Having problems with your 1999 Dodge Intrepid ?

No fire from coil to plugs

\015 Car will start , run for a few seconds and quit.\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

No fire from coil to plugs means that the coil is bad
Repair Help & Product Troubleshooting for 1999 Dodge Intrepid

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Engine quit driving down road, no fire to plug wires but fire from coil. Have changed computer and distributer. Have fire from coil wire and two wires from coil to bottom of dist but no fire from large plug on bottom of dist.


Fault with distributor. Replace rotating contactor and cap at the same time, or if it is electronic, replace the unit. ... 1991 Chevrolet C1500

2002 escape miss fire on cylinder one. took coil from cylinder 5 and put on cyliner one coil did not fire on cylinder one. took coil from cylinder one put on cylinder 5 and it did fire. 160 lbs of compression plug is wet with fuel. replaced spark plugs


Power not reaching cylinder 1 ignition coil. check electrical connections and wiring for any damage. test for power and ground at cylinder 1.\015\012hope this helps. ... 2003 Ford Escape

I have Kia Rio with p0304 keeps coming up, so I change the coil ,Spark plugs and plug wires. Still getting the code so I pulled ea plug out and did a visual on the spark plug fire. I use the cyclinder #2 plug wire and tested each coil port. All Look good except number 4 which was very week fire.


Could be a bad coil pack or the connector is oxidized ... 2004 Kia Sedona

I put a different engine in my 2005 Jeep Grand Cherokee (3.7) and the back 2 cyliners on the drivers side are not getting spark, I changed out the coil packs, plugs and even started the engine with the coil pack out and plug in the coil pack, but they are not firing. The engine runs but rough and I can even start it without those 2 coil packs in and it runs the same so I know they are not firing. I am getting voltage at the coil pack but I dont know if its enough, what is the voltage supposed to


... 2005 Jeep Grand Cherokee

No fire to the spark plugs,,,no fire from the coil to plugs . engine was running good ,,,then died on the highway,,,,wont start,,,,does not fire,,,,no fire to the coil,,,,,is there an ignitor box or computor box on a metro,, ?


Timing belt lossen top bolts on cover pry slightly to check belt\015\012Bad news is these are interface motors meaning when the belt fails its almost always catastrophic...... ... 1993 Geo Metro

I have a 1984 mazda rx-7 it has a new distributer cap,a new rotor button, new plug wires ,new spark plugs and 2 new coils, the coils are firing through to the rotor button inside the distibuter cap,the engine block does have a perfect ground,but i cannot get fire to go through the spark plug wires to the spark plugs.


Bad cap ???? ... 1984 Mazda RX-7

I have an 89 k3500 454 tbi not getting fire to plugs. have fire to and from coil, aldo has new coil ignition module ingnition switch distributor cap rotor button distibutor and starter. but no fire to plugs


Pulled this out of a dark spot in my mind... check that the coil mount screws have not pushed through to the inside of the cap causing an internal short, pulling spark to ground. if distributor is new pickup coil should be ok but check for broken wir ... 1989 Chevrolet K3500

1999 Lincoln continental starting problems it will turn really fast like it wants to start but no fire is getting to the spark plugs and it is not back firing. change the spark plugs and the boots but not the coil pack's done the value cover gasket. run and engine diagnois said miss fire in cyclinder 4 coil pack looks bad could it be the timing change


No timing has not changed i would try crank sensor ,and change number 4 plug and coil pack ... 1999 Lincoln Continental

My 94 Ranger 2.3L 4 cylinder would occasionally loose power when I was driving. Then it would start running fine again. It finally got a little worse, where I could stop when it was running rough so I could check it out. I put an inductive timing light on the plug wires. On the front coil 1 & 4 were firing while 2 & 3 weren't. On the back coil 2, 3, & 4 weren't firing. When it was running ok, all 4 were firing on the front coil, but on the back coil 3 & 4 still weren't firing. I'm not sure if th


If the hi-tension wires check out ok you may want to check on the distributor and the contacts at its end and in the inside. You may also want to test the ignition coil. ... 1994 Ford Ranger Supercab

Have a 2003 pt criuser ,keep getting a po351 changed coil , spark plug wires ran check on coil and plug wires and plugs everything firing fine. rough idle no power rpm slow about rising


... 2003 Chrysler PT Cruiser Base

Have ford 1997 f-250 change 4 plugs and 4 coils and boots. notice that one of the orginal coil packs has a differnt part number than the remaining eight and with the new coil packs and plugs my engine is still miss fireing and bucking. question could it be that the different number coil pack from the orginal parts (which was on plug one) be require to be the same as orginal. got coil packs from NAPA


... 1997 Ford F250 SuperCab

86 ford bronco 2 no fire to the coil wires that plug into the coil so no fire


This is either a wiring loom issue or a ECU issue. ... 1986 Ford Bronco II

Toyota pickup 94 model cant get spark plugs 2 fire replaced pickup coil igniter rotor buton wires cap coil fires plugs wont


I had to replace the magnetic pick-up sensor on the side of the distributor that tells the coil when to fire on my 86 truck. It was $80 and slips onto the distributor held on by the cap. ... 1994 Toyota Pickup

There is no power going to the dist cap. I put a new coil in but this did not fix it. The spark plugs will not fire. Everything works but the plugs will not fire. The engine just turns. Ichecked the wires leading to the coil and the dist cap but there's no power leading to neither one, There are no blown fuses, the fuel pump works fine.


U have a power wire that has been breached ur gonna have to check continuity to ur power wire at the coil and dist hook one lead to the fuse that supplies power and other lead to to same circuit under hood at coil repeat step with all wires on coil ... 1992 Plymouth Voyager

Can not start 2000 Kia Sportage with 161 K Miles. Engine overheated due to head gasket failure. Replaced Head Gasket, new Timing Belt, Spark Plugs (Gapped to 1 mm). Only thing I can not fix easily is Ignition coil wiring plugs (white plastic - cracked badly), which I may try to hard wire & insulate directly as best as possible. Found 12V power on fwd coil wires during prelim voltage check ? Engine trys to fire, but won't catch, and has back fired twice? Found differences in Kia manua


Its bed time here in this time zone so as i think you have checked everything ,plugs i would set to 25th ,timing mark is on the flywheel i think ,take no1 plug out and bring it round to TDC so the piston is at the top,remove the rocker cover and chec ... 2000 Kia Sportage

Will not start after rain or snow replaced coil wires plugs rotor cap and button about the same time this past yr doing the same thing again crnks coil fires plugs do not appear to be firing ????????


Im having same problem this morning i found water setting on the base of my fuel flow meter not much on dist cap also noticed water came in from seal at the backof the hood , i blew water out of that base with is under the trottle cover then ... 2000 Chevrolet Silverado 1500

I have a 2002 ford taurus SE, coil pack has been replaced because Advanced Auto ran a diagnostic and said my coil pack was bad. Well its not and im still not getting fire on #3 and #4 spark plugs. changed the plugs and checked the wires. Could it be crankshaft sensor, which im guessing would fire all not some, camshaft sensor but that regulates fuel, a break in wiring harness but is it common or should i look towards EEC(pcm)?


... 2002 Ford Taurus

I have replaced the ignition coil, rotary button, and coil but still am not getting no fire to Plugs. What else could it be? Engine turns over but no spark on top of the coil where plug wire connects not at any of plugs. Thanks...


If you have the tools, remove the ignition control module (inside the distributor). You can bring it down to AUTO-ZONE and they will test it for free. Other stores may be able to do it too. Is this issue constant, when does it happen? Check the fuse ... 1989 Chevrolet C1500

My 1993 jeep cherokee grand cherokee lerado 4x4 4.0 straight 6 is not firing i change coil ,pickup firing coil,check crank sensor position it good.i cant get a reading from my ecu.im getting a hot to all not getting a fire thru the coil and distruber to spark plugs.


Have you checked all your fuses and also rotate the ASD relay. \015\012\015\012Have you sprayed brake cleaner into the throttle to see if it fires to verify this is positively an igniton related issue. \015\012\015\012Have you ... 1995 Jeep Grand Cherokee

2006 expedition 5.4 2wd had a bad miss fire replced plugs had same miss had put on machine and was told coil 1 thru 4 is miss fireing replaced coils with motocraft coils now does not want to start and if does still has miss fire


... 2006 Ford Expedition

1990 camry 4cyl. motor turns over but will not start. has 105,000 miles on it. I have pulled the plugs out and they are firing. Gas tank is full. Have unplugged and reconnected all connections for the electrical portion of the distributor. If the coil was bad would it still be firing or could it be a weak firing to the plugs, I have replaced the spark plugs and am just puzzled to what it could be please Help


Generally coils either fire or they dont fire. when cranking the engine be sure you rocker arms are moving. to see if your timing belt is not broke or stripped. hope2help shack ... 1989 Toyota Camry

No fire my sons 86 325e has no fire have checked cap rotor coil cleaned reference sensors,i even bought new reference sensor and with the #1 plug out checking fire it fired and started we shut it off put plug back and hasent fired again please help.


Check main relay ... 1991 BMW 3 Series

I have a 1981 K20 chevrolet 4x4 Pickup with a 350 engine. The engine will not fire. No spark. I have replaced the coil, pickup coil, condenser,cap and rotor button. I did install the ground strap from the coil. It still will not fire. I am getting voltage to the coil thru a pink wire which plugs to the battery wire terminal on the distributor cap. What else to do? My e-mail is Jcc1921 @email.com. Help...


Have the ignition module checked. It it in the distributor under the rotor, if it is hei, it held on by 2 small screws ... 1983 Chevrolet K2500

I have a 1991 Dodge Stealth, non turbo, dual overhead cam. I have a misfire. I have replaced emc, all 3 coils, ignition module, new plugs and wires. I am getting fire TO my center coil but not FROM my center coil. I can switch any coil to the center spot and its always that center position thats recieving but not sending fire. It seems to run good most days for about 5 miles before it starts misfiring but other times its right from the start. What could be wrong with my car? Could it be a ground


... 1991 Dodge Stealth

2001 ford windstar-new coil pack,new spark plugs and new wires....same problem. cyl. 3 & 4 not firing. Plugs good wires good. Getting signal from comp. to coil, 2nd coil pack. No corrorion on wire connections on comp. or coil. Were do I go next?


Head gasket?? blowing between two cylinders ... 2001 Ford Windstar
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0082 seconds