Having problems with your 1999 Chevrolet K1500 ?

4 wheel drive grinds when i put it in gear 98 k1500

\015 Grinds when put it in gear moving, but goes in gear while in park\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1999 Chevrolet K1500

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

4 wheel drive grinds when i put it in gear 98 k1500


... 1999 Chevrolet K1500

My 93 Wagoneer is 4WD all time. Pulled into town doing about 35mph and heard a loud knock. It would do it a few seconds after taking off from a stop and when It would try to shift. Before I could get where I was going it quit alltogether. I had nothing in 4 wheel high. Even if you put it in Park it will still roll. 4 wheel low works just fine but now in 4 wheel high when you put it in gear (reverse, drive and lower gears) it make a spinning grinding noise sometimes it will stop if you put it in


Sounds like the fluid coupler inside the transfer case failed. In my opinion using those is a great ideaon paper but they just do not last as well as the older direct engagement units used in Cherokees and wranglers. I own many Jeeps and will n ... 1993 Jeep Grand Wagoneer

Went to the store came out started the car pushed on thebrake to put it in gear heard grinding sound and car just rolled backwards. will not get any gears, it is an automatic too.02 passat front wheel drive. when i try to put it into park it grinds then stops. i also have to use the e brake to park it.


... Volkswagen Passat

Have 1996 jeep grand cherokee larado with chrysler 318 engine and auto transmission, all the time four wheel drive with I believe to be a NP249 transfer case...have not used the low gear range for years....just never needed it....now went to use it and could hardly get shifter to move....finally got it to move to low position, but when put from neutral to drive, hear hear grinding in transfer case like it is not going all the way into gear...one time it did go into gear and it drove in low range


... 1996 Jeep Grand Cherokee

Hi I have a navara d 23 and when I put into 4 wheel drive it feels very unstable on front end like the power distribution is wrong not that it pulls to 1 side but more flicking from 1 side to another . There's no noise from gear box grinding or otherwise and it takes ages to get it to come out Of 4 wheel drive once I pt the lever back into original position ! Thought might be a sensor issue As was fine 1 day not the next any ideas ??? Cheers dan


... Nissan Pickup

I have a chevy pick-up truck the year 1995 Z71. I put the truck in 4x4 high for the first time this year and did not get a light near the gear lever nor did it go into 4 wheel drive. I check the transfer case with it in neutral and the front shaft would turn freely, then put it in 4 wheel high and it would not turn. I also drove the truck on dry pavement with the 4 wheel drive high gear and 4 wheel drive low gear and had no bucking of the front end when I made turns in a parking lot. Any ideas


The accuater on the frontend is out ... 1994 Chevrolet C1500

Question about a 2005 F150 when shifting into 4 wheel drive it sometimes does not go in then all of a sudden it bangs in. when i take it out of 4 wheel you can hear what sound like gears grinding untill you put it back in 4 wheel what could it be


I would say the IWE ( Integrated Wheel Ends ) solenoid is causing you a problem.The 04-06 MY trucks have a TSB on the IWE solenoid, where water can be ingested into the vacuum lines to the IWEs.http://my.voyager.net/~sscully/file_t ... 2005 Ford F-150

Shift solenoid im pretty sure the shift solenoid is screwed in my 97 jimmy 4x4, is there any way i can change the solenoid or do i have to cheage the whole transmission? The jimmy i am looking at is a 95 4 wheel drive.. all gears work, no slipping or grinding or any odd sounds of any kind. what is the problem is that you can be driving along and it will just go into neutral. If you shut the truck completely off and restart an put it back in drive it works great again for few minutes an then poo


You can change the solenoids you should be able to drop the tranny pan and they are right there but you might want to unbolt the cross member that holds the tranny up so the pan comes down easier or you chance breaking the solenoids if you try to for ... 1997 GMC Jimmy

I have a '91 Jimmy and when I am in 2 wheel drive I hear a rattling and slight grinding noise. I believe its from the transfer case. I used to hear this noise after coming out of 4 wheel drive, but then it went away. Now the noise is back, but isn't there if I am in 4 wheel drive. Is there a gear that's rubbing inside the case when I am in 2 wheel drive? Could the gear be slipping into 4 wheel drive? Whats keeping it from slipping into 4 wheel drive? Will adjusting the 2-4 wheel drive lever fix


... GMC Jimmy

I recieved a grinding noise when I tried to put my wrangler in reverse when I was in low 4 wheel drive. I didn't force it in gear because I wasn't sure you can use revrese in that gear.


You can all it means is the 4x4 driver at the time was not all the way locked in ... 1998 Jeep Wrangler

4 wheel drive grinds when i put it in gear while moving, but goes in gear in park


It is only suppose to go in 4 wheel when in park. when it is in drive the transfere case is spinning ,and it will damage it ... 1999 Chevrolet K1500

My 1996 Audi A6 Quattro with automatic transmission makes a loud grinding noise when (after driving) I try to put the transmission into Park. The grinding is also in Neutral. The other gears also seem to operate normally. The steering wheel does not lock when the car is turned off in Park. Consequently, the key cannot be removed. Any ideas?


Hi! THe grinding noise will surely be inside the transmission. I strongly suggest that you have it look at by your trusted mechanic for theres a big possibility that it's grinding inside. Im pretty sure that metal dusts from the grinding transmission ... 1996 Audi A6

I am having several problems with my 93 Grand Cherokee Laredo 4 wheel all the time. First, every time I drive, it seems like it slips out of 4 wheel drive high into neutral, then we have to come to a stop put the regular shifter into neutral then put the gear for all wheel drive back into gear. Do we need a new transfer case? second problem we are having: my computerized panel that tells you when something needs filled, only comes on sometime and when it does stay on it lights up a section near


On your first problem, I would say the transfer case is gonna need some work if not totally rebuilt. You may try checking the fluid in the transfer case to start with. If it is low, the transfer case could be overheating and causing it to jump out ... 1993 Jeep Grand Cherokee

My four wheel drive doesnt work in my 87 s10 blazer , like when i put it in park to put it in gear the shifter on the floor goes into gear but the four wheel drive doesnt turn on ? is there any fuses or anything that need to kick on the front axles ?and when i drive my light on my shifter says its in 4 wheel low but obviously its not going like 65 to 70 mph i dont know whats wrong with it and its really bothering me


Sounds like either a fuse or the do u have locking hubs that need to be engaged also when using 4 wheel drive there is actually only 2 wheels turning usually passenger front and driver back sometimes u also have to drive backwards to engage and also ... 1987 Chevrolet S-10 Pickup

My 2002 Jeep Wrangler X works great in 2 wheel drive and 4 low. 4 high grinds from time to time and causes a loss of power to all wheels. If i put it on 4 low first, 4 high seems to do alright. But when I put it back in 2 wheel drive and back into 4 high, it grinds again. Gotta go to 4 low first every time. Is this a new tranmission I am looking at?


No your tranny is most likely ok. I would be looking at the transfer case. ... 1995 Jeep Wrangler

95 wrangler won't shift into gear when first starts unless you play with the shifter for awhile, doesn't grind if forced into gear. After you put it in gear and drive it does just fine, but if you just put it in gear and don't drive but put it back in neutral it won't go back into gear unless you play with the shifter again.


Loose Shift FORK (INTERNAL) ... 1995 Jeep Wrangler

My 98 chevy silverado 3500 gears grind when trying to put it into 4 wheel drive


Check the transfer case ... Cars & Trucks

I have a 2001 dodge ram 1500 5.2 liter 318, it has 148k miles and has run like a dream for the five years i have owned it and out of no where my reverse gear has no power, drive, park, 2nd, and 1st work fine but when i put it in reverse i can hear it shift to reverse but wont move, no grinding or slipping, i lifted the rear and did same thing and it will definetly shift to reverse and it spins the wheels but when its down on ground the weight of the truck keeps it from actually moving, its almo


You could remove the valve body and clean\015\012You will not see anything at all by looking\015\012You will need a diagram of where the check balls go,because your upside down,with the case facing down.\015\012You will need to put ... Dodge Ram 1500

I have a 2000 Frontier V6 Auto Crew 4x4 with an odd 4x4 issue. When using reverse, the transmission makes a quiet popping noise both when turning or going straight back. When I put it into drive, add accelerate above 25mph, there is a gear grinding noise that worsens when speed increases. If I place the truck into 4x4 while driving, it will make a large thunk, the grinding will stop, and I can put it back into 2wd and no grinding till I put in in park or reverse. Any ideas?


... Cars & Trucks

97 ford taurus is slipping in first .it tries to go but losses it drive the more gas i give .and sometimes it will **** in first as i give it gas. sometimes i can put it in low gear and it drive then i put in regular gear and it drives fine once it catches second gear ..sometimes when i come to a stop it will make a grinding sound


Sounds like you are low on fluid if not then it's time for AAMCO to take a look ... 1997 Ford Taurus

I have a 2001 Jeep Cherokee XJ automatic. The transfer case is slipping when I put the Jeep into 4 wheel drive. The 4 wheel drive works for awhile and then it slips and the Jeep acts like it is in neutral. I have to put it back into 2 wheel drive before the Jeep goes back into gear.


... 2001 Jeep Grand Cherokee

Used my 4 wheel drive 2 get out of a mud puddle and when i put it back into normal drive it seemed as if it slipped out of gear. I could not get the 4 wheel drive shifter to engage back into normal drive gears. It will only drive in 4 high.


Try reversing the car 2or3 times then go forward and try the box and see if it stays in then.\015\012Let me know how you go Ron ... 1996 Chevrolet Blazer

GMC '91 Jimmy, Transfer case. When in two wheel drive I hear a slight grinding noise and rattling noise. When in 4 wheel no noise. 330,000 miles, could something be worn? What keeps the transfer case gear from slipping into 4 wheel drive? I know that I have to back up to change from 4 wheel to 2 wheel. Transfer case lever shifted all the way forward to 2 wheel drive. What ever keeps the transfer case in 2 wheel drive could be worn? Thanks.


Yeah your right about waer but you might be blaming the wrong part. With the truck up on jack stands ( all wheels off the ground) have a helper drive the truck at the speeds that make the most noise you'll find it in the front axel or fround U join ... 1991 GMC S-15 Jimmy

Grinding noise from behind the dash. The noise sounds like it is related to the tachometer. I have a 2004 Suburban with the Stabilitrak system where it is in All wheel drive all the time (no 2H only All wheel drive or 4L). The noise only happens when the vehicle is cold (below 40 degrees out) and then only when you turn to the right. I think the problem may be related to some type of wheel speed/engine rpm sensor to determine wheel slip. The noise sounds like two plasting gears grinding tog


No idea what the problem is either. I have a 04' LT that started doing it as well. Doesnt matter hot or cold, does it randomly. Usually when I come to a fast stop then resume speed its sounds like grinding in the dash and while hitting the gas I get ... 2004 Chevrolet Suburban

2001 Mitsubishi Eclipse 6 cyl Front Wheel Drive Automatic 87000 miles 2001 Mit. Eclipse GT auto. tran. w/ sport shift. Without any previous symptoms, the trans. stop putting power to the wheels. While driving in ''D'', the rpm's went up and I was coasting. No gears work (D or R). It sounds and feels as if it is trying to go into gear, but only rev.s up, no power to the wheels. It will shift into ''N'' because I can push it. Any ideas since no earlier symptoms? Clogged trans. filter? Some hose di


... 2001 Mitsubishi Eclipse
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.3979 seconds