Having problems with your 1997 Jeep Grand Cherokee ?

I have to replace a idler pully o my 1997 jeep grand cherokee lim

\015 I can't find all of the screws to move the radiator\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Just take the top brackets out and lift the radiator out of the bottom cradles
Repair Help & Product Troubleshooting for 1997 Jeep Grand Cherokee

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have to replace a idler pully o my 1997 jeep grand cherokee lim


Just take the top brackets out and lift the radiator out of the bottom cradles ... 1997 Jeep Grand Cherokee

I have a 94 jeep grand cherokee. i repleced the power steering pump, and the pully with it. afterward the jeep keeps eating belts and over heating. i replaced the thermostat. on the way home it over heated and cut off, but there was no fluid running out. as soon as it cooled some i was able to start it and get on the road. please help!!! I'm wondering if its got anything to do with some kind of relay swicth?


If it keeps eating belts I would look at how the pulley is installed, if it is pushed on too far it will have resistance and be misaligned with the other pulleys thus causing the engine to labour all the time. also have a good look at the rest of the ... 2003 Jeep Grand Cherokee

How do I replace the Idler Pulley on my 1994 Jeep Grand Cherokee?


Should only be one bolt going thru the center of the pulley. probably a 14 or 15mm size. ... 1994 Jeep Grand Cherokee

Does the power steering pully need to be removed to replace the alternator on my Jeep Grand Cherokee?


If for any reason the pulley is in your way, remove the pump not the pulley. Alternator is on the other side of the engine...why remove it? The pump is the adjustment for the belt. (loosen bolts and use the transverse bolt underneath to adjust tensi ... 1998 Jeep Grand Cherokee

99 jeep grand cherokee 4.7 v8 oil pressure drops from 40 at idle to 0 when given rpms. Will come right back to 40 when you let idle again. I have removed pan and checked screen. It was clean. Original sending unit was leaking so I replaced. Still thew same. I hooked up aftermarket gauge and pressure never goes below 40 no matter what. Hook back up sender and it acts up again. Don't think 2 senders would be bad. Could it be oil in plug in missing up current?


Oil gauge may be bad, you said you changed the oil sending unit, and tried a aftermarket which worked, so the other option is to have you oil gauge checked. The sending unit may be good but you gauge is not reading proper. ... 1999 Jeep Grand Cherokee

I have a 99 Jeep Grand Cherokee 4.7 oil pressure reads 40 at idle and drops to 0 when given rpms. Pull pan screen was clean. Noticed oil sending unit was leaking, I replaced it. I still have the same problem. Help! Could it be the oil soaked sending unit plug?


I just had the same problem with a malfunctioning gauge with a very oily sending unit. I went to Oreilly's auto and got a replacement sending unit for $38 and put it in and got the same results you did. I would have 40 psi at idle and it would drop t ... 1999 Jeep Grand Cherokee

99 jeep grand cherokee 4.7 v8 oil pressure drops from 40 at idle to 0 when given rpms. Will come right back to 40 when you let idle again. I have removed pan and checked screen. It was clean. Original sending unit was leaking so I replaced. Still thew same. I hooked up aftermarket gauge and pressure never goes below 40 no matter what. Hook back up sender and it acts up again. Don't think 2 senders would be bad. Could it be oil in plug in missing up current?


From what you just said, it sounds like the problem may be the dash gauge itself. I have only seen one oil pump act like that (mine) .... in that case the pump drive gear was turning on the shaft and slowing down as rpm increased but that is so rare ... Jeep Grand Cherokee

Transmission problem 01 Jeep Grand Cherokee limitied. First had code p1762 and replaced the governor pressure sensor and solenoid. Now drives worse shifting in 1st, 2nd, and 3rd mainly shifting from 2nd to 3rd and now has code p1757 saying Governor Pressure Not Equal to Target at 15-20 PSI and Governor Pressure Above 3 PSI In Gear With 0 MPH. Tried disconnecting the battery to reset computuer and still is doing the same thing. Any Solutions.


I had a shifting problem. The car would start in the wrong gear and shift at wrong times. I repaced the governor postion sensor and tranny fluid and the problem has been fixed for several years. Did you replace the tranny fluid? ... 2001 Jeep Grand Cherokee

Need to losen fanbelt to replace my aultinator on my 1996 jeep grand cherokee V8 it seems like I can take off my aultinator. However it looks like I have to losen my fanbelt to release the tention of the pully. Am I looking at ir wrong?


You are correct, you must remove the belt to take the alternator off. ... 1996 Jeep Grand Cherokee

My 1992 Jeep Grand Cherokee makes a high pitched wining noise when I first start it in the morning. It seems worse when the temperature is cooler.It's a 6 cylinder with about 190,000 miles on it.It's had a new water pump two years ago and the upper idler pully was changed last year. [email protected]


If the noise changes when you ...\015\012\015\012rev the engine, check the belt. check tension or try some belt dressing.\015\012\015\012move the steering wheel, check the power steering pump. ... 1993 Jeep Grand Cherokee

Replace idler pulley for 1997 jeep grand cherokee 5.2


... 1997 Jeep Grand Cherokee

The serpentine belt on my 92 jeep cherokee loredo squeaks intemediatly sometimes on startup until the voltage gets up to 14 just replaced the alternator it does not have an idler pully the powerstering pump has the adjustment for tightening the belt sqealing sometimes goes away when i turn off the ac


... Cars & Trucks

How To Install Replace Serpentine Belt Jeep Grand Cherokee 2004 4.0L? I know where the tension pully is located at but the only bolt I see on there is a star type bolt on it but everything else I have seen calls for a 1/2 inch or 15 mm wrench? How do you release the tension on the belt?


Go to u-tube and they will have videos on that I just did the samething with a ford taurs ... 2004 Jeep Grand Cherokee

How to Replace the Blower Motor Resistor in a 1994 Jeep Grand Cherokee Read more: How to Replace the Blower Motor Resistor in a 2003 Jeep Grand Cherokee | eHow.com http://www.ehow.com/how_replace-2003-jeep-grand-cherokee


... 1994 Jeep Grand Cherokee

When key is in the Problem with the Jeep Grand Cherokee 1996 Grand Cherokee when key is in the "on" position my dash lights (check engine, brake, etc) will run their post and then the normal lights will remain on, however my instrument panel doesn't operate at all. The fuel light will come on to indicate that the tank is empty...even though there is a half tank. I've checked the ignition switch, and ignition cylinder. I have replaced the relay for the fuel and starter. I have replace the fuel fi


Well I have never had this problem with a jeep but I have had this problem with some Chrysler mini vans the same year. The problem always ended up being a cold solder on the instrument panel itself. If I resoled the pins on the back of the circuit bo ... 1996 Jeep Grand Cherokee

How to replace jeep grand Cherokee rear axle - 2001 Jeep Grand Cherokee


... 2001 Jeep Grand Cherokee

How to replace tps jeep grand cherokee 2001? - 2001 Jeep Grand Cherokee


... 2001 Jeep Grand Cherokee

Replace a belt on a 1995 jeep grand cherokee - 1995 Jeep Grand Cherokee


... 1995 Jeep Grand Cherokee

Replace 2001 jeep grand cherokee radiator - 2001 Jeep Grand Cherokee


... 2001 Jeep Grand Cherokee

Replace water pump 94 jeep grand cherokee - 1995 Jeep Grand Cherokee


... 1995 Jeep Grand Cherokee

I have a 2004 Jeep Grand Cherokee Laredo with 80,000 miles on it. In the last two years since we've bought it, we've replaced the fuel pump 6 times -- all by the same mechanic! Four out of those six fuel pumps were replaced in the last 6 months. EVERY TIME the Jeep died, we brought it back to him, he replaced the fuel pump, and it ran great again (sometimes for only 45 minutes, sometimes for 2-3 months). Well, the Jeep won't start again and ANOTHER mechanic is telling me it's the fuel pump AN


Recall DateMAR 04, 2004 \015\012Model Affected2004 JEEP GRAND CHEROKEE \015\012DescriptionON CERTAIN SPORT UTILITY VEHICLES EQUIPPED WITH 4.0L ENGINES, THE CRANKSHAFT POSITIO ... 2004 Jeep Grand Cherokee

Can i replace my 2000 jeep grand cherokee engine with a 1998 jeep engine?


... 2000 Jeep Cherokee

1996 Jeep Grand Cherokee Laredo 4wd 4.0 I have had to replace the ignition coil 3 times in a little over a week. The Jeep starts and runs fine for a few days, then while driving on the road the Jeep just shuts down, usually takes it about 10minutes before able to start it again, so i checked to see if its firing when it will not start and No it is not firing, So I replaced the coil and it ran fine for a few more days then the same thing happened. The first 2 coils were purchased at Autozone, The


Also check the crankshaft position sensor by checking if you get any additional error code. ... 1996 Jeep Grand Cherokee

Oil pressure drops to 0 in 2001 Jeep Grand Cherokee Laredo


Does it act different when this happens???? If not do not worry about it. It is just the Oil Pump slowing down with the Motor and will not hurt anything. My 600 HP 95' Silverado does the Same thing and it is not a Problem ... 2001 Jeep Grand Cherokee

1998 Jeep Grand Cherokee - Multi-rib belt Removal & Replacement


Check on upper rad shroud or under hood for routing diagram. Depending on what engine, procedure may vary a little. I wouldn't panic on replacing anything other than belt unless you noticed something noisy under hood in last while.If not up to ... 1998 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.3287 seconds