Having problems with your 1997 Ford Explorer AWD ?

Need to remove the doghouse from a 1997 ford explorer 5.0 liter.

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1997 Ford Explorer AWD

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Need to remove the doghouse from a 1997 ford explorer 5.0 liter.


... 1997 Ford Explorer AWD

How do i remove the fuel pump from a 1994 ford explorer . I have a 1994 ford explorer and i need to remove the fuel pump to replace or see if it just needs to be cleaned can you help me.


Lift the carpet in the back of the vehicle to see if the is a access panel to the fuel tank, to access the fuel gauge.If no access panel then have to drop the fuel tank. ... 1994 Ford Explorer Limited

1999 Ford Explorer Sport. Cracked Lower Seat Frame front of left side hinge attatchment/recliner handle. Lower seat frame needs to be replaced or welded. I am working out of town and can't get to a shop during business hours. Need temporary fix. Can I swap Complete Driver and Passenger Seats? Can I remove Both Seat Assemblies, Remove Slider Tracks, then replace Passenger Seat on Driver's Slider tracks?


... Ford Explorer Sport

I have a Ford Ranger XLT 3 liter six. Why do I have "Starter" persistent problems? I just had my sixth starter replaced. The oil filter oil shield over the starter was removed by Jiffy-Lube when truck was new..they said it wasn't needed. Is oil getting into my starter when the oil filter is removed? Also with a replacement Ford Starter installed...a noticeable whinedown noise is present for a second after starting. Is that noise normal?


... Ford Ranger

1998 ford explorer/ need location to remove and


If your going to be removing all of this I recommend you get the Haynes repair manual on the vehicle so you have the illustrations and directions for dis-assembly and assembly of the starter. The starter should be located on the bottom right of the ... 1998 Ford Explorer

Unable to remove headrest from back bench seat. Need to remove due to being unable see out back window. When facing down no one c ansit there. Must be in upright position to sit there. Unable to locate any buttons to remove, I have a 2006 Ford Explorer EB. Thank you


... Ford Explorer

Need advise on removing the top mounting bolt on a starter of a 1998 ford explorer


Hi Jcetkt, Make sure the park brake is fully engaged. Chock the wheels and prepare a long extension with the correct size socket spanner, (A box wrench set onto a long extension) Slide under the vehicle and loosen it from the bottom. It may be a good ... 1998 Ford Explorer

I need to replace the lifters in my 2004 ford explorer. What is the name and location of the special tool used by the mechanics to remove these lifters?


Try a strong magnet or a dental pick ... 2004 Ford Explorer

I need to know the size of the socket i need to remove my rotor on my 1996 ford explorer 4 wheel drive


Be careful with that. did you remove everything first. to get to the nut. remove the cap. remove the lock dowel. slide the outer retainer teeth off. then inside is the axle nut. i think it is a 1 5/16 socket. after it is out. you may have to pull wit ... Ford Explorer

Ex removed fuses from 1998 ford explorer. need diagram to replace them . just the ones under the hood have been removed.


The diagram is on the lid of the fuse box ... 1998 Ford Explorer

I am removing a transmission from a 94 ford explorer and I was just wondering besides the bell housing bolts the drive shafts and lines and wires going to the transmission what else needs to be done to be able to remove the transmission?


Make sure to remove your transmission cooling lines that run from tranny to radiator also. ... 1994 Ford Explorer Limited

Must the torsion bar be removed on my 1995 Ford explorer 4whdr.6cyl when changing out the lower ball joints? And what kind of puller would be needed to remove the spindle/rotors?


You do not need to remove the torsion bar. just jack up the vehicle under the lower control arm. The shock will also keep the lower control arm from traveling to far. If it has a torsion bar running through the lower control arm than it must ... 1995 Ford Explorer

Need to replace actuator motor on 2003 Ford Explorer XLT and need to know how to remove the dash. I am getting a clicking noise when I switch from heat to air. The heat still comes out of the vents. Air won't come out.


... Ford Explorer

How many bolts will i need to remove when removing starter /what tool/size please?1996 ford explorer sp


If you haven't even looked at the starter, and can't figure out what size a couple of bolts are,take it to a shop. ... Ford Explorer Sport

I have a 2002 ford explorer four wheel drive, do i have to remove the axel to replace the rear wheel bearing? or what do i need to remove to replace it?


... 2002 Ford Explorer

I have a Ford Explorer XLT, 97 and need a diagram of a plastic multi tubed air intake that sits on the top of intake manifold, I need to remove it so I can get to thermostat plastic housig.


... 1997 Ford Explorer AWD

Need to replace 'window regulator' on driver's door on a '96 ford Explorer, 6 cyl. 2w/d. Have removed the inside door panel but need to know the steps to replace the 'regulator'. Is this too difficult for a w/e mechanic??


\015\012Remove the door trim panel and watershield. \015\012Remove the inside door belt weatherstrip and glass stabilizer. Remove the door glass. \015\012\015\ ... Ford Explorer

Transmission removal pictures for a 1996 ford explorer..i need to know how many bolts there are to remove the transmission from the motor


Dimitri; If the Explorer is a 1996, it will have a 4R55E transmission. 1997 and up is 5R55E transmissions, 1995-1996 is the 4R55E, the 4R70W is on the 2002 and up, and the A4LD is on the 1991-1994 Explorers. Just an FIY ... Ford Explorer

Need to replace shift cable on 2000 ford explorer 4.0 liter


... Cars & Trucks

2003 Ford explorer need to remove the interior rear panel


... 2003 Ford Explorer

Need to remove rotor from 1991 ford explored 4x4


... 1991 Ford Explorer

What special tool is needed to remove a rear wheel bearing on a 2005 ford explorer


A press it would be cheaper to but a used rear hub assem ... 2004 Ford Explorer

Need to know how to put a oil pump in a 1998 ford explorer xlt 5.0 liter


The oil pump is internal.Unless you can get the oil pan off,you can't do the job.I'd think you'd have to pull the engine on the explorer especially if it's 4x4.Thats a tight fit.Hope this helps! ... 1998 Ford Explorer

What tool or size allen wrench do I need to remove the oil filter tube that holds the oil cooler in place on my Ford 5.4 liter triton engine?


... 2002 Ford F250 Super Duty SuperCab

Need to locate blend door actuator on 2002 ford explorer, have removed the passenger side kick panel and vents can't find actuator


I am pretty sure you will find it behind the center of dash area. Behind the radio area is where I remember it being. ... 2002 Ford Explorer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.8162 seconds