Having problems with your 1999 GMC Jimmy ?

How do i get my jimmy out of 4 wheel drive lo?

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1999 GMC Jimmy

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

( 1987 GMC Jimmy 4 Wheel Drive 350 Engine 5.7 liter ) ( had rebuilt transmission, torque converter and replaced transfer case) . Problem is that the transmission slipps out of gear / into neautral only when breaking abruptly. To get it back into 2 wheel drive I need to switch into 4 wheel drive ( take it out of 4 wheel drive ) then it operates fine. Replaced engine mounts and took it back in for service 3 times for linkage adjustment and still has the problem but not as frequiently. Can you prov


... GMC Sierra 1500

LAST WEDNESDAY WHILE OUT ON THE BACK ROADS, I DECIDED IT WOULD BE A GOOD TIME TO RUN THRU MY 4 WHEEL DRIVE (ELECTRONIC 2H, 4H, 4L, & ALL WHEEL), ALL OF THE SHIFTS WENT FINE, AND I THEN DROVE HOME. IN THE MORNING HOWEVER THE JIMMY WOULD NOT GO INTO REVERSE AND DID NOT HAVE DRIVE 3 OR DRIVE 2, ONLY LOW 1 TO DRIVE. I THEN HAD IT LOCK UP IN FOUR LOW AFTER I WAS CYCLING THRU THE 4 WHEEL DRIVE AGAIN TRYING TO REGAIN REVERSE, AFTER FINALLY GETTING IT OUT OF 4 LOW AND BACK INTO 2H (STILL NO REVERSE) I T


Sounds like you have a combonation trans and transfer case issues. if you were running youre truck in four wheel on a hard dry surface, witch is not recomended , the trans probibly ran hot. as for the transfer case, it could be a combination of probl ... 2000 GMC Jimmy

1994 GMC Jimmy stuck in 4-wheel low. Is there a way to manually get it back into 2-wheel drive?


Try checking the fuse when you open the driver door theres a panel look at the diagram it should be the first 20A bottom left beside the silver fuses ... 1998 GMC Jimmy

My 1998 GMC Jimmy is stuck in 4 low, and I can not get it to come out of 4 low into 2 wheel drive. What can I do to get it out of 4 low?


I am willing to bet that your silinoid whent out on the transfercase. and can you get it to go into neutral the transfercase that is? ... 1998 GMC Jimmy

How to get a push button four wheel 96 jimmy out of four wheel drive


Take the switches 2wd 4wd hi 4wd lo out of the dash and unplug them all then use small wire to jump the 2wd connectors then replace new 4wd button and new 2wd button ... GMC Jimmy

I have a 1987 gmc jimmy four wheel drive 5.7 fuel injection it starts up fine and when you drive it let off the gas it jerks like it is not getting fuel and when you come to a stop it shuts off and will automatically starts back up it is ans automatic and automatic


... 1987 GMC Jimmy

Vehicle trouble 2000 jimmy gmc while driving home the 2 back wheels seized up and would not move. Had to get towed. Just prior to this happening noise from back end,it would go into gear but would not move due to wheels seized.No warning prior other than noise moments before . When unloading from the tow truck brakes felt down. Any idea as to what could be wrong?


I think you may have a blown Rear Drive Axle due to lack of lubrication. It will be hit or miss if the housing is still usable. I would be against the problem being brakes as the likely hood of both wheels failing at once is extremely unlikely. ... 2000 GMC Jimmy

1996 GMC Jimmy manual - need help with 4 wheel drive - stuck in 4 wheel low and can't get out


Most of the time the motor on the side of the transfer case siezes from corrosion if not the module in the pass side kick panel could be bad. ... 1996 GMC Jimmy

I have a '91 Jimmy and when I am in 2 wheel drive I hear a rattling and slight grinding noise. I believe its from the transfer case. I used to hear this noise after coming out of 4 wheel drive, but then it went away. Now the noise is back, but isn't there if I am in 4 wheel drive. Is there a gear that's rubbing inside the case when I am in 2 wheel drive? Could the gear be slipping into 4 wheel drive? Whats keeping it from slipping into 4 wheel drive? Will adjusting the 2-4 wheel drive lever fix


... GMC Jimmy

How do i get my jimmy out of 4 wheel drive lo?


... 1999 GMC Jimmy

K1998 gmc jimmy 4 wheel drive truck cranks but wontstart.is getting fire,when it did run it smelled like gas strong


GMC Jimmy's have a record of corroded fuel lines at the fuel pump in the fuel tank. Cycle your key from "Off" to "Run" a couple times then look under the vehicle in the fuel tank area to see if there is gas dripping. ... 1998 GMC Jimmy

1996 GMC Jimmy 4 Wheel Drive 4.3 L engine. We are having trouble finding the Oil Pressure Switch to replace it. We are getting mixed messages from different sites as to where it lives in the engine. We need to replace it and have a new one ready to put in.


The oil pressure switch is located on the passenger side of the engine block for the 4 cylinder. On the V6 it is near the distributor at the top rear of the engine. This may be why you are having trouble finding it, since it is located in different ... 1997 GMC Jimmy

My 2001 GMC Jimmy switched itself into 4wheel drive low and now i cant get it back in 2 wheel


... 2001 GMC Jimmy

Hi Need to see a diagram of the engine vacuum lines - tbi, 2.8L 4 wheel drive 86 s-10 blazer THANKS !!!!!!!!! alldatapro doesn't even have a proper diagram or anything I'm getting mine a a GM Chevy MVP but nothin on it or the T40 Checrolet Truck with everyone displaying GMC Jimmy **** that is nothing like what the truck is


Get the Haynes S-10 repair book at the parts store for about $20. It has diagrams for vacuum lines. ... 1986 Chevrolet S-10 Blazer

Cant get out of four wheel drive - 1999 GMC Jimmy


If your truck has a dashboard push-button 4x4, then carefully disassemble and clean with Q-tips and alcohol. when 4x4 lights turn off, drive in reverse over 15 feet. Good luck. ... 1999 GMC Jimmy

My bronco is a 6 cyl automatic with push button 4 wheel drive. no matter what I do I can't get it to shift out of 4 wheel drive back into 2 wheel drive. I have tried about everything but just getting really frustrated. when I push the button the 4x4 light goes out but then comes back on. I've tried backing up to see if that would help unlock the automatic hubs but nothing happens.


... 1989 Ford Bronco II

Used my 4 wheel drive 2 get out of a mud puddle and when i put it back into normal drive it seemed as if it slipped out of gear. I could not get the 4 wheel drive shifter to engage back into normal drive gears. It will only drive in 4 high.


Try reversing the car 2or3 times then go forward and try the box and see if it stays in then.\015\012Let me know how you go Ron ... 1996 Chevrolet Blazer

Last night I drove up my driveway to the top and turned around so I would be headed out this morning. As I was trying to back up my wheels started to spin. I came to a complete stop and turned the knob from 2 wheel drive to 4 wheel drive low. I then proceeded to back about 25 feet. I stopped and turned the knob back to 2 wheel drive. This morning when I tried to leave the driveway my 2008 F-250 Super Duty is stuck in 4 wheel drive low. I can't get it to go back into 2 wheel drive. I tried


\015\012Hi, try putting the tranny in neutral. Then moving the 4wheel lever to 4wheel low, then move the lever to 2wheel then shut off. Hope this works.\015\012\015\012\015\012\015\012On the TCS light issue,\015\012Generally t ... 2008 Ford F 250 Super Duty 4WD

GMC '91 Jimmy, Transfer case. When in two wheel drive I hear a slight grinding noise and rattling noise. When in 4 wheel no noise. 330,000 miles, could something be worn? What keeps the transfer case gear from slipping into 4 wheel drive? I know that I have to back up to change from 4 wheel to 2 wheel. Transfer case lever shifted all the way forward to 2 wheel drive. What ever keeps the transfer case in 2 wheel drive could be worn? Thanks.


Yeah your right about waer but you might be blaming the wrong part. With the truck up on jack stands ( all wheels off the ground) have a helper drive the truck at the speeds that make the most noise you'll find it in the front axel or fround U join ... 1991 GMC S-15 Jimmy

Hi i got a 96 4x4 tahoe the four wheel drive is not engaging the front wheels. when i put the switch to 4x4 hi or low the trans feels like it is 4 wheel drive and gets that heavy feeling like when in 4 wheel drive but the wheels in front are not locked in and the dash lights work but just blink in 4 wheel drive mode......Thanks


Are they vacum operated or you have to lock it in by hand. ... 1996 Chevrolet Tahoe

I have an Isuzu Trooper, 1996, manual tranny. I have the axel (vacuum) engaged 4 wheel drive system (not the hub auto lockers) and shifter lever to engage 4 wheel drive. My 4 wheel drive is getting slower and slower to engage. I drive sometimes 5 miles or more before the light comes on showing engaged (switch on axle was replaced, wiring & switch appear correct). I have also noticed that if I switch off the car for 15 mins or more, like going for a lunch, when i start and drive away, the 4 wheel


There is a vacuum switch on the transfer case left side,up high!(Most have 2-3 vacuum hoses) That switch is bad! ... Isuzu Trooper

My 4 wheel drive went out. I drove about 50 mph in 4 wheel drive for about 50 miles. pulling into the driveway I heard a grinding noise as I accelerated up the drive. Now I have no 4 wheel drive in my gmc 2500hd duramax. It wont move in 4 low and 4 high is just 2 wheel drive now. I would like to fix it myself if possible. Is it possible? and how do I get started?


... 2005 GMC Sierra 2500HD 4WD

2006 Jeep Wrangler. When I put it into four wheel drive, it is making a grinding noise. This happens on ice and if I gun it, I believe that I am only getting one wheel to spin up front, the driver's side. It just started happening, but this is the first year I have had the vehicle in the snow. Sometimes I can get four wheel drive and sometimes not. It's annoying and probably an expensive fix? I'm a city boy with little knowledge about vehicle mechanics. (It happens ONLY when I lose traction) Tha


Don't have your foot into the gas when shifting into 4 wheel. Best is to shift at a lower speed and "feel" the shifter as it goes in. Abandon the attempt if it grinds (picture parts doing really bad things to each other)One general driving tip. ... 2006 Jeep Wrangler

2000 Toyota 4 Runner - 4 wheel drive. Used 4 wheel drive during snow, then couldn't get it out of 4 wheel drive. Dealership took it out finally, but said a part had to be replaced,until then no 4 wheel drive usage. We need a schematic of the engine so my husband can look at replacing it. The part cost on line about $180, dealership want $1200 to do the repair.


... 2000 Toyota 4Runner

We have a 2004 Jeep Grand Cherokee with Quadra Trac II. However, the 4 wheel drive feature is not working. 4LO works. However it is supposed to be ALL TIME 4 wheel drive with engine torque transmitted to the front driveshaft when needed. This is not working. When driving in the snow only the back wheels are spinning. Engine torque does not get transmitted to the front. I had not had any trouble with the 4 wheel drive feature until this winter.


... 2004 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.0515 seconds