Having problems with your 1996 Ford Taurus ?

Car still running after take key out . cheked barrel thats ok don't know if it's relay problem

Posted / edited by AnonymousUser on : 18-09-2017

Answers :

You need a new ignition lock cylinder
I think you have a bad ignition switch, not the ignition lock cylinder. they are 2 different things.
\015\012
\015\012\015\012\015\012\015\012\015\012\015\012Section 11-05: Steering Column Switches \015\012\015\0121996 Taurus, Sable Workshop Manual
\015\012REMOVAL AND INSTALLATION \015\012\015\012\015\012Ignition Switch \015\012\015\012Removal
\015\012
    \015\012
  1. \015\012Disconnect battery ground cable (14301).
\015\012
    \015\012
  1. \015\012Remove lower instrument panel steering column cover (04459).
\015\012
    \015\012
  1. \015\012Rotate ignition switch lock cylinder (11582) to the RUN position.
\015\012
    \015\012
  1. \015\012Disconnect the ignition switch electrical connector.
\015\012
    \015\012
  1. \015\012Remove the two screws retaining ignition switch (11572).
\015\012
    \015\012
  1. \015\012Disengage the ignition switch from the actuator.
\015\012Installation
\015\012
    \015\012
  1. \015\012NOTE: A new replacement ignition switch assembly will be set in the RUN position as received. \015\012
    \015\012
    \015\012Adjust the ignition switch by sliding the carrier to the ignition switch RUN position.
\015\012
    \015\012
  1. \015\012Make sure that the ignition switch lock cylinder is in the RUN position. The RUN position is achieved by rotating the ignition switch lock cylinder approximately 90 degrees from the LOCK position.
\015\012
    \015\012
  1. \015\012Install the ignition switch pin into the actuator. It may be necessary to move the ignition switch slightly back and forth to align the ignition switch mounting holes with the lock cylinder housing threaded holes.
\015\012
    \015\012
  1. \015\012Install retaining screws. Tighten to 5.6-7.9 Nm (50-69 lb-in).
\015\012
    \015\012
  1. \015\012Connect electrical connector to ignition switch.
\015\012
    \015\012
  1. \015\012Connect battery ground cable. Check ignition switch for proper function, including START and ACC positions. Also, make certain that the column is in the LOCK position.
\015\012
    \015\012
  1. \015\012Install lower instrument panel steering column cover with screws.
Repair Help & Product Troubleshooting for 1996 Ford Taurus

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0071 seconds