Having problems with your 1998 Ford Explorer ?

1998 ford explore 4x4 high and 4x4 low lights flash 6times then stop

\015 Drives fine and just started flashing. Will flash 6 times stop go about 500 to 1000 yards then flashes 6 times again.\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Change out the sensors on your tranfer case there are 2ill bet that fixes it
Hi Slilbit, Take the vehicle for a diagnostic scan. The flashing light is indicating a problem with the transmission. Regards John
Repair Help & Product Troubleshooting for 1998 Ford Explorer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1998 ford explore 4x4 high and 4x4 low lights flash 6times then stop


Change out the sensors on your tranfer case there are 2ill bet that fixes it ... 1998 Ford Explorer

I have 1998 ford explorer 4x4 and the low 4x4 and high 4x4 light indicator keeps flashing on and off.


... 1998 Ford Explorer

2002 Ford Explorer XLT, 4.6 V8, 163,000 kilometers. The unit apparently engaged 4x4 High while parked overnight. I had not used anything but 4x4 Auto prior to this for months. When I backed out of my drive in the morning, the wheels crow hopped as I turned. The system engages 4x4 low normally and dash lights indicate that 4x4 low and high engage normally when selected. However when 4x4 Auto is selected, the transfer case does not allow slippage. It works normally while driving straight ahea


The transfer case shift motor or gear shift module is not functioning.The shift module located behind the glove box.That module has to be inspected.\015\012---------\015\012During the Auto 4WD mode, the power flow is t ... Ford Explorer

Hello, my 1995 ford explorer 4wd low and high lights will flash 6 times every 2-3 minutes. When I turn the 4wd switch to 4wd high or low it engages the drivetrain, but does not indicate the change with the dash light.


... Ford Explorer

2002 ford explorer. The 4x4 will not go into 4x4 high or low after the transfere case was rebuilt. The 4x4 high light flickers on and off. I would like to have wiring diagrams for it.


Some schemes and diagrams were published in this link, \015\012for additional details suggest visiting ... Ford Explorer

02 Ford Explorer XLT 4x4 High light flashes and


I had same problem on my 2002 explorer. Its either the computer module, or the electric solenoid on the transfer case. In my case it was both. The computer module I had done twice in 14 months. ... 2002 Ford Explorer

My 4x4 high and low lights are flashing on my 2003 ford expedition. i believe this issue is what caused my first transmission to go out. when the truck was diagnosed withthe transmission is the test read that it was stuck in 4x4 low any idea's?


... 2003 Ford Expedition

2002 Ford Explorer with 4x4 auto, 4 hi and 4 lo.The 4x4 high light flashes 8 times every 2 minutes when in standard 4x4 auto. It will shift in and out of 4x4hi but not into 4x4lo. Also the 4x4 auto doesn't kick in when the rear wheels spin. I've changed the ECM but that didn't help. Any other ideas?


Hello\015\012This can be caused by a problem with the connector under the truck to the transfer case electric shift actuator. Get under the truck and remove the connector to the transfer case actuator motor, check it for water intrusion or corr ... 2002 Ford Explorer

94 explorer, manual trans. last night while driving, 4x4 and low range lights flash on then off. when I shifted into 5th getting on freeway, lose all drive power as if clutch suddenly went out. 4x4 light flashed again, went back to 4th gear and it engaged. then was able to shift back to 5th. 4x4 and low range lights flashed a few more times on the way home, but stayed in gear without other incidents. am I developing a problem with clutch? electrical? can I or do I need to disconnect transfer cas


It sounds like the bearings inside the transfer case are going out, with pressure on it while accelerating its fine, then when you push in the clutch the transfer case gets slack allowing the internal parts to move, causing the lights to flash as gea ... 1994 Ford Explorer Limited

Ford explorer 4x4 high light problem flashing light 8 times


Try checking the transmission fluid it does this sometimes when it is low, if not take it to autozone they can run a code check for free and tell you why it keeps doing this! ... 2002 Ford Explorer

The ABS light came on (stayed on) and the 4X4 HIGH light flashes. There is also a noticable grinding/rubbing noise coming from the front wheel-well when I'm making a sharp turn, going out of a tight space it is a 2004 ford explorer


Here is my question\015\012\015\012The ABS Light is on. For how long,and why are you here,v.s. having it checked out and repaired.\015\012The grinding/etc,would have me putting the vehicle up on stands immediately, and checking it o ... 2004 Ford Explorer

My 1998 ford explorer makes a loud noise (like an plane landing,when i take my foot of the accelerator, when i try to turn left or right it makes a loud grinding noise and won't move forward, it has only recently started to do this, it doesn't do it all the time maybe once or twice a day. When i stop the vehicle and change into neutral & select the 4 wheel drive selector by putting it into high or low 4x4 i hear a bang noise, then when i try to drive it is O K but then when i try to stop the noi


I would say your transfer case is on its way out. but it is hard to say that is a lot of info to take in but ya i say tranfer case is toste ... 1999 Ford Explorer

2004 Ford Explorer ABS light stays on and 4X4 HIGH light blinks


The abs and the 4x4 should not be related. The grinding rubbing noise that you describe when you turn is consistant with the way your car would behave turning on dry pavement when the 4x4 is engaged. You very well could have a sensor problem, but i ... 2004 Ford Explorer

One highbeam light was very dull like a semi broken wire, so i rewired the bad side to the good side it worked for a couple of flashes to test , high low beam , then no high beam lights at all, are they hooked through a seperate fuse, some kind of module, or something different, low beam works great with the switch but they do not comeon as driving lights any more since the high beams stopped working, their is also a blue light in the middle of my gages, on now, never seen it before, are not the


You have a wiring problem, look up cavalier headlight wiring on the internet, there is a harness connector under the battery that sometimes goes bad, or the wires are broken inside the insulation, usually in the front harness, the head lights hi and ... 1998 Pontiac Sunfire

4wd high and 4wd low lights flashing at same time on 1997 ford explorer and often engages 4wd when not needed.


Possible solution is to take out your dash control panel which has 2 screws . pull it out the radio and all will come out and check the wirer behind the switch. see if it is louse or disconnected also you could need a new switch ... 1997 Ford Explorer AWD

02 ford explorer 4x4 wont engage 4-high light flashes 10 times


... 2002 Ford Explorer

My daytime running lights on my 2003 Ford Escape are flashing but once I turn on my low beams or high, they stop. I have an after market command start. Could there be some problem with that?


Did any check light come on , when the engine start\015\012\015\012let me know waht is what I will take you along from there ... 2003 Ford Escape

I have an 05 ford explorer. The ABS, ADVTRAC lights are on, and the 4x4 high flashes. they all came on at the same time while dirving and I want to know if it s a fuse I can replace or if I need to take it in to the dealer?


... 2005 Ford Explorer

My 1998 ford explorer with the awd system and 4.0 v6 has a problem when backing up every time you start the car the ft. wheels dont disengage but if you drive it it will goaway after about a mile and the 4wheel low and high light flashes on and off after driving it a bout half a mile or so and you here the ft. end disengage . if you dont turn off the car it dosent do it again but if you turn it off it goes bak to the same thing


... 1998 Ford Explorer

1998 explorer, very loud whine when driving, when turning left or right tires squeal, also 4x4 high& low flashes on & off, brakes make niose and dont stop as they used to, it as just had new front and rear brakes,can you help pleasethank you.


... 1998 Ford Explorer

96 FORD EXPLORER XLT 4X4 LIGHT FLASHING


Does the 4x4 "actually" work because this is a signal that the system has a problem. Its like a check engine light that comes on or flashes when there is a problem with the engine or emission system. ... 1996 Ford Explorer

Went for a 4x4 trip and the 4x4 stopped working, the light went off the dash and the car would only function in 2w drive. It does not go in to 4x4 high or low at times and when it eventually does go in to 4low it does not stay in 4low and the light goes off the dash and stops working. Please Help!!!


Year make and model ?? ... Cars & Trucks

My 2006 ford f150 4x4 works fine in high and low but the light won't come in the dash for 4x4 high but it works fine for 4x4 low what causes this


The 4x4 high light has been on far longer than the low ratio light, I suspect it has simply worn out and blown, try a new light. \015\012other than that the switch in the transmission could be faulty / have corroded connectors ... 2006 Ford F-150

4x4 lights flash, will not engage into 4wd When switching to 4 high or low the lights come on on the dash but then will go off again. The transfer case does not engage into 4 wheel drive in high or low. I do not believe the solenoid is engaging in the transfer case. checked all fuses. Could it be a dead solenoid? Press ENTER to look up in Wiktionary or CTRL+ENTER to look up in Wikipedia


This is called the selector motor and you may be correct this is a common problem with these trucks the selector motor goes bad and will not engage the correct gear setting you select. ... 1996 Ford Explorer

I have a 2000 ford ranger xlt 4x4 w/ 4.0 engine.when i try to engage the 4 wheel drive the 4 wheel low and 4 wheel high light blinks back and forth for a couple of seconds.also it sounds like some kind of clicking noise coming from the switch.but it wont go into low or high. thanks for any help you can give. Thus problem started all at once before that 4x4 worked fine. Anything would be helpful Thanks- Kevin-


You pretty much answered yourself here, the switch sounds like it is going bad. ... 2000 Ford Ranger SuperCab
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.3176 seconds