Having problems with your 1998 Honda Accord ?

2000 honda accord 2.3L codes p0135 and p1399..after car is driven codes p0300 thru p0304 pop up..did a compression check and all good across the board. any suggestions

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1998 Honda Accord

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2000 honda accord 2.3L codes p0135 and p1399..after car is driven codes p0300 thru p0304 pop up..did a compression check and all good across the board. any suggestions


... 1998 Honda Accord

91 civic dx no spark. Checked fuses, all good. Checked ECU (Replaced). Checked coil, ohmed good. Checked ignitor, via parts store 8x, all passed. Checked continuity ECU->Distributor, good. Checked main relay, good. Checked Ignition switch, good. Forced spark through coil straight from battery by attaching 12v to positive, grounded negative and popped wire across terminal, produced small spark. Any thoughts?


... Cars & Trucks

My jeep starts then dies quickly. The security light does not work anymore either and the dash cluster does not work. This all started at same time and the jeep will not start and run....Any suggestions? I checked battery, it's good..and the fuses all have power across them and are good. I know all these functions are to fuse 7, but the fuse is good and has power across it..Thank you for your help


... 1998 Jeep Grand Cherokee

1995 chevy corsica. intermittentely won't start. checked fuel pressure & spark, both are present. cranks normally. Compression checks good. can hear "popping" in exhaust while accalerator is floored while trying to clear possible flooded condition.


The timming is off it possibly needs a new timming chain or the spark plug wires are on wrong ... 1995 Chevrolet Corsica

'93 Chevy C-1500 V6 4.3L w/TBI -stalls. I have changed distributor, cap, rotor, plugs, wires, coil, map sensor, fuel filter. Checked EGR, TPS, and fuel pumps a gallon every 2 minutes. No apparent vacuum leaks, battery and alternator good. Good compression on all 6. What suggestion would you have for me?


... Chevrolet C1500

Check Oil Pressure Shut Off Engine Reading keeps Popping up. Sometimes you drive it for an hour and it doesn't come on at all, other times it comes on in 5 min. drive time. Oil is clean and full. Had Compression test good. Mechanic said nothing is wrong with engine or head gasket. car 100%. Light never came on for him. Drove it today to sell the car and it came on?


It sounds like it could be the oil pressure sending unit it controls the gauge and that light You don;t say what you have for an engine in the vehicle but its usely located on gm in the back of engine behind the distubtor shaft ... 2003 Cadillac CTS

Flashing service engine light which according to the manual is a miss fire code. We are getting a miss fire on # 8 cyclinder and have run a compression check which is good. We replaced the coil pack on # 8 and it did not solve the problem. My mechanic thinks it is an injector problem and has suggested a service called "Motor Vac" which is supposed to clean the injectors. I have had this done before on other vehicles and it really makes a difference. Ron


... 2002 Chevrolet Tahoe

Have a 1991 Toyota 4-runner 4 cylinder 4WD and would and the check engine light has come on we recently changed the plugs and spark plugs compression is good and also changed the oil and air filter any suggestions? Would appreciate any advise from you! Email address is [email protected]


Two additional items causing the engine light to come on include bad O2 sensor and bad Exhaust Gass Regulator (ERG) valve. Good luck ... 1991 Toyota 4Runner

2003 Tahoe, 5.3 liter vortec flex fuel. Engine replaced at 60k miles due to low end knock (typical late model GM). Scanner shows mutiple misfires on all 8 cylinders and erratic timing. Rough idle. Everything replaced, knock sensors, ckp sensor, even the computer. Everything else tested, checks out fine, fuel pressure, oil pressure, compression all good, even the Chevy house can't figure it out. Any suggestions?


This is a comon problem on chevy 00-06 models a computer ground ,it seems ok at sight but inside it's just holding a few wires ,get under the car on the driver side passenger there you should find a two ground wire goin to the block a big, and a smal ... 2003 Chevrolet Tahoe

#1 cylinder misses but has good compression. I have changed the plugs, checked the injectors and even replaced the electric fuel pump. Is it more likely an electrical problem or mechanical? Suggestions on how to resolve or at least problem solve.


Check your plugwires. ... 1998 Jeep Cherokee

Have heavy whit smoke under throtle . good compression in all cylinders, done a block check no problems in radiator ,no water in oil, any suggestions


Head gasket or crack in block or headsThe white smoke is coolant & it has to becoming from somewhere & entering a cylinder,regardless of what testing has been done so far ... Cars & Trucks

P0304 alarm on my 2000 dodge neon and was running a little rough today. I checked the cam sensor and it has a good connection. I removed the battery to reset but after driving it came back on (but isn't running rough for now)..any suggestions


P0304 means cyl 4 misfire check your plugs or leads on this cyl . ... Dodge Neon

Compression check I have been searching for a toyota truck. I found one with a compression check of 80,69,80.78. From left side of engine to right side. Is this compression good? What is good, decent or excellent compression?


The compressions you mentioned...Good? \015\012No. Not at all.\015\012Those compression reading indicate either really bad/worn piston rings, or valves that are not sealing properly, or both. \015\012Normal compression readings shou ... 1989 Toyota Pickup SR5

1993 FORD RANGER 4.0L 4X4 MANUAL TRANS RUN LIKE IT OUT OF TIME BUT IT KICK IN AND RUN GOOD RUN WORST THE LONGER IT RUNS SMELL LIKE IT NOT GOT THE RIGHT FUEL MIXTURE CHECK FOR VACCUM LEAKS,CHECKED COMPRESSION GOOD,CHECKED FUEL PRESSURE GOOD,CHECKED COIL SEC&PRIMARY RES SECONDARY WAS 14 OMS IT WAS A LITTLE HI,REMOVED EXHAUST AND RUN NO DIFFERANCE


... 1993 Ford Ranger SuperCab

98 Acura 3.0 cl passenger window is stuck fully open. the driver side control will not make it go up either. I have checked the fuses, they are good. A suggestion was made that it may be a relay. I do not know where the relay is or how to check if good or bad. Any suggestions


The location of relays can be found in your manual..\015\012\015\012Rate well ;o) ... 1999 Acura CL

99 grand cherokee 4.7 v-8 engine missfires at rpm's under 2000 ran compression check [good] coolant system check [good] obd only one code p0500 vehicle speed sensor changed plugs,checked spark at coils [good] plugs carbon up after or 15 minutes black inside throttle body drained fuel, added clean fuel , gas dryer, and injector cleaner suspect high pressure in fuel rail, but have'nt tested yet try to relieve fuel pressure by disabling fuel pump after disabling pump, engine runs much b


It is most likely the fuel pressure regulator,it will have a vacuum line going to it,make sure it is getting vacuum,and the hose going to it is in good shape.Ether the regulator is bad,or the return line going from the fuel rail,to the fuel tank is r ... 1999 Jeep Grand Cherokee

I have a 2001 Lexus rx 300 with a check engine light on with code P0301 cylinder 1 misfire. The spark plugs and ignition coils were already replaced. I swapped fuel injectors with known good cylinder and still have same code. Compression check was done and found cylinder 1 to be a bit low. Had the cylinder head sent to machine shop and came back tested fine. Tested electrical signals to fuel injector and got good pulsewidth signal. Checked for spark and got good spark. Don't know what else to do


... 2000 Lexus RX 300

Pcm i was diagnosing why my #5 fuel injector was not responding. i checked it it is good. i replaced spark plugs, wires, distributor and rotor. i ran a compression check. it all checks out good. i took my volt meter and checked all the injector plugs. every one but #5 reads 1 amp in/1 amp out. except #5 it reads 12amps constantly. so i checked the wires all the way back to to the pcm and why i was trying to get another reading i grounded out through the fuel rail. the engine shut down and i cant


First is check fuses, if none bad it's a bad pcm ... 1998 Jeep Cherokee

Loss ofpower BOGS DOWN . TRYED EVERY THING CHECKED TIMING MARKS RIGHT ON .. CHECKED COMPRESSION.. ALL AT 120 ..PUT A MASS AIR FLOW SENSOR STILL THE SAME PUT A NEW DISTRIBUTOR IN NO GOOD CHECKED ALL INJECTORS WORKING FINE . CHECKED FUEL TRIMS ALL IN LINE . IT SEEMS LIKE TIMING LIKE IT DONT ADVANCE. WITH THE SCANER IT SHOW ADVANCE IS WORKING . WHEN ON A HIGH WAY IT GOS GOOD . JUST TAKE OFFS IT WILL NOT SPIN A WHEEL TO SAVE YOUR LIVE AND IT A V6 3.0 I DO HAVE A FALT CODE ON P1400 BUT DONT THINK IT


A P1400 code means there is something wrong with the evap/egr/air/catalyst...also that 1 means its a code made by the manufacturer so its vehicle specific. whatever the problem is it could potentially damage your Catalitic Converter. SO its about so ... 2001 Mitsubishi Galant

Honda stream 2.0L ivtec (same as civic type r) jumped the timing checked compression 200psi in all cylinders stripped and found faulty oil pressure tensioner replaced set up timing and rebuilt and started running perfect stopped and fit covers and wheel and tried to start turning over but not starting (turning over very fast) checked compression 0 on all cylinders stripped and aligned timing marks and checked chain tension all good


... 2003 Honda Stream

I have a 1986 civic AWD wagon 1500. the car had not been started for 2 year. when I got it running it only would run roughly at 1000 rpm at full throttle. I checked the spark which seemed intermitent so replaced the igniter, coil, cap rotor and plugs. the compression was good. after running the engine a few times it ran less and less until it would only fire but not run, I checked the compression again now it had some zero compression in some cylinders, the exhoust valve stems were rusted so I


Do you know for sure that the compression issues were with the heads? It could be the rings.Also, did you run it at all with the gas that had been in it before replacing it?Did you change the oil?Please comment bac ... 1986 Honda Civic

My 2002 Grand Am will not start, when ignition is turned on nothing happens with the starter, not even a sound from the starter, everything else works. I took off the starter and had it checked and it checked good, also checked the battery and it is good, all connections are clean. Any suggestions on what could be causing this problem? Any test that I could do?


I have a 2002 Grand Am also. I had this same problem twice. The first time it happened, the battery was still working but was not strong enough to crank the car or make any noise under the hood at all. All electrical stuff worked though (lights, radi ... 2002 Pontiac Grand Am

I was going down the road and my truck just shut off on me and i checked thr fireing and its good and then i checked the fuel and its gettin gas to the plugs and i checked the compression and it had good comnpression and it will turn the motor over but it want start


Sound like your rollover switch need to be checked passenger side kick panel under dash little slot in kick panel there a button push it ... 1989 Ford F 150

98 jeep grand cherokee limited 4.0 litre. starts up, during warm up process engine will idle irradically and stall out. starts back up and does the same thing. no check engine light on. cleanrd throttle body, good compression, good spark. i checked to see if it might have been the map sensor by starting the motor and then pulling the connector off the map sensor, the rpm's changed a slight bit but went to normal and didn't stall out. i was thinking about checking to see if i have fuel pressure o


98 jeep grand cherokee, starts fine but then dies and will not run, after it dies it will start right back and do the same thing, can not get it run, any help is always appreciated ... 1996 Jeep Grand Cherokee

My 2000 v8 toyota tundra suddenly lost power checked it out and it is misfiring on 1,3,5,& 7. compression checked good, timing checked good, changed all coil packs to other side, misfire stayed on 1,3,5,7. bought another ecm, no change, have fuel pressure, power to injectors, and new plugs, plugs will fire, done this by pulling out coil pack and ground plug. please, need help


Does this motor have the equivalent of crank-trigger ignition? If so, is the sensor A-OK? ... 2000 Toyota Tundra
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.5870 seconds