Having problems with your 1996 Geo Prizm ?

My turn signals dont work and i replaced the fuses alreadt

Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Flasher is bad,under the dash or mounted in fuse panel
Repair Help & Product Troubleshooting for 1996 Geo Prizm

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My turn signals dont work and i replaced the fuses alreadt


Flasher is bad,under the dash or mounted in fuse panel ... 1996 Geo Prizm

Where are the flasher relays located on a 2000 Dodge Durango? My turn signals dont work, but everything else does. Recently replaced the multi function switch too and it solved all the problems except for the turn signals. I have checked the fuses I could find labeled in relation to the area. The 4 ways work perfect, just have no turn signals now.


... 2000 Dodge Durango

When i turn the igniton key to on the fuse for the heater/ac blows.at first the turn signal stoped working when the heater /ac fuse blew. I replaced the fuse. the turn signal and heater worked for 2 days then the fuse blew. I removed the fuse for the heater/ac and the turn signal worked for a day. now the turn signal does not work and when I turn the ignition on the fuse blows immedietely. I downloaded a fuse box diagram from wjjeep.com/fuses and it states that fuse # 20 10amp controls ignition


The ignition run is to the ECU or Engine Control Unit. And the blinker sense is for the blinkers to chime when left on for more than one minute. Finding these kinds of problems are very hard. Because from what you said earlier that it ran for 2 days. ... Jeep Grand Cherokee

My 1999 jeep grand cherokee has no brake lights and my turn signals dont work ...fuses and bulbs are good i replaced the brake switch.i had to remove my turn signal fuse while driving due to constant left turn flash;where do i look now?


Checked fuse & relays box under hood, usually on drivers side fender area. Should be labeled underside of cover. ... 2002 Jeep Grand Cherokee

My top break light works all the time....but the other break lights dont come on unless i use my turn signal.....also my running light do work properly.....why would just the brake lights not work when the other one mounted to the rear glass does? i have replaced the bulbs, checked all fuses, and replace flashers....i dont know what else it could be....please help!!!!


The brake light switch is located in top part of the brake pedal and it controls all brake ligts the top and bottom lights use diferent power line, both come from brake light switch. ... 1997 Oldsmobile Cutlass Supreme

My 1987 dodge ram chargers front and back turn signals dont work as well as my braking lights. My headlights and rear lights work. ive replaced the turn signal flasher and fuse that are located inside my under the steering colum and put new bulbs in the rear but still nothing works


... 1987 Dodge Ramcharger

1993 ext cab toyota pickup (22re engine) lost passenger side blinker assemly one day, replaced it the next and now my turn signals dont work at all but my hazards do. Where is the fuse for the turn signals? I dont have a diagram.


... 1993 Toyota Pickup

I own a 2000 pontiac firebird. Just today, the turn signals stopped working. they dont flash in the dash panel and they dont flash on the car however, my hazard lights work perfectly. The fuses are good too. i dont know what it could be. i already replaced the bulbs but that didnt work. any help would be greatly appreciated.


... 2000 Pontiac Firebird

My 1998 Dodge Ram pickup's flashers arent working. I checked the fuses and (unless I missed one) they seem to be in good working order. I replaced the flash fuse (box looking thing that has 5 prongs in the fuse box). All the lights work but the turn signals and hazards do not. I also noticed when I step on the brake the tail lights dont brighten up either. What could the problem be?


Look for voltage coming to the signal switch, from two sources one live one from the brake pedal , then from the switch out ... Cars & Trucks

2002 ford ranger stepside 4x4 wipers an turn signals dont work already replaced turn signal switch an relays fuses seem good


... Cars & Trucks

My brke lights dont work on my 2001 s10 but everything else works tail lights turn signals hazard lights and even the third brake light i have replaced bulbs, checked fuses and replaced the brake switch


I would check sockets to make sure they are not corroded, if they are not then I would start checking the actual wiring harness. ... 2001 Chevrolet S-10

I have a 96 honda accord. A few weeks ago my turn signals didnt work. i inspected it and thought that maybe it was as simple as a fuse. So i replaced the fuse and sure enough it started working. two weeks later i get in my car after work and they turn signals fail to blink or click. I replaced the fuse again. when i hit the switch it doesnt do anything. So i went to a junkyard and found a switch from a 95 honda accord. i took out my old switch and put that in. This did nothing. the headlight par


I think that you have a bad flasher unit try replacing that. ... Honda Accord

My left turn signal no longer works on my '00 T&C. Hazards, brakes and right turn signal works. I've replaced both lights in front and back, replace turn signal switch and check fuses'. What else can I do. Also, when I replaced the turn signal switch, i noticed that a wire was not plugged into the back of the steering wheel. Not knowing what it is I am not willing to plug it back in. I do have pictures, but no idea how to post them. Any ideas are grateful.


SOUND LIKE WIRE PROBLEM.YOU NEED A WIRE DIAGRAM TO CHECK THE TURN SIGNAL SWITCH WIRING DONT PLUG A WIRE IF YOU DONT KNOW WHERE IT GOES COULD CAUSE ELECTRICAL BLOW OUT.TRY TO GO ON LINE LOOK FOR AUTODATA DIY COM LOOK FOR ELECTRICAL DIAGRAM. ... 2000 Chrysler Town & Country

95 mustange gt brake light dont work check #9 fuses change all bulbs replaced switch on brake pedal hazards lights works ,parking or running lights works,turning signal lights works,what other places i should check is there a relay on there plz help me


I assume the fuse has power if the hazards work.The third brake light skips the turn signal switch, the regular brake light circuit goes thru the turn signal switch.Do you have power going into the turn signal switch on the red lite green wir ... 1995 Ford Mustang

Turn signal periodically the turn signal will stop working. When the truck is first started the turn signals will work fine. After 5 or 10 minutes of driving the turn signal will stop working. The interior indicator will stay solid as will the exterior turn signal lights ( all lights work). We have replaced the fuse and the turn signal switch.


Now replace the flasher unit! Frankster016 ... 2002 Nissan Xterra

On my 2003 cadillac escalade the left turn signal works sometimes and sometime it wont flash or it just dont work at all. Even when I turn on my emergency flasher the only flasher that works is the right turn signal and not the left. I checked the bulb and the fuses which the truck mannuel states this might be the problem and nothing is wrong with the left flash fuses or the left bulb for the left turn signal.


... 2003 Cadillac Escalade Ext

2005 colorado the rear turn signals dont work and the hazard don't work on the back they do work up front and I replaced with new bulbs.Do you think it may not have a good ground the fuses are good


... 2005 Chevrolet Colorado

My turn signals dont work checked the fuse in the car its fine replaced bulbs so is there a fuse in the fuse / relay box under hood for a 2001 kia rio


Hello,Checked the wires? Especially the supply to the relay? ... 2001 Kia Rio

I have a 90 chev 1/2ton the brake lamps are inop,i was towing a trailer and the turn and brake lamps became inop, checked fuses and found turnsignal fuse blown and the brake good,but the brake fuse was a 15amp and some one had installed a 30amp fuse, i replaced the turn signal fuse and the turn signals worked but still no brakes, so i checked the brake switch and found the connector and switch burnt, i replaced the switch and fixed the wiring at the switch still no brake lamps?


Use a test light and see if there is power to the switch. Then depress the pedal and you should have power on both sides. If there is no power to the switch, check the harness from the fuse box to the switch. If it got that hot, it may have melted th ... 1991 Chevrolet C1500

1984 ford F350 diesel...Turn signals stopped working...don't know which fuse...but replaced them all and new flasher. Brake lights work and flasher works...but no turn...replaced brake light switch earlier and then turn signals stopped working...


... 1984 Ford F 350

When I press brake pedal only one side has brake light. When I turn on headlights both back running lights come on, but when I press brake pedal only one side lights up. Turn signal only works on one side, the same side as the brake light that works. I have replaced fuses, blinker fuse, and light bulbs and can't get turn signals to both work and brake lights to both work.


Do you have a towbar fitted?? if so, check wiring installation. If not you may have a bad earth connection on that light cluster ... GMC Vandura

1995 ford Contour. My hazards work. no turnsignals, replaced turnsignal switch, checked all fuses.....still no turn signals....book says turn signal fuse or relay is on turn signal switch. I can hear and feel that thing working when I turn on hazards. Suggestions


Their is a round metal fuse in the fuse box..........Hope this helps. ... Ford Contour

All lights work and brake light at top works. brake lights on bottom left and right don't work. It was hook up to trailer wires connection. going down the road and when you turn on the right turn signal the cruise control would go off. the brake lights would come on but the right turn signal would stop working. as soon as you let off the brakes the turn signal would work again. I took the trailer connections off and replaced brake fuse and they still don't work.


Check a few things...\015\012- The bulbs\015\012- Check for ground at brake lamp connectors\015\012- Check your wiring at the connectors for power\015\012- Check for another fuse blown \015\012- Do not hook up the traile ... 2000 GMC Safari

My right brake light is the only one that doesnt work I have replaced the bulbs and fuses still nothing, my turn signals dont work but the hazards do, what do i do??


Ok when u run ur turn signals do the stay on if so i sugjest to check ur wires that are in you left hand side make shure u dont see any cable teed in to 3rd backe ligh some one did that to mines and now none of my brake lights work whit out it if t ... 1992 Buick Roadmaster

I HAVE A 98 CAVALIER AND MY DRL LIGHT INDICATOR IS FLASHING... MY DAYTIME RUNNING LIGHTS WILL NOT TURN ON AND NEITHER WILL MY HEADLIGHTS. MY HIGH BEAMS WORK AND DASHBOARD LIGHTS UP AND SO DO ALL MY REAR LIGHTS AND SIGNALS...JUST WANTED TO KNOW WHY MY HEADLIGHTS WONT TURN ON. I REPLACED FUSES AND HEADLIGHTS BUT THEY STILL DONT COME ON. PLEASE PLEASE HELP. THANKS


It may be the multifunction switch itself. ... 1998 Chevrolet Cavalier
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.6005 seconds