Having problems with your 1999 Ford Contour ?

How do i replace the oil pressure switch on a 99 ford contour

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1999 Ford Contour

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do i replace the oil pressure switch on a 99 ford contour


... 1999 Ford Contour

Replace oil pressure switch 05 ford freestyle


... 2005 Ford Freestyle

1988 Trooper 2.6L 4ZE1 I have no power going to the Low Pressure Oil switch. where does the LPO switch derive its power from? This happened once before and the low Pressure oil switch was the problem. I replaced the LPOS with a new one and the car ran fine until my wife ran it out of gas after she put gas in the tank the car failed to start and I am not getting any power to the Low pressure oil switch now The Circuit diagram shows it coming from the instrument cell cluster. According to t


Hi,Normally there would be a relay for the fuel pump. It would be among a few others in the fuse/relay box under the hood. Pls confirm with your diagram and to my knowledge, this gets its main power from the FL-3 ECM fuse (30A) and ... Isuzu Trooper

My 1986 Ford Thunderbird Elan shows no oil pressure on the oil gauge on the digital dash. I tried replacing the oil pressure sender, same results. There is a small block that looks like a fuseable link in the wiring that connects to the oil pressure sender. One end of it had bad wires inside and I replaced it with an aftermarket type. Still not working. There is oil pressure just not showing in gauge.


The way a professional would address thi is to check the pressure at the engine with a shop guage to see what is real. If still no pressure the most obvious reasons would be a bad oil pump or clogged stainer or your crank bearings are warn out. An ... 1986 Ford Thunderbird

I have a Grand Cherokee 2001 4.0 6cyl. Thermostat replaced, oil sending switch replaced but still losing coolant fluid. About from full to indicator light in six weeks. My oil pressure gauge went to almost 0. I had it checked out and the mechanic said the oil was very thin. Changed oil and filter and oil pressure resumed main seal products to correct this to 40psi at 1600 and 20psi at idle (pressure in the oil pan). For the next 1000 miles it was good, and then the oil gauge was showing a dip a


Hate to say it, but sounds like a blown gasket or cracked head - the mere indication of the white mily substance.If you haven't done so, it is time to do a compression test. Alternatively have you checked your oil pump itself?Best r ... 2001 Jeep Grand Cherokee

How to Replace a Low Oil Pressure Switch in a Ford mustang


... 1996 Ford Mustang

1993 Oldsmobile 98 Regency Elite wiring checks OK, replaced oil pressure switch with aftermarket part and still not working? Goes to 120 psi after warms up and then "Oil Pressure Switch Problem" displays. Physical gauge installed and psi 40-50 which seems normal. Is an original equipment oil pressure switch needed? We bought 2 different aftermarket brands Napa & BWD. Any ideas?


... Oldsmobile Cars & Trucks

Where is the Oil Pressure Switch located on a 2004 GMC Envoy Xl? I located a switch next to the oil filter but it has a 2 pin switch and the replacement part that I got from Napa is a 3 pin. Is there another Oil Pressure Switch located on the Engine Block towards the back on the passenger side?


Tell me what happened? Yes it is right next to the filter, and there's only one. Did your car die and the low oil pressure light go on? ... 2004 GMC Envoy

How to replace oil pressure switch on 1996 ford f - 150


There is a special socket made just for this porpose. They are sold in any auto parts store. Thanks, Dana ... 1996 Ford F150 Regular Cab

How to replace oil pressure switch on 1996 ford f - 150


... 1996 Ford F150 Regular Cab

Replacing oil pressure switch. where is it located....2002 ford explorer xlt?


I think its down next to the oil filter on the side of the block. Hope this helps. ... 2002 Ford Explorer

Oil pressure switch location on a 2.0 ford contour


... Ford Contour

Replacing oil pressure sensor switch in 94 ford escort


... 1994 Ford Escort

How to replace my oil pressure sensor on my 1996 ford contour 2.5 engine


... 1996 Ford Contour

How to replace oil pressure switch on 2000 ford expedition


... 2000 Ford Expedition

I have a 95 gmc vandura 3/4 ton. No fuel coming out of injectors. Replaced fuel pump( because I no longer heard the it kicking on when i turn the key on, i thought this was the problem), but the relay isn't tripping, I have come to understand that the oil pressure switch is what tells the ECM to trip the relay. How do I test the oil pressure switch, or by pass it to see if that is the problem. Cause if that isn't I guess I looking at tearing out the fuel pressure regulator, or oil pump! Yes I


... Cars & Trucks

Does a 2002 ford explorer 4.6 8 cylinder XLT have an oil pressure sending unit. If so where is it located and where can I buy one. Auto Zone said they never heard of one foe the ford explorer's. I already changed the oil pressure switch and my car is still doing the same thing, check gauge light comes on and the oil gauge pressure goes down to zero and if I run the car that that for a few minutes the car shuts off completely. After a few minutes the car will start again. Please help......


... 2002 Ford Explorer

Where is the oil pressure switch on a 2001 f150 5.4L engine (supercrew) does anyone have a picture or diagram how to find it? When oil pressure gauge drops to zero and light comes on until engine warms up. I am thinking that the oil pressure switch could be the problem and want to replace it, but cannot locate it.


Left ( driver's side ) front of the engine on the 5.4L engine.This is shown to be at the end of the baffled area of the intake, the edge of the pleated area farthest from the airfilter ( looking at the engine, the left side of the pleated ... 2001 Ford F150 Styleside SuperCrew

1996 oldsmobile aurora oil pressure sensor says low oil pressure my mechanic checked it out and replaced the oil pressure sensor and problem still exsists he tested the oil pressure recommended 20 PSI when engine is hot and idling drops to 16-18. Already tried switching to synthetic oil did nothing. please help


The Aurora is a low pressure oil system. The only solution available at this time is to increase the oil weight. I went o straight 30W to solve the idle alarm issue. Some use 20W oil and that works too.With 20W you will be at 80 to 90psi cold ... Oldsmobile Aurora

I have a 96 firebird just replace oil pressure switch because the old broke, but with the old switch was working fine the oil pressure was right in the middle 60psi just put the new one and when down it's almost 1/4 sometimes just below the middle. I check the oil stick and it's fine. What could it be and wha't the lowest it can getwithout harming anything


... 1996 Pontiac Firebird

Hi there I have a 2006 Audi A4 2.0TFSI that I have overalled the cylinder head because of bent valves. The motor is running fine and has got 2bars of oil pressure but as soon as I rev the motor it gives me a low oil pressure mesage and then it goes away and while I am driving the same happens but I can not hear the lifters getting louder from no oil feed the engine is running verry smooth. I did replace the oil, oil filter and the oil pressure switch. wat can be the problem.


... Audi A4

Ford explore has a code of C1284 which my scan tool says it is a oil pressure switch is this the cluster or switch it self when truck runs oil pressure is fine


... 2002 Ford Explorer

My 1989 Ford Ranger 2.3L 2wd has a problem in the oil pressure area. The pressure gauge at idle says normal but when accelerating it goes past Low. I replaced the pressure sending unit and it didnt change the way the gauge works. The oil is brand new and the engine isnt making any noises like it has low pressure. What can I do?


I would take the sender out and install a temporary manual gauge (we use a manual SW gauge connected to a 3' length of 1/4" high pressure hose). If the oil pressure is normal on the manual gauge then about the only thing left is the gauge itself. ... Ford Ranger

I have a 2000 Pontiac Firebird, 3.8, automatic with 170,000 miles. It's reading low oil pressure and sometimes drops down to zero after driving itva few miles. It typically does good after an oil change but then after a few days it does the same thing all over I have replace the oil pressure sending switch, not sure if the oil pump is bad! Any ideas?


... 2000 Pontiac Firebird

Engine light turns on when i drive the volvo and it show a message at the instrument cluster saying no oil pressure. when i start the car and it's idleing. the oil light never comes on. as soon as i drive after 5 minutes oil light turns on. i replaced the oil pressure switch but it's still doing the same. what to do now?!


Before replacing the old switch did you test it with an ohmmeter to see if it is bad. You can do the same with the wiring to see if you are getting a reading. You can also run a diagnostic scan to see if it shows anything. Otherwise fuel pump may be ... Volvo XC70
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.5456 seconds