Having problems with your 1999 Ford Ranger SuperCab ?

1999 ford ranger 4.0

\015 When i first start my truck and it is cold (engine) the a/c compressor thumps over and over like its trying to engage or something. After I shut it off it will continue to thump for several seconds. I'm not familliar with anything to do with a/c's. Anyone have a clue as to what this is?\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

When your defroster is on it makes your ac compressor kick in when the ac is low on freon it will keep kicking in and out. have your ac charged that will fix your problem. Phil.
Repair Help & Product Troubleshooting for 1999 Ford Ranger SuperCab

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Remove cooling fan in ford ranger 3 0 - 2001 Ford Ranger Regular Cab


... 2001 Ford Ranger Regular Cab

Where is the "0" degree mark on the harmonic balancer of a 1991 ford ranger 3.0


... Ford Cars & Trucks

Ford ranger 2006 4,0 litre timming how to set


... Cars & Trucks

1987 ford ranger 2.9 v6 5 speed.Gauges do not read correctly .tack drops to 0 while driving speedometer doesn't register correctly, gas and temperature not recording correctly.


... 1987 Ford Ranger

.0 engine on 2003 ford ranger replaced idler pulleys, fan belt, still doing it what could it be?


A faulty belt tensioner pulley could be cause of belt slipping squealing ... Cars & Trucks

01 ford ranger v6 4,0 fuel pump relay locatew


... Ford Ranger

2003 ford ranger edge 6 cylinder 3 0 engine


... Cars & Trucks

What is the fuel pressure on 03 ford ranger 3,0 vin v engine running


... Cars & Trucks

1995 ford ranger 3 .0 number 5 spark plug wet with fuel have changed injectes blowing bleu smoke


My name is laurence and i need an answer for why my center support bearing makes the front drive shaft too short and will not meet the rear drive shaft now. Sorry for busting in but i'm at my wits end and really need some help. would have went to sev ... 1995 Ford Ranger Supercab

I have a 2002 ford ranger that got a lot of water in the gas. I have drained the tank and added heat as well as replaced the filter. When I try to start it the battery gauge goes down to 0 and all I hear is the starter clicking. I have checked the battery, starter, and the altinator and all are good. I have gotten it started a couple of times and it idols fine but if I drive it I only get about a mile before it dies and the battery will not turn over the starter. The volt gauge still goes down


I think your on the right path with your shorting thought. Is the distance you can travel always different or always the same? If it is always the same then it may not be a short or how long can it sit and idle when you get it running? ... Cars & Trucks

94 ford ranger 3 0 timing gear settings 4whd 6cyl


... Cars & Trucks

Ford Ranger 3,0 TDCI Flyweel to crankshaft bolt torque settings


... 2007 Ford Ranger FX4 Off-Road

OIl pressure is 0 at idle, warm or cold. It comes up as soon as you rev the engine. 1998 4.0 L Ford Ranger.


The gauge must be lying to you or your engine would be knocking and seized up on you by now,Replace the oil sending unit and this should fix you up. ... 1996 Jeep Grand Cherokee

My 1992 ford ranger 4,0 2wd keeps flooding


... 1992 Ford Ranger

Couple of questions on a 1997 4 cyl Ford ranger; engine light stays on all the time. Sometimes its blinking nut mainly just stays lit. In addition the O/D off light comes on to let me know its off for no apparent reason. And last yesterday I checked the "fluids" as its running sluggish and the container that holds the radiator fluid was empty-what caused this? Its been 0-32 degrees out. thank you for your help.


First off, the check engine light. If it's flashing, that indicates the engine is misfiring. You should immediately pull over and shut it off - driving while misfiring can cause serious damage. The fact that it stays lit indicates that you have store ... Ford Ranger

2001 ford ranger 4 0 engine timing chain


... Cars & Trucks

How do you remove the cooling fan in a 2002 ford ranger with 3 0 engine


... 2000 Ford Ranger SuperCab

I have 98 ford ranger 2.5 that broke the timing belt; What type of internal engine problems might I be looking at? I replaced the belt and did a compression test and have 0 compression.


Hello gandolfph: My name is Roger and I will help with your question. I have Alldata and Mitchell on demand programs. I looked at both and neither one says this is a interference motor. That is where the valves bend if the belt breaks. I would go bac ... 1998 Ford Ranger SuperCab

I have a 2002 ford ranger that got a lot of water in the gas. I have drained the tank and added heat as well as replaced the filter. When I try to start it the battery gauge goes down to 0 and all I hear is the starter clicking. I have checked the battery, starter, and the altinator and all are good. I have gotten it started a couple of times and it idols fine but if I drive it I only get about a mile before it dies and the battery will not turn over the starter. The volt gauge still goes down


... 2002 Ford Ranger Regular Cab

1994 ford ranger 4x4 4,0 it idles good but when going down road the check engine light comes on within 20 seconds acts like it is flooding out loses power let off for a second and then runs good for couple mile but at any time if you put throttle to floor within lastinch or so same reaction any ideas


It should have a code stored. Some places still carry the scanners for OBD 1 Fords for around fifty bucks. Without knowing anything else about the truck or what codes you have, it sounds like you have a bad throttle position sensor. ... 1994 Ford Ranger Supercab

Hi there,i need to get a copy of Ford Ranger 2007 parts and services manuals...it is a automatic car..below are the spec.. 1 WHITE MNCLS3E928W708610 W708609 FORD RANGER 3.0 CFS060902 > 4DR 4X4 AUTOMATIC 2007 4CYL DIESEL (T) > 2 WHITE MNCLS3E938W711886 W711886 FORD RANGER 3.0 CFS060902 > 4DR 4X4 AUTOMATIC 2007 4CYL DIESEL (T) > 3 WHITE MNCLS3E988W711866 W711866 FORD RANGER 3.0 CFS060902 > 4DR 4X4 AUTOMATIC 2007 4CYL DIESEL (T) > 4 WHITE MNCLS3E998W712363 W712363 FORD RANGER 3.0 CFS060902 > 4DR 4X


Check out rockauto.com ... 2007 Ford Ranger FX4 Off-Road

Ford Focus engine diagram Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V Ford Focus engine diagram - Ford Focus engine Zetec-E 1,8-2,0 l 16V


... 2001 Ford Focus

Ford ranger 4wd i have a 1996 ford ranger


Go to a junk yard and obtain a 1966 Ford Ranger transmission. Remove the old unit and do an exchange. ... Cars & Trucks

Will a exhaust manifold off a ford ranger 2.3l fit a ford ranger 2.5l


... Cars & Trucks

Ford Ranger My customer cracked his block on his 1997 Ford Ranger. He bought a new engine that is a 1992 Ford Mustang. My question is, can i make this chang even though there are alot of different things?


Yes if the motors are matched in mounts and size but if not matched\015\012yes you can but it requires you adjusting motor mounts maken the chassis stronger there is a lot of welding and alot of moving of parts for this engine\015\012 ... 1997 Ford Ranger SuperCab
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.2315 seconds