Having problems with your 1998 Honda Accord ?
How to replace burned out bulb behind heat and temperature controls\015 Simple question, the bulb behind my cold/hot temperature knob and display has burned out and I want to replace it and dont know how to get to it????\015
Repair Help & Product Troubleshooting for 1998 Honda Accord
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
How to replace burned out bulb behind heat and temperature controls
... 1998 Honda Accord
The A/T temp controller in the middle of the dash is where you change temperature fan speed etc. Looks like on the right hand side the back light is dimmer than the left side. I think one of the bulbs is burned out.I believe if you are careful the bulb might be replaceable but I'm not sure. Can you find out if these bulbs can be soldered in the board.The dealer says,"the whole unit needs to be replaced"(498.00)I understand that but I'm taking a chance that someone has already done this repair a
It can be done, but it's better to take it to a electronic shop to do the repair rather then your self. I had the LED screen on the radio go bad and did not now what station or time it was, the screen was dead and the dealer said the sam ... 2005 GMC Sierra
On a 2000 toyota camry the dash lights behind the 3 control knobs for the fan speed, themp control and area heat /cool are not on. the rest of the dash lights are fine. How do I remove the unit to replace the bulb, or bulbs?
... Toyota Camry
How do you replace the dashboard light bulbs on 1998 Toyota 4Runner? I number of bulbs have gone out, including the lighting behind the heater/AC control panel, with the exception of the actual AC button located at the bottom left of the panel, as well as the light for the automatic transmision gear shift. My wife has a 98 Toyota Camary and some of the bulbs are burned out on her dash as well. Thanks !
... 1998 Toyota 4Runner
How do you replace the light bulb behind the dual temperature heater control. only the passenger side lights up
... 2004 Chevrolet Impala
2006 chrysler 300. How do i replace light bulb behind the temperature control knobs?
... 2006 Chrysler 300
2007 Dodge Grand Caravan Some of the bulbs behind the dash heating system have burned out. How do I replace them
... 2007 Dodge Grand Caravan SXT Minivan
HI, I've got Corolla Verso 2006 T2 and I need to know how to take off central dashboard! I need to replace a light bulbs of heating controls which is behind the panel. does any one know, please tell me. Thanks
... 2005 Toyota Corolla
Is it difficult to remove dash to replace burnt out bulbs behind heating controls on 2003 chevy venture?
Nowdays a lot of the newer cars just have clips so it should pull out for the most part then you might have to use a philips to remove some screws from the control unit in order to get at the bulbs ... 1997 Chevrolet Venture
Replacing bulb behind temperature dial on 1998 honda accord
... 1998 Honda Accord
I need to replace my temperature control on Cirrus 2000. I lost the heat, it only blows cold air. How hard is it to change the control? It worked fine until we tried to reach for the cigarete lighter cable to see why the lighter is not working. One shop told me that I broke the lever behing the temparature controll, and that this is huge job to replace. They siad it may be up to $ 400.00 to fix it. The control it self cost only $ 7.00 --Help--
... 2000 Chrysler Cirrus
2005 toyota avalon heated seats dont work. This happened after rain leaked into the cabin, and there was an electrical burning smell from the area of the controls. I replaced the seat controller, and I see lights on the control panel, but the driver's seat does not get warm. Is there possibly an in-line fuse that could be burned out? The owner's manual does not say.
Either that, or check to make sure the ground wire to the heating element isn't corroded or broken. ... 2005 Toyota Avalon
Hello my repair problem on 89 lincoln town car is what... I HAVE REPLACED THE HEATER CONTROL VALVE, TEMPERATURE GAUGE, THERMOSTAT, REPLACED WITH STRAIGHT ANTIFREEZE, AND NO LINK FROM HEATERCORE AND THE AREA NEAR HEATERCORE IS WARM AND THE BLOWER BLOWS HEAT WHEN FIRST TURN ON CAR AND CONTINUE TO BLOW OUT COOL AIR AND ALSO REMOVED THE ELECTRICAL WIRE ON THE COMPRESSOR TO A/C TO SEE WHETHER THE IT WOULD BLOW HEAT STILL NO GO AND IT NOT RUNNING HOT NOW HOW CAN I RECIEVE HEAT ALSO CHECKED ALL VACCUMS
Never use straight antifreeze water is needed to give it its cooling properties at most the ratio should be 60/40 antifreeze / water. It sounds like a bad check valve locate and replace. ... 1989 Lincoln Town Car
1998 Jimmy with electrical controls for temperature. Replaced Themostat, Flushed heater core, replaced damaged vacuum lines. Vehicle produces heat to heater core but only luke warm interior temp. Rotated interior temp contol but no noticable change of temp. All dampers appear to be working. Checked elecrical current to temp control weak. Any ideas or a method to check temp control. Thanking you in advance.
Suggestion: see if the blend door opens or closes completely to allow all air through the heater core. To see the blend door moving, remove the panel that says "Cut here for service" under the hood along the firewall. I have a 99 Bravada where the ... 1998 GMC Jimmy
Light bulbs behind the 3 heater/ac controls
To get to these you need to remove the box above by taking out the rectangular screw cover at the back and take out the one screw. gain access to the edge of the box with a flat tool and gently pull the box clear from its clips. now the 2 retaining ... 2002 Honda CR-V
2000 jeep cherokee sport - a/c heat control fan stopped working - the blower resistor looked burned so I replaced it - no change - next I relaced the control module - no change - the two related fuses are fine - any suggestions on what I can check or replace next???
Replace fan motor it caused the resister to go out check fan speed switch on back plug in burned? u also should have a fan relay that could be bad ... 2000 Jeep Grand Cherokee
I have flushed heater core, replaced coolant temperature gauage,replaced thermostat, water pump, timing belt, flushed engine block, and radiator. Got a lot of brown sludge out of heater core and radiator. All is clean now and still using G012 coolant. Only get heat in Econ mode, no heat at all in Auto mode. I pressed recirc and econ and the only code shows up is 513 which is engine temp is too low and air control module is not correct. But I have resolved both of these. Pressing fan down,cold b
I envy people like you.You understand this car really well. I had this same issue with a car VW to be precise and until I took it to the dealership in Nigeria I couldn't get it fixed.You have done virtually everything any expe ... Volkswagen Passat
2 questions How do I replace light bulbs in steering wheel controls? Is there light bulbs behind heater controls? 2005 Lesabre
... 2005 Buick LeSabre
I have a 2003 Mazda B2300 pickup truck. A light bulb behind the tachometer on the instrument cluster (dashboard) is burned out. How do I get access to replacing the light bulb that is burned out?
... 2007 Mazda B2300
I have a '99 Solara and want to change the light bulbs that illuminate the three control knobs for heater,fan and directional. Does the front console panel snap on and off or are there some hidden screws? I did find two screws behind two knobs. I have replaced the bulbs behind the main instrument panel bt this may require more dash removal, is this correct? Steve
Correct. This panel is held on tightly and plastic interior pryors help. One it is started tho it will come off. Some control knobs come off too. The heaterr controller once out then needs to be taken apart carefully to reveal the little bulbs. These ... 1999 Toyota Camry Solara
How do I remove the buttons on the steering wheel of my 2004 Buick LeSabre Limited (the ones that control the radio and temperature)? I have lights burned out in some of them and would like to replace the lights (more than likely I'll have to solder them in, like I did with my HVAC control unit). If nothing else, I'd be able to replace the buttons myself and save a labor bill.
... 2004 Buick LeSabre
How do you replace the center console light bulbs on a 2004 toyota sienna (the bulbs that illuminate the fan controls, temperature contol, rear air control, etc)
... 2004 Toyota Sienna
I have a 2002 GMC Jimmy and I have no heat coming out of the vents. I just replaced the thermostat but that wasn't the problem. I felt the 2 hoses that go into the heater core and 1 hose is hot and 1 hose is cold. I figured it maybe the temperature control knob but also could be the heater core plugged up. Could you please help me and tell me how to find the cable for the temperature control under the hood? Thanks,Dean.
If 1 hose is hot and the other is cold you have a stopped up heater core.try back flushing the heater core.you can also pour draino into the heater core and let it sit for about 1 hour a then flush it out again and it should be ok.hope this helps. ... GMC Jimmy
I have a 93 lesabre. The air and heat controller has a mind of it's own. When a light is lit on the controller you have control of the functions. When no light is lit all you have control of is the temperature slide. I have replaced the controller and the new one (used)does the same thing. Does the air/heat have it's own computer and if it does...where is it located? thanks, Captain Jim
... 1993 Buick LeSabre
Cant find bulbs for heater/ac control panel. bulbs behind the fan switch died. dealership can't even identify. they appear to be screw-in replaceable bulbs on the circuit board. any ideas on the bulb number or vendor?
Try part # 5013829AA at your dealer. They are really proud of these, and want ~$6 each for them!!!! ... 2003 Dodge Grand Caravan AWD