Having problems with your 1996 Ford Ranger SuperCab ?

1996 Ford Ranger XLT Clutch Bleeding

\015 I just replaced the whole clutch system and I think I need to bleed the clutch line. The clutch is engaging about an inch off the floor and is really spongy. How exactly do I bleed the system?\015 Posted / edited by AnonymousUser on : 11-12-2017

Answers :

The problem is up at the Master Cyl............It comes ou of the firewall and points DOWN at about a 45 deg angle.....The reservoir is remote and the hose is set to the lowest point of the cyl...........The tube TO the slave is 180 deg around facing bottom...........
Take the master cly OFF the firewall.......tilt it so that both inlet and outlet are the HIGHEST point of the cyl........Gravity bleed or vacula the slave.........then reinstall the master
I know it sounds like a lot of work but it's the easiest way to clear the air out of Ranger/Explorer hydraulics
Repair Help & Product Troubleshooting for 1996 Ford Ranger SuperCab

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Loading ...

  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0113 seconds