Having problems with your 1997 Oldsmobile LSS ?

Replacing serpentine belt on a 1997 Oldsmobile LSS

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1997 Oldsmobile LSS

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replace serpentine belt on 1996 Oldsmobile lss


... 1996 Oldsmobile LSS

Replacing serpentine belt on a 1997 Oldsmobile LSS


... 1997 Oldsmobile LSS

Need diagram of serpentine belt for 94Solution for "need diagram for replacing serpentine belt for 94 ford taurus gl w/3 0 v6 engine and a/c" ford taurus gl w/3.0 v6 engine and a/c


\015\012Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question. ... 1994 Ford Taurus

Replacing the serpentine belt on a 1996 oldsmobile 88 3.8L V6


... 1996 Oldsmobile Eighty Eight

How to replace the serpentine belt on the 1992 oldsmobile achieva


Pry the tensioner with appropiate tool, then pull the belt off the alternator pulley before releasing the tensioner. Note the routing of belt before doing this job. Make sure the new belt is same length before putting back on, reverse the procedure. ... 1992 Oldsmobile Achieva

97 olds lss - replacing fan belt how do i get the old fan belt off? even more so...getting the new one on pre-serpentine diagram.


Is that the one where there's a bolt in the way? If so you have to remove the right front wheel and take nut off that stud and spacer that's in the way, then you need a special socket to remove the stud. The end of the stud is like a "Torx" you need ... 1997 Oldsmobile LSS

Need a replacement serpentine belt for a 2001 oldsmobile silhouette 3.4 liter v-6. 2 belt sizes 86.5 and 87.5 does it have to be taken off first to know what size is needed?


... 2001 Oldsmobile Silhouette

Serpentine belt when i make a right turn the steering wheel is very hard to turn , had someone look at it ,said the serpentine belt was loose,a week later belt did break ,replaced belt but car still won't turn right in less i use all my strength it gets harder to turn if my brake are applied ,Would the loose serpentine belt cause it from not turning properly and if so why is it still not turning after i replaced the belt ? or any suggestions on what else could be causing it ? thank you for your


The power steering and power brakes are connected to an extent. They both pull their power from the same place (basically) I would check to make sure that you have enough fluid in both first. Then check to make sure you dont have air in any of the st ... 1997 Buick Park Avenue

Diagram for replacing a serpentine belt on a 1998 oldsmobile cutlass 3.1


... Oldsmobile Cutlass

Hey there. I am replacing Problem with the 1997 Taurus hey there. I am replacing the serpentine belt on my 1997 Ford Taurus. The idle pulley bearings were shot, so the old belt actually slipped off. I am about to replace the idle pulley. I have loosened off the tension pulley, but for the life of me cannot get the serpentine belt back on. I am about half an inch from getting in on ? the new belt is exactly the same length as the old one. Is the tension pulley supposed to spring forward or back?


Make sure the tensioner is tight,it has a spring in it to move clockwise,do not leave any bolt loose,make sure you are routing the belt where the tension holds the belt on,not other way.\015\012\015\012\015\012Tim ... 1997 Ford Taurus

Serpentine belt i replaced my own serpentine belt and still i hear a wheel that the belt goes around. what is that wheel called and should i replace it. it doesnt sound like it did before i replaced the belt but like the wheel is loose.


Rempve the belt again and hand spin the pulleys listening for a loud bearing type noise in one of the pulleys .. you see anything that spins has a bearing in it. the bearing drys out and the pulley gets louder than normall.most time it an idler pulle ... 2004 Dodge Ram 1500

How do you replace the serpentine belt on an oldsmobile 88


... 1996 Oldsmobile Eighty Eight

How to replace Serpentine belt - 1996 Oldsmobile Eighty Eight


If you reach through the passenger side front wheel well, you can remove the Torx bolt that attaches the motor mount to the engine. It runs through a spacer (about 2" long) which you can remove. This should allow you to install the serpentine belt. ... 1996 Oldsmobile Eighty Eight

Serpentine belt diagram 1996 buick - 1996 Oldsmobile LSS


... 1996 Oldsmobile LSS

How to replace serpentine belt 1991 Oldsmobile Cierra 3.3 litre


... 1991 Oldsmobile Cutlass Ciera

Replace serpentine belt on 2004 Oldsmobile Alero


You should have a decal on the upper rad support or under the hood some were that shows the belt routing.there is a tool designed to move the belt tensioner but you may be able to use just regular hand tools to move the tensioner to take the tension ... Oldsmobile Alero

I am trying to determine if it is worth fixing the timing chain on the 2000 oldsmobile intrigue. i hear they are fairly expensive. we just replaced a cracked radiator and the serpentine belt. The mechanic says we also need 3 new motor motor mounts, new front struts and that we have leaks at the valve cover gaskets and at the power steering hose. It is worth fixing this car? It seems to have so much wrong with it.


Wow. Only worth it if the mechanic is trustworthy and you can't afford to get out from under it. It is a pretty complicated repair. The car probably isn't worth more than a couple thousand dollars, depending on where you are located. Why do they wan ... 2000 Oldsmobile Intrigue

Diagram for a serpentine belt replacement - 1990 Oldsmobile Cutlass Ciera


CLICK on the following LINK. \015\012It has the Belt Diagrams you will need. If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. ... 1990 Oldsmobile Cutlass Ciera

I have a 1995 oldsmobile 88 3600 series. The serpentine belt broke and I need a diagram to replace it.


I cant find a diagram but i know there is one at your local library where they have repair mauals for free ... 1995 Oldsmobile 88

Needs to replace the serpentine belt - 1997 Oldsmobile 88


Hope this helps you. ... 1997 Oldsmobile 88

My friend is trying to replace my serpentine belt on my 96 Oldsmobile Aurora (the ac compressor seized up) and he cannot get the torque plates off does it require taking the power steering pump off? Is there anywhere online to download a service manual? Please help I need my car!!1


Haynes @ http://www.haynes.com/alldata @ http://www.alldatadiy.com/?gclid=CJj87_HlupsCFRAMDQod0WTG_AChiltons @ http://www.chiltondiy.com/default.aspxommitchell1 @ http://www.eautorepair.net/app/YearsMakes.asp?VID=103313a ... Oldsmobile Aurora

My friend is trying to replace my serpentine belt on my 96 Oldsmobile Aurora (the ac compressor seized up) and he cannot get the torque plates off does it require taking the power steering pump off? Is there anywhere online to download a service manual? Please help I need my car!!1


CLICK HERE for belt routing possibilities based on installed opt ... Oldsmobile Aurora

Replace serpentine belt in 1997 oldsmobile 88


Decompress tensioner, slide belt off of idler pulley, Using schematic under hood reinstall belt, again decompress tensioner and slide belt over it ... 1997 Oldsmobile 88

Replacing the serpentine belt on a 2001 oldsmobile alero


... Oldsmobile Alero

How to replace 91 oldsmobile cutlass ciera serpentine belt


... 1991 Oldsmobile Cutlass Ciera
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.8021 seconds