Having problems with your 1999 Audi A4 ?

Steering pump on Audi A4 1999

\015 Steering pump making noise when driving the vehicle\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1999 Audi A4

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Brought my audi a4 in to have the timing belt and water pump replaced and my car is now leaking power steering fluid and making loud noise, i was told when i took it back that the the powersteering fluid was low, they topped it off, it was fine until i drove it for a couple hours and the problem returned and my check engine light came on. had the fluid topped off again. can changing the timing belt and water pump damage the power steering pump/rack?


They may have loosened the power steering pump to take off the belt and not put it back right.\015\012They may have overtightened the belt which has worn the bearings out on the steering pump and made it start leaking from the bearings... ... 2004 Audi A4

I repaced my powersteering serpentine belt and power steering pump 3 months ago. today it was 32 below 0 C', I started my truck and all of the sudden no power steering I parked it the night before and it was fine no noise or whinning and in the morning the steering was stiff , and never inproved after 40 min drive .what do you think is wrong?


You have a leak fords are noritas for this although its a great disgin madza disgined this pump it works like a rotery engine and last for ever its likely the plastic resiveor had swolen and the seal is likely leaking. You could try putting fuild in ... 2000 Ford F150 Flareside SuperCab

Audi cabriolet 1996 2.6 v6 steering pump problem


... 1996 Audi Cabriolet

Which power steering pump for my 2.8 Ve Audi


... 1990 Audi Quattro

I have audi A8L 2004 4.2L. The car starts and after 30 sec. main fuel pump relay shuts off and pressure drops to 0 and engine shuts off. I'm auto technician, I checked circuits to main fuel pump relay and signal from ECM to relay is disapering after 30 sec. Car starts fine every time after shut off and every time it shuts off after 30 sec. Tell me what problem could it be or what I should check? Thank you. Sincerely Jerry


Could be an oveheated fuel pump! Extract the pump out from fuel reservoir and test it! ... Audi A8

I see bubbles in the power steering reservoir, of Audi A6 2003 because of which the steering is getting heavy & making noise, already changed the pump but its same.


... 2003 Audi A6

Change power steering pump on 98 audi a4 v6 - 1998 Audi A4


... 1998 Audi A4

How do i adjust power steering pump the belt is very loose causing the car to loose power steering at low speed?1992 audi 80 e


Slacken off the 3 bolts on the alternator and wedge a long screwdriver behind it to pull the belt tight.then do up the bolts and check tightness... ... 1992 Audi 80

Audi power steering pump location


Before you replace the pump, check the filter located inside the oil tank. This filter cleans the oil before going to pump. REMEMBER that Audi uses a special oil!!! Not your normal power steering fluid! Mixing them could cause damage to the entire sy ... 1999 Audi A6

Power steering pump replacement 1996 audi a4


... 1996 Audi A4

2004 audi a8L power steering pump change


... 2004 Audi A8

Steering pump on Audi A4 1999


... 1999 Audi A4

Whining steering pump audi tt


... 2001 Audi TT

Power steering pump replacement on audi 1998 a4 2.8


... Cars & Trucks

Show video for replace power steering pump of audi a4 2001


... 2001 Audi A4

Put in new power steering pump and the car still has a whining noise. 1997 Audi A4 2.8L


... Cars & Trucks

I was driving making a turn It felt like I lost control of car the steering wheel was hard to turn like locked up. had to put it in N and park it Audi a6 1996 I do need to change water pump but it was working I turn my key and the engine wont start.


Check the power steering fluid level and add fluid if it is low. Check to see if the steering rack is leaking. You can check it by removing the tie rod boots to see if fluid comes out. Make sure the belt is tight. If the pump works and no leaks, you ... Cars & Trucks

Where is the audi a4 2004 power steering pump location


... 1999 Audi A6

01 AUDI A8L FUEL PUMP,IT HOLDS 50PSI AS IT SOULD BUT THE PRESSURE DROPS TO 0 VERYQUICKLY WHEN IGNITIONIS TURNED OFF-I THINK IS THE PRESURRE CHECK VALVE, ...? IT STARTS VERY SLOWLY...IT CRANKS FOR FEW TIMES BEFORE IT STARTS, ONCE IS RUNNING IS OK!


The pressure should not drop more than about 5 psi max , u need a new pump, the built in pressure check valve is defective.. ... 2001 Audi A8

Audi power steering pump rplacment vidio - Cars & Trucks


... Cars & Trucks

Is it hard to change power steering pump in my 2001 audi a4 quattro


... 2001 Audi A4

Power steering 2000 yukon 5.3 broke shaft in steering pump, replaced pump had steering for about a week. lost power, replaced pump again, nothing replaced gear box(pitman arm also replaced due to play in it) still no power steering. there is some sort of electric control or sensor on the pump but I dont know what it does. does anyone know what would cause this? thanks


Blow that dang truck up ... 2000 GMC Yukon

I am trying to replace a power steering pump pulley on a 1998 Grand Marquis but noticed that the steering pump shaft does not have any threads therefore I cannot install Power Steering Pump Pulley Replacer T91P-3A733-A. The small diameter threads on the tool should be engaged in the power steering pump shaft. Do I need to have the pulley professionally pressed in?


On the 98 dodge caravan 3.0 power steering pump there are threads, on this pulley and is pulled by screwing the flange onto the center of the pulley. When you replace it you have to screw it back on, the shaft of the pump is smooth so make sure you g ... 1998 Mercury Grand Marquis

1993 mercury villager with growling power steering. it started after a power steering flush. mechanic has replaced power steering pump. can the pump output be looped back to itself without damaging the pump to isolate the problem to either the pump or the steering mechanism?


WELL YOU COULD PULL THE BELT TO SEE IF IT GOSE AWAY BUT ITS SOUND LIKE THEY DID SOMTHING RONG OR THEY RAN IT LOW OR SOMTHING IS NOT RIGHT WITH NEW PUMP SEAN THIS MANY TIMES IF THERE NOT BLEEDING IT RIGHT YOU CAN DAMAGE THE PUMP RIGHT AWAY SEEN DEARL ... Mercury Villager

I need to replace the o-ring that prevents power steering fluid from escaping from the power steering pressure hose of a 2003 ford windstar. When you change the power steering pump, as you take the hose out from the old pump a new o-ring must be installed because the old one will not be useful again. I'm trying to buy the o-ring but i no one knows where or how to get it. This o-ring goes into the power steering pressure hose, which goes into the power steering pump.


... Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.4649 seconds