Having problems with your 1998 Ford Escort ?

Rear brakes Squakes

\015 I have Ford Escort LX 1997, and when I step on brakes, it squakes. I cleaned the rear brakes, but it still squakes. what next to do?\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Replace them
Repair Help & Product Troubleshooting for 1998 Ford Escort

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Rear brakes Squakes


Replace them ... 1998 Ford Escort

Changed the rear end of 1989 Suburban (4 wheel drive). Put on new brake lines for the rear brakes. The brake pedal is hard. There is no brake fluid going to the rear brakes and the front brakes seem to build up pressure - I assume that is what is causing the brake pedal to be hard. When open the front bleeders the pedal drops to the floor. There is a part on the frame of the truck where two brake line intake holes and two lines that go out. The one that goes out to the rear brakes does not


It has to be your proportioning valve, and it is probably jammed and blocking flow to the rear. You can either replace the valve or try to reset it. To reset, you need a way to put pressure into the rear brake exit port. If the valve has bleeder ... 1989 Chevrolet Suburban

Brake repair The rear brakes in my reatta were inop do to someone closing off the brake line because the lines in the rear were all leaking. I just replaced all of the rear lines and bled the brakes. Now the brakes feel fine when the car is off and I pump the brakes up, Very solid pedal. With the key on or the car running the abs and brake lights both come on when I depress the brake pedal. I can also push a little harder and the pedal will go to the floor. What am I not doing correctly. T


Sounds like maybe you didn;t bleed the brakes and there is air in the system. I would start with that ... 1990 Buick Reatta

Brakes (rear) Previous owner (1 month ago) changed the left rear brake cylinder. Pedal felt spongy when I bought the truck, so I bled the right rear, then the left rear brake cylinders. I'm 99.99% positive that I had no air left in those cylinders, and the master cylinder was kept topped-off the whole time. However, now the BRAKE light comes on whenever I press the brake pedal. What did I do wrong, or is there something else I should look at?


I would look at the othe rear wheel cylinder it is most likely leaking ... 1988 Chevrolet C1500

Hi,my 1992 dodge dakota 4x4 extended cab with a 318 engine is giving me problems!! The brake light and anti lock lights are both on,brakes were working but I found a leak in the rear brake line. Replaced rear shoes,rear cylinders,rear brake lines,front pads and master cylinder. Bench bled the cylinder and then after installing I bled all the lines till there is no air and only clear brake fluid. Tested the power assist and it holds a vacuum. When the engine is off I can get resistance and the br


... 1992 Dodge Dakota

I have a peugeot 205 1.8 diesel (non turbo) 1991. The car failed the mot on the rear offside brakes being inefficient. I insoected the rear wheel cylinder and found that was not moving when the brake pedal was depressed. As a result I have replaced both rear wheel cylinders (the nearside was weeping) both rear shoes, rear brake pipes and hanbrake cables. the hanbrake holds really well. The system has been bled twice but the brake pedal has always been firm with little travel. When depressing the


You must find mounted on the right side of the rear axel,a regulator for brake pressure (weight)I thing there is your problem. ... 1991 Peugeot 405

1996 plymouth voyager brake lines broke back by the fuel tank. i replaced them from the block mid way down the drivers side to the rear. now i an unable to bleed the rear brakes at all. no fluid come out of the rear bleeders. i do have a ggod brake pedal and front brakes. how to i get the system to let fluid to the rear brakes?


... 1996 Plymouth Voyager

When I apply the brake pedal the rear brakes donot work. However my front brakes do work fine. On the 1992 Buick Road Master is there a special valve in the master cylinder? no brake fluid is leaking from the rear brakes . The rear brake shoes are ok .even the emergency brake works. please help and Thank you


Is it drum brakes in the rear or disc?. it could be that it needs to be bleed out or a bad master cylinder/or the wheel cylinders or slides are seized up .if you need any further insistence feel free to ask again thank you . ... 1992 Buick Roadmaster

Rear brake lights are not working 1998 chevy malibu. Brake light in the rear window works, the rest do not. Does this mean the switch on the brake pedal is ok? The fuse is fine. None of the brake bulbs light and they all seem OK. How are these integrated with park lights-explain please. How are the bake lights conected to the brake light in the rear window and how does this one work and the other brake lights do not.


See if you have power going to the break light. it may be bad bolb.or broken wires ... 1998 Chevrolet Malibu

New brakes Installed new brakes front and rear including new wheel cylinders, shoes and flexible brake lines in rear at drums, new calipers and pads in front, new master cylinder. Cant get front drivers side caliper to compress and rear passenger side brake pads wont expand. Front caliper is full of fluid, when i crack bleeder open steady stream of fluid pours out, no air. Same with rear passenger side, wheel cylinder full of oil. Filled lines with new fluid using gravity feed method. Any ideas


Still have air inside, because you used gravity feed method. ... 2000 Chrysler Cirrus

No fluid to rear brakes on a 1992 Lincoln Continental.  Rear brakes stopped working. Pulled rear wheels and found surface rust on disks. Raised car, spun tire and push brake pedal found no friction scenerio at the wheel. Tried to bleed rear calipers, found dry brake lines, no fluid from bleeder valve at all. I checked master cylinder fluid level, found to be full. Guess I need to try to find a proportioning valve. Maybe I'll try to check the lines from the master cylinder. Any suggestions would


Check at the proportioning valve--some have a pin that sticks out from the side, when bleeding the brakes try to push that pin back in. But first check to see why this happened--fluid leak to rear wheels, brake hoses cracked and air getting into the ... 1992 Lincoln Continental

2007 uplander rear brake repair - what type of brake pads came as original equipment? Ceramic or semi-metalic? The dealer service states that the original were semi-metalic. I've replaced the front pads twice and replace the front rotors once. Does anyone have any photos of the stages of rear brake pad replacement? An inspection at the dealer resulted in their suggesting replacement of both the rear brake pads and rotors. Where may rear jack stands be placed in order to service the


Pads last about 20k, rotors about 40,for the fronts and about 30/50 for the rears,they are all semi metallic.if you look under the car you will see the places for the jack(not to be used when working on the car OTHER than replacing a tyre.)for all ma ... 2007 Chevrolet Uplander LT Minivan

I have a busted rear brake line on my 97 Malibu(V6). Stranded outside city limits. In order to ger into town I need to disconnect rear line at the master cyclinder. Is it the front line for the front brakes and the rear one for rear brakes or the other way around? Please help. I only have 1 small bottle of brake fliud and am just a few clicks from a service station.


Disconnecting the line won't stop the fluid from leaking out. Your best bet would be to use a pair of Vise-Grips and pinch the line off where it is broken. You'll probably have to pinch it a couple of times to get it to stop leaking or only seep a li ... 1997 Chevrolet Malibu

Brake lights go out when head lights are on. During day brake lights work fine. At night when driving with lights on, applying the brakes turns off the rear tail lights. The center brake light in the rear window is not affected. When you take foot off brakes rear tail lights come back on.


What most likely you have on the rear lights is a bad ground between the lights and the frame /chassis. If the lights are on a tailgate /hatch then the wire is probably broken in the space between the 2 units where it moves a lot. Try running a temp ... 2001 Isuzu Rodeo

My rear brake lights do not work, however the trailer brake lights work, the over cab brake light works, and the rear blinkers, which are the same bulb as the brake light work. I have checked all fuses, brake light switch and rear harnes connection??????????????????????


Well it could be a frayed wire or a bad ground wire from what you have already checked. You should see if you get voltage at the fuse when you press the brake with the car on and running of course. If you don't then you know that the problem lies bef ... Chevrolet Silverado 1500

I have a 1996 Chrysler Town & Country. The front brake pads were replaced about 3 months ago, the rear pads were replaced about three weeks ago. The brake lines or cylinders were not touched. I experienced a total loss of braking about two weeks after the rears were replaced. Took the van to Big O. They replaced the rear cylinders and completely flushed the brake fluid. The van now has a hard pedal the first time you press it, then goes to the floor if you release the brake and press it agai


All this is because the brake lines have not been 'bled' properly. That's why when you pump the brakes, it changes how they feel. Air in the line does that. Have them bled again. ... Chrysler Town & Country

No brakes after changing brake lines front and rear (4) cannot get any brake pedal rear brakes lock up when pressing pedal front brakes dont when bleeding rear pedal goes to the floor when opening the bleeder front there is no pressure but flows easely when pumpig brkes to bleede front pedal does not go all the way down when opening bleeder only goes down a little ( half an inch with no pressure but leakage. thank you robert


Hi Robert!\015\012\015\012When bleeding the fronts and the pedal does not go down all the way, stand on the pedal HARD and see if it won't go down then... \015\012\015\012The proper sequence is to bleed fronts FIRST... if you ... 1998 Nissan Pathfinder

I have a 91 s10 2wd 5spd with a 2.5 4cyl... i bought the truck with the brakes not working, it had a bad rear brakeline that was cracked right in front of the rear driver tire. and since this truck is going be a lowrider/mini truck, i want the least amount of things near the rear axle as possible because im going to eventualy do a 4link... so i tried to cap off the rear brakes completely by putting a bolt in the master cylinder where the line to the rear brakes was supposed to be. While checking


The master cyclinder is divided into diagonal wheels. meaning that each line from the master cyclinder provides fluid to a front wheel and rear wheel. on the front resevoir of the master cyclinder it would be perhaps the left front and right rear b ... 1991 Chevrolet S-10

Hi i have a 1995 cheverolet silverado 1500. For years i've had the problem of a really soft brake pedal that goes all the way to the floor before it brakes. It has abs, front disc brake and rear drum brakes. I have recently replaced the front brake discs and pads and rear brake shoes and drums. We then went on to replace the brake master cylinder and the brake booster but it still has the same problem even with numerous number of attempts to bleed the brake lines. There is no air in the system t


If you haven't already, check your rubber lines for weakness; they could be ballooning under pressure. ... 1995 Chevrolet K1500

X reg Scenic 1.9DCi Lighting problems. All sorts of things happening! Indicators go double speed when brake pedal pressed or rear fog lights operated. Indicators glow when side lights on. High level stop lights not working at all. Rear fog warning light on dash comes on when brake pedal operated or when indicators on , rear side light switch brings on brake lights and brakes lights only operate around half brightness etc etc etc? Have checked fuses and most connections, but can't find anything o


... 2000 Renault 181

1990 Buick Century custom, 3.3 V6, 4 door automatic. I have replaced the linings, wheel cylinders, both rear drums on this vehicle. When the linings are tight to the drum the brakes seem to operate correctly. I have often experienced a "locking up" of the right rear brake. It seems as if the brake shoes become loose (out of adjustment).I have used the parking brake to try and "self adjust the rear linings as it is my understanding that this is how they work.Since I purchased the vehicle used I e


YOUR BRAKES SHOES NEED ADJUSTING THAT WHY ITS LOOSE.SEE YOU ADJUST THE BRAKE SHOES BY TURNING THE STAR WHEEL ON THE ADJUSTER SCREW UNTIL DRUM JUST SLIPS OVER THE SHOES.WHEN TURNING THE DRUM THE SHOES SHOULD NOT RUB IF THEY DO REMOVE THE DRUM AND BACK ... 1990 Buick Century

What should a rear brake and rear rotor replacement job cost for a 05 denali. Job description reads: replace rear disc brakes with new pads. lubricate & inspect caliper and mounting hardware, refill brake fluid, adjust parking brake. Road test.


Depends on cost of pads in your area of town ,but for doing a job like this ,well if takes more than an hour to do i would sack the mechanic ,sounds like a dealer job to me with dealer waffle and dealer prices for being good with a pen .i would charg ... 2005 GMC Yukon Denali

How do I bleed the rear brakes of a 1998 S-10 pickup? I replaced the brake line to the rear brakes and can't get the brakes to bleed. I think the safety valve has closed off to the rear lines. What do I do?


... 1998 Chevrolet S-10 Pickup

I HAVE GOT A 2002 CHEVY EXPRESS 1500 VAN AND THE REAR BRAKES ARE NOT WORKING AT ALL. I PUT NEW WHEEL CYLINDERS ON THE BACK BLED AND AJUSTED BRAKES BUT IT DID NOT MAKE ANY DIFFERANCE AT ALL. IT DOES HAVE ANTILOCK BRAKES ON FRONT BUT THAT SEEMS TO BE OK. I DROVE THE VAN ON A SNOW COVERED ROAD I OPENED THE DOOR AND WATCHED THE REAR WHEELS WHEN I LOCKED THE BRAKES UP AND THE REAR WHEELS JUST KEPT ON ROLLING NOT STOPPING AT ALL. ANYBODY GOT ANY IDEAS? HELP


Bad master cylinder seal must replace master cylinder ... 2002 Chevrolet Express

Rear brakes after i drive my 1987 ford bronco for about 20 minutes the rear antilock light and the brake light comes on and it feels like the rear brakes lock up one time i kept driving it and when i got off the rear wheels were smoking what should i do?


Take it to a shop and let them scan the computer and see if any codes come up. ... 1987 Ford Bronco
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.1151 seconds