Having problems with your 1998 Ford Explorer ?

1998 ford explorer negative battery cable issues

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1998 Ford Explorer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1998 ford explorer negative battery cable issues


... 1998 Ford Explorer

I had my battery fully charged and check it tested good, put battery back in car and started my ford explorer 2005 it ran, the next morning the battery was dead i got a jump, then as the car was gunning i took the positve and negative battery cables to check the alternator the car continued to run, two hours later went to started car battery was dead. could someone help me with this problem please thank you.


There is a strong possibility that you may have what is called a parasitic drain on your battery. Which simply means that there is something running in the background that is pulling a load on your battery. These kinds of drains can extremely hard to ... Ford Explorer

My 2005 ford focus has corrosion in the negative battery cable is replacing the negative battery cable difficult


Not hard at all. But are you sure you want to change the whole cable? You can change just the termanal end if you wish. There should be two bolts holding it on. If it is a manufactured cable that is solid and no bolts then you can cut the end off and ... 2005 Ford Focus

Electrical problem Recenly bought a 1977 ford F150, 400, C6. Towed boat to lake on bumpy road. When I started truck to pull away from boat launch the started hung and the truck would not turn off by the key and the battery ground wire got very hot and melted the solder that held it to the battery terminal. I was able to stop the fire by separating the negative cable were the solder melted. The next day I returned, replaced the started the solenoid to be safe and the negative batterey cable. It r


There is a short on the car electric circuits, or inside the ignition block. If I was in your shoes I would start by replacing the ignition block. This can probably fix it. If it doesn't, you should check the ignition circuit backward to find the sh ... 1981 Ford F 100

I have installed a new battery in the 1992 dodge stealth that run before storing last winter. The lights don't even come on - interior-exterior and of course it doesn't start./ the new battery was tested on my Ford and starts that perfectly-. I then cleaned the battery cables. And got a sprak when I attached the negative cable. Do I need new cables or is there a short somewhere? What's the problem?


Replace the battery cables if they havent been change in a while.check battery voltage it should be 12.5 volts.if you not getting interior and exterior lights.it sound like poor ground.make sure ground cable to engine is tight. ... 1992 Dodge Stealth

2001 Ford F250 w/7.8L V8 Diesel. It has dual batteries but single alternator. The charge indicator (battery) light stays on all the time. I have replaced both batteries. Replaced the positive and both negative cables and ensured they were getting proper ground. The alternator and the 2 small wire harness were replaced at the Ford dealership. I had the alternator and batteries tested at Advanced Auto and Auto Zone and all tested OK at both locations. It drains the batteries if I run the vehicle a


... 2001 Ford F250 Super Duty Super Cab

1999 Ford Ranger - Has a BATTERY LIGHT on at idle, GAUGE shows charging ALL the time, CONTINUITY between positive & negative battery cables (battery disconnected), SMOKE from negative battery post during a jump start...HELP!


There is a diode in most older alternators that when working properly put out the light u speak of. The guage has some age so - take ur truck to advance auto - auto zone or one of them - have them check the battery - if u had to get a jump and had a ... 1999 Ford Ranger SuperCab

My battery light is flickering on my 1998 ford Taurus. The alternator is only two years old but the battery is close to six or seven years old. But, it still starts up in negative degree temperatures. The battery cables seem secure, and the cables in the alternator seem secure. Is the alternator going already?


Probably the alternator again. If you have a voltmeter or there is one in the car, check battery voltage with car running. It should be at least 14 volts. Not 14 volts or no voltmeter--take alternator off and have tested at parts chain. Let me kn ... 1998 Ford Taurus

My spouse had to get out 1996 ford explorer boosted while i was at work,so that evening i tested the battery it had a charge of 12.4 and is about 5 years old so i bought a new battery ,i put the new battery in it had a charge of only 12.36 so i went for a drive came back and tested the battery it had a charge of 13.32, i checked it again about 1 hour later the charge was at 12.7,the next morning itested the battery it was at 12.4,i unhooked the battery cables took the battery out it ,tested i


A new battery should have approx 12.62 fully charged\015\012It could be slightly more\015\012If you ever see 13 volts, on an old battery, it is gone\015\012\015\012You need a min of 12.5, to do any testing of your vehicle, or ... Ford Explorer

2002 Ford Explorer XLT does not engage in 4 wheel drive. Disconnected negative terminal to battery, removed 4X4 Control Module, inspected module, modulel looks new, reconnected 4X4CM and reconnected negative cleaned battery terminal. 4 wheel drive still will not engage in nuteral or drive. Should we take it to Tunex?


... 2002 Ford Explorer

1999 Ford Explorer XLT 5.0 AWD - starter will not engage. I hve replaced the starter/solenoid, ingition relay, ignition switch, neutral safety switch and battery. battery cables are clean and solid. I can start the Explorer by jumping across the solenoid. Once it starts it run's fine. No check engine light. I have also connected an ODB Code Reader and it does not show any codes.


If you replaced the solenoid was there one wire to the solenoid or two? If the new solenoid had two small posts did you connect the single wire to the S (starter) or I (ignition) side? If you connected to the I side this is your problem. If you ha ... Ford Explorer

I have a 2002 ford windstar that keeps dying after driving for a few miles. Both the engine and electrical die. The battery and alternator are new. The alternator, positive cable and positive side of the battery are extremely hot but the negative end and cable are not. Any ideas would be appreciated.


... 2002 Ford Windstar Cargo

I have a 97 ford explorer all my lights in the interior came on my battery level went low and the car turned off as though i had no battery but i had just bought a new battery and recently changedle the battery cables but it still doing tha same i checked the alternator it was running at 12.6


12.6 is to low. It should be reading 13.8 to 14.5 when the alternator is functioning properly. Sounds to me like you got a bad connection or a bad alternator. hope this helps. good luck. ... 1997 Ford Explorer AWD

I have a 1996 ford econoline and the battery dies when i leave the cables on. but i take the cables off so it want.i followed the negative cable and the positive ,nothing is touching them.what else could it be?


So you have a parasitic power drain when the system is off. You can narrow the fault quite quickly if you have access to an ammeter (multimeter set to DC current). connect the ammeter in series between the battery negative terminal and its cable. ... 1996 Ford Econoline

I have a 1999 Ford Windstar SEL 3.8L V-6, and I am having troubith the Charging System. After Installing a new battery, new alternator, negative and positive cable wires, the battery light is still coming on. Within 3-5 days, the battery is completely drained. I can't seem to wrap my head around a probable cause. If there's any solutions out there, can I get some insight about this situation I'm having, Please!!


The PCM or computer "turns" the alternator on once the engine starts.There are two fuseable links between the alternator and the battery.One is on the main battery feed yellow and white, and the other is on the battery voltage orange and lite ... Ford Windstar

I have a 1977 Ford f150 4x4 . I put in the 460 big block it originally had the 400 in it. The problem I have is the starter will not turn the engine over when its warm. It makes the same sound as a low battery would. I let it sit for about an hour and it will start like nothing. I have replaced, battery, battery cables, (both negative and positive) solenoid, and starter. Its starting to get annoying and I could use some help. It has done this with every engine I put in so far and I've had thre


... Cars & Trucks

1993 Ford Explorer battery was stolen and they cut all the cables


The shorter wire which connects to the chassis is the negative or ground wire. The long wire that routes down under the engine and to the starter solenoid is the positive.the other smaller wires are a little more difficult.The smaller wir ... 1993 Ford Explorer Limited

2001 Hyundai with automatic trans axle. When driving the car the transmission starts going crazy. It down shifts roughly, up shifts and seems to do whatever it wants to as though it is possessed. An OEM speed sensor was installed yesterday, the negative battery cable checked and disconnected from battery for 30 minutes or longer and an additional ground circuit was added to the car as I have read that prior to 2001 there were ground issues. After these items were changed the trans axle acted


Hi,The code you have, P1529, is set in the cars PCM and basically is an information code that says a transmission error has occurred. When this code is set there will be another code set in the TCM, or transmission control module. The cod ... Hyundai Elantra

My 2006 ford fusion will not start after replacing the battery, negative battery cable, and the starter.... HELP!!


... 2006 Ford Fusion

I have a 1992 Ford Explorer with no electrical systems working. I already changed th neg battery connection to ground and am using a new battery. If I use the pos side of a jumper cable I can bridge across the solenoid and the engine turns over. What next? Is there a relay I can change?


Look for corrosion on pos term wire going to battery term, also clean clean clean the terminals,... look inside black boxes under hood for a main fuse that may have blown..no lights either means no power from batt or blown main fuse... ... 1992 Ford Explorer

I have a 96 Ford Probe that I purchased a few weeks ago. I had both of the belts and the thermostat replaced and then I started losing power so I was told to replace the battery cables and terminals. I did that and now when my son tries to put the battery back in the car , with the negative in place , he touches the positive to the post and it sparks alot and grabs ahold of it , like it's melting. He went over everything that he thought may cause this and we still can't find the problem. We even


Sorry I can't so much for you on this one except tell you that you have a hot wire or cable grounding out somewhere. I obviously is a large power line since it melts the positive post when contact is made. Check the positive cable that runs down to t ... 1996 Ford Probe

Battery Replacement i have a 2001 Ford Explore Sportrack. I want to take out battery but cables are unlike anything I've seen before because nut is round in shape. Any advice?


Is it a torq socket by chance... the socket would fit in the center of the bolt.\015\012\015\012Robert ... 2001 Ford Explorer Sport Trac

I want to change the negative battery terminal in my 1995 Ford ranger. When I cut the battery cable, do i cut the ground also and just splice the two together? Then clamp it back into the new connector?


Just cut cable & little ground wire cut them back install on new ends ... 1995 Ford Ranger Supercab

1992 Ford Tempo GL 2.3L. Replaced battery yesterday. Car will not start or crank. Ran fine as of two days ago. There was a wire that ran from the negative terminal to the frame in front of it that was disconnected, reconnected that, put a new negative terminal clamp on, still nothing. Yesterday the fuel pump would come on fully and there was a click (solenoid?) every 5 seconds or so. Dash lights would work but faded in and out as well as the door chime. I assumed it was a ground issue. Tried mo


Is it turning over,have you checked the starter?if so spray some brake cleaner in the throttle body and see if it will start.\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\01 ... 1992 Ford Tempo

No start on a 2005 jeep grand cherokee It is a random problem. I read that the ignition switch was the problem and changed it two wkd ago, since then the problem M has shown 3 times. Click but no start. Have read that the starter is not the issue... What else? FCM? Not the battery for sure. Tonite, I pulled the positive cable from battery ( reset the module) but no success , then unplugged the negAtive one alone and it worked.... Coincidence I guess but it is killing me because it happens


I had the same problem it is your Key Fob. By taking off the negitive battery connection it resets the key fob. After resetting it may work for a week,month, etc but will need to take off the negitive connection again. Jeep said I need new Key Fobs ... 2003 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.0376 seconds