Having problems with your 1999 Ford Escort ?

Fault code 214

\015 1995 Escort 1.9 L code reader indicates a continous error code KOEO 214 Cylinder identification circuit failure. what does this mean and how do I correct it?\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

This code is caused by the CID sensor, it is a common fault on Escort OBD 1 engine control The Cylinder ID (CID) sensor provides crankshaft position information to the Powertrain Control Module (PCM). The PCM uses this information during engine start up to begin sequential fuel injection at the correct time.\015\012It's a good possibility the CID is bad or the wiring between the CID and the PCM is open. The CID is located in the back of the cylinder head on the distributor side of the engine systems.
Repair Help & Product Troubleshooting for 1999 Ford Escort

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Can anyone tell me what these engine fault codes refer to on a 1998 mercedes c180 auto,1.8 petrol. I suspect it may be releated to tempeture sensor. Total of 6 codes 065 (2,2,0,41) resistance too high 104 (2,2,0,68) resistance too low 122 (2,2,0,7a) resistance too low 126 (2,2,0,7e) resistance too low 129 (2,2,0,81) resistance too low thanks jim 161 (2,2,0,a1) resistance too high


Most common is o2 sensor ... 2002 Mercedes-Benz C-Class

At elev. 8500 severe power loss under load. Live feed engine data as follows:0-5 engine timing retarded,pending code fuel system fault OL and sometimes will set mass air flow code. mass a sensor replaced recently. removed air filter resonator from behind bumper,left top portion w/filter element in place. once vehicle returns to lower elev. runs great.will not set code again until returns to 8k .vehicle 30k mi. org. owner.have own scanner w/live feed.


Does your scanner give you a reading for barometic pressure? ... 2001 Hyundai Sonata

Fault code P1000 [18,2,10,0],Ford Fiesta 2005


P1000 means that you or someone has disconnected the battery,and the car has not been driven far / long enough for the computer to relearn its stratagies.\015\012Engine light could be the fault of the speed sensor, or wiring to the sensor. ... 2007 Ford F

Frieghtliner m2 fault codes eng 0, 4376, fail 5 and eng 0, 3361, fail 05


... Cars & Trucks

Engine stop while running, check engine indicator is on using autoboss v30 diagnostic computer 6 fault was found fault code 11 description aps fault code 46 description inj adj v fault code 27 description aps2 fault code 31 description can comm. fault code 52 dseciption vgt cont.prs. fault code 51 description egp pos.snsr


... 2000 Mitsubishi Montero

Heater not coming on - "0" fault code comes on, so not sure what the problem is. Fuse is okay. Could be heater box. Any suggestions


... 1999 Saab 9-5

D13 volvo fault code spn 4344 fmi 5 sa 0


... Volvo Cars & Trucks

Eml fault code 153 bosch 0 205 000 005, 1990 e32 v12


... BMW 750

I have fault code EGS (054) 36 Gear monitoring 4, BMW X5 E53 3,0 D 2002


2003 X5 bmw the trans. fail safe program comes on when driving, I was told that the trans needs to clean out and put new sensors. Is that true it gives the code 055 ... 2004 BMW 5 Series

Mercedes E200 Kompressor, 210048. Engine fault light came on and the fault code was "intake air device:wrong operation (work link), air flow too small. (P0410)" The air flow meter was replaced and the fault code deleted. Remained OK for about two weeks then the engine fault light and the same code re-appeared. Any assistance greatly appreciated.


CODE PO410 AIR INJECTION MALFUNCTION. CODE PO410 AIR INJECTION RELAY. PROBLEM COULD BE THE AIR INJECTION RELAY. ... 2004 Mercedes-Benz C-Class

I have a 1995 Chevy Van with a 4.3 liter, it's a CMFI eng. I have 2 fault codes 32 and 83, I changed the IAC vavle which is fault code 32. I do not know what 83 is, but the fault codes as the IAC vavle is still not working, and put two brand-new ones in and still not working. What is fault 83 and how do I cure it??


I dont know what that code is but i do know that those enigines have a bad problem with fuel leaks under the upper intake what happeins is the plastic type line that go to your injectors crack or just break and then they leak and then the van runs li ... 1995 Chevrolet Astro

I have my rexton 3.2 ...now the problem is when im start it,the engine was running and not stable n some time ok...plug coil,plug new....i already do diagnostic n the fault code tell the (o2 sensor heater fault)(not defined)......i changed all o2 sensor,but still not stable...sometimes OK...exhaust have black smoke... the fault code some time have many,,some time a little bit..but same fault code...have a problem with my computer box or not????please help me!!!!


... Mercedes-Benz E320

The problem with 2002 nissan altima is ,whenever the battery terminal is removed,the car wont accelerate,so i used my scanner to detect the faults,and it shows me some fault codes,e.g. ( u1000,u1001,P1490,P0650,P0037,P0113,P0462,P0447).When i wiped the faults code,the car will accelerate,But when i remioved the battery terminal again,it wont accelerate and the fault code will generate again.What is the possible permanent solution.thanks.


... 2002 Nissan Altima

Mazda 626 (Capella) ABS fault. I have a Mazda Capella (626) 1998, 2.0 l sedan (ex Japan) A few weeks back the ABS and TCS warning lights began to come on intermittently. I took the vehicle to a service dealer who replaced the left rear wheel speed sensor, but the problem persisted. I have since extracted the fault codes by linking the TBS pin to ground as my vehicle is not OBD II compliant. The codes obtained were 14, 44, 48 and 87. After resetting the codes, the fault code 44 comes back and th


\015\012Hi,\015\012Code 44Oxygen sensor voltage was under 0.25 volts for up to 4 1/2 minutes of closed loop operation, lean exhaust. Check the ECM wiring connections. Check for vacuum leaks at the hoses and ... Mazda 626

2001 golf gti had fault code p0420 come up had new rear lamda done still p0420 so got new front lamda, code still come up so then got a new cat, then fault code p0420 and p0120 come up,, then had new maf sencor,, still now im getting fault code p0420 come up please help


Re the funny smell, i need to speak to my friend as i have never heard of that one,does it smell of rotten eggs??? ... 1998 Volkswagen Golf

My grans hyundai getz 53 reg had an abs fault, i tried my bosch kts an snap~on solus but would not give any fault codes, i borowed a friends diag tool an it found an engine mgnt fault in abs system, i cleared the fault, road tested the vehicle an the light came back on again the same engine mgnt fault, i road tested the vehicle with live data and found the n/s/f sensor faulty, today i replaced said sensor and tried the kts again the knock the fault code off and got c2402 (pump motor engine relay


Hi from uk for your info there was a recall back in2004/5 for the getz relating to the abs system going faulty my wifes 2003 getz gsi was recalled and i took car to dealers for her to enquire what fault has there beenon some getz with a ... 2003 Hyundai Santa Fe

Transmission fault code "reverse solenoid fault" keeps me stuck in limp mode (stuck in third gear)keeps popping up! WHAT can cause this code to keep me in third gear???!!!! im a stay at home dad with 2 kids, 2 dogs, 2 turtles and a frickin stratus that satan himself refused! but its all we got for now so I HAVE TO MAKE IT WORK!!! please help me if I can find out the list of possible causes to make this reverse solenoid fault code happin i can find it and fix it and stop tearing thru gas and rp


The automatic transmissions of today's cars are electonically controlled by the ECM, when a problem arises the transmission will send a DTC (Diagnostic Trouble Code) to your ECM. You will need to take your car to a mechanic to test and replace the Re ... 1996 Dodge Stratus

I need a little help with a P1211 fault code in a 2002 7.3 Powerstroke engine. I drive down the road, and the check engine light comes on. The engine loses power then the smoke pours out. I pull off to the side of the road and shut the engine down and wait about two minutes. Then I restart the engine, the fault code disappears for about ten minutes or when I go above two thousand rpms. When I came back to the shop where I work I put the scan tool on it. The fault code came across with a P1211.A


... Ford F-350

I have a KIA Optima 2006, V6, 2.7L, that just this past weekend I got a check engine light. The codes stated misfiring on cylinder 1 and 2 and random misfiring. Replaced all plugs and wires but the issue was not resolved. Now the codes (P0305 and P0274) are now just on cylinder 5. Codes Reads as follows: P0305 ? Cylinder 5 misfire detected probable cause - Rich or lean Air/Fuel mixture - Ignition system fault - Fuel injector fault - Engine mechanical fault P0274 ? Cylinder 5 in


... 2006 Kia Optima

Car will start if using a jumper cable.. but acts like theres no power to the bater when i shut it off and try to restart it... fault code flashed 12 and then 55 on the check engine light...the haynes manual says that means this Code 12.................Problem with the battery connection. Direct battery input to PCM disconnected within the last 50 ignition key-on cycles. and this Code 55.................Completion of fault code display on CHECK ENGINE light. This is the end of stored codes s


If the battery goes dead, or is disconnected, you will get the code 12. Pull out the battery, bring it to a parts store to be checked to see if its low charge or a bad battery This is a free service. Clean up the battery connections with a nifty ch ... 1995 Dodge Stratus

Fault finding Car lacks power occasionally, Autel scanner list Air inlet manifold pressure sensor open circuit. Fitted new sensor, fault code will not reset. Put old sensor back in used 'erase code' code goes but comes back when engine run. Put new sensor back in and again will not reset the code, but car seems to run OK!!! Any ideas? Thanks Les


... 2006 Peugeot 206 1.4

Airbag codes hi,i have a 2003 mitsubishi outlander,its hasmodule fault codes..72 and 82..system fault codes..93 and 96..can anyone tell me what the codes are.thans wayne


... 2003 Mitsubishi Outlander

Mercedes faults Could you tell me what these faults are? fault code (DTC) 930C fault code (DTC) 9370


... Cars & Trucks

Peugeot 207 cc fault code ecu-mev17.4,fault 2.what is this code


... Peugeot 207

P0421, P0431 Unable to pass inspection on my 2001 Mazda Millenia. Mechanic tells me as long as there are 2 fault codes ( P0421and P0431 ) it can not pass inspection. If there was only one fault code it will pass. He gave me a sheet that explains that if I drive the car with out the AC and headlights turned off and Run it at 3500 rmp for 4 minutes it might clear one of the codes. My problem is 3500 is about 85 mph. Money is very tight and I can not afford to get a speeding tickey. Does anyone kno


Technically, you can put the car in neutral and press the gas while the car is running, til it reaches 3500 rpm. You don't have to actually have the car on the road while you do this. ... 1999 Mazda Millenia
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1303 seconds