Having problems with your 1997 Chevrolet Blazer ?

1997 chevy blazer park neutral switch

\015 Location and troubleshooting\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1997 Chevrolet Blazer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 1998 Chevy Blazer automatic with electronic transfer case switches. I was in a three foot snow drift and had to use 4LO to get out. With the vehicle in neutral and stopped, I pressed the 4LO switch. Although I was able to get into 4LO, both the 4HI and 4LO indicators blinked and then stayed lit. Then I could not transfer from 4LO to 4HI or 2HI. Per instructions in the Chevy manual, I was able to get into 4HI by pressing the 4HI switch in neutral and quickly shifting into park while t


Place the vehicle in 2 wd, then backup about 5 feet. The 4x4 should kick off and now be in 2 wheel drive. If it didn't disengage, then there could be a problem with one of the solenoids. You can test the solenoids with an ohmmeter/voltmeter ... Chevrolet Blazer

1997 chevy blazer park neutral switch


... 1997 Chevrolet Blazer

I have a 1996 Blazer 4X44.3 engine 4L60E trans.the engine is new with only 900 miles on it. The trans is new with 386 miles on it. The Park Neutral Switch on the trans is brand new. The prndl printed circut board led will not light up in any position except when the key is in the unlock position it will light the 2nd gear led in ROD21st positionsbut when the key is turned to the run position none of the led's light up. Continuity checks for Park and neutral confirm the Parkeutral switch is ad


I am no blazer expert but if only the second gear lights up, it sounds like the transmission either thinks its hot because of a bad temp switch or its low level switch is messed up. I would check all switches and systems on the tranny. ... Cars & Trucks

My 1995 Chevy Silverado , 4x4 , 5.7 litre motor will not recognize or go into park. The transmission shift lever will not stay or go into park. I have to place the transmission in Neutral to start the truck. Is it the "shift actuator switch"? Any reply is appreciated. thanks


Sounds like it is slightly out of adjustment - on the shift cable ... 1995 Chevrolet C/K 2500

I have a 1997 chevy blazer that blows the #3 PK- LRS fuse as soon as the headlight and parking light switch is turned on replaced the headlight switch didnt fix it can find a break where it is groundi


Make sure fuse is the right size if not check size it calls for if that doesn't work check for shortages in the wiring in dash and bad contact on wire into the switch ... 1997 Chevrolet Blazer

How do you replace an ignition switch on a 2002 chevy venture van? I have a 2002 chevy venture van and have had a problem with the starter staying engaged. I replaced the started and it fixed it temporarily. The van now does it again but only in park and neutral. The van also tries to start even without a key in it if you move the van much( like entering or exiting the van)I have also checked voltage at the starter and have it only when this noise occurs


... 2002 Chevrolet Venture Passanger

1997 chevy blazer won't shift out of park


... 2004 Lincoln Navigator

I have a 95 chevy blazer and the headlights will not come on the parking lights and inside lights work fine ... could it be the headlight switch ?


... Chevrolet Cars & Trucks

2002 chevy s10 crew cab when i go to shift gears the gear selector will show it is still in D when its in R and it takes a second for it to catch up, but when i shift it to P it doesnt register it, but it is in park. Looking at what it could be it sounds like the neutral safety switch. How hard are those to replace?


... 2002 Chevrolet S-10

Where is park neutral safety on 1999 chevy blazer


... 1999 Chevrolet Blazer

What would cause the rpm and speedometer ONLY to not work in my 2001 Chevy Blazer? Everything else on the instrument panel works exept the speedometer, rpm, and you can't see the the mileage or if the vehicle is in park, neutral, reverse, ets.


... 2001 Chevrolet Blazer

How do you replace a neutral safety switch on a 1999 chevy blazer


BOLTS ON LH SIDE AT MANUAL SHAFT ... 2001 Chevrolet Blazer

I have a 1996 chevy silverado will not start when i turn ignition key either in park or neutral, but will start when i press on starter relay ,could this be faulty ignition switch?


Nuetral safett switch or PRNDL switch ... Cars & Trucks

How do i find and bypass a neutral saftey switch on a 1997 chevy s-10 blazer 4 door 4x4 auto trans


Then here's the way I would do it. The old transmission would have had some wires going to it. One was probably the reverse backup light. The other should have been the wire your looking for. You can take that wire and ground it to the chassis some w ... 1997 Chevrolet Blazer

Where do you find safety neutral switch on a 1999 chevy blazer


... 1999 Chevrolet Blazer

1998 Chevy blazer wont start after replacing battery,starter and neutral safety switch


... 1998 Chevrolet Blazer

2001 CHEVY BLAZER starts but not able to shift out of PARK. if i start in NEUTRAL it is able to shift, WHY IS THIS?


Check the park neutral safety switch. It is a black box located on the side of the transmission. You will want to heat up the switch where the electrical connectors go in with a heat gun, or you will break the switch or connectors. ... 2001 Chevrolet Blazer

1997 chevy blazer 4*4 will not go into reverse , drives and shifts sluggish in forward gears . parked overnight went to back up the next morning and vehicle was like neutral in reverse. fluid level is ok .


You may have a bad revers solenoid. Check the fuse and look for any of the fuse to be bad like the transmission fuse. Best thing to do is get the blazer scanned at Auto Zone free of charge for any DTC codes that may be affecting your tra ... 1994 Chevrolet C1500

I can't get the parking lights to work on my 1980 chevy blazer 4x4 CK4. 1) Where are they located on the fuse block? 2) How do you remove the headlight switch without taking the plenum (heater air duct) out? The bulbs have been tested are are good.


First check the fuse which controls the parking lamp.The fuse is located under the hood.Its in the power distribution box.Its a 20amp fuse.On some fuses its mentioned "PRKLP".But on some its not mentioned.But its 20 amp fuse.So check the fuses in fus ... Chevrolet Blazer

How do you aline a neutral safety switch 2003 chevy trail blazer


... 2003 Chevrolet TrailBlazer

I test drove a 1992 chevy s-10 blazer 4x4.everything worked good except when I shifted from 4 low back to 4 high.I states you have to put it in neutral and put on parking brake to go from 4 high to 4 low which I did.Going from 4 low back up to 4 high the gears would grind any Ideas?


Put in neutral !!! ... 1985 Chevrolet S-10 Blazer

My parking brake light is on and i cant get it to go off its not engaged and i checked the switch its not it. can you help?? its a '91 chevy s10 blazer 4.3 fuel injected 2x2


The brake light can come on for two reasons. I is the brake pedal is engaged witch you have found is not the case. The other is because the brake fluid is low or the sensor that monitors brake fluid level is defective. Check the brake flu ... 1991 Chevrolet S-10 Blazer

How to install a turn signal switch in a 85 chevy blazer v8 right brake light does not work everything else works parking lights


... 1985 Chevrolet Chevy

Replace 85 chevy blazer neutral safety switch


... Chevrolet Blazer

2006 chevy impala park neutral safety switch - Impala Chevrolet Cars & Trucks


... Chevrolet Impala
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.1603 seconds