Having problems with your 1997 Mitsubishi Pajero ?

Noise from rear axle

\015 There is noise form the rear axle when the car is moving. I changed the rear bearing on one of the wheels, but the problem still exists. I was told to change something called buckex, I don't know what is it. I am really worried for my car. I am also losing balance on curbs and turns.\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

I would replace the bearing on the other side if for no other reason than to know what I have in it.
Repair Help & Product Troubleshooting for 1997 Mitsubishi Pajero

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a clicking noise coming from my rear passenger side tire or axle houising. I looked at the rear axle and it seems like the axle housing is coming out from the rear differential. I can see a little wear where the housing maybe was rubbing something. I am not a car expert by any means but i can tell something is wrong. The amount of the clicking noise increases in speed when i drive faster. Please help. What is wrong and is it safe to drive on?


Replace the bearing and driver side axle due recommended by a mech. I had a niose coming form the rear of the car. After they replaced the bearing and axle I could still hear the noise in the rear. What could be causing the noise?

Hello. I'm surprised the mechanic did not recommend replacing the bearings in both sides. Did the noise diminish at all with just one side bearing being replaced? ... 1997 Lincoln Town Car

Hello.... I hear some big noise in the rear axle (differential);so i have to change it,but only found the rear axle of a L300 petrol one,when mine is a diesel.So, are rear axles Mitsubishi L 300 gasoline and diesel the same? Thanks

While I am uncertain, sadly no diesel here in the USA (danged EPA) I would expectthe diesel rear axel to have a different ratio from the gasoline, as the diesels run slower. You should be able to manually turn the yoke on the rear-end and count the r ... 1990 Mitsubishi Minivan

HAve a roaring comig for rear end. Appears to from left axle. When Place on jack stands and stop roght rear wheel from turning and left wheel rolloing, get a loud noise from that side. Was told it was the pinon & spider gears. Sounds more like the bearing to me. Are rhw axle's "floating" axles or are they foxed with a keeper ring or device? Wayne


On a 2002 Lincoln LS ..... I ahve a rear axle bearing noise. Is it necessary to open the "pumpkin" to release the axle from inside the axle or is there a bolted flange retainer behind the rear brake rotor ??

Hello lemofla: My name is Roger and I will help with your question. It is not necessary to remove the rear axle from the differential in order to replace the wheel bearing. This operation does require some special tools and alignment of ... Lincoln LS

Grinding noise from the rear end when in drive and when i go into reverse it grinds and does not move at all. and when you drive it it grinds and makes a heck of a noise. ??? i believe the rear axle is bad or something. i have a 84 camaro with the 305 4bbl h.o automatic.

... Chevrolet Camaro


You have a seal leak causing the differential oil to get onto the rear brakes shoes.what is happening is the brakes grab the drum and shift until they can`t move(turn)any more causing the clunking noise.the groove in the axle if it is bad enough then ... 2004 Ford F150

My mitsubishi outlander, 2006 makes noise. I hear it is due to the rear axle differential. Is this a major fault? Is it expensive to replace the rear axle diffential?

... 2006 Mitsubishi Outlander

My 03 Santa Fee is making an intermittent creaking noise under the hood. I spent a TON of $$ at the Hyundai dealership 3-4 weeks ago that included an oil change, tran. flush, radiator replacement, left front axle replacement and rear brake work. It wasn't making this noise when I took it in, and took it back the next day after I noticed the noise on the way home from the dealer! They told me they didn't hear the noise, but oops, my sway bar bushings needed to be replaced. STUPIDLY, I OK'd the jo

There are some possibilities you have to check out for this noise \015\012there's a TIMING belt,which has to be changed at about 60K miles,if it skips a notch or breaks,you could severely damage your motor.Then there's the accessory drive ... 2003 Hyundai Santa Fe

HI,in reference to a 2000 chevy silverado,for a couple of weeks i have noticed that when i make a slow turn the right rear wheel seemed to be skipping instead of turning,as soon as i straitened out it was fine,until last night it made a lot of noise in the rear and quit moving,had to pull it home ,do you think maybe a broken rear axle or the whole rear end went bad,and how can i tell,thanks cudu

You will need to open the rear axle and look for broken parts. You might have not had any oil in it to begin with. ... 2000 Chevrolet Silverado 1500

Whirring/whining noise from rear trans-axle

Check your rear end and make sure it has plenty of gear oil..if full then there is friction in it somewhere and it is probly getting ready to go out. ... 2000 Chevrolet Blazer

Every time tension is placed on the rear axle it makes a rusty spring noise and i looked under my jeep and found the problem but i do not know what it is called. it sits on top of the axle and looks like a rusty spring going from the axle to the body. what is this part called?

Leaf spring ... 2002 Jeep Liberty

2004 Chevy Aveo has clunking noise comming from right rear, have took it to mechanic 3 times, they replaced both rear wheel bearings, last time said they could not find anything wrong in rear but said it needed sway bar links had those replaced. My husband said the right trailing arm bushing seems wore out but can't find anyone who knows anything about this. If this is the problem, Can you buy the bushing by itself or do you have to replace the whole axle? Thanks for any help.

Bushings available on ebay used them on my 2004 aveo and the work ... 2004 Chevrolet Aveo

When I make a right hand turn. The rear right wheel makes a grinding skweeking noise. I was wondering if it could be that the brakes are causing this noise or maybe there is something wrong inside the axle shaft. The tires move freely and noise free when it is jacked up off the ground

Four wheel disc brakes or drums on rear? ... Jeep TJ

Rear axle noise knocking noise scenic dti 2001

... Renault Megane


... 2006 GMC Yukon Xl Denali

Noise from rear axle

I would replace the bearing on the other side if for no other reason than to know what I have in it. ... 1997 Mitsubishi Pajero

My 1996 gmc yukon makes a clacking noise in the rear axle

... Cars & Trucks

1998 Jeep Cherokee TDi the rear axle makes some noises

Any noise from the rear axle can be coming from many different causes, depending upon exactly what you are doing when the noise happens.Check all mounting points and make sure none of the bushings are loose and that all hardware is tight. Jack ... 1998 Jeep Cherokee

2001 Toyota Corolla LE 4 door rear axle noise I believe

First thing I would do is to get a chassis lube job. Many places that do oil changes will also do a chassis lube for you at the same time. The axle bearings can get dry and do require lubrication. If left to long without a lube job, pits can form ins ... 2001 Toyota Corolla

Grinding noise from rear axle of 2004 ford explorer

... Cars & Trucks

Grinding metal on metal grinding noise while driving. Already have replaced the axle bearings on front and rear axles.

I had the same problem with mine && it ended up being a simple fix. Check out your heat shield underneath near the back of the car. They tend to come loose and need to be massaged with a hammer or taken out completely. This proble ... 2001 Kia Sportage

I have a ford 8" rear axle with gear noise i replaced the gears 3 times still has gear noise any ideas

Hiya Larry,\015\012 I think the best thing for you to do to save you any more money is to take the car to an expienced and reputable technician who can properly inspect and setup the rear end for you because if you don't you would be guessin ... 1966 Ford Mustang

A client is complaining of a loud and felt thumping noise from the rear axle area. They are thinking rear struts. 92. 500SEL with auto leveling, ADR option unknown, VIN WDBGA51E7NA035055

First I would check your sway bar links in the rear to make sure they are not broken. If the suspension is stiff it is probably your ads accumulaters( I believe it was standard on the 500 model). Also check your fluid level to make sure ... 1992 Mercedes-Benz Mercedes Benz 500 Class

I have a 93 5.0 mustang have noise in the rear axle,checked and found that there is about an 1/8 slide in the axle. checked the ring and pinion and it seems find.any suggestions

It likely has a pitted bearing. Recommend pulling out the carrier and the pinion shaft and checking bearings. ... 1993 Ford Mustang
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0469 seconds