Having problems with your 1996 Ford Windstar ?

1996 windstar relay

\015 I cant find the fuel relay for a 1996 Windstar replaced pump but found out old pump works fine. Cant find relay or fuse all fuses look fine. What can I do. anyone have a diagram?\015 Posted / edited by AnonymousUser on : 15-01-2018

Answers :

The fuel pump power on the Windstar is controlled by a component called a Constant Control Relay Module (CCRM).
Its located located on the driver's side of the engine compartment.d7fb0ae.jpg
Repair Help & Product Troubleshooting for 1996 Ford Windstar

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

2006 dodge charger, er code p0406, check egr harness for 5v power on yellow with pink wire and no voltage 0 car is idling a little rough and has slight hesitation when accelerating.replace egr before i found 0 voltage.Also would like a diagram of the relay locations in the fuse box.there are 4missing relay plug sockets


Every fuse box has empty slots, so that is not the issue, this problem is this, the "EGR valve position sensor high signal return detected", this means that the EGR system is working, just the fact it generat ... 2006 Dodge Charger

My 98 windstar gl is not getting the ground comand through the pcm to open injecters and the fuel pump relay is not exciting the pump for initial start pressure and i have replaced most every sensor pcm and relays checked grounds replaced fuel pump eec dioad and clutch dioad pcm relay fuel relay ignition switch and more fuel pump is fine if iremove pump relay and jumper it run i have also tested the inertia switch the other pain in the but is i bought an obd meater yet it is unable to establish


If you don't think your getting the ground command through your PCM, you can make your own ground just by bypassing the PCM all together. First you need to find a PCM connector end view showing which pins are which wires and locate the ground you nee ... Ford Windstar

1994 e-150 conversion with a battery guard system. not starting, no click at solenoid, just relay click. I replaced the starter relay due to the relay clicking but no starter rotation after. The ignition wire to the starter stays hot all the time (12 volts), but goes to 0 volts when the ignition turned to the start position. Any ideas???? I might have wired the relay incorrectly. I'd like to find a picture or description of the exact relay wire placement.


Bad ignition switch it sounds like. A contact may be bad inside your switch upon turning it to the start position ... Ford E-150

I have audi A8L 2004 4.2L. The car starts and after 30 sec. main fuel pump relay shuts off and pressure drops to 0 and engine shuts off. I'm auto technician, I checked circuits to main fuel pump relay and signal from ECM to relay is disapering after 30 sec. Car starts fine every time after shut off and every time it shuts off after 30 sec. Tell me what problem could it be or what I should check? Thank you. Sincerely Jerry


Could be an oveheated fuel pump! Extract the pump out from fuel reservoir and test it! ... Audi A8

I have a 99 dodge ram 1500 5.9 we put a fuel pump with regulator in and a relay .still would not start it will start with the fuel relay out the psi will drop down to 0 and still will run just at idle but still run as soon we put relay back in it stall like it getting to much fuel


... Dodge Ram 1500

I have a 03 ford windstar lx wipers dont work in front tested the motor its good replace two relays replace wiper switch and test the power its goes to the relays but dont go to the motor dealer said there's another hiding relay but cant tell me where its at help


... Cars & Trucks

I HAVE A 1998 WINDSTAR I NEED TO KNOW WHAT AMPS THE RELAY FUSES ARE MY PROBLEM IS I HAD SOMEONE CHECK THE FUSES BECAUSE MY WINDOWS AND WIPERS WOULDNT WORK THE WAS A RELAY FUSE MISSING THE PERSON WHO CHECKED IT TOOK THE OTHER RELAY FUSE OUT AND PUT IT WHERE THE WINDOW FUSE WAS AND THE WINDOWS WORKED BUT RIGHT AFTER THAT THE LIGHTS WENT DIM AND THE ALARM WENT OFF AND THE VAN WOULDNT START BACK UP WE HAD THE ALTINATOR CHECKED AND WAS TOLD IT WAS GOOD SO WE REPLACED THE BATTERY IT RAN FINE UNTILL W


The relays are pretty fool proof--not like fuses where they have different amperages. Switching fuses or relays will not drain the battery. OK, so you have a new battery and alternator, right? And the car is not starting? And you think it's becau ... 1999 Ford Windstar

I am having seriuos electrical problems with my 1995 ford windstar. the door locks wont work when you hit unlock. When you do the park lamp relay clicks and not the relay for the door locks. Also the interior lights won't go out. also the power windows wont work the relay and fuses are good and the switches are good and the motors are good. getting no power to the switches. could all this be caused by the computer? and also i put in an after market stereo and would like to know what color the sp


My 19995 Grand Marquis had the exact same symptoms, but seemed sometimes if I would wiggle the fuse box just under the dash or release the parking brake quickly (which would shake the box) then things were fine for a while. Turned out to be the main ... 1995 Ford Windstar

1999 Ford Windstar 3.8 engine. Not charging. Alternator is good. Battery is good. No dash indicator lights showing any type of problem. Put a tester on the battery while running. Not charging. Tried my tester on another vehicle and it is OK. I assume that a fuse or relays in the circuit is bad, but can not find any in the owners manual specific to the alternator to battery circuit. There are fuses and relays all over the place. Which fuses and relays should I check?


You have a broken wire, get a wireing diagram off line ($15) I believe it's the field wire, I hate guessing but I don't have the diagram. ... 1999 Ford Windstar

2001 Ford Windstar fuel pump relay - 2001 Ford Windstar


... 2001 Ford Windstar

Where is the fuel pump relay 2003 windstar - 1998 Ford Windstar


... 1998 Ford Windstar

A/c clutch relay 2000 ford windstar location - 2000 Ford Windstar


... 2000 Ford Windstar

Relays in dash pass side clicks, lights go on and off, security light comes on, 3 of the relays get hot, battery voltage drops to 0 car stays running.


Test alternator for proper voltage gain. ... 2002 Chevrolet Monte Carlo

Find door lock relay for 1999 ford windstar - 1999 Ford Windstar


... 1999 Ford Windstar

Relay for the horn 2000 ford windstar - 2000 Ford Windstar


... 2000 Ford Windstar

Where is the starter relay for a 95 windstar - 1995 Ford Windstar


... 1995 Ford Windstar

1996 ford windstar lx 3.8l powertrain control module relay o.e.m. #F68F-12B577-AA Man date 20 SEP 1995 Vehicle required new relay module when old one failed to start radiator cooling fans when A/C was turned on. otherwise the fuel pump, cooling fans on engine high temp, and A/C compressor operation was fine. I was first given a BWD RCM12M module by local parts store. It failed to give me fuel pressure and engine start. Also it ran cooling fans constant as soon as battery was hooked up. I r


Are u referring to the IRCM? (Integrated relay control module), when u say proper placement what do u mean by this? Have u run a test of the IRCM with a OBD2 scanner, It will produce a code if it is the problem, if u have not scanned the system I str ... Ford Windstar

My windstar not turn dash lites off stay on and i need to disconected battery i try, to. disconected head lite switch,ignition switch, both fuse boxes ,all relays,all relays, computers some help please 2001 model


The dash lights and all interior lighting is controlled by a central module called in most Fords the GEM module, what must be done is to have the module scanned to show which component is causing this problem, it is most likely on of the micro switch ... Ford Windstar

Hello I have a 2002 dodge durango. 4.7 L Problem is po138 problem is i have no power going to either 0 2 senor. This system has only 2 o2 . not 4 my problem is my alldat info has the wrong wireing diagrams. they show in the pdc box a o2 heater relay, and a u fuse. i have empty pin cavitys. i have allway know chryler to power the o2 heater throught the asd relay with the coils and injectors. need to get a diagram or answer to where it get its power from thank you


Your best bet for a visual of the wiring diagrams is to buy a Haynes book for your truck at Autozone,they have a pretty complete set in the back of every book.$20.00 ... 2002 Dodge Durango

2000 FORD WINDSTAR 3.8 NO POWER TO FUEL PUMP TRIED TO PUSH RESET BUTTON INBACK RIGHT HAND CORNER DID NOT ACT LIKE IT DID ANYTHING RELAY IN FUSE BOX CLICKS WEN KEY IS SWITCHED ON . COULD RELAY BE THE PROBLEM????????


Check fuses ... 2000 Ford Explorer

Removing wiper relay in 2003 windstar - Windstar Ford Cars & Trucks


... Ford Windstar

96 windstar looking for fuel pump relay, not by battery, looked all over need pin point directions where it is located, can't find ignigtion control module, i know where powertrain control relay module is. haynes book not helping me at all. i have no power to fuel pump, i have spark


Check out your Inertia switch first. It is located in an access panel on the rear passenger side of your vehicle. There is a button to press to reset this and its function is to cut off power to the fuelpump in a wreck.\015\012\015\012T ... 1999 Ford Windstar

Location relay turn signal windstar 99 - 1998 Ford Windstar


... 1998 Ford Windstar

2000 windstar abs relay location - 2000 Ford Windstar


... 2000 Ford Windstar

Ford windstar fuel pump relay - 2000 Ford Windstar


... 2000 Ford Windstar
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.7878 seconds