Having problems with your 1997 Chevrolet Lumina ?

WILL A 95 PONT GA 3.1 ENGINE AND TRANS FIT IN A 97 CHEV LUMINA CAR 3.1?

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Not really cause i believe ur car has the 2 engine mounts going 2 the radiator support the ga dont goto milzymotorsports and u can get a kit to put a 3400 or 3500 in your car the 3400 is and easy swap for u
Repair Help & Product Troubleshooting for 1997 Chevrolet Lumina

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

WILL A 95 PONT GA 3.1 ENGINE AND TRANS FIT IN A 97 CHEV LUMINA CAR 3.1?


Not really cause i believe ur car has the 2 engine mounts going 2 the radiator support the ga dont goto milzymotorsports and u can get a kit to put a 3400 or 3500 in your car the 3400 is and easy swap for u ... 1997 Chevrolet Lumina

I have replaced my Catalytic converter with a direct fit replacement, also replaced my engine speed sensor and crank shaft sensor and i still have my service engine soon light on. The latest fault says something about a sylinoid malfunction? The car will not start or is very hard to start randomly...not every time it is cranked, the whole car sometimes jerks going down the road and it feels really sluggish, i have took care of my car trans been serviced 2 times and oil changed religiously..


If a converter failed in less than 12 or more years--you have a problem, that caused it to fail, correct that first,then the new converter.\015\012\015\012If you replaced Sensors yourself, based solely on codes,and did no testing,they may ... 2005 Nissan Altima

I have a 1995 chev lumina 3.1 engine. The car always starts and runs fine when cold. After driving the car for a while and the engine is hot it will restart right away after turning off. BUT if the car sits for 15 minutes or more after shutting off it will not restart. Fuel filter ok fuel pump running ok.It will try to start but sputters out like all cylinders arent firing. Once it cools down enough it starts fine again????


It almost sounds to me like your EGR valve is full of carbon and not able to open properly so your engine is running rich. ... 1995 Chevrolet Lumina

I have a 98 chev lumina 3100 engine, after warning engine for a few minutes car is not throwing any heat. when engine is under load temperature gauge climbs very fast to hot. I checked coolant is full.


Sounds like you have air in your system! ... 1998 Chevrolet Lumina

Oil pan removal on 1993 Chevy Lumina Car. 3.1L. I already have the front motor mount and trans mount out of car as well as the timing chain cover front yolk. Oh and the two dog bone mounts also. Can't seem to raise engine high enough to get clearance enough to remove oil pan. What next?


Took the car out into my back field and smoked it.It was getting to be such a head ache and I couldn't take it anymore so I lit it on fire and watched it burn to the ground.Thanx.Me ... 1993 Chevrolet Lumina

Trans problems 1994 chev lumina, when I shift the car into gear, it will not engage, I have to keep moving the shifter back and forth until it finnally starts to move, the fluid is full, the shifter linkage is moving properly, and there is not just a delay, it sometimes takes many trys to get in gear, and other times just goes rite in, transmision works great and shifts properly as long as it engages, is there something internally just under the pivot arm on top of the trans that has become worn


Possible internal shift linkage problems. ... 1994 Chevrolet Lumina APV

I will do the best I can. I have a Chev Metro LSI 2000 Automatic. The Service engine yellow light on. My Gear Shift is locked in Park. I can move the yellow level that releases the Shift out of Park. I would like to know what switch control the level. Would the Brake switch have anything to do with it? All I would like to do is pass the Calif Smog test. My car passed all the emission test. Failed what is called, Code (P0705)Called Trans Range Sensor Malfunction. (PRNDL) Input. If you can help I


... Chevrolet Metro

Looking for 2005 chev express van 6 liter motor wire diagram Ecu to engine to fuse box. Want to put motor in 65 sub and rewire to meet emission standards for 2005. Also shorten or lengthen wires as needed to fit car better. Will have after market gauge cluster so have figured out oil, alt, temp pressure wire needs. Also speedo and tack. Duane Sorensen


The only way that you are going to get a wiring diagram for the van is to buy a service manual. And the Haynes and Chilton's that you buy at the auto parts stores will not have the wiring diagram in that much detail. So you will have to go to Chevrol ... Chevrolet Express

I have a 1995 Lumina and the transmission clunks very bad when you stop. When driving down the road, the trans is very smooth, but when I stop, it clunks very loud and goes into neutral. I have to put the car in park, then back into drive to start driving again. Also when at idle, it sounds like there is something loose inside the tranny, as it rattles until the engines RPM's are increased to about 1500.


You're discribing a noise that is typical of a tourque coverter dis engageing at low rpm.There is either an internal leak in it or the clutches in it a going bad,the next step is to get the transmission removed or take the car to a transmission repa ... 1995 Chevrolet Lumina

If collant take over filled (over high mark) could this cause sensor problems as engine surges when hot.Not loosing any coolant 2000 chev lumina 70,000 miles. Upper intake manifold gasket replaced along with thermostat and pcv valve (leak) System blead. Car normally runs better with heat turned on. air conditioner compressor bearings making loud noise. Radiator fans comming on about 200 degrees.


No this will not cause a surging, could be the egr valve if that year model has one ... Chevrolet Lumina

1996 pont grand prix, automatic trans, no 4th gear (overdrive) & service engine soon light on, tried shifting manually with shift lever, no difference, disconnected battery, thought something might reset, reconnected, still same problem. 214500 miles on car, tranny rebuilt at 108000 miles


It can be a temp sensor problem. I took the t-stat out of my car and the same problem came to be until i put one back in. ... 1996 Pontiac Grand Prix

Where can i get a mass airflow sensor for my 1993 Chev Lumina that has a 3.1 fuel injection engine.( CAR)?


Local junkyard and pick-a-parts are loaded with 3.1 engine parts, cheap too. They are also all over ebay. ... 1993 Chevrolet Lumina

After rebuilding the engine of my 2002 Jeep Grand Cherokee 4.7 it won't start. I bought the car as a non runner after the previous owner kept driving after the drive belt tensioner seized and shredded the belt, and basically cooked the engine! I managed to buy a brand new lower engine, and had the heads crack tested and rebuilt, I fitted a new timing chain kit and finally fitted it into the car. The battery has been off the car for more than a year, and when I refitted it, there are 2 orange lig


If you had the engine out you may have broke the crank senceronthe back of the engine it gos down in to the little hole in the tranmission the engine won't start if that was broke from taking the engine out ... 2004 Jeep Grand Cherokee

I have a 2001 camaro that wont shift out of 1st gear and the speedo does not work either. i just put the engine and trans in out of a donor car (a 2000 camaro) both had 3800 series ll engines and 4l60e trans. they both worked fine in the donor car. i have swaped the pcms back and forth a few times and i took the vss from the original trans and put it in the donor trans with no change to my problem. i cannot afford to take it to a trans shop so any help would be greatly appreciated. tom


Thats an interesting problem, i would be looking for either a pinched wire or i would also look at the plastic gear on the end of the vss they must be the same color and they should be interchangeable if the are not the same, and while you have the v ... Chevrolet Camaro

Constant P300 code on 1996 chev lumina with the 3.4L DOHC engine


Everything you did is fine but missing a step, check your catalic converter it may be clogged.\015\012\015\012good luck. ... 1996 Chevrolet Lumina Mini

Engine seized put new engine in a camry got the car running. the reason it seized was the owner drove the car with no oil, put the old trans and torque converter back on, and the gears are messed up there was no visable scaring on the outer trans shaft but could the seize have messed up the trans or converter?


If the engine locked up while driving, that could cause the transmission to also lock up and make the car some to a screeching hault. It could cause damage to axles, transmissions, torque converters, etc. ... 2006 Toyota Corolla

I have a 1993 nissan altima which i just put engine in and now have no fire the engine come out of same car however the one i am trying to get running is a manuel trans and the car the engine came out of is automatic trans


There can be a misfire too from the cylinders.An engine that \015\012hesitates, stumbles or misfires when accelerating or when\015\012 it is under load is an engine that is either sucking too much air, not \015\012getting enough fuel or m ... Nissan Altima

1998 audi a4 quattro I changed the engine hooked every thing back up and started the engine up.I ran the engine to operating temp shut it back down checked fluids and restarted ran up to temp. everything seemed normal so iput the automatic trans in gear and had nothing. the trans worked fine before replacing the engine. the trans was left in the car and none of the electrical to the trans was disconnected. I checked the fluid,dropped the pan and found what seemed to be normal wear, no metal fai


Did you replace the torque converter? If so, did you fill the converter with fluid before you bolted it to the flywheel? It sounds like you have no connection between the engine and the transmission. I don't understand how you could get the input sha ... 1998 Audi A4

Changing transmission i have a 2000 accent and i put in a 99 transmission it went right in but there is one wire on the trans and one on car harnes that dont fit all of the other ones fit the car side is a six wire plug and the one on the trans is a four wire plug thanks for your help


I was told by a wrecking yard mechanic that only Hyundai Accent 2000-2005 Automatic Transmissions are compatible, (interchangeable with one another). ... 2000 Hyundai Accent

1994 chev lumina, trans problems


If there is a delay(like 2-3 secs) when you shift from neutral to drive...then down to reverse...most likely the transmission is screwed,or on its way out.Is the Fluid level correct?,and is the fluid red or dark and smelly ?.Dark an ... 1994 Chevrolet Lumina

My 2000 Volvo c70 turbo has a rebuilt trans, engine. Had the car for almost three weeks and now the speedometer shuts off, my odometer reads ---- and red blinking arrow (winter/wet) won't turn off. I've fixed the red blinking arrow once already by turning the car off and then turn it back on as close as on can be without starting the engine, and then shifting from park to drive about fifteen times before turning the engine on. But now that won't work. I really like this car. Always heard Volvo


You do realize no one ever has to go to a dealer,ever,even with a new car,you own it,& as you said the dealersare expensiveWhat about the couple hundred thousand repair shops thatdo the same as a dealer? ... Cars & Trucks

Hi. I have a cadillac BLS with a saab engine. It has a very high oil presure reading and the engine is rattling because of this. It has been stripped and all oil ways blown through, new turbo fitted, oil pump stripped and rebuilt, new timing chain set fitted and the head removed oil ways cleared and then re-fitted. The car now smokes like hell on start up but dose get better after a short time but the oil pressure is still way to high. Apart from a new engine, any sugesstion?


... Cadillac Escalade

1996 Saturn SL, 4 cylinder, auto trans.. Car starts and runs fine. However if you turn off the ignition when the car is hot, the car will not start again until the engine cools down. When you turn the key while the engine is hot the dash lights come on as normal, but the engine does not turn over, not even a click when you turn the key.


I also had the same problem with my 1996 Saturn SL1, and it also was the starter. I thought it was an electrical problem until, just on a whim I pulled the starter. One of the brushes was almost gone and the commutator looked like hell. I cleaned up ... 1998 Saturn SL

1996 Saturn SL, 4 cylinder, auto trans.. Car starts and runs fine. However if you turn off the ignition when the car is hot, the car will not start again until the engine cools down. When you turn the key while the engine is hot the dash lights come on as normal, but the engine does not turn over, not even a click when you turn the key. i have the same problem with my '96 wagon, don't know what to do, wont turn over when hot, have replaced the starter three times in 6 months cause it is burning


Form the saturn..........when starters age they tend to have problems when engine hot.You need to replace the starter.As for the wagon it sounds like some sort of ignition problem if it's turning but not starting........I have seen o2 sensors c ... 1996 Saturn SL

I have a 2003 camry,4 cyl engine auto trans,143000 miles on it, just replaced the trans with used unit with 20,000 mile on it, car dose the same thing, when shifting from 2nd to 3rd it holds the shift high then bangs, or sometimes slips, if car is manually shifted works perfect on original trans, fluid was discolored and burnt smelling, also slow to engage into reverse,the used trans shift to reverse fine, the cooler was also flushed out before installing


Usually burnt and discolored ATF mean pump or torque converter not doing there job or bands and clutches are worn. Shift solinoid or a pressure problem is the problem with 2nd and 3rd gear, Take it to a transmission shop and have them look it over ... 2003 Toyota Camry
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.7120 seconds