Having problems with your 1998 Chevrolet Blazer ?

Replace the front turn signal light bulb

\015 How do you replace the front turn signal light bulb on a 1998 Chevy Blazer\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

You have to go under the front of the car. very easy to fix.
You should have two tongues holding the main headlamp assembly, they are towards the inside of the engine compartement, slide them off upwards and wiggle the assembly and should come off, once off you'll have access to you signal light, hope it helps
Repair Help & Product Troubleshooting for 1998 Chevrolet Blazer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

88 Jeep Cherokee, left turn signals don't work. Right signals flash as they should. Emergency flashers work as well. When the left turn signal is activated, the dash arrow lights up, the front bulb lights up and the rear bulb lights up but the flasher doesn't click. The flasher was replaced to rule it out and because it is easy, the left rear turn signal bulb was replaced and the front bulb was checked. It seems to me then next item to replace would be the turn signal switch. Any thoughts?


... 1988 Jeep Cherokee

Front driver side turn signal light doesn't flash.replaced bulb,replaced socket,all other lights work on emergency flasher,except front driver side.rear driver side turn signal light works,but flashes fast,also when turn signal switch is on for driver side turn signal,no indicator light on instrument panel.running light driver side front has power,just no flash.


Replace flasher......usually located in fuse block area...listen in this area....select passenger side ...then select driver side...you can hear flasher clicking...you have seperate flashers for each...FLASHERS are small cubes plugged into fuse block ... 1998 Buick Century

2003 Ford Ranger, XLT 6Cyl. Flashers, Running Lights, Reverse Light, Right and Middle Brake Light and Headlights are working. Front running/parking lights are not working. Signal Lights, Front and Rear are not working (replaced Bulbs already). Rear Left Brake Light not working (replaced bulb already). Fuses checked an all appear to be good. What do I do? State Inspection was due yesterday, getting all kinds of hand gestures and horn honking for slowing down to turn without signal lights.


Found very detailed assistance and instructions, FREE on the Ranger Station Forum. It is nice being able to go on-line and find lots of free information from fellow American Ford Ranger owners and not be asked for $$$.\015\012\015\012If ... 2003 Ford Ranger Regular Cab

1997 Sunfire GT. Right, left, and spoiler brake lights not working. Rear left and right turn signals not working either. Both front turn signals work, but they blink quickly as if a bulb were out. Headlamps both extremely dim, and I only have use of Parking lights when driving. I first inspected the fuses on the inside console. They looked to be ok, looked at bulbs, the filaments seem to be ok, but grease where the bulb is plugged in is dried up and hardened. I replaced the turn signal switch


Replace the turn signal switch. All of these lights run threw it. ... Pontiac Sunfire

Front turning light does not work, i replaced the bulb, and when i turn the truning signal does not turn off.


Sounds like you have a bad ground. Follow the wiring harnesses under the hood and in the trunk, there should be a ground wire going to the chassis or to the body. If they are all clean and tight, you might be looking at a bad light socket. ... 1996 Dodge Neon

Ok I have a 1993 buick century and my brake lights and rear turn signals were not working so I replaced the bulbs and it worked for about 10 mins. Than it blue the flasher relay. So I replaced that and now only my front turn signals work. The rear turn signals and brake lights do not.????


... Cars & Trucks

2001 Toyota Tocama 1) Right turn signal comes on when I brake, it does not flash it just comes on. 2) If I have it turned on, it will not flash whilel the brake pedal is pressed. 3) When I turn on left turn signal, both front signal lights light up and the left turn signal still blinks. 4) This is an intemittent problem, I've replaced all the bulbs but it continues to happen. How can I locate the problems?


If you have an aftermarket trailer towing plug, that's the first place to look. There is probably a short in the wires, and when you push the brake, the signal light comes on. If not, then it will be a bare wire somewhere, probably at the back where ... 2001 Toyota Tacoma

I have a 1990 full size ford Bronco. The rear right turn signal went out and I replaced in and it still did not work but the rest of the turn signals worked. I then took it to a shop and they looked at it for twenty minutes and could not figure it out. When I got home the rear tail lights brake lights , turn signals (all one multifunctial bulb) would not work and also the back up lights. Also the front blinkers will not work now. I have tried the fuze and that is not the problem. I don't think


... 1990 Ford Bronco

I have a 1990 full size ford Bronco. The rear right turn signal went out and I replaced in and it still did not work but the rest of the turn signals worked. I then took it to a shop and they looked at it for twenty minutes and could not figure it out. When I got home the rear tail lights brake lights , turn signals (all one multifunctial bulb) would not work and also the back up lights. Also the front blinkers will not work now. I have tried the fuze and that is not the problem. I don't think


... 1990 Ford Bronco

My brake lights dont work and my hazard lights in back.. brake light in window works.. hazard lights in front work blinking fast. when put turn signal on go back to normal blink. turn signals work and running lights work in back.. replaced brake switch twice and all bulbs are good... only brake lights and hazard lights in back out


... 1996 Mercury Grand Marquis

My front left turn signal will not operate and I have replaced the bulb. All other light bulbs are working on the vehicle. The right side turn signal works fine.What do I need to check or replace?


That is a wiring problem or corrosion in the socket. make sure the socket is clean. then test with a multi-meter while the left blinker is on, if you have voltage then it is the light, if no voltage is present, ... 2004 Mazda 6

Have four way flashers in front of car but no turn signals on front or rear of car but yet i still have parking lights and brake lights and have replaced the bulbs and the fuses are not bad and the flasher unit is also working just no turn signals or four way flashers on rear what should i do next


The most common cause of your problem is the Flasher Unit. Functioning four way flashers doesn't mean the existing unit is working. Also, there are multiple flasher units on some cars. Since the bulbs are all working, replacing the flasher unit mak ... 1994 Chevrolet Cavalier

2002 Pontiac Montana. Front passenger side turn signal doesn't blink but the bulb is working as a running light. The faulty turn signal connection causes the right turn signal to blink excessively fast. Do I need to replace the bulb or a fuse? thanks.


I have the same problem. The bulb is good, works fine on the other side. However the terminal gets no juice, so sayeth the voltmeter. Fuses are fine, suspect a bad wire/connector somewhere. I haven't found the problem yet. I'll check the wire to the ... 2002 Pontiac Montana

My rear break lights and turn signals have stopped working on my 2006 Mercury Mariner. I have replaced the rear bulbs and fuses which hasn't fixed the problem. The lights on the front work fine. A mechanic has tested my turn signal control switch and told me that is not the problem. He says it is the turn signal flasher, but when I call to order the part from the dealership they gave me different prices for different parts. I don't want to waste 100 to 200 dollars on the wrong part.


There is two different Flasher Relay's for the 2006 Mariner.With Towing Package: Part # YL8Z13350AA or SF620 (Around $45 online)Without Towing Package: Part # YL8Z13350BA or SF621 (Around $60 Online) ... 2006 Mercury Mariner

Signal lights won't blink on, replaced flasher and bulbs and fuse with no change in condition. Turn on hazard lights and only front right signal light blinks. Rear emergency lights and left front don not blink. Right arrow on console only blinks with hazard switch on. Not sure what else can cause this. Your help is greatly appreciated!


... Mitsubishi Montero

Rear lights work when turned on. No brake lights or rear turn signals. Front turn signals flash more rapidly. Replaced both rear bulbs with no change


If you're getting a more rapid flash in the front you have a possible blown relay to the back. Check fuses first and see if those are out. ... 1996 Chevrolet K1500

During the day my brake lights work, but not my rear signal lights. when i turn on my head lights, the brake and signal lights will not work. my signal lights in front work all the time, but they blink real fast. i checked my fuses on the dash panel box, all are ok. i checked under the hood and those fuses were ok also, but i do not know about the square big multi pronge fuses. i replaced my rear tail light bulbs also even though my old ones were ok. could there be a loose ground wire or a bad b


U have a short loose ground or power wire check all bulb sockets ur head light switch can be bad also ... Ford Ranger

My 1987 dodge ram chargers front and back turn signals dont work as well as my braking lights. My headlights and rear lights work. ive replaced the turn signal flasher and fuse that are located inside my under the steering colum and put new bulbs in the rear but still nothing works


... 1987 Dodge Ramcharger

2005 Pontiac Grand Prix front left turn signal went out, I replaced the bulb and the light comes on but the turn signal still doesn't work. If I have the lights sent on automatic the right parking


Hey I literally just today had the same problem, put a new bulb in the light was on but did not blink!!!! SUPER EASY SOLUTION, you simply have the bulb in too far. I gently pulled mine out a tiny bit and it started working fine... guarantee that's al ... 2005 Pontiac Grand Prix

1999 buick lesabre my right signal doesnt blink it stays solid , my left turn signal blinks fine i have to manually blink the right side every turn , i put the hazard lights on and the front left and right blinks but in the back the left blinks and the right doesnt even light up??? iiiiiii neeeed help im broke im doing the repair myself one person told me fix the bulbs , one said replace the wire harness im not taking out the steering column if its not needed


Replace all the bulbs on the right side. You must have a bad one. ... 1999 Buick LeSabre Custom

1992 volvo 940 front right turn signal light not blinking. The rear light is blinking but real fast. The bulb works, I replaced it also. The right turn signal is just fine. What do you think.


Check voltage going to the front socket with a tester if good chek the ground on same ... 1992 Volvo 940

I NEED TO REPLACE THE FRONT LEFT TURNING SIGNAL LIGHT BULB IN MY 2006 MONTANA VAN. hOW DO i REMOVE THE HEADLIGHT ASSEMBLY SO I CAN THEN ACCESS THE LOWER TURN SIGNAL LIGHT?


... 2006 Pontiac Montana SV6

1998 cavalier, back turn signals do not work, replaced bulbs, front turn signals work, brake light does not work. but brake light works inside the car on rear window.


OK try this turn the signal light on one side or the other then push brake pedal if brake lights come on replace the turn signal switch ... Chevrolet Cavalier

I have a 2002 Chevy S-10. The right rear turn signal doesn't work. Neither does the brake light. The running light works. I replaced the bulb, and still, doesn't work. What could possibly be the problem? The right front turn signal works great, mach speed in fact, the rear, not so much. All wires are fine. Please help!!


You probably have a burned or melted bulb socket connector where the bulb actually plugs into the socket and it is preventing the bulb from making contact with the socket connector. Look into the socket and see if you can see the connector recessed o ... 1997 Chevrolet Blazer

2000 Oldsmobile Intrigue - Turn Indicator Problem. So I have a "quick flash" on the instrument cluster for the left turn signal. I've replaced the bulbs, checked the contacts, checked the main fuse panel, and for good measure gave the wires a solid jiggling. The center running lamp (yellow) and front left turn bulb won't indicate a left turn. Instead just the cornering lamp comes on (this I believe is a built in function) If the lights are turned on, the low-level filament turns on (maybe it


While a fast flash usually indicates a burned out bulb, you've obviously covered these bases. Your next step should be to check the turn signal solenoid, also called a turn signal "flasher", as these ususally cost between $6 and $12. If that doesn' ... 2000 Oldsmobile Intrigue
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.2742 seconds