Having problems with your 1996 Ford Contour ?

How to replace fuse for 1996 Ford Contour turn signal

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Repair Help & Product Troubleshooting for 1996 Ford Contour

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

1995 ford Contour. My hazards work. no turnsignals, replaced turnsignal switch, checked all fuses.....still no turn signals....book says turn signal fuse or relay is on turn signal switch. I can hear and feel that thing working when I turn on hazards. Suggestions


Their is a round metal fuse in the fuse box..........Hope this helps. ... Ford Contour

How to replace fuse for 1996 Ford Contour turn signal


... 1996 Ford Contour

Have a 1990 Ford Bronco 5.8L 351. Replaced Ignition control module on the steering column and it ran for a few minutes. Tried to restart, but would not turn over. Had power to fuel pump, P/W, P/L, blower motor, headlights, hazards. No turn signals, stereo power. Replaced relays to fuel pump, EEC. Would not turn over. Tested all fuses, rechecked wiring to ignition module. Now, no P/W, stereo, turn signals, instrument panel, fuel pump or blower motor. When I tried to turn over, it sounded like a f


Ok i havea 1990 ford bronco and it runs forabout 5min and the it shuts off ... 1990 Ford Bronco

1984 ford F350 diesel...Turn signals stopped working...don't know which fuse...but replaced them all and new flasher. Brake lights work and flasher works...but no turn...replaced brake light switch earlier and then turn signals stopped working...


... 1984 Ford F 350

1997 FORD Aerostar Van, turn signals and flashers are not working. Even with the flasher "not working" I am not getting the turn signal light light to come on and hold. Figured out that the flasher buss setup in the 1997 was changed from what they show in the owners manual. I had a Ford flasher connected to the fuse box with a special bracket. I also saw another part connected separately, but I don't know what it is for. I have finally replaced the Flasher Buss with FL 34 from AutoZone. It


You need to check fuses for parking lights, brake lights, and the other fuse could have been an add on for sound system or a towing package for alternative lights for a trailer or camper. you should have 2 flashers one is for 4 way emegency flashers ... 1997 Ford Aerostar Extended

1994 Ford F150 Turn Signals to the Right & Left do not work at all--Flashers do work--Replaced Flasher Fuse & checked Turn Signal Fuse, All bulbs look good--Is there anything else I can check?


... 1994 Ford F150 Styleside Supercab

I have a 95 ford F-150 5.0, keeps blowing the fuse, therefore the turn signal doesn't work, i replaced it like 20 times already, as soon as i put it in it blows it, i replaced the light bulbs the turn signal switch at the steering column and the blinker it's weird please help thanks.


You have got a pinched wire back there somewhere. You need to start with the 'flasher unit'. This device gives the blinker the on...off function. Replace that first. If that doesn't do it, get to the wiring and look for a pinched/grounded wire undern ... 1996 Chrysler Cirrus

I have a problem with my turn signals on my 2004 Ford Expedition eddie bauer edition. They flash but then they don't. I have replaced the relay and they still do it!! I also checked the fuse and fuse is good. what else could be wrong making my turning signals do this??? Please help. Sandy


Replace the multifuction switch, it is faily easy to do you can do it at home or if you choose a shop will charge only a few dollars, the part is about 67.00 ... 2000 Ford Expedition

Turn signals and hazard ligths on 1996 ford f150 not working..Already replaced turn signal relay fuse.??


... Cars & Trucks

1990 ford mustang gt turn signals wont work but the hazards do. Replaced all fuses and all bulbs thinking about the ignition switch? Will this be a hard job to replace or will it be as easy as replacing a fuse??


Does it have a seperate flasher?most all cars that still use flashers have 2 flashers one for 4 way and one for turn ... 1990 Ford Mustang

1990 ford mustang gt turn signals wont work but the hazards do. Replaced all fuses and all bulbs thinking about the ignition switch? Will this be a hard job to replace or will it be as easy as replacing a fuse??


There are a number of things that could be wrong here. The best way to troubleshoot electrical issues is to work your way back from the device, in this case the lights. Make sure the bulbs are good. If the signalS both stopped working, I imagine a ... 1990 Ford Mustang

I have a 1997 Ford F150 4x4 Supercab Stepside with 5.4L and factory towing package. On the factory trailer wiring plug I am not getting power for turn signals or brake lights. Running lights and brake controller work fine. I have checked fuses, and one was blown, which I replaced to get running lights working. But I still do not have brake or turn signals at the plug. Is there something else I can check before tracing the lines?


No, check the wiring in the rear going to hitch plug, they may have rotted or broke,if lights work on the truck then i would say its wiring,test wiring moving backward until you get power, this way you can pinpoint break location area, good luck, ho ... 1997 Ford F150 Regular Cab

2002 ford ranger stepside 4x4 wipers an turn signals dont work already replaced turn signal switch an relays fuses seem good


... Cars & Trucks

Have a 1999 bounder 34j on a ford f53 chassis with a v10. turn signals and emergency flashers quit but wipers still work. checked and tested all fuses and relays. 2 20 amp,2 15 amp,1 60 amp outside and 2 5 prong relays all were good so replaced the turn signal switch but still no luck. is ther a flasher relay somewhere that i have not found? on the bottom of the steering column i found a gold with a black rubber end that is round with a 3 wire plug in.


Flasher and blinkers look like a small silver cylinder, maybe an inch or so in diameter. they are usually in the fuse box or somewhere in the dash. (in my 93 mustang the flasher is almost in the middle of the dash instead of driver side while the bli ... Ford F-450

I replaced turn signal relay, which now works. But now the blower motor relay, which is adjacent to the turn signal relay, doesn't work. I checked all fuses and relays. Still now blower to the A/C. Any ideas? This is a 2000 Ford Expedition.


... 2000 Ford Expedition

I have 1999 Ford Contour Lx 2.0. My turn signals will not work. The only time I get a turn signal to work is when my emergency lights are on, then they flash inside the car and outside from side to side, but my emergency lights are also flashing. I have lights all around, have replaced i socket and have put in a new flasher. I don't know what to do.


... 1998 Ford Contour

Turn signals on 1996 ford contour quit working. hazards were still working. replaced flasher, but now, turn signals still don't work, and hazards are not working either. what is going on?


... 1998 Ford Contour

2003 Ford Ranger, XLT 6Cyl. Flashers, Running Lights, Reverse Light, Right and Middle Brake Light and Headlights are working. Front running/parking lights are not working. Signal Lights, Front and Rear are not working (replaced Bulbs already). Rear Left Brake Light not working (replaced bulb already). Fuses checked an all appear to be good. What do I do? State Inspection was due yesterday, getting all kinds of hand gestures and horn honking for slowing down to turn without signal lights.


Found very detailed assistance and instructions, FREE on the Ranger Station Forum. It is nice being able to go on-line and find lots of free information from fellow American Ford Ranger owners and not be asked for $$$.\015\012\015\012If ... 2003 Ford Ranger Regular Cab

When i turn the igniton key to on the fuse for the heater/ac blows.at first the turn signal stoped working when the heater /ac fuse blew. I replaced the fuse. the turn signal and heater worked for 2 days then the fuse blew. I removed the fuse for the heater/ac and the turn signal worked for a day. now the turn signal does not work and when I turn the ignition on the fuse blows immedietely. I downloaded a fuse box diagram from wjjeep.com/fuses and it states that fuse # 20 10amp controls ignition


The ignition run is to the ECU or Engine Control Unit. And the blinker sense is for the blinkers to chime when left on for more than one minute. Finding these kinds of problems are very hard. Because from what you said earlier that it ran for 2 days. ... Jeep Grand Cherokee

Initial problem was right turn signal remained on. Found a buent fuse and then replaced turn signal flasher with no luck. Was told it was the turn signal combo switch. While looking to see how to replace the switch I needed to go somwwhere so went to start the car. Initla electric contact then complete power outage. Was told it may habve burned the main fuse. Battery is fine and cables care clean. Found a battery fuse in the fuse box under the hood but can't tell if it is burned out. ANy ide


It sounds like you maybe have a defective ignition switch or an open internal open battery post. So first have the battery tested by a parts store it is free then go from there ... 2000 Mitsubishi Montero Sport

I have a 1988 ford ranger and the turn signals quit working all of the sudden i checked fuses all is good and the reverse lights quit to and they are on the same fuse i even replaced the fuse anyway still wont work


... 1988 Ford Ranger

I have a 90 chev 1/2ton the brake lamps are inop,i was towing a trailer and the turn and brake lamps became inop, checked fuses and found turnsignal fuse blown and the brake good,but the brake fuse was a 15amp and some one had installed a 30amp fuse, i replaced the turn signal fuse and the turn signals worked but still no brakes, so i checked the brake switch and found the connector and switch burnt, i replaced the switch and fixed the wiring at the switch still no brake lamps?


Use a test light and see if there is power to the switch. Then depress the pedal and you should have power on both sides. If there is no power to the switch, check the harness from the fuse box to the switch. If it got that hot, it may have melted th ... 1991 Chevrolet C1500

I have a 1993 ford f-150, the headlight switch shorted out to where the headlights would still come on but the tail lights and parking lights and dash lights would not work. My brake lights and turn signals still work. I replaced the switch and it still has the same issue. I checked my fuses and replaced 2 of them but that didn't fix it either. I then checked my bulbs and they were fine. Am i missing a step here?


Also check the fuses, there are 2 on in the interior fuse panel, over your left knee, and 1 in the "big" fuse box under the hood on the drivers side engine compartment, beside the overflow-washer box, and almost under the master cylinder, check em' b ... 1993 Ford F150 SuperCab

I replaced the bulbs for the running lights on a 1999 Ford Contour, but they still won't work. Is it in the fuse box or is there a switch on the dashboard that needs turned on? Help! If in the fuse box, what number on the diagram?


Dont know # but u can use a test light to test fuses or pull out 1 by 1 and check if good may be light switch which is a common problem with fords ... 1999 Ford Contour

I have 12 volt power to the intermediat, but no power to the main motor. I have replaced the wiper motor & the wiper switch that is with turn signal. I have traced the three wires to the fire wall they look ok. I have power on the fuse for the wiper I there another sourse for power relay or fuse? This is a 1994 ford F350


I know on chevys that there's a module on the motor itself that is a common problem in those trucks. I'd check and see if there's one on the ford. It costs a whole $20 at the oreillys ... 1995 Ford F350
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 4.0695 seconds