Having problems with your 1995 Nissan Pathfinder ?

NEED TO REMOVE KNOCK SENSER FROM A 95 NISSAN PATHFINDER 3.3 ENGINE

\015 WHAT ALL NEEDS TO BE REMOVED FROM LOWER INTAKE MANIFOLD TO GET TO KNOCK SENSOR\015 Posted / edited by AnonymousUser on : 22-01-2018

Answers :

Repair Help & Product Troubleshooting for 1995 Nissan Pathfinder

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

NEED TO REMOVE KNOCK SENSER FROM A 95 NISSAN PATHFINDER 3.3 ENGINE


... 1995 Nissan Pathfinder

My 1997 nissan pathfinder p0325 code came up on the scanner, and I need to change my knock censor on the car. I do not known were this part is located on the engine


Very familiar with this. it is down under the intake manifolds in the valley of the engine. it is a single wire connector. you must remove the manifolds to replace this item. parts will run you about $100 and take about 3-6 hours depending on your co ... 1997 Nissan Pathfinder

I have 1995 Subaru legacy GT with the 2 litre Boxer 2-stage twin turbo engine. My garage said my car needs a 'knock sensor'. I have a second non-running car the same and I want to get the knock sensor off this one to save cash. My garage mechanic said I need to remove the 'inter-cooler' (2nd radiator on top of engine block beneath bonnet air scoop?) to reach it - but how do i get this thing off??? Thanks!!!


Hi! There are hoses that attaches to the intercooler radiator. Usually it has only metal fittings that can be loosen by using a screwdriver. Remove those hoses and remove the bolts that attaches the turbo intercooler. By then you can have access to t ... Subaru Legacy

1995 nissan pathfinder 4DR key broke off in door cylinder passenger side front. I dont have another key and its to old to get a key code from Nissan. The dealer said there possibly is a key code on the cylinder. I need a schematic of the door panal and the cylinder that shows me how to remove the door panel and how to remove door cylinder. [email protected]


... 1995 Nissan Pathfinder

Whats modifications need to be done to put the 3.3L motor from a 1997 nissan pathfinder into a 1995 nissan pathfinder engine compartment?


... 1995 Nissan Pathfinder

I just replaced the vg 30 i engine in my 1988 Nissan Pathfinder with one from Japan that is supposedly the same vg30i ,but the accessories are different since i am in California. I need to know what size pulley I need to change it to a serpentine belt . Can i use the same one as on the old vg30i? What other vehicles have one that is compatible for this .I need cross referencing help.


... Nissan Pathfinder

My 2005 Nissan Pathfinder Service Engine Light came on at 80,495 miles.I took it to the dealer and after $403.78 worth of repairs code PO455 was replaced an cleared. One month later at 81,159 miles the Service Engine light returned and after $524.73 later, codes U1000 & P0403 were cleared and I was told that my vehicle will need BANK 2 CAT CONVERTER at a cost of $1200.00. The Service Engine Soon Light is on again at 81,700 miles. Is this a realistic cost for these repairs? How long do I have to


Are you the original buyer? If so I would have contacted nissan because most states have what is referred to as a lemon law. According to Statelawyers.com, Lemon Law refers to the statement from the government that was created to protect consu ... 2005 Nissan Titan

On my 96 Nissan 4x4 pickup with KA24E engine I am removing the differential to access the oil pan. On the forward support that is to come down there are 4 bolts that need to be removed, 2 on each end


Sorry but what are you asking?? more info please. ... 1996 Nissan Pickup

I have a 2003 nissan xterra and when I crank it up a loud knocking noise can be heard I do mean loud. I took it to autozone a while back when the check engine light was on and they said I needed a new knock sensor and a oxy sensor. The noise is incredibly loud and I was told it could possibly be something to do with a gasket in the manifold or something? I don't know much about cars so if anyone could help it sure would be nice


I would have to be there to hear it. You may want to have it towed to a shop to get their opinion. A knocking noise is usually a rod bearing or other internal engine part, and very serious damage can result. ... Cars & Trucks

Pathfinder engine knock - 2001 Nissan Pathfinder


... 2001 Nissan Pathfinder

I just bought a 93 nissan pathfinder xe-v6 and it needs a little work the power locks dont lock or unlock, i dont know what bulbs to put in the by the rear view, the window washer for the rear window works but the one one in the front doesn't( does the same motor work both front and back)?,it sounds like a lifter is knocking how do I adjust them on a nissan? for some reason it sounds like the plugs or the plug wires are bad but their not. I have cleaned the throtle body and put some cleaner in t


I have a 1994 Nissan Pathfinder too and it does the same problem when you push the locks down it sounds like a relay in the back of the Vehicle and when the weather is cold they work fine, finally found that the lock of the hatch is bad and this is c ... 1993 Nissan Pathfinder

Hi can someone tell me please on my nissan nomad 1990 2.4 z24 dual spark single ohc engine what the cylinder head bolt tensions are and if head bolts need replacing and how do u lock the timing chain or stop it from falling. do u need to lock the tensioner or remove front cover etc or will the chain simply pull back up onto the cam once reinstallment commences.. is it possible to drop links..? thanks


... Nissan Minivan

I need to know the fuel injector size (flow rate/capacity) for a 1997 Nissan Terrano (Pathfinder) petrol engine type VG33(E). This is for programming a trip/engine performance computer plugged into the Nissan Consult port.


If it's the 3.3L VG33E engine, that's the same as used in the Pathfinder/Quest/Maxima.\015\012\015\012Injector Flow Rate =\015\012147.1cc/[email protected] ... Nissan Pathfinder

2001 Expedition 5.4L. Trying to find out what this noise is. I am getting a loud knocking sound from the passenger side engine compartment when under 1k RPM. It goes away when applying gas, and accelerating. I recently had an issue with the AC clutchbeing stuck on. I removed the fuses so that I could drive the vehicle. I have heard the ting ting ting sound coming from the AC clutch so I know that probably needs to be replaced. I have no oil leaks or burning and the engine only has 99k miles


... Cars & Trucks

Hi i want to know if its possible for me to remove and disable the exhaust catalyst (air cleaner) from my toyota rav4 1997 coz i think it is closed and my engine is working hardly especially on a up road. N.B. i have 2 oxygene senser : one before the catalyst and one after it so all i need to know if my works fine if i disable it and remove it thank you


If you take out the sensors it will report a fault , if you remove the cat then the motor will fail the emisions test.\015\012\015\012If you live in the UK then it fails the MOT \015\012\015\012If you get a pull from the polic ... 1997 Toyota RAV4

My f150 4.6 stugles to stay on after i start it however if i keep my foot on the throtle long enough the engine comes alive with no knocking or smoke but when i remove my foot off it chockes with very low rpm and it shuts off. i was told that the engine is out of timing or need to replace timing chain???


You might try cleaning the throttle body first. Buy some good Throttle body cleaner and a old tooth brush take off the air intake hose to the engine, have a friend hold the gas pedal to the floor with the engine off and spray and scrub the throttle b ... Ford F-150

1997 Nissan Altima 2.4L serpentine belt and ac belt replacement. How do I do this? I have removed the damaged alternator and have a replacement along with the belts but cannot see the belts well. Do I need to remove the ac unit also or is there an idler that gets moved? I cannot raise the car, so can all of this be done above the engine? Would it be better to tow it to a garage and pay to have it done?


There is an idler pully for the AC belt and im sorry this will have to be done from underneath the car because the idler pulley is on the very bottem. if you can jack it up. and put some stands underneath and it should be no problem. refer to this li ... 1995 Nissan Altima

Hi i want to know if its possible for me to remove and disable the exhaust catalyst (air cleaner) from my toyota rav4 1997 coz i think it is closed and my engine is working hardly especially on a up road. N.B. i have 2 oxygene senser : one before the catalyst and one after it so all i need to know if my works fine if i disable it and remove it thank you


You don't want to take the cat out because the oxygen sensor will make the check engine light to come on.\015\012the up stream oxygen sensor is called air/ fuel ratio sensor, with out that one your engine will not run right ... 1997 Toyota RAV4

95 NISSAN PATHFINDER ENGINE KNOCK SENSOR


... 1996 Nissan Pathfinder

Need estimated labor hours to remove and replace engine in nissan maxima 2005 3.5l asap


... 2005 Nissan Maxima

How do I reinstall my distributor-Nissan 1998 Pathfinder v6 3.3L engine-no org marks made before removal, Haynes diagram 3.8 for TDC on 2B-3 does not seem same as my suv.


... 1998 Nissan Pathfinder

Will a 1997 3.3 Nissan Pathfinder engine be good to swap out a 2004 3.5 Nissan Pathfinder engine ??


Being that you have a complete donor car the swap would be easy enough, one thing to keep in mind is the fuel management system and ECM will be different between the two. you may want to research the swap before you dive into it. it most likely will ... 1997 Nissan Pathfinder

I have a 1995 nissan hardbody and the fuel pump quit I replaced it and it would only run half speed then shortly after the engine completly shut down. I have experience using genisys pathfinder for obII I am trying to figure out the Dtc's (Diagnostic trouble codes) retrieval on this particular model . Do I need a Obd1 scanner or can I just turn a screw on the computer to go into the diffrent modes like on the 91 model? Its a ka24 four cylinder . Thanks. jason


Pump running half speed? check for bad ground and yes you need an OBD 1 scanner,need more help get back to me as i strive to be the best. Please rate my fix? Thanks Ray ... 1995 Nissan Pickup

1996 Nissan Path finder, How do I remove the drive pully from my pathfinder, pully seems loose, it jiggles a little bit and when running makes a rattleling noice,the pulley is wide and it holds 3 different belts,and to pull it off do I need special tools? Thank you.


No special tools needed. Just the exact bolt size to get the pulley loose. You will need to loosen up and remove the belts first. ... Nissan Pathfinder

The transmission/clutch on my 1998 Nissan Pathfinder LE 4x4 (automatic transmission) was slipping a little bit yesterday. Only a couple times, and it's been good since...so, knock on wood hoping it was just a fluke. If not, how much time am I likely to have before it goes out completely? Also, can anyone give me an approximate range as to the cost for this car's transmission should I need to invest in a new one? I know sight unseen you can't give a specific number; I'm only looking for a general


I paid $1,000 dollars for my sons tranny auto 4X4 ... 1998 Nissan Pathfinder
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.6593 seconds