Having problems with your 1995 Jeep Grand Cherokee ?

I need to change a igniton on a 1995 jeep grand cherokee

Posted / edited by AnonymousUser on : 15-01-2018

Answers :

Is not to hard, review the service manual for ZJ-Secc-8D-Ignition-Systems (page 35 and next)

Have a nice day (remember rated this help) Good luck.


Repair Help & Product Troubleshooting for 1995 Jeep Grand Cherokee

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need to change a igniton on a 1995 jeep grand cherokee


Is not to hard, review the service manual for ZJ-Secc-8D-Ignition-Systems (page 35 and next)Have a nice day (remember rated this ... 1995 Jeep Grand Cherokee

I HAVE A 1999 JEEP GRAND CHEROKEE, 112,000 MILES. JUST FOUND OUT BALL BEARINGS NEED REPLACING. THE MECHANIC SAID WOULD COST $1,600- $1,700 TO FIX AND THAT THE RODS OR CRANK MAY NEED REPLACING BUT HE WILL NOT KNOW UNTIL HE GETS "IN THERE" IS THIS TRUE? CAN A JEEP DEALER TELL WITH JUST CHANGING THE BALL BEARINGS AND /OR SHOULD I EVEN BOTHER GETTING THIS FIXED? (PLEASE DON'T SAY TOO BAD I DID NOT GO FOR CASH FOR CLUNKERS!!) LTW


The front bearings on a Jeep should have lasted longer but, there you go. When he disassembles the front end to replace them he should check the steering linkage and suspension since they are weaker than the bearings and even more prone to give out. ... 1999 Jeep Cherokee

Need to reset computer in 1995 jeep grand cherokee limited editiom 5.2 ltr dont know how. changed starter yesterday ,now jeep wont run any longer than ten secondes, read on this site if i reset computer will solve problem, i dont get it, all i did was change the starter nothing else thanks, ken


You can try closing all the doors, then locking drivers door using the key...then unlock. Depending upon what system you have, this often works! ... 1995 Jeep Cherokee

I have 1994 grand cherokee Jeep, Jeep heats up and will not start the temp gage is not working; i have replaced the thermo sts sensor and gasket. The temp gage on panel still doesnt work... My Jeep also blow out white/light blue smoke from exhaust pipe; I have changed oil/filter and gasket. im so confused and need help


White /light blue smoke is a sign of a blown head gasket or intake gasket when you changed the oil filter was it creamy cause if it was then is a head gasket ... 1994 Jeep Grand Cherokee

I need to change axle on jeep grand cherokee 2000 but need special tool to take off 3 bolt please tell me what tool do I need


Tork-bit socket. ... 2000 Jeep Grand Cherokee

Purchased used 2006 Jeep Grand Cherokee - The navigation system manual was not provided. Need to change addresses in navigation system and can't determine how to make necessary changes. Can you help me?


Access enter new destination menu, then add new or delete existing ... 2006 Jeep Grand Cherokee

Hi. I have a 2003 jeep grand Cherokee 4x4 v8. The oil gauge drops to zero and then will stay up in the full position. It is also making a slight clacking noise a little while after running.we just did an oil change and we are seeing the same problem. When we changed the oil there seemed to be water mixed in the oil. Everyone thinks we need a new engine or valve gasket covers? Could it be something else?


... Cars & Trucks

Help I have a 2000 Jeep Grand Cherokee Laredo 4x4. Recently, it started surging on me. While I am driving, the oil pressure gauge will go high then return to normal. While it is doing this, my RPM's go low and high. Any suggestions? I have had the spark plugs changed but, the guy told me it doesnt have spark plug wires. I have added injector cleaner, changed the air filter also. Maybe needs a fuel filter? Any suggestions?


Hey, I just had the same rpm surging problem... really bad all of a sudden over the last couple days. The check engine light came on today and it's idle changed from big time shaking to barely a pulse. Drove okay on the highway on our way to my favor ... 2000 Jeep Grand Cherokee

I have a 1998 Jeep Grand Cherokee Laredo. It will not start. After checking fuses then changing the ignition switch on console I still can not get anything to light up on the dash when I turn the key, Someone told me that it is probably the on board computer. Is there anyway to check that system or do I need to buy one to find out. Thank you for your help. 160.000 mile Cherokee owner


Hello jam... you need to have your jeep's computer scanned for error codes. many auto parts stores, even AAMCO shops now scan for free. Start there. Joe ... 1998 Jeep Grand Cherokee

Need to change the starter on a 2008 jeep grand cherokee limited with a v8 hemi. Found the starter but not sure how to get it out. Do I need to remove the exhaust or drive shaft? Thanks for your help.


Same issue. 2008 Grand with Hemi. loos like the Driveshaft has to come out but I still do not know if there is enough Wire length to get the wires off with the starter unbolted ... 2006 Jeep Grand Cherokee

My 1996 Jeep Grand Cherokee Laredo is running badly. It jerks like it needs more gas. Thought changing the catalylic converter and oxygen sensors would help since is smogged as a gross pollutor need help


Well if it is miss-firing, it could be an ignition or fuel problem, or something mechanical.Is the check engine light on ? ... 1996 Jeep Grand Cherokee

It's not really a problem. I just need to know the color coding of the factory amp to my friends1999 Jeep Grand Cherokee Laredo. Basically he was so impatient that he had this kid just snip wires not knowing where everyone goes to and now its all messed up. I just need color codes for this because after the factory amp the speaker wires change colors.


I would try to find out who manufactured the amp and try get info from them. If not try searching more on the internet. If it is in a Chrysler or jeep good chance it may be manufactured by infinity. ... 1999 Jeep Grand Cherokee

I am having the hardest time finding a vacuum leak on my 1996 jeep grand cherokee and need to know what hoses/lines and any thing else that i need to look at and methods of finding this aggravating leak. ive changed the brake booster, the iac, and prayed carb cleaner and still no sign of a vacuum leak.


Try using dish soap and warm water in a spray bottle. Spray all vacuum hoses and around the intake and air intake. Bubbles should indicate a leak. ... Jeep Grand Cherokee

My engine was knocking so I thought I just needed an oil change. After $200 for good oil change, transmission flush and new oil, transverse case flush, it still knocked. In fact on that same day, it got so loud, it started smoking really bad and it died and never started again. It said "coolant low", but looking under the car, all the oil (at least it looked that way to me) was on the pavement. Do you think I blew it up. It is a 1999 Jeep Grand Cherokee Limited Edition. Really nice truck b


First find out where the oil came from, if its from the filter whoever replaced it is liable, if its a hole in the side of the engine then it threw a rod and you are out of luck, let me know what you find ... 1999 Jeep Grand Cherokee

I cannot find the fuse box for the heated seats in my Jeep Grand Cherokee 2000. Also the "thing" that tells me when I need an oil change, which direction I'm going, etc. is no longer changing when I push it's buttons. Can someone please respond to these questions? Thanks!


The heated seat fuse is located in the junction block behind the left side of the dash. It is fuse number 20, a 10amp fuse. As for the driver information center not changing the display when you push the button, I believe this is a singl ... 2000 Jeep Grand Cherokee

How do I add brake fluid to my 2004 Jeep Grand Cherokee Laredo? Does a mechanic need to do it? What type of brake fluid would I need if I can do it myself? Brake fluid was judged to be very low by JiffyLube folks during recent oil change. Thanks.


Hello... Yes, this is something you can do without the help of a mechanic. If you have or can get your hands on the owners manual for the vehicle that would be the best help.\015\012\015\012Generally speaking, the type of brake fluid need ... 2004 Jeep Grand Cherokee

99 jeep grand cherokee oil pressure drop to 0 could it need oil or what ??


... 2002 Jeep Grand Cherokee

Hesitating i have a jeep grand cherokee that will only hesitate in tthe morning for five seconds. I have changed the fuel filter and the spark plugs are only 6 months old. need help


Have you cleaned the throttle body and idle air valve?? if not do that, also the ECT or engine coolant sensor can be giving the fuel injection computer a wrong temperature signal, that will make the engine hesitate. That has ... 1995 Jeep Cherokee

Serpintine belt i need the diagram for a 1996 jeep grand cherokee 4.0 serpintine belt instalation Need Serpentine belt route for 1995 Jeep Grand Cherokee Laredo 6 cylinder 4.0 L 4WD with AC.


This link will take you to a picture of the diagram. If the link doesn't work contact me and I can email you the picture directly.\015\012\015\012 ... 1995 Jeep Grand Cherokee

Jeep Grand Cherokee Limited 10-CD changer CD Player not working, needs repair. system seems to spin up the CD and even changes the CDs but will not play them. How can I get this fixed?


Try inserting deck with force. make sure c/ds are properly inserted ... 1999 Jeep Grand Cherokee

I NEED TO KNOW THE EASYEST WAY TO CHANGE AN A/C EVAPERATOR ON A 1996 JEEP GRAND CHEROKEE


Just like emissionwiz said "there is no easy way". When I worked for\015\012Jeep, we must have done 10 a/c evaporators a week in the summer. Do you\015\012know that Jeep extended the warranty on the evaps. to 100,000 miles\015\012because of defects i ... 1996 Jeep Grand Cherokee

Need help on re wiring the right turn signal in the rear of my 1993 jeep grand Cherokee. Brought the Jeep Grand Cherokee and found that the right turn signal in the rear of the car doesn't work. Took it apart and found that it was wired to the front turn signal. Need to know how to fix this.


Review the Repair Manual for Jeep ZJ-Secc-8W-Wiring-DiagramsWith this guide the work is so easy to solve (remember rated this hel ... 1997 Jeep Grand Cherokee

1993 Jeep Grand Cherokee It has recently developed a clattering on start up, or shortly there after. I am assuming it is the tappits, and am wondering if you could recommend the best additive to quiet them for this make and model? It has very high mileage, but the engine performance is still good, no excessive oil leaks, etc.. I am also going to attempt my first oil change, (yes, I am a girl) and am wondering if there is somewhere I can access step by step instructions without needing to purchas


Crawl under jeep find wrench should be 16mm break drain loose place pan under plug slowly remove plug drain all oil replace plug on passenger side the oil filter is screwed on engine break filter loose spin off make sure rubber seal came off with fil ... 1993 Jeep Grand Cherokee

Transmisson When you change the fluid in your transmisson do you need to add any additive? I have a 2000 jeep grand cherokee limited.


No just put the factory recomended fluid. ... 2000 Jeep Grand Cherokee

My horn I have a 1996 grande jeep cherokee loredo. it was towed about 6 months ago, because it has an alarm on it, they found some way to turn off the horn. i have finally decided to try on my own to fix it but i dont know where the horn wires are, and i dont know which fuse is the horn fuse to see if it needs to be changed.


Your horn wires are in your dash bord and if you are going to try to do that on your own goodluck cuz if you are going to try to take that apart then you are crazy that is a lot of wiring and you are going to **** it up and when you get it back toget ... 1996 Jeep Grand Cherokee
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.carrestorationshop.com || Terms of Use || Contact || Privacy Policy
Load time: 3.2040 seconds