Having problems with your 1999 BMW 328 Series ?

Transmission stuck in failsafe mode 1997 bmw 328i

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1999 BMW 328 Series

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Transmission stuck in failsafe mode 1997 bmw 328i


... 1999 BMW 328 Series

I have a 2003 BMW Alpina B10 8S the transmission is stuck in the failsafe mode which keeps it in 3 gear. I think it's a sensor or transducer that may be involved, the dealer says I need to replace the transmission which I doubt. This problem started after I had the engine bay washed with a power washer. Any Suggistions?


Hi,\015\012Water is most likely sitting in the connector at the front of your transmission sump(oil pan) and shorting the pins together. Just unplug the connectors and blow out the water, use some contactcleaner spray on the terminals and blow ... 2003 BMW M5

I have a 2003 BMW Alpina B10 8S that has the transmission in failsafe mode the service center wants to replace the transmission but I believe they have not checked the sensors advice please!


... 2011 BMW ALPINA B7

My 2000 E 430 Mercedes Benz has been stuck in park since yesterday when I spilt a soda in center console and when I stick a pen and bi pass the locking mechanism it stays in first gear and will not shift. Iv been told it went into safe mode because it got wet. How do I get it off safe mode because before that happened I had 0 problems with my transmission. HELP!!!


Oh thats bad I have seen this before the gearbox control module is located directly under were you spilt your soda there is no reset sorry you have shorted the module and will need to replace it ... 2000 Mercedes-Benz E-Class

My bmw x5 2004 has transmission failsafe prog error code and is stuck in 3rd gear whether automatic or switched to manual shifting. cant go down to 2nd or 1st gear, or upwards to 4th, 5th, 6th. A di


... Cars & Trucks

My bmw x5 2004 has transmission failsafe prog error code and is stuck in 3rd gear whether automatic or switched to manual shifting. cant go down to 2nd or 1st gear, or upwards to 4th, 5th, 6th. A di


... Cars & Trucks

1987 bmw 635csi transmission stuck in limp mode


... BMW 6 Series

My bmw 735i is stuck in limp home mode, had it diagnosed but were unable to get into the transmission ecu. havent got a clue what could be wrong. the speedo also does not work along with the rev gauge and the petrol gauge. do you have any ideas please?


... BMW 750

Transmission failsafe i'm getting transmission failsafe warning in my 730d bmw 2003 can u helo thanks


... Cars & Trucks

VAN IS STUCK IN 2ND OR "LIMP MODE". I HAD SCANED. IT GAVE ME CODE PO888 & PO700. THE PO888 WAS A TRANSMISSION RELAY, CHANGED IT DID NOT WORK, STILL STUCK IN 2ND. I TOOK IT AND HAD THE COMPUTER & TRANSMISSION SOFTWARE FLASHED & REPROGRAMED, DID NOT WORK.


... 2005 Dodge Caravan

How much does a 2003 Kia Sedona wiper transmission cost to repair? Intermit wiper mode does not work. Wipers gets stuck in up position. Regular speed of wipers work fine when moving consistently. But when in intermit mode, wipers get stuck.


There are several for sale on ebay for $50.00 ... 2003 Kia Sedona

My 1992 dodge stealth has locked transmission into failsafe mode. only fwdgeer is 2nd. how do i test trans to find out problem? or how do i get it out of failsafe mode?


... 1991 Dodge Stealth

My 1998 BMW 328i the transmission is in a lower gear.


Hello.\015\012\015\012My first solution would be to change the transmission oil. ... 1999 BMW 328 Series

2007/2008 Winnabago - View Sprinter Mercedes Chassis and Drivetrain. Stuck on trip with the shift lever stuck in low gear and transmission not shifting. It sticks in park unless you release it by pressing a button below the shifter, then it is stuck only in low gear. It runs as if it is in some form of "lock out" and only runs in a "cripple mode".  Just stopped for a fill-up and couldn't get it out of park, then found the button but can't get it to shift.


Check and see if the brake lights are working.....and you need the key on for this....there is a shift interlock tied into the brake switch....if they are not working it will not release the shifter......it is also possible the shifter assembly itsel ... 2007 Dodge Sprinter

BMW E39 M5 transmission Disassemble. Hi guys i would like to get steb by step instruction to disassamble this transmission. My car is in transmission shop for one week now and they are stuck in place with no results. Thanks in advance, Dan


... 2001 BMW M5

1993 dodge caravan transmission stuck in limp mode,changed both sensors on transmission but no fix, is there a relay somewhere the transmission only has like 2000 miles on it


... Cars & Trucks

Our 1999 Mercury Villager is stuck in second gear. I have been told on the phone by a transmission shop that the van is stuck in limp mode.


... 1999 Mercury Villager

My BMW 325is transmission goes to limp mode when


... 1992 BMW 3 Series

Overdrive solenoid I have a 1999 hyundai sonata. The transmission is stuck in 2 or 3rd gear the fail-safe mode. Code p1723 popped up on the check engine code. Changed it and drove the car for about 20 miles and it went back into fail-safe mode. Check engine light came back on and not it's coming up as a bad overdrive solenoid. Is this an easy fix or should I just get a used tranny?


Its not that hard to fix, i did it my self on 3000gt. ... 1999 Hyundai Sonata

Driving @ 65mph the vehicle went into reduced power mode, like when the transmission usually goes out. It then stalled. The transmission had been noisy leading up to the stall. Pocket reader said 0 codes. It looks like the crankshaft position sensor is covered in smuck! What should I do next? Is it possible that the crankshaft position sensor is toast? How do I determine the state of the sensor?


Testing Crankshaft sensor:Method 1:Pull up the RPM reading and crank the engine over. Hold accelerator to \015\012floor to shut off fuel to the engine. No reading find the crank sensor, \015\012inspect for ... 2002 Saturn VUE

I have a 93 Nissan Altima (AT transmission) and while driving my car....sometimes the speed ometer stays on "0" and the RPM goes up while I have my foot on the gas and it sounds like it is stuck in first gear. Then after a minute or so it will shift over and the speed ometer will go to normal and you can hear the gear switch over & the car will also **** a little while it goes into the next gear. Does this sound like it needs a new transmission?


Speedometer failed when the cable is broken; if the gears wont egnage, its possible that you have any propblem in the Torque Converter or Solenoids. First try with mainenance and check fluids. ... 1993 Nissan Altima

Driving @ 65mph the vehicle went into reduced power mode, like when the transmission usually goes out. It then stalled. The transmission had been noisy leading up to the stall. Pocket reader said 0 codes. It looks like the crankshaft position sensor is covered in smuck! What should I do next? Is it possible that the crankshaft position sensor is toast? How do I determine the state of the sensor?


Testing Crankshaft sensor:Method 1:Pull up the RPM reading and crank the engine over. Hold accelerator to floor to shut off fuel to the engine. No reading find the crank sensor, inspect ... Saturn Vue

I got a BMW 318i e46 (1999). at first I lost reverse gear, and now I seem to have lost gear 1 & 2. My transmission has gone into limp mode (with the transmission light permanently on {!}.) What is the likely cause? And how do I fix it?


... BMW 318

Transmission failsafe i have a 1998 740il bmw transmission keeps going to failsafeand throws acode 106 speed sensor output what is my first step in fixin


BMW523i\012after replacing both fuel level senders for fuel gauge, on board computer shows trans failsafe appears from time to time. Can anyone help? ... 1997 BMW 7 Series

Transmission fault code "reverse solenoid fault" keeps me stuck in limp mode (stuck in third gear)keeps popping up! WHAT can cause this code to keep me in third gear???!!!! im a stay at home dad with 2 kids, 2 dogs, 2 turtles and a frickin stratus that satan himself refused! but its all we got for now so I HAVE TO MAKE IT WORK!!! please help me if I can find out the list of possible causes to make this reverse solenoid fault code happin i can find it and fix it and stop tearing thru gas and rp


The automatic transmissions of today's cars are electonically controlled by the ECM, when a problem arises the transmission will send a DTC (Diagnostic Trouble Code) to your ECM. You will need to take your car to a mechanic to test and replace the Re ... 1996 Dodge Stratus
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.7090 seconds