Having problems with your 1996 Jeep Grand Cherokee ?

1996 jeep grand cherokee 4.0

\015 Not starting/turning over\015
Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1996 Jeep Grand Cherokee

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 97 jeep grand cherokee larado with a 91 grand cherokee motor in it, my oil pressure will go from 40 to 0 every now and again when i come to a stop any solutions?


Gauge or sensor could be bad and could be oil pump going bad....hope this info helps and if so please leave rating on this post and good luck. ... 1991 Jeep Cherokee Briarwood

Help! Just purchased a used 2004 Jeep Grand Cherokee and the speedometer jumps from 0-70. Had it checked at 3 shops, 2 of which were Jeep dealers, and none of them can figure out what's wrong. I haven't had my Jeep for 34 days and I just want it back :( Any suggestions?


Did anyone check for a binding or defective drive cable? ... Cars & Trucks

I have a 2000 jeep grand cherokee 4.7 liter 4x4. the problem i am having is that when i turn the jeep on and it is idling the oil pressure is at about 40 lbs. however as soon as i touch the accelerator the pressure will drop to 0 until i let off the accelerator and then it will return to normal. it only does this after the engine gets cold or the first start of the day. the outside temperature seems to affect this some what because i used to be able to let the jeep warm up for 10-15 minutes when


... 2000 Jeep Grand Cherokee

I have a 95 Jeep Grand Cherokee that I traded in on the c4c deal. I have not yet taken delivery (they are waiting for the gov't $) and my Jeep died a couple of nights ago, it was running, I stopped, parked, ran into a store, came out to restart, it sputtered and choked then died. It tries to start but won't turn over. After a tow and many tests, my mechanic says it is the fuel pump - he's getting 0 pressure from it, although the wires show power. He tried banging on the tank to jolt it for "


I dont know why Chrysler did this,but yes you have to get the whole unit,it is called a fuel pump sending unit.Did you consider getting a used unit for a lot less,and if your lucky fewer miles on the part. ... 1995 Jeep Grand Cherokee

My 2001 Jeep Grand Cherokee Loredo, straight six, is having a problem that the oil pressure gauge goes to 0 and my check gauges light comes on but when i accelerate it goes back up and the light goes off. Is this a sensor issue? Nothing seems to be wrong w/ the jeep


Your problem could be the result of a bad pressure sending unit but I would take care of that immediately. If the pressure doesn't return to normal after installing the new unit, do not drive 'til you have a mechanical gauge installed and the actual ... 2001 Jeep Cherokee

97 Jeep grand cherokee 6 cyl. idles down to 0 and dies.


Any leaks in intake or exhaust upstream of the sensors, sparkplug\015\012condition and engine controls/sensors for out of range operation\015\012(including fuel pressure and condition of regulator) \015\012IAC should be cleaned and checked as t ... 1997 Jeep Grand Cherokee

Oil pressure drops to 0 in 2001 Jeep Grand Cherokee Laredo


Does it act different when this happens???? If not do not worry about it. It is just the Oil Pump slowing down with the Motor and will not hurt anything. My 600 HP 95' Silverado does the Same thing and it is not a Problem ... 2001 Jeep Grand Cherokee

99 jeep grand cherokee oil pressure drop to 0 could it need oil or what ??


... 2002 Jeep Grand Cherokee

On my 2002 jeep grand cherokee the malfunction idicator lamp is on but code reads 0


... 2002 Jeep Grand Cherokee

The speedometer in 1995 jeep grand cherokee doesn't work all the time. My friend started it up last night and drove off with it cold and she said that the speedometer stayed at 0 for about a mile and a half then bounced a little and then started working. what would cause this.


The corresponding fuse is bad and needs to be replaced.Rate this. ... Toyota Pickup

2001 jeep grand cherokee 4.7 v8. my oil pressure drops to 0 when sitting at a stop light but fine when i am driving


It is your oil pressure sensor I had the same problem it is right above the oil filter they crack and leak oil through them and it shorts them out, atleast that's what cause my oil pressure to do that ... 2001 Jeep Grand Cherokee

99 jeep grand cherokee 4.7 v8 oil pressure drops from 40 at idle to 0 when given rpms. Will come right back to 40 when you let idle again. I have removed pan and checked screen. It was clean. Original sending unit was leaking so I replaced. Still thew same. I hooked up aftermarket gauge and pressure never goes below 40 no matter what. Hook back up sender and it acts up again. Don't think 2 senders would be bad. Could it be oil in plug in missing up current?


From what you just said, it sounds like the problem may be the dash gauge itself. I have only seen one oil pump act like that (mine) .... in that case the pump drive gear was turning on the shaft and slowing down as rpm increased but that is so rare ... Jeep Grand Cherokee

I have a 1996 Jeep Grand Cherokee Laredo 4.0L. About a couple of months ago, my dad did a tune-up on it: changed the spark plugs, the O2 sensors, and the fuel filter. However, recently my car has started to stall. For example, I was driving, and was about to turn onto another street. In the middle of the intersection, my car "shut off". The engine died because the gages all went down to 0, the power steering went out and the brakes were hard to push, but all the electricity was on like the radio


Is there a check engine light on when truck is running ? Does it stall when you hit bumps, only when you turn, stop ? ( my concern is the sometimes dont start.) for a minute or next day or what. Take it to a garage and have them do a fuel pressure te ... Jeep Grand Cherokee

Shock size ok so i go to the auto parts store and tell them i need shocks. tey ask if its a 0 inch lift, 1 , 2 , 3, upcounty ect ect. i got this car used im 95% sure its stock suspension. i have a 98 jeep grand cherokee limited. could someone tell me what size is right


They are talking about the lift it has, if it's stock, you need a 0 lift shock. ... 1998 Jeep Cherokee

Oil pressure down to 0 - 2001 Jeep Grand Cherokee


Obvious question: Is the oil in the engine full and is the engine making any noise? If the oil is full and not noisy, likely the oil pressure sending unit has failed (usually located somewhere near the oil filter on most engines)If the engin ... 2001 Jeep Grand Cherokee

I have a 99 Jeep Grand Cherokee 4.7 oil pressure reads 40 at idle and drops to 0 when given rpms. Pull pan screen was clean. Noticed oil sending unit was leaking, I replaced it. I still have the same problem. Help! Could it be the oil soaked sending unit plug?


I just had the same problem with a malfunctioning gauge with a very oily sending unit. I went to Oreilly's auto and got a replacement sending unit for $38 and put it in and got the same results you did. I would have 40 psi at idle and it would drop t ... 1999 Jeep Grand Cherokee

Oil pressure idal 0 when stopping - 1999 Jeep Grand Cherokee


Try replacing the oil preasure switch if the gauge is still 0 when stopping then have a gauge test done this is where the switch is removed and a gauge is installed for acurrate readings if the reading is still low then oilpump or main/rod bearings a ... 1999 Jeep Grand Cherokee

How can I get the belt routing diagram for a 2000 6cl 4,0 l Jeep Grand Cherokee Laredo 2x4. I need to install the new belt but I dont' have the routing diagram


If your getting your belt from autozone or NAPA the routing is on the back of the package ... 2000 Jeep Grand Cherokee

99 Jeep Grand Cherokee 4.7 Oil Pressure reads 40 PSI at Idle and drops to 0 at higher rpms. I just changed the Oil Pressure sender/ Same Problem


I'm having the same problem. Did you get yours fixed? ... 1999 Jeep Grand Cherokee

99 jeep grand cherokee 4.7 v8 oil pressure drops from 40 at idle to 0 when given rpms. Will come right back to 40 when you let idle again. I have removed pan and checked screen. It was clean. Original sending unit was leaking so I replaced. Still thew same. I hooked up aftermarket gauge and pressure never goes below 40 no matter what. Hook back up sender and it acts up again. Don't think 2 senders would be bad. Could it be oil in plug in missing up current?


Oil gauge may be bad, you said you changed the oil sending unit, and tried a aftermarket which worked, so the other option is to have you oil gauge checked. The sending unit may be good but you gauge is not reading proper. ... 1999 Jeep Grand Cherokee

2000 Jeep Grand Cherokee Limited oil pressure gauge is dropping to 0 when idling in gear. What is wrong and what do I have to do to ix it?


First check the oil level and top up as necessary. If the oil pressure is at 0 , then it would very quickly sieze the engine, that not being the case, it sounds like you need to replace the oil pressure switch/sensor, which will be mounted either on ... 2000 Jeep Grand Cherokee

Loud noise! 0 Jeep Grand Cherokee after about 5 min starts a very loud high pitch whinning.It used to eventually go away but now it is always whinning and even louder!Seems like it's coming from drivers side engine compartment near the intake manifold. I thought it was a belt because when you step on the gas the rpms go up and the noise quits until you slow down or come to a stop then it starts again!! Is it a vacuum leak? A bearing seizing somewhere? Belt tensioner?


I would say a bad pulley also. Try to open the hood at idle and see if you can hear where it's coming from. Possibly a bad idle pulley or even the fan belf if yours is a mechanical fan. ... 2000 Jeep Grand Cherokee

95 jeep grand cherokee rpm goes to 0 and then starts back up what is this


Hey,\015\012I have the same year and model. Mine does it too. I've spoken to someone about this before and they said it is common for our jeeps to do that. There is some repair that you need done, and should cost around $250. If you don't get i ... 1995 Jeep Cherokee

Transmission problem 01 Jeep Grand Cherokee limitied. First had code p1762 and replaced the governor pressure sensor and solenoid. Now drives worse shifting in 1st, 2nd, and 3rd mainly shifting from 2nd to 3rd and now has code p1757 saying Governor Pressure Not Equal to Target at 15-20 PSI and Governor Pressure Above 3 PSI In Gear With 0 MPH. Tried disconnecting the battery to reset computuer and still is doing the same thing. Any Solutions.


I had a shifting problem. The car would start in the wrong gear and shift at wrong times. I repaced the governor postion sensor and tranny fluid and the problem has been fixed for several years. Did you replace the tranny fluid? ... 2001 Jeep Grand Cherokee

My 2004 jeep grand cherokee se shuts off while im driving down the road. the over head computer that reads miles to empty goes from 300 to 0. it fluxuates and the car doesnt want to run. it will run for short periods of time then shut off


... 2002 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 1.0846 seconds