Having problems with your 1999 Jeep Grand Cherokee ?

How do you remove the steering colomn shroud?

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Review this information:
- Steering column opening cover

- Steering Column Assembly / PDF (only as guide reference)

Good luck!!!





































Repair Help & Product Troubleshooting for 1999 Jeep Grand Cherokee

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you remove the steering colomn shroud?


Review this information:- Steering column opening cover- ... 1999 Jeep Grand Cherokee

The gear shift lever completely broke off where it comes out of a housing sleeve on the steering column. The shroud around the back of the steering wheel has been removed and I am able to manually shift with my fingers. I need to know how to replace the shifter, does it require a special tool to remove it and replace it etc. Thanks, Steve


... 2005 Mercury Mountaineer

How to remove the steering column shroud from a 97 crown Victoria


... 1997 Ford Crown Victoria

Ford F150 1993 Steering column shroud how do I remove the shroud


... Cars & Trucks

How do you remove the upper and lower shrouds around the steering column to in order to remove the ignition lock cylinder


Hello Kozacik.There are three screws with torx heads that need to be removed from the bottom of the cover.The top and bottom cover also snap together. After you remove the 3 screws pull them apart carefully starting at the steering ... 1999 Pontiac Grand Prix

How to remove steering column shroud 2004 pontiac montana


... 2004 Pontiac Montana

How to remove shroud around steering column in pt cruiser


... 2006 Chrysler PT Cruiser

Remove steering shaft shroud 06 pt cruiser - 2006 Chrysler PT Cruiser


... 2006 Chrysler PT Cruiser

How do i remove the steering colum shroud to replace ignition on 1996 ford thunderbird


Remove the bottom shroud panel below the steering wheel and then the bottom black steering wheel cover (3 screws in the holes). You will see a 1/8 inch hole and pin below the lock set. Put the key lock in the neutral position and push the pin and rem ... Ford Thunderbird

How do I remove shroud from 83 cutlass supreme steering column


... Ford Crown Victoria

How to remove steering column shroud - 2000 GMC Sierra C/K3500


... 2000 GMC Sierra C/K3500

Remove steering column shroud 1991 f150to replace ignition switch


Not sure if I remember right or not, but I believe you remove the horn, steering wheel, etc., and get at it from the end, not by taking the shroud off. But not completely sure anymore. ... 1991 Ford F150

How do i remove the shroud on the steering column


... 2001 GMC Savana

Need to remove ignition cylinder from 97 plymouth voyager minivan. The key has broken off in the cylinder and the steering column is locked. Have taken off the shroud around the cylinder and now cannot seem to get the cylinder out without a torx screwdriver. Is there any other way and if not where do you find one of those torx drivers?


Torx drivers can b found at any hardware ,auto ,where most tools are sold but before u do all that pick up a set of small picks like used in removing o-rings u should b able to fit one of the angled ones in cylinder and remove broken piece ... 1997 Plymouth Voyager

How do you remove the steering column shroud off of a 2003 GMC sonoma SLS with tilt wheel?


Look under the cover you will see holes inside the holes are screws remove the screws and the cover comes off in two halfs, the screws are troxs or phillps head screws. ... 2003 GMC Sonoma Extended Cab

How to remove plastic shroud on 97 gmc steering column


... 1997 GMC Sierra

Remove steering column shroud from 2000 dodge durango


... 2000 Dodge Durango

How to remove shroud around steering . can't get off because of tilt knob....


Pry tilt handle straight off it is a press fit over the metal clip ... 2002 Chevrolet Impala

I have a 2003 Chevy Cavalier. The horn works intermittently (usually on the right side of the steering wheel pad). When I push on the steering wheel pad to sound the horn, there is no real resistance and the pad plunges straight back to the stop. I have: disabled the SIR system, removed 3 screws from the steering column to remove the top and bottom half covers, and removed 2 screws from the back cover of the steering wheel and pulled it loose. I do not know how to remove the front soft cover/ai


See the diagram attached and proceed according for to fix, use the VOM.God bless you. ... Chevrolet Cavalier

1997 honda crv...need to change the turn signal switch...removed all the screws holding the one piece coverplate behind the steering wheel (where the switch resides) but it looks like it can't be removed without removing the steering wheel...the steering wheel has an opening on one side with one phillips screw inside...could this be the only screw holding the steering wheel on...seems improbable...but this being a girlfriends car with no workshop manual i'm a bit bamboozled...help


... 1997 Honda CR-V

I need to remove the steering wheel in my 1998 Audi A6 Quattro 2.8. I have removed the airbag, but there is no steering nut to remove. There is what appears to be a bolt with a star shaped hole in it. I need to know how to remove the steering wheel so I can replace the Ignition switch.


Hi....\015\012\015\012I don't think you have to remove the wheel. \015\012Check these tips that i got from my friend.\015\012Some tips.a)I used a nice soft cloth (actually, it's a bar/cleaning cloth that ... Audi A6

I am working on a 2001 Ford Taurus. I am trying to change the heater core. I removed the 2 bolts under the steering column and I am trying to remove the steering wheel. The tires are straight and the wheel is locked. But I am not sure how the steering wheel is removed. Can you assist?


HELLO\015\012 To remove the steering wheel first you must disarm the steering wheels Airbag module, the esiest way is to disconnect the battery NEGATIVE cable at the battery for 10 minutes prior to removing the air bag, the Airbag is held on th ... Ford Taurus

Trying to remove the steering column from 95 cadillac sedan deville. I am at the point where the rubber boot is housing the final bolts and it is screwed on from the other side. What is the quickest way to remove the steering column from this point? Battery has already been taken out and steering wheel has been removed. What do I do from here?


Put the steering wheel back on,and turn the steering wheel so you can access the bolt ... 1992 Cadillac DeVille

97 Passat Ignition Switch Removal Replacing ignition switch on 97 Passat. I've removed the steering wheel, turn signal lever, wiper lever....... Everything to expose the switch. All wiring connectors have been removed as well as the cable to the automatic trans shift selector, and the socket head capscrew that clamps the switch to the steering tube has been removed. The switch will slide up over the tube, but probably less than 1mm, then is stops dead. I have not removed the steel bridge o


1 did you drill the hole as directed on the autozone site. If so then you flip the drill bit over and push in the hole to release the spring. It is step 10. I hope you read the directions on autozone. ... Volkswagen Passat

I need some help to remove lock cylinder switch on my 1995 volkswagen passat vr6. i have gotten some advise off this site but i still cannot get the housing off the steering wheel shaft. this is where i am at now on the removal of this lock cylinder. i have disconnected the battery cable and taken off the steefring wheel. i have removed the top and bottom covers around the shaft of the steering wheel. i have removed the blinker and wiper switch. and i have removed the big hex screw on the left


Usually there is a little tab that pops out when the key is not in the on position that holds that lock cylinder in place. Try putting the key in and turning it to the on position, it should slide right out. ... Volkswagen Passat
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.2602 seconds