Having problems with your 1998 Kia Sportage ?

2001 kia sportage where is crank shaft sensor located

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1998 Kia Sportage

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2001 kia sportage where is crank shaft sensor located

... 1998 Kia Sportage

98 2.0 engine on kia sportage where is the crank shaft sensor located at

... 1999 Kia Sportage

98 kia sportage with a 2.0 engine where is the crank shaft sensor located at

... 1998 Kia Sportage

Changing timing belt on a kia sportage 2002 having problems keepingthe top two pullys and the bottom crank shaft pully all three in line while putting the belt on. need some advice

... Cars & Trucks

Need to know where the crank shaft position sencer is on the motor of a 1999 kia sportage


How to bench test crank shaft sensor - Sportage Kia Cars & Trucks

... Kia Sportage

Have a '02 Kia Sportage, my crank sensor is bad, bad, bad.... How do I replace the css? And where is it located, and is there a picture showing it?

... Dodge Ram

Crank sensor on a 1996 kia sportage - 2000 Kia Sportage

... 2000 Kia Sportage

2002 kia sportage cam shaft - 2002 Kia Sportage

... 2002 Kia Sportage

Kia sportage Squealing in the drive shaft on 2001 Kia sportage thought it was breaks until i got under the car

Have you check you belts for proper adjustment. ... 2001 Kia Sportage

Hi Sir, Hope u will be fine, I have a problem with KIA Bongo and KIA Carnival both are CRDI and delphi, the under mentioned some codes please look these and advise me thanks Carnival VIN No. KNAMA75433S479100 P119 Inlet Metering Valve Control P1120 Electric Governer Mallfunctioning P0380 Glow Plug Heater Circuit P0382 Air Heater Relay 2 P0335 Crank Shaft Position Sensor KIA BONGO III VIN No. KN3HNP6N67K253964 P0102 MAF Circuit Low Input P0203 Injector Circuit open Cylinde

... Kia Sedona

I have a 1996 Kia Sportage. It cranks over, no fire, fuel pump won't kick on, and hand held scanner won't show any codes and nothing is stored in the computer's memory. The check engine light was on before it quit. Already changed the crank sensor, and then unplugged each sensor while cranking it over and the computer would not throw a code on none of them.

With given info, the computer might be bad, and if the problem is sensor related it would have a hard code stored in the computer, but if the computer is bad then it might not. ... 1996 Kia Sportage

How do i replace the bearings on drive shaft on a 2001 kia sportage

... 2001 Kia Sportage

My 98 kia sportage wont crank.

Http://www.kiatechinfo.com/index.asp\015\012\015\012Good source for Kia its free to register NO STRINGS ... 1998 Kia Sportage

Mt 1999 kia wont crank - 1999 Kia Sportage

Put a drop of fuel in the carb and see if mt1999 will fire ... 1999 Kia Sportage

I have a 97 kia sportage which overheated so i had the head done, it now will only run at an engine rpm over 900, the timing has been checked and double checked, and according to all information i have found, it's correct. using a scan tool i initially found only one code [ crank angle sensor ] which i replaced with no result. i also noticed that the ignition advance says its at 108 degrees BTC and it doesn't change while cranking. next time i tow started it the engine light came back on

It may be possible that there is a significant vacuum leak. Check all of the vacuum hoses for cracks or disconnection, or possible connection to the wrong sites. ... 1997 Kia Sportage

Hi Greg, its good to see on the net . Pls advice me how to timing my car Kia avella from Crank shaft to Cam shaft. Thank you

... 1997 Kia Avella

I have a starting problem with my 2001 Kia Sportage. In Aug 2008, sometimes it would start and other times it would crank but not start. I took it to a Kia dealer and he changed the feul pump, the relay, and the fuse. It started ok after that thru the whole winter, but when spring came it began having the same problem again. At first it would start only after the second try or third or fourth, then it got worse until it wouldn't start at all. Sometimes it would fire for about a few seconds and t

Correct. There is no further scope of troubleshooting. \015\012\015\012Thanks for contacting Fixya.\015\012Would appreciate if you rate Fixya. ... Kia Sportage

Locate crank shaft sensor 2003 kia sedona - Sedona Kia Cars & Trucks

... Kia Sedona

Rebuilt my 454 engine, installed distributor with rotor at 0 TDC on #1 cylinder. Engine ran fine but ses light was on. Code was P1345-- disagreement between cam sensor and crank sensor. Scanner showed anywhere from 19 to 25 degrees advanced. Rotated dist. shaft. to ****** timing. Wouldn't run. Tried two teeth positions in either direction from original setting. Ever have a sensor go bad. The crank sensor is new, cam (on distributor) is not.

The ignition timing is not adjusted with a timing light or with the engine running, and to set the ignition timing follow these procedures.There is a mark or notch on the distributor housing that the rotor should be pointing to when the e ... 1998 Chevrolet K2500

My cam shaft timming gear and my crank shaft timming gear dots line up and my harmonick balancer timming mark is on 0 which way should my rooter button face towards number 1 or towards rear of engine

The rotor should be pointing close to number 1, but keep in mind that the spark is actually supposed to happen before the piston gets to tdc so the rotor will be a little bit past the number 1 terminal when the crankshaft indicates that you're at tdc ... 1994 Chevrolet K1500

Replace crank shaft sensor on a kia carens 2 ltr diesel

... Kia Cars & Trucks

How do you fix crank shaft pully on 2005 Kia sorento

... Cars & Trucks

What would cause the coil packs and crank sensor not to have power and every thing else does on my 2001 kia sportage

... 2001 Kia Sportage

Where do i locate crank sensor kia sportage 2000cc manual (2005)

Yes go to www.yourfixcars.com or www.automecanico.com or www.autoelectronico.com and proceed according.God bless you ... Cars & Trucks
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0652 seconds