Having problems with your 1999 Chevrolet Lumina ?

1994 3.1 6 cylinder pops back thru intake need correct firing order.

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Here is the firing order for that engine.
\015\012
\015\012
1472bda.gif
Repair Help & Product Troubleshooting for 1999 Chevrolet Lumina

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1994 3.1 6 cylinder pops back thru intake need correct firing order.


Here is the firing order for that engine.\015\012\015\012 ... 1999 Chevrolet Lumina

Truck is not firing on 3 cylinders yet it runs.. Runs really rough, back fires, under powered.. Plugs are Wet, Firing order is correct. New Spark plug cables. Don't know that is wrong! Please Help


Check for spark at the plug ( may have coil problem).If spark is good then do a compression check. Pressure shouldn't be less than 75% of known good cylinders. ... 1995 Dodge Dakota

Firing diagram order for oldsmobile 3.1,v-6,need order from coil pack to each plug correct from front to back need to know if plugs in front number and the one near the firewall number and if they go


Here is the diagram. Hope it works. ... Oldsmobile Alero

How to change out ignition coils? Pictures included. I need to know what the cylinder firing order is and the number locations for the ignition coils 1 thru 6. I have a misfire code on my #1 cylinder which is in need of a plug and ignition coil.


... 2000 Lexus RX 300

Need firing order for bmw z3 four cylinder. do not know which way two of the wires go; they are both the same length and do not seem to fit well either way I put them. What is the correct firing order?


For the 1996 Z3 Roadster 1.9L DOHC In-Line 4-Cylinder:\015\012Firing Order:\015\0121 - 3 - 4 - 2\015\012Cylinders:\015\012(back)\015\012|..4.. ... 1996 BMW Z3 Roadster

We did a tune up on our 1994 Ford Aerostar sport van 3.0 6 cylinder but the ignition wires that go into the distributor cap won't stay in they popped off and now we need to know the firing order and why would they pop off the distributor cap


... 1994 Ford Aerostar Extended

Replaced distributor cap and need to know thr correct order to put wires back, 1996 gmc Sierra truck 4.3l, this would be th firing order?


Please contact me at [email protected] or call 800-382-7717 ask for jason in parts. I will need the last 8 of the VIN. ... 1993 Chevrolet S-10 Blazer

I have a 1989 L300 4g63 8 valve van and need to know the firing order so i can figure out how to put the distributor back in properly with the number one cylinder anyone know the firiong order please? this is non turbo


... Mitsubishi Galant

Back firing thru intake, tune up done-new plugs, wires,cap and rotor. timing good, firing order good... 5.8l efi


Check your plug wires again and check the cap and rotor sounds like either a bad cap and rotor or a couple wires backwards ... 1992 Ford F150 SuperCab

Engine back firing. need to see a diagram of the firing order of a 1992 ford f150 inline 6 cylinder


Hi,\015\012 1-4-2-5-3-6\015\012Hope this helps... Good luck! ... 1992 Ford F150 SuperCab

I need to check the firing order of the 96 mazda protege. Someboby tinkered with my the spark plug wiring on my daughter's car and now it's skipping and popping. I think it's missing because "somebody" did not replace wires in correct order.


... Mazda Protege

I need the firing order for a 2004 3.9L V6 showing the correct coil hookup, to the spark plugs. the one I have is still incorrect. "The car still has no power, and back fires." Please help if you can . (This is for my mother.) thank you.


For 2004 Ford 3.9 liter V-6 VIN "6" check this...Hope helps. ... Ford Freestar

I just need to find out the firing order to put these back on the distributor cap correctly


Http://boxwrench.net/specs/chevy_sb.htm ... Chevrolet 1500

Periodically firing while trying to cold start, finally started running but barely at at idle. Pumping throttle slowly increased RPM , but was popping back thru the intake. AFter a few minutes, rev it up-but ran really rough. Shut off, pulled plugs and they were sooted over. Later-restarted, after cleaning plugs-seemed to run better but overheated exhaust pipe to glowing red.


Catalytic convertor clogged more than likely.. Muffler shop can test back pressure. ... 1986 Audi 5000 CS

I just replaced the intake gaskets on a 2000 olds bravada because of leaking antifreeze it ran fine before the distributor was put back in the correct position but the center and rear plug are not firing they have good spark but it seems like i'm not getting fuel to the two cylinders could this be something to do with the spyder fuel lines i did separate to upper and lower to replace all gaskets could it be something i did


... 2000 Oldsmobile Bravada

I need the corect firing order for my car the diagrams i have been given are not the right ones my coil pack is numberd 632514 the front of my engine is in the front of the car and the back is at the back you know 3 spark plugs at the front and 3 at the back by the fire wall i need to know what one is what one i am verry frustraited with this thing and its cold


You do not say what size eng you have so I can not tell you the firing order. The firing order is usually staped on the intake manifold. ... 1988 Oldsmobile Delta 88

I need some explanation on the firing order on the spark plugs and how to properly install them. Because my husband changed them out and now the van starts but won't turn over and go! I have the same problem . I know the firing order 165432 blazer zr2 2002 v6 but I would like to know how to place the wires on the distibutor also we have removed the distributor and I need to know the piston # one is tdc but know what to do with the distributor so I can get it back working thanks Dan


Your plug num,bers should be on the cap. ... 2002 Chevrolet Blazer

I need a diagram showing the firing order on a 1999 V8 4.6 LITER Land Rover engine with coil packs, the problem is that some guy was changing the spark plug cables but all at once and he did not mark whick one was for each cylinder and now the car is misfiring. I need to know how the cables are installed or what order do they have for each of the 8 cylinders. Thanks


1999 Land Rover 4.6 liter V-8Hope this help (remember comment and rated this). ... 1999 Land Rover Range Rover

My car has a misfire on one of the plugs and i need the firing order cause its either cylinder one or two i just need the picture diagram of the firing order


Firing Order 1-2-3-4-5-6 \015\012\015\0121-3-5 is the right side\015\0122-4-6 is the left side (driver side) ... 1990 Nissan 300ZX

Replaced fuel pump. module/coil, new fuel filter, getting spark, but back fires through engine exchaust. firing order of plugs correct, But after priming engine throttle with ether, car only back fires and wont start. Cant seem to get engine to fire or get gas to the engine


Sorry but you have a timing problem,recheck the fireing order because that what is causing the backfire through the exhaust i think you are nearly there stop useing ether it will blow the head of the engine or blow a piston out through the engine tak ... Buick LeSabre

I have an 84 Firebird 2.8L V6. Some of the spark plug wires were taken out of it without me knowing, and then put back on in the wrong order. While trying to fix it, the cap got twisted around, and now everything is out of order and un aligned. I need to know the Engine firing order, the distributor cap firing order, what position the rotor should be pointing under the cap, and I have 3 notches on the harmonic balancer for TDC, the previous owner has highlighted them, two in white, one in green,


84 firebird 2.8L ... 1984 Pontiac Firebird

I need the cylinder ordering for a 99 chrysler concorde LXI 3.2L: Check engine code: cylinder 4 miss fire Q: which is cylinder 4??? the entire order list would be appreciated! thanks so much if any one knows.


Hope this helps ... 1999 Chrysler Concorde

I have a 1991 5.7 we have a wierd problem. At idle 8,3,5,2 cylinders will not fire(header tubes not getting hot) Increase the idle to say 1500 or so they fire up . We have checked compression, valves, new distributor, new intake and carb (both Eldlebrock), double checked the firing order...just wierd that everyother cylinder appears dead at idle.It does have a mild cam, could that have something to do with it. Thanks Carl


Okay, a mild cam can cuase this effect, you will need to make sure the timing is also set for this type of cam, these are not idling cams they will run a little rough at idle and also check your vacuum readings, is this a good cam for this engine? if ... 1991 Chevrolet K1500

Distributor problems?? I installed an accel distributor in my truck, found it was not compatible with computer for fuel injection. So, I went back to stock. I installed it found TDC aligned timing back to 0 noted the location of the distributor cap for number one firing position and connected wires in a clockwise fashion in the right firing order. Truck will not fire off now, I repeated the same steps three or more times, nothing. Any ideas?????


Are you certain you were on TDC of compression stroke? If you were on exhaust stroke, your dist. will be 180 degrees off.If timing is right, check for spark. You need to see a blue snapping spark at the end of the sparkplug wire to know ignitio ... 1989 Chevrolet Silverado 2500

I have a 2004 Jeep wrangler with 4.0 L eng. I have popping through through the intake - After looking over the engine I found cyl 3 had bad lobe on intake. Lifter had hole in bottom. Replaced cam, lifters, timing chain, had head tested and milled .006 - machine shop disassembled head and determined it did not need a valve job. - I thought for sure I found it the problem. On putting back together I still get popping through intake. Now what? I am stuck. All I can think of it coil pack but I


Best way to find what cylinder is in question is to unplug one injector at a time to see which one makes the popping less or all together gone. \015\012Then your going to have to do a compression and a leak down test. Should do this on a warme ... Jeep Wrangler
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.7728 seconds