Having problems with your 1998 Chevrolet K1500 ?

Where is the ignition sensor located on a chevy 5.7

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

On the front of the engine in the bottom of the timing chain cover. You need to go under the truck to see and serive it.
Repair Help & Product Troubleshooting for 1998 Chevrolet K1500

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Temp Sensor im trying to change the tempature sensor on my 04 chevy imapla. Its a 3.4L and im having trouble finding where it is located. The box on the sensor says SU109 Temp sensor. Hope that helps :/ i appreciate it. P.S. My impala temp gauge has been reading high for a bit but when i get home i can shut the car off and turn the ignition on and the gauge will reset back to zero. Then when i start the car it reads that the temp is normal. So i think its the temp sensor if you think its somethi


The temp sensor known as the engine coolant temp. sensor tells the computer if the engine is overheating and so forth and tells the injectors how much fuel to give the engine. The temp. sending unit is what controls what your guage reads. It sounds l ... 2004 Chevrolet Impala

I have 1990 chevy corsica 2.2 engine turns but no spark replaced the ignition module still no spark no fuel have been told could be knock sensor can tell me where the knock sensor is located


... 1991 Chevrolet Corsica

1999 Chevy Suburban will not fire. I have replaced coil, cap, rotor, wires, crankshaft position sensor, and ensured that all fuses are good and that I am receiving voltage at the fuse terminals. I have tested the ignition module and it appears to be good. I also ran a code scan and came up with none present. I was driving one day and the truck started to run rough and died. I started it shortly thereafter to have it die again half a mile away from the previous location and have not been able to


If you are getting spark at the plug wires, it is not an ignition problem. Did you check for spark? Also a fuel pump is a common failure with these trucks (all GM). Try spraying carburetor cleaner in the intake. If it tries to fire and runs for a sec ... Chevrolet Suburban 1500

Where is the ignition sensor located on a chevy 5.7


On the front of the engine in the bottom of the timing chain cover. You need to go under the truck to see and serive it. ... 1998 Chevrolet K1500

Can you show me on screen exactly the location of the knock sensor part #22060-30P00 8D SENSOR A and Oxygen sensor part # 22690-40U06 8D, HEATED O,(FR,RH), sensor assy-02, #1 bank, located before the catalytic converter for the '97 Maxima 6 Cyl 3.0L,distributor less ignition. I need to replace these parts, would like to do it myself if possible but can't locate them on my engine or pipe. Do I need special tools to do this?


Gpk722000: the knock sensor is located under the intake manifold.\015\012If you are standing in front of the car, look to the right of the oil filler cap and go more to the center of the valve cover. Now, if you look carefully belo ... 1997 Nissan Maxima

I am installing a performance chip on my 2008 vw beetle. I need help figring out which leads are the IAT leads on the MAF/IAT sensor. It has five leads. Turn engine off, remove key from ignition and remove the negative (black) battery terminal. » Locate the vehicle?s Intake Temperature Sensor (IAT) located on or near the intake tube, in the air box or near the throttle body. Figure 1 shows the typical location for the 2 wire IAT sensor. FIGURE 1. FIGURE 2. FIGURE 3. Visit performance


I have Mitchell and I can't find the wire colors anywhere, My wiring diagrams show the MAF and the IAT but the wires do not indicate who's who. I looked everywhere. We get this alot on the newer models because Mitchell and Alldata update the info ... 2008 Volkswagen Beetle

What does the oxygen sensors look like in a 2003 Chevy Venture (warner Brothers Edition) ? How many are there? Where are they located? Can you show a picture of them in place? How do i replace them? Chevy dealer scanned it for codes: "VEHICLE HAS A CODE #PO141 - OXYGEN SENSOR BANK #1 SENSOR #2 WORKING SLOW.. VEHICLE NEEDS OXYGEN SENSOR BANK #1 SENSOR #2 REPLACEMENT.. (A SES LIGHT IS ON - NO RUNNING PROBLEMS)


There should be an O2 sensor before and after the catalytic converter on your vehicle, so it will have 2 sensors. You'll need a 7/8" open end wrench or an O2 sensor socket to replace them.It'll look something like this: http://www.carstee ... 2003 Chevrolet Venture Passanger

I have a 2006 chevy aveo. i was told the throttle position sensor was out. i bought the sensor. i cannot find the location on the engine where it goes. is there a photo available which would show the location of this sensor anywhere?


You do not have a TPS in your car.. I too have a 2006 ChevyAveo.. We have 2 TPS's located inside our Throttle body.. I had the same problem. I have completely replace the throttle body. IT fixed the problem, but when it gets dirty i have to clean it ... Chevrolet Aveo

1990 chevy lumina 3.1 ltr runs for 5 mins, then guits, codes 32 & 43 says 02 sensor, check circuit fuse a relay could be defective, and check circuit wiring, Where is the fuse for the 02 sensor located and the relay ? also where is the wiring for the 02 sensor located ?


I would check back pressure to Catalytic converter. Sounds like it could be plugged off. You have to plumb a gauge ahead of the converter and check the back pressure. ... 1990 Chevrolet Lumina

96 chevy cavalier 2.2 turns over but wont start have changed the following: fuel pump fuel filter map sensor crank shaft position sensor ignition module ignition coils plugs wires ran a ground from ignition module. It still wont start I need to get it going. I need ideas on what it could be


... 1996 Chevrolet Cavalier

I have a 1997 chevy astro van all wheel drive wont start cranck but not running unles i put gasoline on the aircleaner i get advise many times from you site, i replaced cranck sensor,cam sensor ignition coil ignition module fuel pressure regulator but no luck i check my fuel pressure is only 40psi after truck run goes to 55psi then after 2 hours go back to 20 psi when i put ignition on only reads 40 psi can sombody help mi last time sonbody ask for model and type of truck i do not nowk wy everit


I am going to give you my experience with my 1994 chev S-10 blazer with 4.3L engine. My Blazer acted much like yours is, I changed many of the same things that you did with no luck. I finally bit the bullet and pulled the fuel tank and changed the pu ... Chevrolet Astro

Last friday i posted a question and no answer can sombody help mi on this one chevy astro van 1997 4.3 engine repl cranck sensor repl cam sensorrepl ignition coil,repl ignition module repl fuel pressure regulator and still wont start( replaced battery crank only no start unless i put gasoline on maf sensor intake)" air filter" then start will run all day if needed after seat for 2 hours will cranck but wont start i check fuel pressure and only reads 40psi cold and go dow


These is barely a fuel system related problem.\015\012\015\012Also you cannot rule out the idle control solenoid. That is a right idea bbut you will need to service the injector nozzles too.\015\012\015\012They are specialised ... Chevrolet Astro

Can you tell me where the camshaft sensor is located on a 1995 Chevy S-10 2.2 liter? We are replacing the camshaft and can't locate the sensor


\012The Camshaft Position Sensor is located on the backside of the engine between the engine and the firewall. \012You will need to jack the car up and preferable put the axles on jack stands. ... Chevrolet S 10

What location is the crankshaft position sensor ignition misfire sensor located on the 2005 dodge stratus


... 2005 Dodge Stratus

The knob to my car to turn on the heater doesnt turn off, we cant seem to locate the sensor to completely shut it off. one day it stayed on and never turned off with the keys not in the ignition and it drained my battery. can you help me locate the sensor?


You need to replace the blower motor resistor. ... 2004 Pontiac Grand Prix

I have a 2000 chevy camaro that i drove and one day cut off on me and it wouldnt start. so i dianogesed it and the codes that came up were P1514, p0305, p0480, and idk what these codes problems are and where are they located on my car.i have a 2000 chevy camaro that i drove and one day cut off on me and it wouldnt start. so i dianogesed it and the codes that came up were P1514, p0305, p0480, and idk what these codes problems are and where are they located on my car. i disconnected the MAF sensor


Tps sensor will be on the throtle body, the mass air flow is befor throtle body, sounds like your problem may be a clogged catalitic converter. ... 2000 Chevrolet Camaro

I have a 1997 chevy tahoe. 5.7 liter motor. it was idling yesterday and just died. i have no spark. i have replaced everything with the ignition system except for wires and spark plugs. i have done the crankshaft sensor, i have dont the cam shaft sensor, i have dont the coil, and i have dont the ignition module. still no spark. any idea on what it could be????


... 1997 Chevrolet Tahoe

Where is the crankshaft sensor located on a 2002 Chevy Tracker with a 2.0 motor and 5speed manual trans?Trying to find location of crankshaft sensor.


... 2003 Chevrolet Tracker

I have a 1990 chevy corsica lt 6cyl 3.1 multi port fi dis ignition. the problem is it starts and idles fine, but when i push the gas it dies. before i changed some parts it wouldnt even start. ive changed the crankshft sensor,coolant temp. sensor,fuel filter,o2 sensor,pcv valve,map sensor,throttle position sensor,idle air control valve, i cleaned out the egr valve with throttle body cleaner, been told maybe a bad egr valve ,but thats expensive to replace ,if not problem.also maybe a bad speed se


You can manually test the egr valve by pushing up from underneath it and seeing if the spring loaded valve moves and re seats itself. If no, it's bad. ... Chevrolet Cars & Trucks

Knock sensor locations locations 2005 Chevy impala 3.4 liter


... Chevrolet Impala

2004 chevy. van. engine light on ,po-135code heater sensor malfuction bank 1 sensor-1 where is it located?


It's the oxygen sensor screwed into exhaust manifold on driver side. ... 2000 Chevrolet Venture

Where is the sensor located on a 2002 chevy silverado bank 1 sensor 2


... 2000 Chevrolet Silverado 1500

2000 chevy blazer, truck cranks and immediately dies. Have replaced computer, fuel pump, injectors, regulator, crank shaft sensor, oil pressure sensor, checked throttle position sensor, check ignition fire(good at all times) will start on fuel injector cleaner. need heeelp!


Does your battery go dead? ... 2001 Chevrolet Blazer

O2 sensors i need to know what kind of sensors i have AFR or regular o2 sensors and where they are located. What color the signal wire is and wiring diagram. Can anybody help me. My van is a 2007 chevy uplander 3.9L v6. Thank you for your help. Miriam


The dealer would have that exact spec for your car. Do you have any friends who are in the auto repair business or that work at an Auto Dealership? The car you have is so new that there is no repair manual out yet to cover it. I have called Chevy Dea ... 2007 Chevrolet Uplander

Hello I have a 1999 Chevy Blazer with a 4.3L I keep getting the code Multiple misfire or misfire cyl 5. I have replaced the crank sensor, cam sensor, ignition module, map sensor, injectors, fuel filter, fuel pump, plugs, wires, cap and rotor. The thing still idles rough, jumps and jerks while driving. Help Please


... 1999 Chevrolet Blazer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.1076 seconds