounts? Generally, I've taken the weight off an engine with a jack, unbolted and replaced.
The problem with most modern cars is that you have to lift the entire engine from it's casing to get to the mounts especialy the transmision mount. ... 2002 Kia Rio
I was just wanting to know what the ignition switch does and controls and how much it will cost to have it fixed? My girlfriends car needs a lot of work. The gas gauge doesn't work, the car dies in the middle of the road at times, sometimes the car has a problem starting, the tie rod is wore out, and needs a hub-assembly. Also, the motor mount needs to be replaced. I was wondering how much would all this cost and where would I get the parts and where would I need to go and have it all fixed.
These cars came with computer brains when they start going out all kinds of things start going wrong your best bet is to have it put on a diagnostic machine see where to go from there weigh the options might be cheaper to get another car ... Oldsmobile Intrigue
Something is wrong with my AC/ Heat in my 2003 Acura TL-S. I took it to acura $$$$ for a diagnosis but was told that the blower motor needs to be replaced. I took it to another mechanic and was told to replace the blower motor resistor. I dont know who is right (doubt acura is) because in the winter time my dad rigged it so the heat would blow, but it blows at high speed as I soon as I turn my car on. I took it to someone else because I thought it just needed freeon(sp?), but that didnt work. No
It sounds like whatever your dad did needs to be un-done. If you are getting hot air then you don't need to replace the blower or any part of it, it sounds like something is just wired up wrong. I would ask you dad what he did and if he can change ... 2003 Acura 3.2TL
Well, every once in a blue moon my blower motor will work in my car. But, most of the time, I am hot am miserble because it doesn't. I'm assuming I need to replace the blower motor and was wondering where on the car it is located and how to replace it. Do you think that is what it is or do you think there is a loose connection somewhere and if there is how would I locate where it is?
I think u have a loose connection on the moter it's selh.It should be located under the hood on the passenger side back by the fire wall..Hope this helps. ... 1992 Buick LeSabre
Recently leased n14 nissan pulsar all good for four days then starter motor began to stick. Have started car by tapping above mentioned starter motor on a few occassions but more often than not need to clutch start vehicle.need to know any simple temporary repair methods till i can replace. I need car for work very urgent
You need a mechanic that can pull the starter and have him replace the starter solinoid or tighten up all the bolts and connections and turn the disk around on the solinoid. ... Nissan Pulsar
2002 chrysler sebring LXI coupe would not start 2 days ago.(Drove into town and was on my last stop). Tapped under car on starter and was able to get home. Wouldn't start after turning off. Tapped under car on starter again yesterday and took to shop. They replaced starter but now car cranks but will NOT start. Any thoughts I can relay to shop since I REALLY need my car and can't afford hours of labor charge? Starter they replaced was put in less than 6 months ago.
They have either left a wire to the starter unhooked or they have blown a fuse or fuselink ... 2002 Chrysler Sebring