Having problems with your 1997 Chevrolet S-10 Pickup ?

How to check relay switches on 97 s10 pickup - 1997 Chevrolet S-10 Pickup

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1997 Chevrolet S-10 Pickup

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to check relay switches on 97 s10 pickup - 1997 Chevrolet S-10 Pickup

... 1997 Chevrolet S-10 Pickup

S10 1999 bearings bad 0 oil pressure,removed and rebuilt engine, replaced most all. back in and...Won't start, not a crank or a ticking from the starter. Starter and starter selanoid, battery all tested OK.conecting to starter and starter getting power. Replaced neutral safety switch twice , check all 3 relays all OK. Still no response. Lights and accessory lights all go on when ignition turned. Have tried all gears but still nothing. Could I have forgotten to replace something. Is there a way t

Yes, you can hotwire the starter, use a button starter to energize the solenoid. there is a chance thet the new or rebuilt starter isn't working. it has happened to me I went an bought a newly rebuilt starter but it was no good, it happens sometimes. ... 1999 Chevrolet S-10 Pickup

1998 Chevrolet s10 - No daytime running lights or dim lights. Bright lights work. Changed dimmer/ turn signal switch assembly and checked all relays, fuses, and diode. Help!!

Sounds like the switch itself ,.....or a bad ground which you already covered . but sounds like the switch ... Chevrolet S 10

1998 s10 pickup no drl or dim lights changed dimmer switch checked all fuses relays and drl diode in power dist center brights work fine

... 1999 Chevrolet S-10 Pickup

I have a 1995 Nissan 4 cylinder pickup. It will turn over but will not start. I have changed the fuel filter, checked the relay switch, checked the fuel pump. Any ideas on what to check next?

Always start with the least expensive things, fuses, timing, fuel pressure regulator? ... 1995 Nissan Pickup

89 s10 blazer parking and rear tail lights stay on . changed headlight switch and connecter, brake light switch check bulbs and fuse dont have fuse relay box under hood check radio wiring.could it be

... Cars & Trucks

1996 chevy s10 will not start. battery, fuses, checked. getting power to fuse block from ignition. seem to be getting power to clutch switch. when i jump the pins on the clutch switch it blows the fuse. there is no power to activate the starter relay from ignition but relay power from battery is there.

Check the crankshaft sensor ... 1996 Chevrolet S-10 Pickup

1987 Chevrolet S-10 Pickup1987 chevy s10 2.5l tbi will not start. changed bad fuel pump works well now strong pressure to throttle body. change fuel pressure switch, oil pressure switch, o2 sensor, map sensor, distrib cap, rotor, electric part on dustrib, check for 12v to fuel injector good, check ground good, fuses good, ecm swapped changed fuel injector engine runs now but runs high idle and will not wind down. when i step on gas engine bogs down

Check the trottle body postioning sensor... ... 1987 Chevrolet S-10 Pickup

I'm working on 2000 chev S10 pickup. the blower fan doesn't work from dash controls. I jumpered the moter and it spins fine, I have tested the wiring at the switch and I believe the switch is working fine. When I went to the parts store to check out a new switch, the style in the vehicle is for 2001 vehicles. when I try to trace the wires from the switch to the blower resistor the color of the wire switch somewhere, maybe at the firewall connections. at the blower motor connection, the blue wire

Did you remove and inspect the blower motor resistor - a bad one can stop the blower and make for some hot wires ... 2000 Chevrolet S-10

Blower motor won't work. Switch and blower resistor check out ok. No power at the blower motor. I suspect the blower relay, but even though this relay is shown in my wiring diagrams for the 2002 F150 regular cab pickup, I can't find the location of this relay in my owner's manual. Where is it? Thanks in advance!

In there\015\012 you have four devices to check out to pin point the problem: the switch it's \015\012self, the blower relay switch, resistor block, and the blower motor it's\015\012 self.I find this information in the Haynes ... 2002 Ford F150 Regular Cab

1996 Chevrolet 1500 series 350 Vortec stalls after 2-3 minutes running perfectly. Have jumped out the fuel relay, checked for vaccuum leaks. Starts up aND RUNS FINE FOR 2-3 MINUTES AND HAVE CHANGED out fuel pump recently and new fuel filter. Could this possibly be the emergency fuel shut off switched. I have looked on the passenger side under the glove box and inside the panel and havew not located any sort of switch!!! HELP!!!!!!!

... Cars & Trucks

Describe your 1996 Chevrolet Cavamy cavalier ac broke i check with a mechanic the fuse, relay, ac switch button inside the car,low line valve is full of refant liguad, but i noticed that the raditor fan does not come on when i press the ac on to engage the compessor . is there electrical switch or sensor somewhere near the engine that make the compessor engage. [email protected]

There are pressures sensors on the a/c lines for low and high side pressure. if the high side pressure exceeds a certain high, or the low side doesn't have a minimum, then the pump and fan will shut off. if you took the vehicle to a mechanic and he ... 1996 Chevrolet Cavalier

94 s10 pickup 4wd fuel pump relay location - 1997 Chevrolet S-10 Pickup

... 1997 Chevrolet S-10 Pickup

I have a 97 chevy s10 with a 2.2 engine. fuel pump not running unless power is manually put to it. checked at the fuel pump relay and not getting power from the oil pressure switch. replaced that switch and still the same thing. what could be the problem????

... 1997 Chevrolet S-10 Pickup

I have a 199 chevy s10 4x4. the starter will engage in the run position and stay engaged even when the engine starts. .I've replaced the starter and checked wiring at started. replaced ignition switch(electrical ) and switched relays in power distribution box. i've also moved wiring harness around under hood and under dash. Any ideas????

It is so confusing though I had a go at one sometime and it took a whole lot out of us before we realised that it needed a touch from Chevy garage.Please visit the Chevy Garage it won't cost you much to fix.Good luck and thank ... Chevrolet S 10

I have a 2002 Chevy S10 Crew Cab Pickup. The Windshield Washer Pump does not work. I have replaced the pump and checked wiring from the pump to the steering console and the ground side wire. I can get the pump to work if, I jump power to the steering console wire. That would leave the power to the switch, the switch, or a fuse. All of the fuses in the cab seem to be fine. The engine fuse box had a spot for the windshield washer pump, but no connections for a fuse to go into that spot (not even s

Looking at the Diagram the power for the washer pump goes from the multi-function switch on column to the pump for domestic vehicles and the power fuse also runs the wipers so if it was the fuse your wipers would not work. The fuse in the PDM in the ... Chevrolet S 10

Hi..I have 90 Celica GT model and I came to Autozone to pickup can of Freon to recharge my ac.. Autozone guy came out to check make sure compressor was working when I push the AC button. It was working fine before I purchased the freon..And then when I came out It is not working when I press AC button and compressor will not engage anymore.. I checked AC relays but they are fine and he said it may be the cut off switch on compressor..but I am not sure really whats going on...At the time outside

Did you put freon in the car? If you did, and you have too much, there is a "high-pressure" cut off switch, and there is also a "low-pressure" cut off switch. So, if the freon is too little or too much, the AC is prevented from engaging. The best thi ... 1990 Toyota Celica

1997 Chevrolet S10 pickup turning indicators won't work

I dunno but my 91 silverado does the same thing a friend of mine told me it was a relay and the guy wanted like $400 to fix it i tried to replace my switch and it worked for a bit then started flashing again ... 1997 Chevrolet S-10 Pickup

I have a 1995 chevrolet s10 pickup with check engine light on

... Cars & Trucks

'88 Toyota pickup, carbuerated 4cyl - won't start. have power to guages, can hear relay when turn ignition to start, but won't turn starter motor. Have checked all fuses and fuseable links, replaced starter. Have 12V coming in to ignition. Have 12v at accessory lead at ignition switch. When turn key to start get 7.5v at other lead (brown wire). I'm stumped.

Since you have 12 volts going into ignition. Check to see how much you have coming out of ignition. If you are only getting 7.5 volts to the starter, then there must be a cable connection that is not metal to metal contact, or solenoid is weak, or ba ... 1988 Toyota Pickup

Iam having a problemw with the new fuel pump on a chevy s10, 2001, the truck was running fine and when we left the diner it did start and then when i put it into gear it died, so i had to have the truck towed home, and was told that the fuel pump was bad , no humming in the fuel tank at all, so with the new airtex fuel pump, i spliced the new wiring harness to the old wiring harness, also check the fuel relay switch in the fuse box under the hood,it does click when the key is on. also tried to s

Hii gwpisme\015\012 As there power to the relay when you turn key on...if you do jumper the relay and see if pump comes on...if not check the plug at the pump for 12 v when you turn key on...if you have 12 v relay is ok.. ... Chevrolet S 10

Iam having a problemw with the new fuel pump on a chevy s10, 2001, the truck was running fine and when we left the diner it did start and then when i put it into gear it died, so i had to have the truck towed home, and was told that the fuel pump was bad , no humming in the fuel tank at all, so with the new airtex fuel pump, i spliced the new wiring harness to the old wiring harness, also check the fuel relay switch in the fuse box under the hood,it does click when the key is on. also tried to s

You said the orange wire and the black wires are hot, well the black wire is the ground it shouldn't be hot. That tells me that you have lost your ground and the power is flowing thru to the black wire. look for a corroded ground either on the frame ... 1998 Chevrolet S-10 Pickup

Replace clutch switch chevy s10 1998 - 1998 Chevrolet S-10 Pickup

... 1998 Chevrolet S-10 Pickup

1995 chevrolet S10 has no turn signals. I have replaced all of the bulbs, the flasher, the turn signal switch, and checked the fuses. This problem started after I replaced the heater core.

Are you sure you hooked up all the connectors and the grounds. Forgetting the one wire ground wires is the most likely problem ... 1995 Chevrolet S-10 CA Edition

How to replace a Chevy S10 Ignition Switch - 1999 Chevrolet S-10 Pickup

... 1999 Chevrolet S-10 Pickup
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.7179 seconds