Having problems with your 1996 Nissan Sentra ?

I need a free radio wire instalations thank you

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

I'm not for sure this is what you need but I'll try to help. Here are the wire color codes:
\012
\012Constant 12 volt + - Pink
\012Switch 12 volt + - Blue
\012Ground - Gray
\012Illumination - red/blue
\012Dimmer - Red/yellow
\012Left front speaker (+) - pink
\012Left front speaker (-) - Blue
\012Right front (+) - White
\012Right Front (-) - Black
\012left rear (+) - light green
\012Left rear (-) - purple
\012right rear (+) - blue
\012right rear (-) - pink
\012
\012I hope this is what you're looking for and that it helps. good luck.
Repair Help & Product Troubleshooting for 1996 Nissan Sentra

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need a free radio wire instalations thank you


I'm not for sure this is what you need but I'll try to help. Here are the wire color codes:\012\012Constant 12 volt + - Pink\012Switch 12 volt + - Blue\012Ground - Gray\012Illumination - red/blue ... 1996 Nissan Sentra

Hi my name is Casey and i am pretty handy but I have ran into a problem installing a new radio for my truck. It states that in the radio manual that the BRAKE wire must be connected to the (-) side of the parking brake system. i have located the brake wire but cannot locate the park brake system. This is need for the dvd portion of the radio to work. Please if you could assist me in locating this i would be grateful and so would my daughter. thank you


Have a look up the arm of , or above the park brake for a switch that is activated when pushed. ... 2001 Dodge Ram 1500 Truck 2WD

Im installing an aftermarket stereo in my 2002 Grand Am.. I bought an expensive harness and its not working.. I have the radio working, but the ignition wire from the radio is hooked up to battery connection which makes it on constantly. I need to know which wire is the ignition wire so it will only come on when the ignition is on. Thanks


This vehicle does not have a switched power suppy in the factory harness. The orange wire in the car harness is a constant 12 volts.\015\012To resolve connect the 12 volt power supply from the head unit to a switched circut at the fuse block a ... 2002 Pontiac Grand Am

I need a pin out, or color code description for the two plug radio wiring harness on a 1996 Ford F-350, so I can install a new Kenwood KDC-108 CD/receiver. I have the pinout and wire color descriptions for the Kenwood pigtail, but can't find the corresponding info for the Ford harness. The Kenwood harness has 14 wires, and the two Ford harnesses have a combined total of 15 wires. I know I'm already in trouble. Thanks


... 1997 Ford F350 Crew Cab

Radio wiring I'm wanting to install a '00-'03 ford f250 stereo single disc head unit into my '93 lx mustang. but i'm unable to find the wiring diagram for the head unit. any free links or diagrams that can help me. thanks


Go on to google, Type the brand and model number into the search box. You will will find sites, where you can down load a manual for no charge. ... 2002 Ford F250 Super Duty SuperCab

Installing a sub in 2008 Sierra with factory in-dash 6-CD, XM. What's the best way to get to rear of the radio? I just need speaker level for the input but it would seem better to go from the radio instead of trying connect to door speakers and fish wires through door harness flex cover. Thanks


Hi,This radio/stereo system does not have aux inputs it only has a 16 pin plug on the back and the antenna etc but not aux output connectors for an external sub woofer.You will need to get a separate amplifier, and then wire this in ... 2008 GMC Sierra 1500

I need to install a snap on ferrite on the fuel pump electrical wires. Where and how accessible are they? I am a Amateur Radio Operator and I believe I am getting fuel pump noise into my radio. Thank you.


If you go under the car you will see the harness that comes from the tank, that harness is for the pump and gauge sending unit. Doubt if you are getting noise from there though, Most likely "noise" source is the alternator which usually has a capacit ... 2003 Saturn VUE

Wiring diagram need a free wiring diagram for 02 chevy malibu to install remote start and keyless entry. thanks


Try this link\015\012http://64.85.6.121/diagrams/printpage.asp?ModelID=17081&MakeID=54 ... 2002 Chevrolet Malibu

Need diagram on wiring harness for 1984 f150 radio old radio gone putting in a different one a ford model no.6A-D7AF-19A241- AB so I need to know what color wires need to be hooked to the wires on the radio and what they are for like the power, light, left and right speakers and so on. Thank you in advance for your help. Dwight


... Ford F-150

I need a free wiring diagram for a 1991 Sunbird radio & speaker installation


... 1991 Pontiac Sunbird

I am trying to install a after market cd player and i need to know what all the wires from the car radio go to. thank you


1998 Hyundai Elantra Car Stereo Radio Wiring Diagram\015\012Car Radio Constant 12V+ Wire: Light GreenCar Radio Ignition Switched 12V+ Wire: BrownCar Radio Ground Wire: BlackCar Stereo Illumination Wire: Dark Green/White ... 1998 Hyundai Elantra

My radio in my truck has soped working and I need to install a new radio. However I do not know which wires go to what speakers etc. Can you help me identify which color wires represent the speakers they go to and all the color wires needed to hook up a new radio.


I always would go to bestbuy or walmart to get a harness adapter kit and the radio bezel installation kit to install an aftermarket radio. Just plug it in, and the wires are all labeled for speakers, antenna, power, etc. ... 1996 Chevrolet Cavalier

I have an x type jaguar with a radio witch has a phone simble on it for hands free, i have a hands free which i want to wire in to the radio instead of being seperate powered by the cigarett lighter can you tell me how it is posible to do this as im not that clued up about radio wiring many thanks peter.


I'm not being difficult but you will have problems doing this if you already lack the knowlege of how to do it. I would not recomend this but if you must do it your best bet would be to splice into the cig lighter supply and fuse a seperate supply fr ... 2002 Jaguar X-Type

Replacement radio i am replacing radio in 1991 honda accord original was stolen (wires cut) will any radio work ,do i need codes? also need wiring diagram thanks for any help


No codes but not just any radio will fit in the dash, contact these folks for advice and help picking the right radio.\015\012\015\012http://www.crutchfie ... 1991 Honda Accord

Radio install Hi there, I am trying to install a simple Kenwood receiver/CD player into my '81 Toyota Tercel. I have all the wires matched but a blue and red one coming from the Kenwood. A radio specialist said I did not need the blue one, and the red one could be wired right into the fuse box. This sounds kind of half-assed to me. It's the one that goes to the battery. He said I could also splice it in with the one that goes to the ignition, but that the radio would be on all the time unle


... 1983 Toyota Corolla Tercel

Radio installation what wires do i need coming out the car to make my girlfreinds radio to come on and what wires do i need from the radio


I think it really depends on what one she has. Mine was the full unit with tape and CD. When I got my car the radio didn't work. I later found out that the amp under the passanger seat went bad and took down the whole system. Toyta, for some reas ... 1992 Toyota Camry V6

Need a wiring diagram for a 2004 mitsubishi mirage hatchback radio. I have a new radio I am to install and need a wiring diagram for the connector into the unit to hardwire a new connector.


Shops that sell car radios and do the installing will have the right connectors for this job. ... Cars & Trucks

2004 cavalier, hooking up aftermarket radio, and there is no wire in the harness from factory for an inigition wire that the aftermarket radio needs. what wire/color in the ignition do i need to tap into to make that work. car is a base model, no power options, has factory cd player. thanks


Should be a feed 12v permanent and a 12v feed from the ignition switch it must have these two wires ,so use a multi meter and find them ... 2004 Chevrolet Cavalier

1985 gmc s15, no air, 4wd, 2.8L jasper engine, NOT a stock gm engine. 6 cyl. need wiring diagram for it, OR need to know if the haynes manual has the right diagram for that truck. all i need right now is to know which wire is for the cig lighter so i can install a lighter to charge my cell phone. i tried another site called free wiring diagrams.com or something like that 6 weeks ago. they said it would take 7-10 days but i never heard from them.


... 1989 GMC Sierra

Im installing a high amperage alternator for my 1999 hyundai accent 1,5 liter engine.i need to know the color code of the two wires because im going to have to cut them and i need to identify them. i need to know which wire color is for the ignition and the color of wire for the gauges out put of alternator please help thank


White/red goes indrectly to the red light for charge.\015\012pink/blu goes to engine controls system through fusible link\015\012 ... 1999 Hyundai Accent

RADIO HARNESS WAS CUT TO INSTALL CD PLAYER BUT IGNITION/STARTER FUSE KEEPS BLOWING.SO CD PLAYER WAS TAKEN OUT AND CONNECTOR WAS RE-ATTACHED TO WIRES. DASH LIGHTS WORKS ,HEAD LIGHTS WORKS,ETC., BUT WHEN YOU TURN THE KEY TO START ENGINE , THE IGNITION/STARTER FUSE BLOWS AGAIN. NO CLICK ON STARTER NOR DO STARTER TURN OVER. COULD THE STARTER SOLENOID BE BAD OR THE RE-ATTACHMENT OF WIRING TO RADIO HARNESS IS BAD. WIRES ARE COLOUR CODED AND ORIGINAL RADIO IS NOT HOOKED UP. ANY IDEAS THANKS HARRY


It might have just been a coincidence, but it sounds like it might be your starter as you have guessed. ... 1999 Chrysler Cirrus

Installing aftermarket radio need color code for explorer wiring


Http://www.the12volt.com/installbay/stereodetail/858.html ... 1994 Ford Explorer Limited

How to install new ingnition wires on a 1995 Honda Accord with a 2.2 liter 4- cylinder engine Wires were detached from the distributor. I need to the know the sequence for the installation of the new wires. Which wire to which spark plug. If you have a picture of the sequence it would be great. Thanks, Jim


The firing order on most inline 4's is 1-3-4-2. If number one is marked on the cap then all you have to do is take the cap off and have someone crank the engine with the starter to see which way the rotor turns.\015\012If the cap is not marked ... 1995 Honda Accord

I'm trying to install a new radio in my 04 pontiac sunfire and i need a wiring diagram for the factory wires in the car to match them up.


... 2004 Pontiac Sunfire

Trying to hook up after market radio inside my 2005 chevrolet impala using a wire harness but it will not come on. I had another radio installed before this one but someone broke in my car and stole it. I have checked all of the fuses but getting not power. I asked around and was told that I have the right wire harness but it needs to be hooked up a different way for it to work. Can anyone help me with this problem and tell me which wires have to be crossed.


I had the same issue. You have to run the red power wire to a suitable 10 amp fuse in the fuse panel. Just remember that when you look for fuses, you connect to one that is not "hot" at all times. Meaning connect to one that operates off the key o ... 2005 Chevrolet Impala
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 2.8304 seconds