Having problems with your 1996 GMC Yukon ?

I need to replace the CD player on my 1996 GMC Yukon

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1996 GMC Yukon

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2003 GMC Yukon XL All gauges on instrument panel stopped working. They all stopped at 0, including spedometer, rpms, fuel, oil, etc. The electrical odometer is still working. Is this a fuse problem or does the entire instrument cluster need to be replaced?


If this is an intermittent problem,\012remove the IPC 10A fuse in the fuse box under the hood,\012not in the fuse panel by the driver side door,\012for 5 minutes.\012The electronics will reset. ... 2003 GMC Yukon XL

2003 GMC Yukon XL All gauges on instrument panel stopped working. They all stopped at 0, including spedometer, rpms, fuel, oil, etc. The electrical odometer is still working. Is this a fuse problem or does the entire instrument cluster need to be replaced?


Sounds as though u have experience the GM usual cluster failure. They go bad more often then probably any other vehicle. Gm has been replacing some under a goodwill warranty for some customers. ... 2003 GMC Yukon XL

I need to replace the CD player on my 1996 GMC Yukon


... 1996 GMC Yukon

I have a 2009 GMC Yukon XL and need to replace the passenger side view mirror. It is a power, heated mirror with signal. Does the triangular panel by the window the access to replace the mirror or do I need to remove the entire door panel?


... 2009 GMC Yukon XL

Gmc yukon windshield washer pump replacement procedure. The dealer of course painted a picture of a long drawn out repair. I am a vending mechanic by trade so repairs are not an issue but need to know the quickest way to get it out and fixed. I need to replace both pumps, the one for the rear and front.


These instructions are for the regular size Yukon, but hopefullly will apply to your XL. Despite what you may read elsewhere it is virtually impossible to access the pumps and fittings without releasing and lowering the reservoir. Release the four p ... 2001 GMC Yukon XL

Need to replace fuel pump 2001 gmc yukon


... Cars & Trucks

Need a diagram of a 2001 GMC Yukon door, power window motor needs to be replaced


The diagram is kind of small, but here is some info.\015\012\015\012Removal Procedure:\015\012\015\012Raise the window. \015\012If the window motor is inoperable, remove the window to gain access t ... 2001 GMC Yukon

2004 GMC Yukon. Speedometer is reading much faster than my actual speed. Then sticks sometimes. Checked with GM dealer here and they said that if my vehicle had less than 70K they would check the speed cluster and replace, free of charge, if bad. My vehicle has 88K and not covered. The cost to replace the cluster is approximately $500. Would you think the problem might be the speed sensor on the transmission? How would I check to see if this might be what is needed? Suggestions?


If you have cruise control in the vehicle you can test to see if it's the speed sensor or the cluster. If cruise control works, the problem is in the cluster not with the sensor. And it's most likely the stepper motor issue.There was not ... 2004 GMC Yukon

I have a 2004 yukon denali with 100,000 mi today my oil pressure indicator went down to 0 and the alarm went off. i took it to my mecanic we thought we could replace the switch, and after that 300.00 dollar repair im still loosing oil pressure ,do you think it needs an oil pump? or do i need a new engine?


If it's not blowing blue smoke indicating bad rings or valve guides, you may have a blocked oil pickup screen. This problem can occur with certain types of pan gaskets that break up and get sucked up to the pick-up tube screen.\015 ... 2004 GMC Sierra Denali

Replace cd player for 03 yukon - 2003 GMC Yukon


Pop out the old cd player disconnect it and plug in the new one and pop it back in ... 2003 GMC Yukon

2001 gmc yukon the HVAC Heater Blend Door Actuator needs replacing. need to get dash board off seems like passenger side air bag holding it up


... GMC Yukon

1996 gmc yukon. replaced fuel pump 3 times in 2 months, finally running then it wouldnt start one day. cranked it over for awhile and nothing. sat 15 min it started right up, drove home shut off, then started back up. next day no start. just replaced fuel relay still no start, checked fuel pressure its at 0, is it possible the pump is bad again or could it be the clip for the power to the pump being loose or faulty?


This is a very common problem. GM has issued a service bulletin to replace the wiring connector at the fuel pump assembly on top of the tank. check the end of the plug for burnt terminals. the service bulletin states that these corroded connectors ca ... 2000 Chevrolet Tahoe

Need to remove the column cover on my 1996 GMC yukon so i can check the connections on or replace the hi beam-low beam/wiper/turn signal switch. I have intermitent low beam headlights and I have replaced the on/off switch and I am able to make the lights go off/on by wiggling the wire bundle going up inside the column.


The steerin wheel screws have come loose inside the steering colum, if you can move the steering wheel up and down and back and forth you will have to remove the air bag the horn and horn button and tighten the two screws that are tork heads #8 to fi ... 1996 GMC Yukon

Need to replace a ignition control module on a 97 gmc yukon V8 5.7 eng don't know how to get the old one off do I need a particular tool?


Theres a bracket bolted to the intake and the throttle body and after it's unbolted and the wires from the module and the coil unplugged the module is bolted to the bracket and it's alumunim heat sik with two 5.5MM headed bolts and the coil you have ... 1997 GMC Yukon

Need to replace antenna on 2001 GMC Yukon - is this something I can do or do I need to take in to dealer?


... 2001 GMC Yukon

I need to replace the rear wiper arm on 2007 GMC Yukon


... 2007 GMC Yukon

I need instructions on replacing a heater core for my 2005 GMC Yukon.


... 2005 GMC Yukon

Need to replace the fuel pump in 1997 GMC Yukon 4 door


... 1997 GMC Yukon

I need to replace 2 of the tires on my leased Yukon Denali. Does GMC care (for turn-in purposes) if the 2 on the front are a different brand than the 2 on the back, as long as they are all the right size, etc.?


Nope.It is recommended though that your new tires, have a similar tread pattern and similar rubber compound as the tires you already have. Tires of different tread patterns and different compounds will act differently (corner, braking, wet tra ... 2006 GMC Yukon Xl Denali

How do you install an a/c compressor belt, my a/c quit last summer the mechanic told me today the belt broke. How difficult is the installation and do I need to replace the tensioner. Thanks. My truck is a 2001 GMC Yukon XL with a 5.3 ltr.


... 2001 GMC Yukon

I have a 2001 gmc yukon need to replace some speakers, where can i get them at?


... 2001 GMC Yukon XL

Need to replace water pump. how easy it it? - 1999 GMC Yukon


Pretty easy. Just drain antifreeze. Then loosen 4 bolts that holds fan to pulley. Remove plastic fan schroud and fan pulley. Loosen water pump bolts in criss cross pattern and remove water pump. Clean surface install new gasket and water pump install ... 1999 GMC Yukon

Need to remove the wiper arms to replace a cracked cowl on a 2005 GMC Yukon. How do they come off?


On most g.m. products they're on a spline you need to pry them upward and away from the linkage,they can be tough so hold other parts so you dont bend or break anythinf,also if you can get some penetrating oil up there it may help too, lots of dirt a ... 2005 GMC Yukon

Hello I need to replace all four of my O2 sensors for my 1999 GMC YUKON does any have instruction or direct me where I can find them


Locate the sensors in the exhaust pipes below the exhaust manifolds and behind the catalytic converters. Disconnect the sensors at the connectors. Using a special sensor socket or a box wrench, unscrew the sensor from the pipe. This may be easier ... GMC Yukon

Need help with my 99 gmc yukon! replaced map sensor, and idle air control module. getting gas to shaffer valve, getting spark to the spark plugs. yellow fire.


Im guessing the vehicle wont start? If so you shouldnt rule out fuel just because your getting fuel to the shrader valve, these vehicle require a certain amount of fuel pressure to run, im guessing around 60psi, so i would check fuel pressure, if ok ... 1999 GMC Yukon
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.0453 seconds